Lipophilic efficiency

Last updated

Lipophilic efficiency [1] (LiPE), sometimes referred to as ligand-lipophilicity efficiency (LLE) is a parameter used in drug design and drug discovery to evaluate the quality of research compounds, linking potency and lipophilicity in an attempt to estimate druglikeness. [2] [3] For a given compound LiPE is defined as the pIC50 (or pEC50) of interest minus the LogP of the compound.

A plot of LogP vs pIC50 for 2 series of compounds (series 1: green dots, series 2: blue dots). Diagonal lines represents areas of equal LiPE. Analysis of this LiPE plot shows that series 1 includes many compounds with a high LiPE, and thus may represent a better lead series for further optimization. LiPE Plot.png
A plot of LogP vs pIC50 for 2 series of compounds (series 1: green dots, series 2: blue dots). Diagonal lines represents areas of equal LiPE. Analysis of this LiPE plot shows that series 1 includes many compounds with a high LiPE, and thus may represent a better lead series for further optimization.

In practice, calculated values such as cLogP or calculated LogD are often used instead of the measured LogP or LogD. LiPE is used to compare compounds of different potencies (pIC50s) and lipophilicities (LogP). High potency (high value of pIC50) is a desirable attribute in drug candidates, as it reduces the risk of non-specific, off-target pharmacology at a given concentration. When associated with low clearance, high potency also allows for low total dose, which lowers the risk of idiosyncratic drug reaction. [4] [5]

On the other hand, LogP is an estimate of a compound's overall lipophilicity, a value that influence its behavior in a range of biological processes relevant to a drug discovery, such as solubility, permeability through biological membranes, hepatic clearance, lack of selectivity and non-specific toxicity. [6] For oral drugs, a LogP value comprised between 2 and 3 is often considered optimal to achieve a compromise between permeability and first-pass clearance.

LiPE allows capturing both values in a single parameter, and empirical evidence suggest that quality drug candidates have a high LiPE (>6); this value corresponds to a compound with a pIC50 of 8 and a LogP of 2. Plotting LogP against pIC50 for a range of compounds allows ranking series and individual compounds.

An alternative equation uses the logarithm of the ratio of potency (measured as binding energy) and the partition coefficient to compute a lipophilic ligand efficiency index (LE) with a different scale. [7]

The following review discusses LipE in the context of other compound efficiency metrics. [8]

Related Research Articles

<span class="mw-page-title-main">Drug discovery</span> Pharmaceutical procedure

In the fields of medicine, biotechnology and pharmacology, drug discovery is the process by which new candidate medications are discovered.

In the physical sciences, a partition coefficient (P) or distribution coefficient (D) is the ratio of concentrations of a compound in a mixture of two immiscible solvents at equilibrium. This ratio is therefore a comparison of the solubilities of the solute in these two liquids. The partition coefficient generally refers to the concentration ratio of un-ionized species of compound, whereas the distribution coefficient refers to the concentration ratio of all species of the compound.

<span class="mw-page-title-main">Ligand (biochemistry)</span> Substance that forms a complex with a biomolecule

In biochemistry and pharmacology, a ligand is a substance that forms a complex with a biomolecule to serve a biological purpose. The etymology stems from Latin ligare, which means 'to bind'. In protein-ligand binding, the ligand is usually a molecule which produces a signal by binding to a site on a target protein. The binding typically results in a change of conformational isomerism (conformation) of the target protein. In DNA-ligand binding studies, the ligand can be a small molecule, ion, or protein which binds to the DNA double helix. The relationship between ligand and binding partner is a function of charge, hydrophobicity, and molecular structure.

Hit to lead (H2L) also known as lead generation is a stage in early drug discovery where small molecule hits from a high throughput screen (HTS) are evaluated and undergo limited optimization to identify promising lead compounds. These lead compounds undergo more extensive optimization in a subsequent step of drug discovery called lead optimization (LO). The drug discovery process generally follows the following path that includes a hit to lead stage:

<span class="mw-page-title-main">(+)-CPCA</span> Stimulant drug

(+)-CPCA is a stimulant drug similar in structure to pethidine and to RTI-31, but nocaine is lacking the two-carbon bridge of RTI-31's tropane skeleton. This compound was first developed as a substitute agent for cocaine.

Druglikeness is a qualitative concept used in drug design for how "druglike" a substance is with respect to factors like bioavailability. It is estimated from the molecular structure before the substance is even synthesized and tested. A druglike molecule has properties such as:

<span class="mw-page-title-main">Epiboxidine</span> Chemical compound

Epiboxidine is a chemical compound which acts as a partial agonist at neural nicotinic acetylcholine receptors, binding to both the α3β4 and the α4β2 subtypes. It was developed as a less toxic analogue of the potent frog-derived alkaloid epibatidine, which is around 200 times stronger than morphine as an analgesic but produces extremely dangerous toxic nicotinic side effects.

<span class="mw-page-title-main">Fluorenol</span> Chemical compound

Fluorenol, also known as hydrafinil, is an alcohol derivative of fluorene. In the most significant isomer, fluoren-9-ol or 9-hydroxyfluorene, the hydroxy group is located on the bridging carbon between the two benzene rings. Hydroxyfluorene can be converted to fluorenone by oxidation. It is a white-cream colored solid at room temperature.

<span class="mw-page-title-main">9-Aminomethyl-9,10-dihydroanthracene</span> Chemical compound

AMDA (9-Aminomethyl-9,10-dihydroanthracene) is an organic compound which acts as a potent and selective antagonist for the 5-HT2A receptor. It has been used to help study the shape of the 5-HT2A protein, and develop a large family of related derivatives with even higher potency and selectivity.

CCR5 receptor antagonists are a class of small molecules that antagonize the CCR5 receptor. The C-C motif chemokine receptor CCR5 is involved in the process by which HIV, the virus that causes AIDS, enters cells. Hence antagonists of this receptor are entry inhibitors and have potential therapeutic applications in the treatment of HIV infections.

Relief from chronic pain remains a recognized unmet medical need. Consequently, the search for new analgesic agents is being intensively studied by the pharmaceutical industry. The TRPV1 receptor is a ligand gated ion channel that has been implicated in mediation of many types of pain and therefore studied most extensively. The first competitive antagonist, capsazepine, was first described in 1990; since then, several TRPV1 antagonists have entered clinical trials as analgesic agents. Should these new chemical entities relieve symptoms of chronic pain, then this class of compounds may offer one of the first novel mechanisms for the treatment of pain in many years.

<span class="mw-page-title-main">8-Carboxamidocyclazocine</span> Chemical compound

8-Carboxamidocyclazocine (8-CAC) is an opioid analgesic drug related to cyclazocine, discovered by medicinal chemist Mark P. Wentland and co-workers in Cogswell Laboratory at Rensselaer Polytechnic Institute. Similarly to cyclazocine, 8-CAC acts as an agonist at both the μ and κ opioid receptors, but has a much longer duration of action than cyclazocine, and does not have μ antagonist activity. Unexpectedly it was discovered that the phenolic hydroxyl group of cyclazocine could be replaced by a carboxamido group with only slight loss of potency at opioid receptors, and this discovery has subsequently been used to develop many novel opioid derivatives where the phenolic hydroxy group has been replaced by either carboxamide or a variety of larger groups. Due to their strong κ-opioid agonist activity, these drugs are not suited for use as analgesics in humans, but have instead been researched as potential drugs for the treatment of cocaine addiction.

Ligand efficiency is a measurement of the binding energy per atom of a ligand to its binding partner, such as a receptor or enzyme.

<span class="mw-page-title-main">VU-0238429</span> Chemical compound

VU-0238429 is a drug which acts as a selective positive allosteric modulator for the muscarinic acetylcholine receptor M5. It was the first selective ligand developed for the M5 subtype, and is structurally derived from older M1-selective positive allosteric modulators such as VU-0119498. Replacing the O-methyl- by a phenyl group further improves the receptor subtype selectivity.

<span class="mw-page-title-main">Biphalin</span> Chemical compound

Biphalin is a dimeric enkephalin endogenous peptide (Tyr-D-Ala-Gly-Phe-NH)2 composed of two tetrapeptides derived from enkephalins, connected 'tail-to-tail' by a hydrazide bridge. The presence of two distinct pharmacophores confers on biphalin a high affinity for both μ and δ opioid receptors (with an EC50 of about 1-5 nM for both μ and δ receptors), therefore it has analgesic activity. Biphalin presents a considerable antinociceptive profile. In fact, when administered intracerebroventricularly in mice, biphalin displays a potency almost 7-fold greater than that of the ultra-potent alkaloid agonist, etorphine and 7000-fold greater than morphine; biphalin and morphine were found to be equipotent after intraperitoneal administration. The extraordinary in vivo potency shown by this compound is coupled with low side-effects, in particular, to produce no dependency in chronic use. For these reasons, several efforts have been carried out in order to obtain more information about structure-activity relationship (SAR). Results clearly indicate that, at least for μ receptor binding, the presence of two pharmacophores is not necessary; Tyr1 is indispensable for analgesic activity, while replacing Phe at the position 4 and 4' with non-aromatic, but lipophilic amino acids does not greatly change the binding properties and in general 4,4' positions are found to be important to design biphalin analogues with increased potency and modified μ/δ selectivity. The hydrazide linker is not fundamental for activity or binding, and it can be conveniently substituted by different conformationally constrained cycloaliphatic diamine linkers.

<span class="mw-page-title-main">LBP-1 (drug)</span> Chemical compound

LBP-1 is a drug originally developed by Organon for the treatment of neuropathic pain, It acts as a potent and selective cannabinoid receptor agonist, with high potency at both the CB1 and CB2 receptors, but low penetration of the blood–brain barrier. This makes LBP-1 peripherally selective, and while it was effective in animal models of neuropathic pain and allodynia, it did not produce cannabinoid-appropriate responding suggestive of central effects, at any dose tested.

<span class="mw-page-title-main">4-Fluoromethylphenidate</span> Chemical compound

4-Fluoromethylphenidate is a stimulant drug that acts as a higher potency dopamine reuptake inhibitor than the closely related methylphenidate.

<span class="mw-page-title-main">QMPSB</span> Chemical compound

QMPSB is an arylsulfonamide-based synthetic cannabinoid that has been sold as a designer drug.

<span class="mw-page-title-main">DOB-FLY</span> Chemical compound

DOB-FLY is a recreational designer drug with psychedelic effects. It can be regarded as the alpha-methyl derivative of 2C-B-FLY or the partially saturated counterpart of bromo-dragonfly. Unlike bromo-dragonfly, DOB-FLY is only slightly more potent than DOB itself, with an active dose in humans of around 1 mg.

References

  1. Ryckmans T, Edwards MP, Horne VA, Correia AM, Owen DR, Thompson LR, Tran I, Tutt MF, Young T (August 2009). "Rapid assessment of a novel series of selective CB(2) agonists using parallel synthesis protocols: A Lipophilic Efficiency (LipE) analysis". Bioorganic & Medicinal Chemistry Letters. 19 (15): 4406–9. doi:10.1016/j.bmcl.2009.05.062. PMID   19500981.
  2. Edwards MP, Price DA (2010). "Role of Physicochemical Properties and Ligand Lipophilicity Efficiency in Addressing Drug Safety Risks". Annual Reports in Medicinal Chemistry. 45: 381–391. doi:10.1016/S0065-7743(10)45023-X. ISBN   9780123809025.
  3. Leeson PD, Springthorpe B (November 2007). "The influence of drug-like concepts on decision-making in medicinal chemistry". Nature Reviews. Drug Discovery. 6 (11): 881–90. doi:10.1038/nrd2445. PMID   17971784. S2CID   205476574.
  4. Uetrecht J (January 2001). "Prediction of a new drug's potential to cause idiosyncratic reactions". Current Opinion in Drug Discovery & Development. 4 (1): 55–9. PMID   11727323.
  5. Uetrecht J (January 2008). "Idiosyncratic drug reactions: past, present, and future". Chemical Research in Toxicology. 21 (1): 84–92. doi: 10.1021/tx700186p . PMID   18052104.
  6. Hughes JD, Blagg J, Price DA, Bailey S, Decrescenzo GA, Devraj RV, Ellsworth E, Fobian YM, Gibbs ME, Gilles RW, Greene N, Huang E, Krieger-Burke T, Loesel J, Wager T, Whiteley L, Zhang Y (September 2008). "Physiochemical drug properties associated with in vivo toxicological outcomes". Bioorganic & Medicinal Chemistry Letters. 18 (17): 4872–5. doi:10.1016/j.bmcl.2008.07.071. PMID   18691886.
  7. García-Sosa AT, Hetényi C, Maran U (January 2010). "Drug efficiency indices for improvement of molecular docking scoring functions". Journal of Computational Chemistry. 31 (1): 174–84. doi:10.1002/jcc.21306. PMID   19422000. S2CID   19092197.
  8. Shultz MD (November 2013). "Setting expectations in molecular optimizations: Strengths and limitations of commonly used composite parameters". Bioorganic & Medicinal Chemistry Letters. 23 (21): 5980–91. doi:10.1016/j.bmcl.2013.08.029. PMID   24018190.