Royal Aircraft Factory F.E.4

Last updated

F.E.4
RoleGround attack fighter
National origin United Kingdom
Manufacturer Royal Aircraft Factory
First flight1916
Number built2

The Royal Aircraft Factory F.E.4 was a twin-engine biplane aircraft built by the Royal Aircraft Factory in 1916. Intended as a cannon armed ground-attack aircraft, it was unsuccessful, only two being built.

Contents

Design and development

Shortly after the outbreak of the First World War, the Royal Aircraft Factory began development of the F.E.4, a twin engined aircraft intended for ground attack to be armed with a COW autocannon.

The design had large two-bay biplane wings, with the longer upper wing fitted with strut-braced extensions that could be folded down during hangar storage. The lower wing was attached to the fuselage halfway up, so the aircraft sat close to the ground. In addition to the conventional landing gear there was a set of wheels mounted to the nose of the fuselage, to prevent damage if it tipped forward. The tailplane was large, with a central fin and two additional vertical surfaces for rudders. [1]

The fuselage housed a crew of three, with the pilot and forward gunner sat in tandem in a large forward cockpit with dual controls. Despite a limited field of fire caused by being sat behind the pilot, the forward gunner was to be armed with two Lewis guns and a COW gun. A rear gunner sat behind the wings in a second cockpit. [2]

The two engines, RAF 5s, [3] were installed just above the lower wing in a pusher configuration.

The first F.E.4 was built in March 1916, and the second in July 1916. The second aircraft was fitted with Rolls-Royce engines, and did not include the rear cockpit. The intention was to put the rear gunner in an elevated section mounted above the wings, accessible by a ladder and hole in the upper wing, but this was never built.

Both aircraft were tested at Central Flying School beginning in May 1916, but neither performed well. In September 1916 the second F.E.4 was fitted with bomb-carrying equipment for further testing. Designs were created for engine upgrades, intended for RAF 3As, RAF 4As or RAF 4Bs, but no work was actually done. [4]


Specifications (RAF 5)

Data from Bruce, 1959. p 335.

General characteristics

Performance

Armament

Related Research Articles

Royal Aircraft Factory F.E.2

Between 1911 and 1914, the Royal Aircraft Factory used the F.E.2 designation for three quite different aircraft that shared only a common "Farman" pusher biplane layout.

Vickers F.B.5 Fighter aircraft; first operational purpose-built fighter

The Vickers F.B.5 was a British two-seat pusher military biplane of the First World War. Armed with a single .303 in (7.7 mm) Lewis gun operated by the observer in the front of the nacelle, it was the first aircraft purpose-built for air-to-air combat to see service, making it the world's first operational fighter aircraft.

Vickers Virginia

The Vickers Virginia was a biplane heavy bomber of the British Royal Air Force, developed from the Vickers Vimy.

Avro 549 Aldershot

The Avro 549 Aldershot was a British single-engined heavy bomber aircraft built by Avro.

Short Bomber

The Short Bomber was a British two-seat long-range reconnaissance, bombing and torpedo-carrying aircraft designed by Short Brothers as a land-based development of the very successful Short Type 184.

The Grahame-White Ganymede was a prototype British heavy night bomber intended to serve with the Royal Air Force in the First World War. A large, three-engined, twin-boom biplane, the sole prototype Ganymede did not fly until after the war had ended, and although an attempt was made to convert the aircraft to an airliner, it was unsuccessful.

De Havilland Dormouse

The de Havilland DH.42 Dormouse and its two variants the de Havilland DH.42A Dingo I and II were two-seat single-engined biplanes designed for fighter-reconnaissance and army cooperation roles. They did not achieve production.

The de Havilland DH.72 was a large British three-engined biplane bomber, designed as a Vickers Virginia replacement. It did not go into production.

The Sopwith 2FR.2 Bulldog was a prototype British two-seat fighter of the First World War. A single-engined biplane, the Bulldog was a fighter/reconnaissance aircraft intended to replace the Bristol F.2 Fighter, but was unsuccessful, with no replacement for the Bristol Fighter being purchased.

Vickers F.B.11

The Vickers F.B.11 was a prototype British three-seat escort fighter of the First World War. A large single-engined biplane, it carried one gunner in a nacelle mounted on the upper wing to give an allround field of fire. Only a single example was completed.

Vickers E.F.B.7

The Vickers E.F.B.7 was a prototype British fighter aircraft of the First World War. A twin-engined biplane, the E.F.B.7 was unsuccessful, only a single example being built.

Royal Aircraft Factory F.E.9

The Royal Aircraft Factory F.E.9 was a prototype British two-seat fighter-reconnaissance aircraft of the First World War. A single-engined pusher biplane of 1917, the F.E.9 had poor performance and handling, and only three were built.

Royal Aircraft Factory N.E.1

The Royal Aircraft Factory N.E.1 was a prototype British Night fighter of the First World War. A single-engined pusher biplane, it was a development of the Royal Aircraft Factory's earlier F.E.9 fighter, but was not successful, only six being built.

Westland Westbury

The Westland Westbury was a British twin-engined fighter prototype of 1926. Designed by Westland Aircraft it never entered service but played a useful role in the testing of the COW 37 mm gun. Only the two prototypes were completed.

The Vickers F.B.24 was a British two-seat fighter aircraft of the First World War. Only a few prototypes were built, as, although it had good performance, the Bristol F.2 Fighter was preferred.

Robey-Peters Gun-Carrier

The Robey-Peters Gun-Carrier was a British three-seater armed tractor biplane designed and built by Robey & Company Limited at Bracebridge Heath, Lincoln for the Royal Naval Air Service (RNAS).

Mann & Grimmer M.1

The Mann & Grimmer M.1 was a British prototype two-seat fighter aircraft of the First World War. It was a single-engined biplane with a radial engine in the aircraft's nose driving two pusher propellers, which was hoped to give a good field of fire for the gunner and high performance. Only one example was built, with no production following.

The Dyott Bomber was a prototype twin-engined British biplane bomber aircraft of the First World War. Two examples were built but the type was not adopted for service.

The Caproni Ca.61 was an Italian heavy day bomber aircraft of 1922. It was the final development of the Caproni three engine, twin boom biplane types developed during World War I, but it was not put into production.

The Astra 1916 bomber was a large 3-engined biplane, with two fuselages and a central nacelle. Power was supplied by three 220 hp (160 kW) Renault 12Eb water-cooled V-12 piston engines, two tractor engines in the noses of the fuselages and a pusher engine at the rear of the central nacelle. The flight crew of two sat in individual cockpits in the central nacelle and a gunner were housed in a cockpit, aft of the wings, in each fuselage. Designed for a 1916 concours puissant the performance of the aircraft was unsatisfactory and further development was abandoned.

References

Notes

  1. Mason 1992, pp.82-83.
  2. 1 2 Mason 1992, p.83.
  3. These were effectively a pusher version of the RAF 4A engine, with a supplemental cooling fan to ensure an adequate airflow. Bruce 1957, p.402.
  4. Bruce, 1959. p 335.
  5. Bruce 1957, p.404.

Bibliography

  • Bruce, J.M (1957), British Aeroplanes 1914-18, London: Putnam
  • Bruce, J.M. (September 1959), "The F.E.4", Air Pictorial, Aircraft of the 1914-18 War, 21 (9), p. 335
  • Mason, Francis K (1992), The British Fighter since 1912, Annapolis, Maryland, USA: Naval Institute Press, ISBN   1-55750-082-7