The NAD 3020 is a stereo integrated amplifier by NAD Electronics, considered to be one of the most important components in the history of high fidelity audio. [1] Launched in 1978, this highly affordable product delivered a good quality sound, which acquired a reputation as an audiophile amplifier of exceptional value. By 1998, the NAD 3020 had become the most well known and best-selling audio amplifier in history. [2]
Launched in 1978 [2] when the principal preoccupation of hi-fi manufacturers was power output, the sub-£80 (US$135) low-powered solid state amplifier, created and marketed by a then little-known manufacturer, [3] gained a reputation for excellent sound quality and exceptional value. [2] [4] Stereophile magazine called the NAD 3020 "ridiculously inexpensive". [5] It was the first integrated amplifier built with convincing ability to drive difficult loudspeaker loads, and a sound quality that far exceeded other integrated amplifiers at its price point for the time. [2]
In an era when the NAD's rated power output of 20 watts per channel continuous into 8 ohms was considered anaemic, [3] the manufacturer claimed it could deliver much stronger power output into lower impedances under dynamic conditions (music or peak power output). [6] [7] Indeed, it is capable of delivering 40 watts into 8 ohm, 58 watts into 4 ohm, and 72 watts into 2 ohm loads for a limited time if pushed. [8] The amplifier's main appeal was its inherent musicality, its ability to drive difficult speaker loads, and to allow audiophile grade source components to excel. [2] [3] Launching the product in the US at the Consumer Electronics Show, the company wired up a battery of loudspeakers in a way which presented an impedance of 1.1 ohm, and the amplifier experienced no problems. [8] Similarly, at its London launch, NAD successfully demonstrated it driving the Linn Isobarik, whose impedance characteristics are known to be very challenging for amplifiers. [9] It was the best-known and best-selling amplifier in the annals of hi-fi. [2] The NAD 3020 revolutionised the amplifier segment of the hi-fi industry. [3]
Bjørn Erik Edvardsen, NAD's director of advanced development, [1] set out to create an "inexpensive amplifier ... easily capable of driving the very best loudspeakers". [7] NAD eschewed the laboratory test equipment thinking, which was prevalent at the time, and instead aimed to make their amplifiers capable of properly driving "real loudspeakers" under realistic conditions. This paradigm shift gave rise to an amplifier that cost less and sounded better. [10] [11] NAD was able to achieve a low cost base by foreign manufacture. The company designed the product in Europe and had it produced in factories in Taiwan – it was one of the first manufacturers to de-localise production to Asia. [12]
The design, and models following it, included "soft-clipping circuitry" that protects against over-driven signals, connections that allow splitting of the power amplifier section from the preamplifier, and "Full Disclosure" power ratings measuring output power under real-world loads. [13]
The NAD 3020 has four inputs that can be switched via the front panel – Aux, Tuner, Phono, Tape. The manufacturer claims the phono input, which can also be used with high-output moving coil cartridges, contains a 6-transistor circuit "engineered for extremely low noise and nearly distortion-free performance". Reviewers note the pre-amplifier's "decent moving-magnet phono stage". [2] [12] [8] The amplifier is bandwidth-limited, incorporating infrasonic and ultrasonic filters to supposedly reduce the effects of non-musical signals such as acoustic feedback, disc warps and electromagnetic interference on the musical signals. [7]
The amplifier has bass and treble tone controls which, according to the manufacturer, are "tailored for musically effective response in the high and low frequencies without altering the critical mid-range tonal balance". A loudness switch – de rigueur in that era – boosts upper and lower frequencies; a "mute" switch reduces volume by 20 dB for low-level listening. [7] There is also a headphone socket mounted onto the front panel.
According to the manufacturer, the NAD 3020 is a high voltage design that uses the same large powerful output transistors (2N3055 and MJ2955) that "other manufacturers employ in their '60-watt' amplifiers", enabling the amplifier to deliver power headroom for musical transients. [7] The "Soft Clipping" circuitry is intended to limit the output voltage so that the transistors do not distort when driven beyond its rated power.
The innovative split of pre- and power-amplifier sections allows the use of the pre-amp stage to drive multiple power amplifiers in parallel, or use long signal cables to connect to remote power amplifiers or powered speakers. [14] This facility became hugely popular with audiophiles, who would seek to isolate this "remarkably fine-sounding preamp section", to use with one or more external power amplifiers. [12] [11]
The amplifier has what the manufacturer calls a "dual-mode power supply", where the output stage is only loosely regulated, so it is free to supply the high voltages needed for musical transients and the large currents at lower voltages needed for driving low-impedance loads in the power amplifier circuitry. The design also incorporates a separate regulated power supply circuit, fed from a secondary winding on the transformer, dedicated to the pre-amplifier and tone control stages. It is thus claimed that intermodulation distortion and blurring of the stereo image due to power supply functioning cannot occur. [7]
The styling of the NAD 3020 resembled that of other budget amplifiers of the time, and it was available in charcoal grey or a much rarer silver. Stereophile commented that it was "inexpensive and looked it". [12]
The highly popular NAD 3020 is considered one of the most important hi-fi components in the history of home audio. [1] Sonically, it benefited from a design error where crosstalk between left and right channels presented better detail and more ambiance; the error was corrected in a later guise. [8] Its sound is described by reviewers as dark and warm, with a "sweet and sensual midrange"; [2] [3] some reviewers observed a very noticeable rolling off at frequency extremes that may detract from sonic neutrality, and that its soundstage lacked precision [2] [3] but it was universally praised for its value for money. [2] [3] [15] The amplifier was a hot seller, [1] [6] and the NAD 3020 alone achieved a record 1.1 million units in its lifetime. The figure would be much higher if the sales of other amplifiers derived directly from its design are included. [16] The quality made possible at a £79 (US$133) price tag opened up the market for budget yet quality amplifiers, and spawned similarly low-priced competitors such as ARCAM Alpha, Rotel 840, Mission Cyrus I, Pioneer A400, Denon PMA 350 and Marantz PM40 SE. [9] In 2002 it ranked No. 19 in list of "The Hot 100 Products" by Stereophile. [1] [5] In 2011, The Absolute Sound placed it at No. 9 in their list of "The Ten Most Significant Amplifiers of All Time". [16] The Absolute Sound remarked that this "iconic gem could embarrass amplifiers costing 10 times more with its big, warm and detailed sound and best of all, its affordable price made it available to a wider audience." [3] [10]
A retrospective review by Chris Martens said that the 3020 was not perfect, and while it may have been surpassed by other components according to other performance criteria individually, it was "better than any $200 integrated amp had any right to be". [15] Martens complimented the quality of the electronic circuit design, noting in particular that the phono stage "sounded clearer and better balanced than many dedicated phonostages of the day". [15]
The NAD 3020 sold half a million units in the first three years of its life, and the second-generation NAD 3020A replacing it, which corrected some minor design errors, proved even more popular than its predecessor. [8]
Variants included the NAD 3020B with high quality loudspeaker binding posts, NAD 3020E, and an "almost identical" audiophile version dubbed NAD 3120, stripped of tone controls and with higher quality loudspeaker binding posts. [9] [17] The NAD 3020i is an "improved" version of the NAD 3020 [18] that retailed at £149 (US$250) when it was launched in 1991. [14] [19] The NAD 7020 receiver (tuner-amplifier), that included the amplification circuitry of the NAD 3020, received a mixed reception due to severe reliability issues. [8] Following its release, and upon realisation that the product was much sought after for its pre-amplifier section, a preamp version of the NAD 3020 was released under the name NAD 1020. [3] [6]
The 3220PE and 3225PE (PE being 'Power Envelope') are further improved versions of the 3020E and 3020i respectively, sharing circuit boards with the 3020 models, the main change being a different "dual voltage" transformer and improved power supply design. [20] [21]
In 2013, the 40th year of the company, NAD launched a range of digital products, including a digital amplifier bearing the name NAD D 3020. [10]
High fidelity is the high-quality reproduction of sound. It is popular with audiophiles and home audio enthusiasts. Ideally, high-fidelity equipment has inaudible noise and distortion, and a flat frequency response within the human hearing range.
An audiophile is a person who is enthusiastic about high-fidelity sound reproduction. An audiophile seeks to reproduce recorded music to achieve high sound quality, typically in a quiet listening space and in a room with good acoustics.
Audio power is the electrical power transferred from an audio amplifier to a loudspeaker, measured in watts. The electrical power delivered to the loudspeaker, together with its efficiency, determines the sound power generated.
In an audio system, the damping factor gives the ratio of the rated impedance of the loudspeaker to the source impedance of the power amplifier. Only the magnitude of the loudspeaker impedance is used, and the power amplifier output impedance is assumed to be totally resistive.
PS Audio is an American company specializing in high-fidelity audio components equipment for audiophiles and the sound recording industry. It currently produces audio amplifiers, preamplifiers, power related products, digital-to-analog converters, streaming audio, music management software and cables.
Founded by David Hafler and Ed Laurent in Philadelphia, Pennsylvania in 1955, Dynaco was an American hi-fi audio system manufacturer popular in the 1960s and 1970s for its wide range of affordable, yet high quality audio components.. Its best known product was the ST-70 tube stereo amplifier. They also manufactured other tube and solid state amplifiers, preamplifiers, radio tuners and bookshelf loudspeakers. Dynaco was liquidated in 1980, and the trademark is now owned by Radial Engineering Ltd.
Robert W. (Bob) Carver is an American designer of audio equipment based in the Pacific Northwest.
A headphone amplifier is a low-powered audio amplifier designed particularly to drive headphones worn on or in the ears, instead of loudspeakers in speaker enclosures. Most commonly, headphone amplifiers are found embedded in electronic devices that have a headphone jack, such as integrated amplifiers, portable music players, and televisions. However, standalone units are used, especially in audiophile markets and in professional audio applications, such as music studios. Headphone amplifiers are available in consumer-grade models used by hi-fi enthusiasts and audiophiles and professional audio models, which are used in recording studios.
Roksan is a British manufacturer of high fidelity audio products for domestic use, based in Rayleigh, Essex. It is best known for its influential and innovative design for hi-fi equipment, and in particular its Xerxes platform for playing LP records.
NAD Electronics is a brand name of an electronics firm whose products include home hi-fi amplifiers and related components. NAD is an abbreviation for New Acoustic Dimension.
A single-ended triode (SET) is a vacuum tube electronic amplifier that uses a single triode to produce an output, in contrast to a push-pull amplifier which uses a pair of devices with antiphase inputs to generate an output with the wanted signals added and the distortion components subtracted. Single-ended amplifiers normally operate in Class A; push-pull amplifiers can also operate in Classes AB or B without excessive net distortion, due to cancellation.
Musical Fidelity is a British producer of high-end audio equipment focusing on streaming music players, and its core product range of amplifiers of various types. Other products have included headphones, Digital-Analog Converters (DACs), CD players, Bluetooth Receivers, ‘all-in-one systems’. Founded in the United Kingdom in 1982, they are known for their unusual industrial design, Nuvistor tube use and Class-AB amplifiers.
A valve audio amplifier (UK) or vacuum tube audio amplifier (US) is a valve amplifier used for sound reinforcement, sound recording and reproduction.
Technical specifications and detailed information on the valve audio amplifier, including its development history.
Tube sound is the characteristic sound associated with a vacuum tube amplifier, a vacuum tube-based audio amplifier. At first, the concept of tube sound did not exist, because practically all electronic amplification of audio signals was done with vacuum tubes and other comparable methods were not known or used. After introduction of solid state amplifiers, tube sound appeared as the logical complement of transistor sound, which had some negative connotations due to crossover distortion in early transistor amplifiers. However, solid state amplifiers have been developed to be flawless and the sound is later regarded neutral compared to tube amplifiers. Thus the tube sound now means 'euphonic distortion.' The audible significance of tube amplification on audio signals is a subject of continuing debate among audio enthusiasts.
Acapella Audio Arts is a German manufacturer of loudspeakers, and one of the oldest hi-fi manufactures in Germany. Acapella Audio was founded by Alfred Rudolph and Herman Winters in 1978 in Duisburg, Germany. Acapella is famous for its heavy horn-loaded speakers that are able to reproduce the whole audible sound spectrum. Other signature characteristic for the products of the company is the widely utilized plasma tweeter technology.
The Naim NAIT is an integrated amplifier from the British hi-fi manufacturer, Naim Audio. The original NAIT is one of the most recognisable pieces of hi-fi equipment ever made. Hi-fi critic Lucio Cadeddu recognised its legendary status, referring to it as "one of the most controversial and famous integrated amps in the history of HiFi".
Naim Audio is a specialist British manufacturer of high-end audio amplifiers well known for their self described qualities of "pace, rhythm and timing".
The Linn Isobarik, nicknamed "Bariks" or "Briks", is a loudspeaker designed and manufactured by Linn Products. The Isobarik is known for both its reproduction of low bass frequencies and being very demanding on amplifiers.
The Quad Electrostatic Loudspeaker (ESL) is the world's first production full-range electrostatic loudspeaker, launched in 1957 by Quad Electroacoustics, then known as the Acoustical Manufacturing Co. Ltd. The speaker is shaped somewhat like a home electric radiator curved slightly on the vertical axis. They are widely admired for their clarity and precision, but known to be difficult speakers to run and maintain.