Scud running

Last updated

In general aviation, scud running is a practice in which pilots lower their altitude to avoid clouds or instrument meteorological conditions (IMC). The goal of scud running is to stay clear of weather to continue flying with visual, rather than instrument, references. This practice is widely accepted to be dangerous, and has led to death in many cases from pilots flying into terrain or obstacles, such as masts and towers, normally referred to as controlled flight into terrain, or CFIT; [1] however, even instrument-rated pilots sometimes elect to take the risk to avoid icing or embedded thunderstorms in cloud, or in situations where the minimum instrument altitudes are too high for their aircraft.[ citation needed ]

Contents

Scud running is occasionally described as "maintaining visual contact with the ground while avoiding physical contact with it" or "if the weather's too bad to go IFR, we'll go VFR." [2] A procedure under instrument flight rules (IFR), called a contact approach, is often referred to as a form of "legalized" scud running. [3]

The term gets its name from scud, which is used to describe small, ragged, low cloud fragments that are unattached to a larger cloud base, and often seen with and behind cold fronts and thunderstorm gust fronts. [4]

Canadian regulations

In Canada, the visibility and altitude requirements are similar to those in the U.S., but most controlled airspace outside of terminal areas bottoms out at 2,200 feet (670 m) Above Ground Level (AGL), so there is more room to scud run legally. In northern Canada, there is little controlled airspace at all, below the high-level class A airspace.[ citation needed ]

US regulations

In the United States, most controlled airspace below 10,000 ft (3,000 m) MSL requires a pilot flying under VFR to remain 500 ft (150 m) below a cloud ceiling and to maintain 3 statute miles (4.8 km) visibility. However, outside of airport control zones and major terminal areas, controlled airspace typically begins at 1,200 feet (370 m) above ground level; below that is uncontrolled (class G) airspace, where (at that altitude) a pilot is required only to remain clear of clouds and to maintain 1 statute mile (1.6 km) visibility. Flying in the airspace above the tree line, yet below 1,200 feet (370 m) is considered "scud running" where land ownership rights ends at the height of the property tree line.

Related Research Articles

<span class="mw-page-title-main">Instrument flight rules</span> Civil aviation regulations for flight on instruments

In aviation, instrument flight rules (IFR) is one of two sets of regulations governing all aspects of civil aviation aircraft operations; the other is visual flight rules (VFR).

In aviation, visual flight rules (VFR) are a set of regulations under which a pilot operates an aircraft in weather conditions generally clear enough to allow the pilot to see where the aircraft is going. Specifically, the weather must be better than basic VFR weather minima, i.e., in visual meteorological conditions (VMC), as specified in the rules of the relevant aviation authority. The pilot must be able to operate the aircraft with visual reference to the ground, and by visually avoiding obstructions and other aircraft.

The basic principles of air navigation are identical to general navigation, which includes the process of planning, recording, and controlling the movement of a craft from one place to another.

Airspace is the portion of the atmosphere controlled by a country above its territory, including its territorial waters or, more generally, any specific three-dimensional portion of the atmosphere. It is not the same as outer space which is the expanse or space outside the Earth and aerospace which is the general term for Earth's atmosphere and the outer space within the planet's vicinity. History:

<span class="mw-page-title-main">Visual meteorological conditions</span> Flight category allowing pilots to fly using vision as well as instruments

In aviation, visual meteorological conditions (VMC) is an aviation flight category in which visual flight rules (VFR) flight is permitted—that is, conditions in which pilots have sufficient visibility to fly the aircraft maintaining visual separation from terrain and other aircraft. They are the opposite of instrument meteorological conditions (IMC). The boundary criteria between IMC and VMC are known as the VMC minima and are defined by: visibility, cloud ceilings, and cloud clearances.

<span class="mw-page-title-main">Airway (aviation)</span> Designated route along which aircraft travel between airports

In the United States, airways or air routes are defined by the Federal Aviation Administration (FAA) in two ways:

<span class="mw-page-title-main">Flight plan</span> Document filed by a pilot or flight dispatcher indicating the aircrafts flight path

Flight plans are documents filed by a pilot or flight dispatcher with the local Air Navigation Service Provider prior to departure which indicate the plane's planned route or flight path. Flight plan format is specified in ICAO Doc 4444. They generally include basic information such as departure and arrival points, estimated time en route, alternate airports in case of bad weather, type of flight, the pilot's information, number of people on board, and information about the aircraft itself. In most countries, flight plans are required for flights under IFR, but may be optional for flying VFR unless crossing international borders. Flight plans are highly recommended, especially when flying over inhospitable areas such as water, as they provide a way of alerting rescuers if the flight is overdue. In the United States and Canada, when an aircraft is crossing the Air Defense Identification Zone (ADIZ), either an IFR or a special type of VFR flight plan called a DVFR flight plan must be filed. For IFR flights, flight plans are used by air traffic control to initiate tracking and routing services. For VFR flights, their only purpose is to provide needed information should search and rescue operations be required, or for use by air traffic control when flying in a "Special Flight Rules Area."

The world's navigable airspace is divided into three-dimensional segments, each of which is assigned to a specific class. Most nations adhere to the classification specified by the International Civil Aviation Organization (ICAO) and described below, though they might use only some of the classes defined below, and significantly alter the exact rules and requirements. Similarly, individual nations may also designate special use airspace (SUA) with further rules for reasons of national security or safety.

<span class="mw-page-title-main">Instrument meteorological conditions</span> Flight category requiring pilots to fly with instruments rather than sight

In aviation, instrument meteorological conditions (IMC) are weather conditions that require pilots to fly primarily by reference to flight instruments, and therefore under instrument flight rules (IFR), as opposed to flying by outside visual references under visual flight rules (VFR). Typically, this means flying in cloud or poor weather, where little or nothing can be seen or recognised when looking out of the window. Simulated IMC can be achieved for training purposes by wearing view-limiting devices, which restrict outside vision and force the trainee to rely on instrument indications only.

An instrument rating is an authorization required for a pilot to fly under instrument flight rules (IFR). In the United States, the rating is issued by the Federal Aviation Administration.

<span class="mw-page-title-main">Instrument approach</span> Aircraft landing procedure

In aviation, an instrument approach or instrument approach procedure (IAP) is a series of predetermined maneuvers for the orderly transfer of an aircraft operating under instrument flight rules from the beginning of the initial approach to a landing, or to a point from which a landing may be made visually. These approaches are approved in the European Union by EASA and the respective country authorities and in the United States by the FAA or the United States Department of Defense for the military. The ICAO defines an instrument approach as, "a series of predetermined maneuvers by reference to flight instruments with specific protection from obstacles from the initial approach fix, or where applicable, from the beginning of a defined arrival route to a point from which a landing can be completed and thereafter, if landing is not completed, to a position at which holding or en route obstacle clearance criteria apply."

Special visual flight rules are a set of aviation regulations under which a pilot may operate an aircraft. It is a special case of operating under visual flight rules (VFR).

<span class="mw-page-title-main">Allegheny Airlines Flight 853</span> 1969 mid-air collision

Allegheny Airlines Flight 853 was a regularly scheduled Allegheny Airlines flight from Boston, Massachusetts, to St. Louis, Missouri, with stops in Baltimore, Maryland, Cincinnati, Ohio, and Indianapolis, Indiana. On September 9, 1969, the aircraft serving the flight, a McDonnell Douglas DC-9, collided in mid-air with a Piper PA-28 light aircraft near Fairland, Indiana. The DC-9 was carrying 78 passengers and 4 crew members, and the Piper was leased to a student pilot on a solo cross-country flight. All 83 occupants of both aircraft were killed in the accident and both aircraft were destroyed.

VFR over-the-top (OTT) refers to flying over top of clouds in visual flight, rather than with reference to instruments. This is usually done for brief amount of time to avoid weather or turbulence.

<span class="mw-page-title-main">Airspace class (United States)</span> U.S. airspace system classification scheme

The United States airspace system's classification scheme is intended to maximize pilot flexibility within acceptable levels of risk appropriate to the type of operation and traffic density within that class of airspace – in particular to provide separation and active control in areas of dense or high-speed flight operations.

<span class="mw-page-title-main">Separation (aeronautics)</span> Concept for keeping aircraft safe distances apart

In air traffic control, separation is the name for the concept of keeping an aircraft outside a minimum distance from another aircraft to reduce the risk of those aircraft colliding, as well as prevent accidents due to secondary factors, such as wake turbulence. Separation can also apply to terrain, obstacles, and controlled airspace, wherein an aircraft must stay at a minimum distance from a block of airspace; as an example, all aircraft must be approved by the controller who "owns" the airspace before the aircraft is approved to enter that sector.

<span class="mw-page-title-main">Victor airways</span>

In the United States and Canada, Victor airways are low-altitude airways. They are defined in straight-line segments, each of which is based on a straight line between either two VHF omnidirectional range (VOR) stations, or a VOR and a VOR intersection, hence the beginning letter V.

In United States aviation VFR-on-top is defined as air traffic control authorization for an aircraft operating under instrument flight rules (IFR) to do so in visual meteorological conditions (VMC) at any appropriate visual flight rules (VFR) altitude. A pilot receiving this authorization must comply with the VFR visibility, distance from cloud criteria, and the minimum IFR altitudes. The use of this term does not relieve controllers of their responsibility to separate aircraft in Class B and Class C airspace or TRSAs.

<span class="mw-page-title-main">Texas International Airlines Flight 655</span> 1973 plane crash in Arkansas, United States

Texas International Airlines Flight 655, registration N94230, was a Convair 600 turboprop aircraft en route from El Dorado to Texarkana, Arkansas, crashing into Black Fork Mountain, Arkansas, on the night of September 27, 1973. The eight passengers and three crewmembers on board were killed.

A contact approach is an approach available to aircraft operating on an instrument flight rules (IFR) flight plan, where the pilot may deviate from the published instrument approach procedure (IAP) and proceed to the destination airport by visual reference to the surface. It is similar to a visual approach, except that the pilot is not required to have the destination airport nor the preceding aircraft in sight at all times during the approach, and the visibility requirements are less stringent.

References

  1. ↑ "FATAL CRASH UPDATE: FAA Registry Shows Plane Belongs to Midland Business". www.cbs7.com. Archived from the original on 2016-06-03.
  2. ↑ FAA AC60-22 "Aeronautical Decision Making"
  3. ↑ Thomas, Horne (1988-08-01). "Instrument Insights Part 8 of 12: Tricks of the Trade". AOPA Pilot Magazine. 41 (8). Retrieved 2017-05-13.
  4. ↑ "Scud". National Weather Service (NWS) Glossary. Federal Aviation Administration. 2010-08-26. Retrieved 2010-12-05.
This page is based on this Wikipedia article
Text is available under the CC BY-SA 4.0 license; additional terms may apply.
Images, videos and audio are available under their respective licenses.