Resistojet rocket

Last updated

A resistojet is a method of spacecraft propulsion (electric propulsion) that provides thrust by heating a typically non-reactive fluid. Heating is usually achieved by sending electricity through a resistor consisting of a hot incandescent filament, with the expanded gas expelled through a conventional nozzle. [1]

Contents

Resistojets have been flown in space since 1965 on board military Vela satellites. However, they only became used in commercial applications in 1980 with the launch of the first satellites in the INTELSAT-V program. Many GEO spacecraft, and all 95 Iridium, used Aerojet MR-501/MR-502 series resistojet engines. [1] [2] Nowadays resistojet propulsion is used for orbit insertion, attitude control, and deorbit of LEO satellites, and do well in situations where energy is much more plentiful than mass, and where propulsion efficiency needs to be reasonably high but low thrust is acceptable.[ citation needed ]

Resistojets have also been proposed as means of using biowaste as reaction mass, particularly in conjunction with hydrazine. Studies focus on the characteristics of steam and carbon dioxide as major constituents of a biowaste stream, and typically use cubic zirconia as a heating element. [3]

Advantages

Many satellite missions necessitate an ability for minor alterations in trajectory even after the craft has been inserted into orbit. Most satellites use monopropellant rocket motors or cold gas thrusters for such orbital adjustments. Both methods, however, suffer from some limiting drawbacks: Hydrazine, the most commonly used monopropellant, is highly expensive and due to its volatile nature unsuitable for smaller satellites that are sent to space as secondary cargo. Cold gas thrusters, while utilizing relatively cheap, inert and therefore "safe" gasses like nitrogen, suffer from low specific impulse in comparison to monopropellant motors. Resistojets are designed to bridge the gap between these two methods of propulsion, offering the safety of an inert propellant coupled with specific impulse nearing that of hydrazine. [4]

Disadvantages

The main disadvantage of a resistojet design in comparison to simpler cold gas thrusters is the need for a power supply, which takes up space and is therefore sometimes a prohibitive factor for Microsat missions. In addition, the increased technical complexity of a resistojet relative to simpler solutions results in a greater risk of technical failure.

Since they do not take advantage of chemical combustion, resistojets (and similar designs) have a lower thrust that is orders of magnitude lower than those of more conventional solid fuel and liquid-propellant rockets. As a result, they are unsuitable for orbital maneuvers that require high delta V over shorter periods.

Physical Principles

Resistojets can be considered an evolution of traditional cold gas thrusters, which are the simplest form of rocket engine available. Their fuel tank holds the propellant, which is then led into the nozzle where it decompresses, propelling the craft forward. In a resistojet, a resistor is used to heat the fluid before it enters the nozzle, making it expand more forcefully, resulting in higher specific impulse.

A resistor is an electrical component which converts electrical energy into heat. Therefore, the thrust of a resistojet engine can be regulated by simply altering the wattage flowing through the resistor.

Heating a fluid by 300 °C in such a way results in a 41% increase in specific impulse. If heated by 900 °C, specific impulse could be doubled in comparison to a cold gas thruster using the same propellant.

See also

Related Research Articles

<span class="mw-page-title-main">Spacecraft propulsion</span> Method used to accelerate spacecraft

Spacecraft propulsion is any method used to accelerate spacecraft and artificial satellites. In-space propulsion exclusively deals with propulsion systems used in the vacuum of space and should not be confused with space launch or atmospheric entry.

A monopropellant rocket is a rocket that uses a single chemical as its propellant. Monopropellant rockets are commonly used as small attitude and trajectory control rockets in satellites, rocket upper stages, manned spacecraft, and spaceplanes.

An arcjet rocket or arcjet thruster is a form of electrically powered spacecraft propulsion, in which an electrical discharge (arc) is created in a flow of propellant. This imparts additional energy to the propellant, so that one can extract more work out of each kilogram of propellant, at the expense of increased power consumption and (usually) higher cost. Also, the thrust levels available from typically used arcjet engines are very low compared with chemical engines.

<span class="mw-page-title-main">Hall-effect thruster</span> Type of electric propulsion system

In spacecraft propulsion, a Hall-effect thruster (HET) is a type of ion thruster in which the propellant is accelerated by an electric field. Hall-effect thrusters are sometimes referred to as Hall thrusters or Hall-current thrusters. Hall-effect thrusters use a magnetic field to limit the electrons' axial motion and then use them to ionize propellant, efficiently accelerate the ions to produce thrust, and neutralize the ions in the plume. The Hall-effect thruster is classed as a moderate specific impulse space propulsion technology and has benefited from considerable theoretical and experimental research since the 1960s.

<span class="mw-page-title-main">Ion thruster</span> Spacecraft engine that generates thrust by generating a jet of ions

An ion thruster, ion drive, or ion engine is a form of electric propulsion used for spacecraft propulsion. An ion thruster creates a cloud of positive ions from a neutral gas by ionizing it to extract some electrons from its atoms. The ions are then accelerated using electricity to create thrust. Ion thrusters are categorized as either electrostatic or electromagnetic.

Monopropellants are propellants consisting of chemicals that release energy through exothermic chemical decomposition. The molecular bond energy of the monopropellant is released usually through use of a catalyst. This can be contrasted with bipropellants that release energy through the chemical reaction between an oxidizer and a fuel. While stable under defined storage conditions, monopropellants decompose very rapidly under certain other conditions to produce a large volume of its own energetic (hot) gases for the performance of mechanical work. Although solid deflagrants such as nitrocellulose, the most commonly used propellant in firearms, could be thought of as monopropellants, the term is usually reserved for liquids in engineering literature.

A propellant is a mass that is expelled or expanded in such a way as to create a thrust or another motive force in accordance with Newton's third law of motion, and "propel" a vehicle, projectile, or fluid payload. In vehicles, the engine that expels the propellant is called a reaction engine. Although technically a propellant is the reaction mass used to create thrust, the term "propellant" is often used to describe a substance which contains both the reaction mass and the fuel that holds the energy used to accelerate the reaction mass. For example, the term "propellant" is often used in chemical rocket design to describe a combined fuel/propellant, although the propellants should not be confused with the fuel that is used by an engine to produce the energy that expels the propellant. Even though the byproducts of substances used as fuel are also often used as a reaction mass to create the thrust, such as with a chemical rocket engine, propellant and fuel are two distinct concepts.

A solar thermal rocket is a theoretical spacecraft propulsion system that would make use of solar power to directly heat reaction mass, and therefore would not require an electrical generator, like most other forms of solar-powered propulsion do. The rocket would only have to carry the means of capturing solar energy, such as concentrators and mirrors. The heated propellant would be fed through a conventional rocket nozzle to produce thrust. Its engine thrust would be directly related to the surface area of the solar collector and to the local intensity of the solar radiation.

<span class="mw-page-title-main">Gridded ion thruster</span> Space propulsion system

The gridded ion thruster is a common design for ion thrusters, a highly efficient low-thrust spacecraft propulsion method running on electrical power by using high-voltage grid electrodes to accelerate ions with electrostatic forces.

This is an alphabetical list of articles pertaining specifically to aerospace engineering. For a broad overview of engineering, see List of engineering topics. For biographies, see List of engineers.

<span class="mw-page-title-main">Spacecraft electric propulsion</span> Type of space propulsion using electrostatic and electromagnetic fields for acceleration

Spacecraft electric propulsion is a type of spacecraft propulsion technique that uses electrostatic or electromagnetic fields to accelerate mass to high speed and thus generating thrust to modify the velocity of a spacecraft in orbit. The propulsion system is controlled by power electronics.

A cold gas thruster is a type of rocket engine which uses the expansion of a pressurized gas to generate thrust. As opposed to traditional rocket engines, a cold gas thruster does not house any combustion and therefore has lower thrust and efficiency compared to conventional monopropellant and bipropellant rocket engines. Cold gas thrusters have been referred to as the "simplest manifestation of a rocket engine" because their design consists only of a fuel tank, a regulating valve, a propelling nozzle, and the little required plumbing. They are the cheapest, simplest, and most reliable propulsion systems available for orbital maintenance, maneuvering and attitude control.

<span class="mw-page-title-main">Rocket propellant</span> Chemical or mixture used as fuel for a rocket engine

Rocket propellant is the reaction mass of a rocket. This reaction mass is ejected at the highest achievable velocity from a rocket engine to produce thrust. The energy required can either come from the propellants themselves, as with a chemical rocket, or from an external source, as with ion engines.

A thermal rocket is a rocket engine that uses a propellant that is externally heated before being passed through a nozzle to produce thrust, as opposed to being internally heated by a redox (combustion) reaction as in a chemical rocket.

<span class="mw-page-title-main">Green Propellant Infusion Mission</span> NASA satellite testing a new rocket fuel

The Green Propellant Infusion Mission (GPIM) was a NASA technology demonstrator project that tested a less toxic and higher performance/efficiency chemical propellant for next-generation launch vehicles and CubeSat spacecraft. When compared to the present high-thrust and high-performance industry standard for orbital maneuvering systems, which for decades, have exclusively been reliant upon toxic hydrazine based propellant formulations, the "greener" hydroxylammonium nitrate (HAN) monopropellant offers many advantages for future satellites, including longer mission durations, additional maneuverability, increased payload space and simplified launch processing. The GPIM was managed by NASA's Marshall Space Flight Center in Huntsville, Alabama, and was part of NASA's Technology Demonstration Mission Program within the Space Technology Mission Directorate.

<span class="mw-page-title-main">Liquid apogee engine</span>

A liquid apogee engine (LAE), or apogee engine, refers to a type of chemical rocket engine typically used as the main engine in a spacecraft.

<span class="mw-page-title-main">KTDU-80</span>

The KTDU-80 (Russian: Корректирующе-Тормозная Двигательная Установка, КТДУ) is the latest of a family of integrated propulsion system that KB KhIMMASH has implemented for the Soyuz since the Soyuz-T. It integrates main propulsion, RCS and attitude control in a single system pressure fed from a common dual string redundant pressurized propellant system. The common propellant is UDMH and N2O4 and the main propulsion unit, is the S5.80 main engine. It generates 2.95 kN (660 lbf) of thrust with a chamber pressure of 880 kPa (128 psi) and a nozzle expansion of 153.8 that enables it to achieve a specific impulse of 302 s (2.96 km/s). It is rated for 30 starts with a total firing time of 890 seconds. The integrated system without the pressurization or tanks weighs 310 kg (680 lb); it is 1.2 m (47 in) long with a diameter of 2.1 m (83 in).

NASA's Pathfinder Technology Demonstrator (PTD) Project is a series of tech demonstrations of technologies aboard a series of nanosatellites known as CubeSats, providing significant enhancements to the performance of these versatile spacecraft. Each of the five planned PTD missions consist of a 6-unit (6U) CubeSat with expandable solar arrays.

Cavea-B is a mixture of 1,4-Diaza-1,2,4-trimethyl bicyclo[2.2.2]octane dinitrate, dissolved in white fuming nitric acid. It was researched during the 1960s by teams associated with NASA as an alternative to the more commonly used hydrazine monopropellant for use in spacecraft's attitude control and thruster systems. It was derived from an earlier, similar formulation which came to be called Cavea-A, which showed less promise due to its excessively high melting point.

Microwave electrothermal thruster, also known as MET, is a propulsion device that converts microwave energy into thermal energy. These thrusters are predominantly used in spacecraft propulsion, more specifically to adjust the spacecraft’s position and orbit. A MET sustains and ignites a plasma in a propellant gas. This creates a heated propellant gas which in turn changes into thrust due to the expansion of the gas going through the nozzle. A MET’s heating feature is like one of an arc-jet ; however, due to the free-floating plasma, there are no problems with the erosion of metal electrodes, and therefore the MET is more efficient.

References

  1. 1 2 Jahn, Robert G.; Choueiri, Edgar Y. (2002). "Electric Propulsion". Encyclopedia of Physical Science and Technology. Vol. 5 (3rd ed.). San Diego: Academic Press. pp. 125–141.
  2. Hoskins, W. Andrew; Cassady, R. Joseph; Morgan, Olwen; Myers, Roger M.; Wilson, Fred; King, David Q.; Kristi deGrys (October 6–10, 2013). 30 Years of Electric Propulsion Flight Experience at Aerojet Rocketdyne (PDF). 33rd International Electric Propulsion Conference. p. 2. IEPC-2013-439.{{cite conference}}: CS1 maint: date format (link)
  3. Page, R. J.; Stoner, W. A.; Barker, L. (September 1, 1986). A design study of hydrazine and biowaste resistojets (Report). pp. 22–27. NASA Contractor Report 179510.
  4. Gibbon, Dave (2002). "The Development of a Family of Resistojet Thruster Propulsion Systems for Small Spacecraft". Surrey Space Centre, University of Surrey: 1.