Gabriel P 6 | |
---|---|
Role | Training aircraft |
National origin | Poland |
Manufacturer | Pawel and Jan Gabriel |
Designer | Pawel Gabriel |
First flight | late May 1924 |
Number built | 1 |
The Gabriel P 6 was a Polish training aircraft and the P 7 a tourer. The difference between them was the wing configuration, chosen to optimise their speed range for their role, so the P 6 was a biplane and the P 7 a parasol wing aircraft.
After their first powered design, the single seat P 5, the Gabriel brothers considered the different requirements of two seat trainers and tourers. Both needed to handle well, ideally with similar characteristics, but the trainer required lower landing speeds and the tourer higher cruise speeds. They decided that economical solutions would share engines, fuselages, landing gears and wings but that the trainer should be a biplane with a cantilever lower wing and the tourer, without the lower wing, a parasol wing monoplane. The same airframe was flown in both the biplane (P 6) and parasol (P 7) configurations. Like the Gabriel P 5, the new aircraft was strongly influenced by the Fokker D.VII. [1]
The P 6 was an all wood aircraft. Both of its wings were tapered in plan and were built around two spars with plywood covering. The upper wing was mounted over the fuselage by a cabane of inverted V-struts from the upper fuselage and braced on each side with a parallel pair of struts from the spars to the lower longeron. The lower wing was attached to the lower longerons. [1]
The trainer was powered by a 48–52 kW (65–70 hp) four cylinder, water-cooled inline Mercedes engine. [1] [2] The forward part of its rectangular section fuselage was covered with aluminium sheet and the rest with plywood. There were two cockpits in tandem, equipped with dual control though with flight instruments only in the rear seat. Its empennage was externally braced, with ply-covered fin and tailplane carrying fabric covered control surfaces. [1]
Its fixed landing gear, with a track of 1.6 m (5 ft 3 in), was of the tailskid type, with mainwheels on a single axle held via rubber ring shock absorbers on V-struts from the lower longerons. [1]
The Gabriel P 6, the first Polish designed two seat trainer, was flown for the first time in late May 1924, piloted by Jan Gabriel at Bydgoszcz. It was subsequently tested by pilots from the Bydgoszcz pilot's school, who reported that it handled well. [1]
Later in 1924 the lower wing was removed, a straightforward alteration in the absence of interplane struts, and the aircraft was flown successfully as the Gabriel P 7. With only 63% of the P 6's wing area but slightly lighter the P 7 had both maximum and landing speeds that were 20 km/h (12 mph; 11 kn) faster than the P 6.
The Polish aeronautical authorities showed no more interest in the P 6 and P 7 than they had in the P 5. No funding was gained and, although Pawel Gabriel had designed a new high wing, low power ultralight, the P 7 was the Gabriels' last aircraft to fly. [1]
Data from Cynk (1971) [1] except where noted
General characteristics
Performance
The Junkers T 23 was a two-seat, single-engined experimental training aircraft, built in Germany in the early 1920s. It could be configured either as a parasol winged monoplane or as a biplane to compare handling characteristics. 4 were constructed.
The Farman FF 65 Sport was a French built light biplane, with a single engine and tandem seats, intended for sport and touring. First flown in 1919, it achieved modest sales at home and abroad in the early 1920s. Two unusual modifications produced a biplane glider and a low aspect ratio parasol wing machine.
The Skraba S.T.3 was a two-seat Polish biplane built in 1928. It was the first all-metal aircraft designed in Poland; only one was completed.
The Medwecki HL 2 was a Polish two seat lightplane flown in 1927. Handicapped by a low power, unreliable engine, its flying life lasted little more than a month.
The Medwecki and Nowakowski M.N.3 or just M.N.3 was a low-powered, four seat, Polish aircraft flown in 1928. The sole example was modified into a more powerful two-seater which served aeroclubs until World War II.
The Medwecki and Nowakowski M.N.5 was an economical Polish trainer aircraft initially aimed at the club market, though there was also some military interest. It performed well but lacked a constructor after Samolot became insolvent in 1930, so only one was completed.
The Rogalski and Wigura R.W.1 was designed and built by a pair of students at Warsaw Technical University in 1927. The single example was a two-seat parasol-wing monoplane which entered two national competitions, served the Warsaw Academic Aeroclub and also towed an advertising banner.
The Gabriel P 5 was the first nationally developed aircraft to fly in Poland after it became independent in 1918. It was an amateur-built, low-powered, single seat parasol wing machine. Only one was completed.
The Semal III was a parasol wing test bed for a wing with variable camber, intended to increase the speed range of aircraft and to lower landing speeds. It was based on a Nieuport 80.
The Silesia S-4 was a Polish, low-power parasol wing aircraft built in 1925. After an engine change and airframe modifications it became one of the Silesian Aeroclubs fleet. It was lost in a take-off accident in 1931 and was the last Silesia aircraft to fly.
The Działowski D.K.D.1 was the first powered aircraft designed by Stanislaw Działowski. It was a low-power high-wing monoplane with a cabin for one passenger. After attending an aviation exhibition in Warsaw in 1927 it was badly damaged when the engine failed as it left and it did not fly again.
The D.K.D.3 was a Polish, single seat, parasol-wing sports aircraft first flown in 1927. Only one was built but flew in demonstrations and in national competitions into the early 1930s.
The Kozlowski WK.3 was a one-off Polish biplane trainer. It first flew in 1933 and was later re-engined, serving an aeroclub until the invasion of Poland.
The Grzmilas Orkan II was a Polish one-off, single-seat sports aircraft. It came second in the second National Lightplane Contest held soon after its first flight, with outstanding take-off and climb characteristics. Its designer and builder continued to use it until 1939.
The D.U.S. III Ptapta was a two-seat sports and touring biplane and only the second Polish aircraft using aluminium alloy construction.
The LKL IV and LKL V were a pair of very similar Polish parasol wing two-seaters, built in the early 1930s. They differed primarily in their engines.
The Sido S.1 was a Polish two seat, parasol wing trainer aircraft, first flown in 1930.
The Gabriel Śląsk (Silesia) was a Polish light aircraft designed and built by an amateur in the mid-1930s. After two flights the Polish authorities banned further development.
The Czerwiński CW 8 was a mid-1930s Polish open-frame basic training glider. Its design was advanced and its price low, but its stalling characteristics were too dangerous for beginners, so the thirty-plus examples completed were rapidly withdrawn from use. Two were subsequently modified, one with greater span and the other with a small engine.
The Czajka (transl. Lapwing) or Kocjan Czajka after its designer was a Polish secondary training glider which was in continuous production from 1931 to the start of World War II. More than 160 were completed in Warsztaty Szybowcowe in Warsaw.