Scophony

Last updated

Scophony was a sophisticated mechanical television system developed in Britain by Scophony Limited. A black and white image was produced by an early form of acousto-optic modulation of a bright light using a piezoelectric crystal to excite vibrations in a column of water or another transparent liquid.

Contents

Principle of operation

The light modulator worked as follows. Crystal vibrations at one end of a horizontal water column would cause waves to propagate through the water. The light was passed through this column from the side across the waves as they propagated through the column, via separate horizontal and vertical orientated cylindrical lenses. The vibrations through the water would act as a diffraction grating, the higher the amplitude, the more that the light passing through would be diffracted. The light passed through the water column was then horizontally focussed onto either a slit or narrow optical block, depending on whether positive or negative modulation of the water column was used. The amount of light which would either pass through the slit or go around the block depended on the amplitude of the modulation, thereby causing the light amplitude to be modulated. Following the slit/block, the light would hit the high speed horizontal rotating mirror drum which was synchronised to the propagation of the waves through the water bath, in order that a particular wave in the water bath would appear at a fixed position on the screen, although that wave would actually be moving through the water column. This technique allowed significantly more of the light from the light source to be used compared to previous light modulation techniques. Vertical scanning was achieved by a separate much larger rotating mirror drum.

It is a common misconception that the water column would contain a complete video line, but this was not necessary with the Scophony system.

Innovation

Scophony's system used several innovative devices:

Company

The company Scophony Limited was established by entrepreneur Solomon Sagall in the early 1930s to exploit the patents of inventor George William Walton and William Stephenson. In 1932, Ferranti invested £3,500 in the company, however in 1934 Ferranti turned down the option to invest a further £10,000 to re-structure Scophony Limited, and in 1935 EKCO replaced Ferranti as the company's main investor. [2]

In 1938, the Scophony company demonstrated three types of 405 line mechanical television receivers at the Radiolympia exhibition in London: a home receiver, with a picture area of approximately 24 in × 20 in (61 cm × 51 cm) and two systems intended for theater operation, one producing a 6 ft × 5 ft (180 cm × 150 cm) image and the other a 9 ft × 12 ft (270 cm × 370 cm) image.

Several of the theatre systems were installed and operated successfully but none of the receivers were sold as production was halted due to the impending war.

Scophony Limited operated as a television manufacturer in Britain up to WWII and then in the USA. During WWII Scophony moved to Somerset and worked on war work. "Of all the electro-mechanical television techniques invented and developed by the mid-1930s, the technology known as Scophony had no rival in terms of technical performance." [3]

In November 1948, Scophony merged with John Logie Baird Ltd to become Scophony-Baird; offering for sale a line of four Baird-branded television sets the following year. [4]

See also

Related Research Articles

<span class="mw-page-title-main">Amplitude modulation</span> Radio modulation via wave amplitude

Amplitude modulation (AM) is a modulation technique used in electronic communication, most commonly for transmitting messages with a radio wave. In amplitude modulation, the amplitude of the wave is varied in proportion to that of the message signal, such as an audio signal. This technique contrasts with angle modulation, in which either the frequency of the carrier wave is varied, as in frequency modulation, or its phase, as in phase modulation.

<span class="mw-page-title-main">Analog television</span> Television that uses analog signals

Analog television is the original television technology that uses analog signals to transmit video and audio. In an analog television broadcast, the brightness, colors and sound are represented by amplitude, phase and frequency of an analog signal.

<span class="mw-page-title-main">Frequency modulation</span> Encoding of information in a carrier wave by varying the instantaneous frequency of the wave

Frequency modulation (FM) is the encoding of information in a carrier wave by varying the instantaneous frequency of the wave. The technology is used in telecommunications, radio broadcasting, signal processing, and computing.

In electronics and telecommunications, modulation is the process of varying one or more properties of a periodic waveform, called the carrier signal, with a separate signal called the modulation signal that typically contains information to be transmitted. For example, the modulation signal might be an audio signal representing sound from a microphone, a video signal representing moving images from a video camera, or a digital signal representing a sequence of binary digits, a bitstream from a computer.

<span class="mw-page-title-main">Wavelength</span> Distance over which a waves shape repeats

In physics and mathematics, wavelength or spatial period of a wave or periodic function is the distance over which the wave's shape repeats. In other words, it is the distance between consecutive corresponding points of the same phase on the wave, such as two adjacent crests, troughs, or zero crossings. Wavelength is a characteristic of both traveling waves and standing waves, as well as other spatial wave patterns. The inverse of the wavelength is called the spatial frequency. Wavelength is commonly designated by the Greek letter lambda (λ). The term "wavelength" is also sometimes applied to modulated waves, and to the sinusoidal envelopes of modulated waves or waves formed by interference of several sinusoids.

<span class="mw-page-title-main">John Logie Baird</span> Scottish inventor, known for first demonstrating television

John Logie Baird was a Scottish inventor, electrical engineer, and innovator who demonstrated the world's first live working television system on 26 January 1926. He went on to invent the first publicly demonstrated colour television system and the first viable purely electronic colour television picture tube.

<span class="mw-page-title-main">Sideband</span> Radio communications concept

In radio communications, a sideband is a band of frequencies higher than or lower than the carrier frequency, that are the result of the modulation process. The sidebands carry the information transmitted by the radio signal. The sidebands comprise all the spectral components of the modulated signal except the carrier. The signal components above the carrier frequency constitute the upper sideband (USB), and those below the carrier frequency constitute the lower sideband (LSB). All forms of modulation produce sidebands.

<span class="mw-page-title-main">Carrier wave</span> Sinusoidal wave without any modulation.

In telecommunications, a carrier wave, carrier signal, or just carrier, is a periodic waveform that carries no information that has one or more of its properties modified by an information-bearing signal for the purpose of conveying information.

Mode locking is a technique in optics by which a laser can be made to produce pulses of light of extremely short duration, on the order of picoseconds (10−12 s) or femtoseconds (10−15 s). A laser operated in this way is sometimes referred to as a femtosecond laser, for example, in modern refractive surgery. The basis of the technique is to induce a fixed phase relationship between the longitudinal modes of the laser's resonant cavity. Constructive interference between these modes can cause the laser light to be produced as a train of pulses. The laser is then said to be "phase-locked" or "mode-locked".

A transducer is a device that converts energy from one form to another. Usually a transducer converts a signal in one form of energy to a signal in another. Transducers are often employed at the boundaries of automation, measurement, and control systems, where electrical signals are converted to and from other physical quantities. The process of converting one form of energy to another is known as transduction.

Video modulation is a strategy of transmitting video signal in the field of radio modulation and television technology. This strategy enables the video signal to be transmitted more efficiently through long distances. In general, video modulation means that a higher frequency carrier wave is modified according to the original video signal. In this way, carrier wave contains the information in the video signal. Then, the carrier will "carry" the information in the form of radio frequency (RF) signal. When carrier reaches its destination, the video signal is extracted from the carrier by decoding. In other words, the video signal is first combined with a higher frequency carrier wave so that carrier wave contains the information in video signal. The combined signal is called radio-frequency signal. At the end of this transmitting system, the RF signals stream from a light sensor and hence, the receivers can obtain the initial data in the original video signal.

<span class="mw-page-title-main">Continuous-wave radar</span> Type of radar where a known stable frequency continuous wave radio energy is transmitted

Continuous-wave radar is a type of radar system where a known stable frequency continuous wave radio energy is transmitted and then received from any reflecting objects. Individual objects can be detected using the Doppler effect, which causes the received signal to have a different frequency from the transmitted signal, allowing it to be detected by filtering out the transmitted frequency.

<span class="mw-page-title-main">Mechanical television</span> Television that relies on a scanning device to display images

Mechanical television or mechanical scan television is an obsolete television system that relies on a mechanical scanning device, such as a rotating disk with holes in it or a rotating mirror drum, to scan the scene and generate the video signal, and a similar mechanical device at the receiver to display the picture. This contrasts with vacuum tube electronic television technology, using electron beam scanning methods, for example in cathode-ray tube (CRT) televisions. Subsequently, modern solid-state liquid-crystal displays (LCD) and LED displays are now used to create and display television pictures.

The Jeffree cell was an early acousto-optic modulator, best known for its use in the Scophony system of mechanical television. It was invented by J.H. Jeffree in 1934, and was a major improvement over the Kerr cell modulators used up to that time by allowing more than 200 times the available modulated light.

A photoelastic modulator (PEM) is an optical device used to modulate the polarization of a light source. The photoelastic effect is used to change the birefringence of the optical element in the photoelastic modulator.

A radar system uses a radio-frequency electromagnetic signal reflected from a target to determine information about that target. In any radar system, the signal transmitted and received will exhibit many of the characteristics described below.

<span class="mw-page-title-main">Stooky Bill</span> Dummy used in testing of early television systems

Stooky Bill was the name given to the head of a ventriloquist's dummy that Scottish television pioneer John Logie Baird used in his 1924 experiments to transmit a televised image between rooms in his laboratory at 22 Frith Street, London.

<span class="mw-page-title-main">Technology of television</span> Telecommunications, sound and video

The technology of television has evolved since its early days using a mechanical system invented by Paul Gottlieb Nipkow in 1884. Every television system works on the scanning principle first implemented in the rotating disk scanner of Nipkow. This turns a two-dimensional image into a time series of signals that represent the brightness and color of each resolvable element of the picture. By repeating a two-dimensional image quickly enough, the impression of motion can be transmitted as well. For the receiving apparatus to reconstruct the image, synchronization information is included in the signal to allow proper placement of each line within the image and to identify when a complete image has been transmitted and a new image is to follow.

<span class="mw-page-title-main">Envelope (waves)</span> Smooth curve outlining the extremes of an oscillating signal

In physics and engineering, the envelope of an oscillating signal is a smooth curve outlining its extremes. The envelope thus generalizes the concept of a constant amplitude into an instantaneous amplitude. The figure illustrates a modulated sine wave varying between an upper envelope and a lower envelope. The envelope function may be a function of time, space, angle, or indeed of any variable.

The following timeline tables list the discoveries and inventions in the history of electrical and electronic engineering.

References

  1. ↑ Iain Logie Baird, The Last Remaining Scophony TV Receiver High Speed Scanner Motor
  2. ↑ The Setmakers by Keith Geddes and Gordon Bussey ( ISBN   0951704206)
  3. ↑ Paul Marshall, Inventing Television: Transnational Networks of Co-operation and Rivalry, 1870-1936
  4. ↑ Iain Logie Baird, Terry-Thomas and the Baird Portable , Bairdtelevision.com
This page is based on this Wikipedia article
Text is available under the CC BY-SA 4.0 license; additional terms may apply.
Images, videos and audio are available under their respective licenses.