| RWD 7 | |
|---|---|
 | |
| Jerzy Drzewiecki and Jerzy Wędrychowski by the RWD 7 | |
| Role | Sports plane |
| Manufacturer | Warsaw University of Technology workshops |
| Designer | RWD team |
| First flight | July 1931 |
| Introduction | 1931 |
| Retired | 1938 |
| Primary user | Polish civilian aviation |
| Number built | 1 |
The RWD 7 was a Polish sports plane of 1931, constructed by the RWD team.
The RWD 7 was constructed by the RWD team of Stanisław Rogalski, Stanisław Wigura and Jerzy Drzewiecki in Warsaw. It was based upon their earlier designs, especially the RWD 2 and RWD 4. The RWD 7 was meant to be a record-beating plane, so it had a more powerful engine, while its mass was reduced. From its predecessors, it took the same fish-shaped fuselage without a direct view towards forward from the pilot's seat. [1]
The only RWD 7 built (registration SP-AGH) was flown in July 1931 by its designer Jerzy Drzewiecki. On August 12, 1931, Drzewiecki and Jerzy Wędrychowski established an international FAI speed record of 178 km/h (111 mph) in the light touring plane class, (below 280 kg / 616 lb empty weight). [1] On September 30, 1932, Drzewiecki and Antoni Kocjan set a height record of 6,023 m (19,755 ft). The RWD 7 was used in Warsaw Aero Club, among others, for aerobatics, then in 1936 it was bought by a known aviator Zbigniew Babiński for touring flights and used until 1938. [1]
The RWD 7 was known for its extremely short take-off run: with a single crew member only 18 m (59 ft), with two crew members, 30 m (98 ft). [1]
The RWD 7 was a wooden construction, conventional in layout, high-wing cantilever monoplane. The fuselage was rectangular in cross-section (narrowing in upper part), plywood-covered, apart from the engine section, which was aluminium sheet-covered. The wings were trapezoid, single-spar, single part, canvas and plywood covered. A crew of two was sitting in tandem, with a pilot in the rear cab. The crew cabs were open on upper sides, and had doors on the right side. The engine was 5-cylinder Armstrong Siddeley Genet II radial engine, 56 kW (75 hp) nominal power. Two-blade wooden propeller of a fixed pitch. The plane had a conventional landing gear, with a rear skid. A 30 L fuel tank was in central part of wing. A cruise fuel consumption was 18 L/hour. [1]
Data from Polskie konstrukcje lotnicze 1893–1939 [1]
General characteristics
Performance
Related development
The RWD 6 was a Polish sports plane of 1932, constructed by the RWD team. It was a winner of the Challenge 1932 international tourist aircraft contest.
The RWD 5 was a Polish touring and sports plane of 1931, a two-seat high-wing monoplane, constructed by the RWD team. It was made famous by its transatlantic flight, being the smallest aircraft to cross the Atlantic.
The LWS-2 was the Polish air ambulance aircraft prototype, designed in the late-1930s in the LWS factory.
The RWD 4 was a Polish sports plane of 1930, constructed by the RWD team.
The RWD 2 was a 1929 Polish single-engine high-wing monoplane sports plane constructed by the RWD team.
The RWD 3 was a 1930 Polish sports aircraft and liaison aircraft prototype, constructed by the RWD team, a single-engine high-wing monoplane.
The RWD 1 was a Polish sports plane of 1928, a single-engine high-wing monoplane constructed by the RWD design team.
The RWD-10 was a Polish aerobatics sports plane, single-seat parasol wing monoplane, used from 1933 to 1939 and constructed by the RWD team.
The RWD 9 was a Polish sports plane of 1934, constructed by the RWD team.
The RWD-15 was a Polish touring aircraft of 1937, designed by the RWD team and built by the Doświadczalne Warsztaty Lotnicze (DWL).
The P.W.S.8 was a 1930 Polish sports plane, constructed by the Podlaska Wytwórnia Samolotów (PWS), that remained a prototype.
The RWD 23 was a Polish low-wing trainer aircraft of 1938, constructed by the RWD team, that remained a prototype.
The JD-2 was a Polish sports plane of 1926. It was the first sports plane designed in Poland, that was built in a small series.
The RWD-16 was a Polish two-seat low-wing sports plane of 1936, constructed by the RWD team, that remained a prototype.
The Lublin R-XII was the Polish three-seat sports and touring aircraft, designed in 1930 in the Plage i Laśkiewicz factory in Lublin, that remained a prototype.
The RWD 16bis and RWD 21 were Polish two-seat low-wing touring and sports planes of the late 1930s, constructed by the RWD bureau, sharing the same construction, main difference of the RWD 21 being a stronger engine.
The Lublin R-XI was the Polish passenger plane for 4 passengers, designed in 1930 in the Plage i Laśkiewicz factory in Lublin, that remained a prototype.
The RWD-19 was a Polish two-seat low-wing sports aircraft of 1938, constructed by the RWD bureau.
The PWS-51 was a Polish sports plane of 1930, a single-engine low-wing monoplane, constructed by the Podlaska Wytwórnia Samolotów (PWS), that remained a prototype.
The PWS-11 was a Polish aerobatic and trainer aircraft, developed in 1928-1929 by PWS, which remained a prototype.
 | Wikimedia Commons has media related to RWD 7 . |