Boulton Paul Bodmin

Last updated

Bodmin
RoleExperimental bomber
National origin United Kingdom
Manufacturer Boulton & Paul Ltd
Designer John Dudley North
First flight1924
Number built2

The Boulton & Paul P.12 Bodmin was an experimental British twin-engined biplane bomber with its engines mounted in a fuselage engine room and with tandem pairs of tractor and pusher airscrews mounted between the wings. The two Bodmins built flew in 1924, proving the concept but the layout was not developed to production.

Contents

Design and development

The Boulton & Paul Bodmin was one of the few multi-motor propeller-driven aircraft to have its engines in its fuselage. The concept arose immediately after World War I, when the British & Colonial Aeroplane Co. (soon renamed Bristol Aeroplane) began thinking about large transport aircraft powered by steam turbines mounted in an "engine room" in the fuselage and driving wing mounted propellers. They intended to develop the idea using their large Bristol Braemar triplane bomber, initially modified to be powered by four 230 hp (172 kW) Siddeley Pumas and called, in anticipation of steam power the Tramp. [1] They gained Air Ministry support for this project, the Ministry appreciating the extra safety of an aircraft whose engines could be serviced in flight. The Ministry also issued Specification 9/20 for a smaller aircraft of the same configuration and placed orders for two prototypes with both Boulton & Paul for the twin-engined Bodmin and for the single-engined Parnall Possum They were described as "Postal" aircraft to cover the Ministry's intents but were clearly bombers. [2] All three types were built but only the Bodmin and the Possum flew. It was recognised that the "engine room" arrangement came with a weight penalty owing to the gearing, clutches, drive shafts and supports, plus the need to strengthen wings but John Dudley North, the Boulton & Paul chief designer argued that the airframe weight would be reduced by 10 per cent due to the all-metal construction, as pioneered in the Boulton Paul P.10. [3] This used tubes etc. produced in-house from steel sheet; the airframe was then fabric covered.

The Bodmin was a large three bay biplane with unswept and unstaggered square tipped wings of equal span and constant chord. [3] [4] These had leading-edge-balanced ailerons on upper and lower planes and the rather rectangular fin and tailplane carried similarly balanced control surfaces. The rudder extended below the fuselage underside. The fuselage centre section contained the "engine room" with its two 450 hp (336 kW) Napier Lions in tandem. [3] [4] One was ahead of the wing leading edge and the other at the wing centreline, with an enclosed, illuminated space between them where the engineer could stand upright and monitor them. The engines were mounted on the upper fuselage longerons, leaving a crawl space beneath. [4]

The Lions were orientated with their gearboxes away from the engineer's room and the power from each was taken to the airscrews by two drive shafts at right angles to the fuselage. The two from the front engine drove a pair of two-bladed tractor propellers ahead of the leading edge via a pair of gearboxes halfway between the wings, just beyond the first interplane struts. Their mountings extended rearwards to carry a pair of four-bladed pusher propellers driven by the rear engine. Port and starboard airscrews rotated in opposite directions and the fore and aft pairs did likewise, so that either engine could be shut down without any power asymmetry. The centre section, engine drive shafts and propeller mountings were built as a unit independent of the wings, the drives having their own struts and bracing. [3] The space between each fore and aft pair of propellers was occupied by a cylindrical petrol tank and thin radiators extended between these tanks and the fuselage. [4] Radiators and driveshafts were enclosed by a streamlined fairing on either side. [4]

The rest of the fuselage was conventional and of square cross section with rounded decking. [3] [4] The pilot sat well forward, behind a front gunner's position and the forward end chin shaped; the long front fuselage has been described as being "like the bow of an inverted boat". [3] There was also provision for a dorsal gunner just behind the wings. The main wide tracked single axle undercarriage had pneumatic springing and damping; a pair of smaller wheels further ahead and closer together served to prevent nose-overs and a standard tail skid extended below the rudder.

The first of two Bodmins flew early in 1924. [3] It flew well, though with some drive and cooling problems and showed that despite Bristol's problems with the Tramp the fuselage mounted engine arrangement was workable. John North had been able to compensate the extra weight of this configuration by the savings of metal construction, which he estimated after the Bodmin was built to be as high as 20 per cent, a factor of two better than his design estimate. The safety bonus of engines that could be adjusted and mended in the air, the most important reason behind the layout was achieved. The maximum speed and climb rate of the Bodmin were marginally better than those of the identically powered though slightly smaller metal-framed Boulton & Paul Bugle II. [3] [5]

The Bodmin could fly level on one engine and there was no asymmetry of thrust unlike a conventional twin-engine design. [6] The first prototype was written off due to undercarriage failure and the trials were completed with the second. The "engine room" concept did not catch on but all-metal airframes served later aircraft well.

Specifications

Data from [7]

General characteristics

Performance

See also

Related development

Related Research Articles

Boulton Paul Sidestrand

The Boulton Paul P.29 Sidestrand was a twin-engine biplane medium bomber of the Royal Air Force. Designed for daylight operations, it was manoeuvrable and provided with three defensive gun positions. Named after a village on the Norfolk coast near Boulton & Paul's factory in Norwich, the Sidestrand first flew in 1926 and entered service in 1928. It remained in service until 1936, equipping No. 101 Squadron RAF. It was an agile and relatively fast aircraft that was capable of aerobatic manoeuvres such as loops, rolls and spins.

Boulton Paul P.111 Tailless delta experimental aircraft, United Kingdom, 1950

The Boulton Paul P.111 is an experimental aircraft designed and produced by the British aircraft manufacturer Boulton Paul. It was amongst the first aircraft designed to explore the characteristics of the tailless delta wing configuration.

Boulton Paul Balliol

The Boulton Paul Balliol and Sea Balliol are monoplane advanced trainer aircraft designed and produced by the British aircraft manufacturer Boulton Paul Aircraft. On 17 May 1948, it became the world's first single-engined turboprop aircraft to fly. The Balliol was operated primarily by both the Royal Air Force (RAF) and the Royal Navy Fleet Air Arm (FAA).

Boulton Paul Mailplane

The Boulton & Paul P.64 Mailplane also known as the Mail-Carrier was a 1930s British twin-engined all-metal biplane transport aircraft designed for Imperial Airways and built by Boulton & Paul Ltd.

The Bristol Tramp was a British steam-powered passenger and airmail transport aircraft designed by the Bristol Aeroplane Company. It was built but never flew.

The Bristol Type 91 Brownie was a light sports aircraft produced in the United Kingdom by the Bristol Aeroplane Company in 1924. It was a low-wing cantilever monoplane aircraft of conventional configuration with fixed tailskid undercarriage. The pilot and passenger sat in tandem open cockpits. It won the £1,000 pound prize for second place at the Lympne light aircraft trials in October 1924.

Salmson-Moineau S.M.1

The Salmson-Moineau S.M.1 A3,, was a French armed three-seat biplane long range reconnaissance aircraft of the First World War designed by René Moineau for the Salmson company.

Boulton Paul Bugle

The Boulton & Paul Bugle was a heavy bomber designed and produced by the British manufacturing group Boulton & Paul.

Bristol Berkeley

The Bristol Berkeley was built to a British government specification for a single-engine day or night bomber. Three of these two-seat biplanes were built, but no contract for further production was awarded.

The de Havilland DH.72 was a large British three-engined biplane bomber, designed as a Vickers Virginia replacement. It did not go into production.

Boulton Paul P.32

The sole Boulton & Paul P.32 was a British three-engined biplane built to an Air Ministry specification for a long range night bomber. A lack of engine availability slowed construction and by the time it went for tests the thinking on bomber types had moved on.

Boulton Paul Phoenix

The Boulton and Paul P.41 Phoenix, a single-engined two seat parasol monoplane was aimed at the amateur private flyer which costs less than the successful de Havilland Moth. Despite positive responses from its target purchasers, no orders were forthcoming and only one was built.

Boulton Paul Partridge Biplane fighter

The Boulton & Paul P.33 Partridge was a single seat single-engined biplane fighter designed to an Air Ministry specification. One prototype was ordered and built for trials in 1928, but it was not put into production.

Boulton Paul Bolton

The Boulton & Paul P.15 Bolton was a one-off experimental twin-engined reconnaissance biplane ordered by the Air Ministry to sustain Boulton & Paul's development of steel-framed aircraft early in the 1920s. It was the RAF's first metal-framed aircraft.

Boulton Paul Atlantic

The Boulton & Paul P.8 Atlantic was Boulton & Paul's attempt to adapt their well-performing Bourges bomber into an airliner. They hoped to gain publicity for it by winning the outstanding prize for the first non-stop Atlantic crossing but a first flight accident made them miss their opportunity. Two were built but none sold as airliners.

The Boulton & Paul P.6 was a one-off conventional single-engined biplane built by Boulton & Paul Ltd to test the aerodynamics of different airfoil sections. It was later used as the company sales machine.

Boulton Paul P.10

The Boulton & Paul P.10 was a two-seat, single-engined biplane built just after World War I to develop techniques for the construction of all steel aircraft. It is also notable for its first use of plastic as a structural material. Only one P.10 was built and it attracted much attention; but it probably never flew.

Parnall Pixie

The Parnall Pixie was a low powered British single-seat monoplane light aircraft originally designed to compete in the Lympne, UK trials for motor-gliders in 1923, where it was flown successfully by Norman Macmillan. It had two sets of wings, one for cross-country flights and the other for speed; it later appeared as a biplane which could be converted into a monoplane.

Parnall Possum

The Parnall Possum was an experimental triplane, with a single, central engine driving wing-mounted propellers via shafts and gears. Two of these British aircraft were built in the mid-1920s.

The Westland PV.7 was a private venture submission to a 1930s British specification for a general-purpose military aircraft with two crew. It was a single-engined, high-wing monoplane of promise, but was destroyed early in official tests.

References

Notes
  1. ↑ Barnes 1964 , pp. 140–2
  2. ↑ Brew 1993 , pp. 174–9, 177
  3. 1 2 3 4 5 6 7 8 Brew 1993 , pp. 174–9
  4. 1 2 3 4 5 6 Flight 6 September 1923 , pp.  528–33
  5. ↑ Brew 1993 , pp. 187
  6. ↑ Kinsey, G Boulton & Paul Aircraft 1992 Terence Dalton p41
  7. ↑ Brew 1993, p. 179
Bibliography
This page is based on this Wikipedia article
Text is available under the CC BY-SA 4.0 license; additional terms may apply.
Images, videos and audio are available under their respective licenses.