| Possum | |
|---|---|
 | |
| Role | Experimental bomber |
| National origin | United Kingdom |
| Manufacturer | George Parnall and Co. |
| Designer | Harold Bolas |
| First flight | 19 June 1923 |
| Number built | 2 |
The Parnall Possum was an experimental triplane, with a single, central engine driving wing-mounted propellers via shafts and gears. Two of these British aircraft were built in the mid-1920s.
The Parnall Possum was one of few large aircraft having its engine in its fuselage and the propellers on its wings. [1] The concept arose immediately after World War I, when the British & Colonial Aeroplane Co. (later Bristol), began thinking about large transport aircraft powered by steam turbines mounted in an "engine room" in the fuselage and driving wing-mounted propellers. They intended to develop the idea using their large Bristol Braemar triplane bomber, initially modified to be powered by four 230 hp (172 kW) Siddeley Pumas and called, in anticipation of steam power the Tramp. [2] They obtained Air Ministry support for this project, the Ministry appreciating the extra safety of an aircraft whose engines could be serviced in flight. The Ministry also issued specification 9/20 for a smaller aircraft of the same configuration and placed orders for two prototypes with Parnall, for the single-engined Possum and with Boulton & Paul for the twin-engined Bodmin. [3] They were described as "Postal" aircraft but were clearly experimental bombers; all three types were built but only the Possum and the Bodmin flew. [1] [2] [3]
The Possum was a single-bay triplane, with equal span, parallel chord wings without sweep or stagger. The lowest wing joined the lower fuselage longerons and the middle wing the upper longerons, with the upper wing held well above the fuselage on cabane struts. There were ailerons on all wings. The propeller shafts were mounted in the middle wing within small fairings and placed as close to the fuselage as the two-bladed, 9 ft 6 in (2.90 m) propellers would permit. One advantage of the triplane layout was that each propeller shaft could be symmetrically braced with a pair of X-shaped struts to the upper and lower wings. One set of Xs joined the forward spars and the other the rear. The wing structure was fabric-covered wood. [1]
The fuselage was also wood; slab sided and plywood-covered, from the side the nose was rectangular but it was rounded in plan, rather like that of the Vickers Vimy. The front gunner's position was slightly back from the nose, with the pilot's cockpit just behind it and well in front of the wings. A rear gunner's cockpit was placed at the trailing edge of the high set upper wing, the gunners' cockpits fitted with Scarff rings. The 450 hp Napier Lion engine, a water-cooled unit with 12 cylinders in W or broad arrow arrangement was placed at the centre of gravity inside the fuselage, though with its cylinder heads exposed. There was a radiator on each side of the fuselage near the trailing edge; unusually, these were hinged so that they could be adjusted in flight more or less directly into the slipstream as the pilot chose. The Lion was mounted in line with the fuselage, with its output close to the leading edge of the middle wing, where a bevel gear transmitted the power via drive shafts to gears behind the propellers. The propellers counter-rotated at low speeds. [1]
At the rear of the Possum the fabric-covered wooden empennage was conventional. The fin had a straight and vertical leading edge but a curved top that blended into a rounded rudder which extended downwards between separate elevators; the tailplane was mounted just above the fuselage. Underneath, unusually for the time, there was a tailwheel rather than a skid, which was steerable and fitted with an automatic brake which provided increasing resistance with increasing load, unless the pilot overrode it. The main undercarriage was less innovative, with a pair of wheels single axle-mounted on short oleo legs to the wings with rear bracing. [1]
Preliminary runs had resulted in an increase in rudder area before the Possum's maiden flight on 19 June 1923. It was piloted by Norman Macmillan, accompanied by the Possum's designer, Harold Bolas. On 15 April 1924 the Possum went to the Royal Aircraft Establishment at Farnborough and appeared at the RAF Hendon Air Pageant in June that year. After some delay a second Possum was built, flying in April 1925 and transferred to the Aeroplane and Armament Experimental Establishment at RAF Martlesham Heath in August 1925. They were both active at Martlesham some time thereafter. [1]
Data from Wixey 1990, pp. 117
General characteristics
Performance
Aircraft of comparable role, configuration, and era
The Roe IV Triplane was an early British aircraft designed by Alliott Verdon Roe and built by A.V. Roe and Company. It was first flown in September 1910.
The Bristol Type 91 Brownie was a light sports aircraft produced in the United Kingdom by the Bristol Aeroplane Company in 1924. It was a low-wing cantilever monoplane aircraft of conventional configuration with fixed tailskid undercarriage. The pilot and passenger sat in tandem open cockpits. It won the £1,000 pound prize for second place at the Lympne light aircraft trials in October 1924.
The Blackburn 2F.1 Nautilus was a British single-engine two-seat biplane spotter/fighter built in 1929. Only one was completed.
The Vickers Type 253 was a single-engined two-seat biplane general-purpose military machine built to a 1930 government specification. It won a production contract, but this was transferred to the same company's monoplane equivalent, the Wellesley. Only one Type 253 was built.
The de Havilland DH.72 was a large British three-engined biplane bomber, designed as a Vickers Virginia replacement. It did not go into production.
The Handley Page H.P.47 was a British single-engined low-wing monoplane built to an Air Ministry specification for a general-purpose bomber and torpedo bomber aircraft. Only one was built.
The sole Boulton & Paul P.32 was a British three-engined biplane built to an Air Ministry specification for a long range night bomber. A lack of engine availability slowed construction and by the time it went for tests the thinking on bomber types had moved on.
The Boulton & Paul P.33 Partridge was a single seat single-engined biplane fighter designed to an Air Ministry specification. One prototype was ordered and built for trials in 1928, but it was not put into production.
The Boulton & Paul P.12 Bodmin was an experimental British twin-engined biplane bomber with its engines mounted in a fuselage engine room and with tandem pairs of tractor and pusher airscrews mounted between the wings. The two Bodmins built flew in 1924, proving the concept but the layout was not developed to production.
The Boulton & Paul P.15 Bolton was a one-off experimental twin-engined reconnaissance biplane ordered by the Air Ministry to sustain Boulton & Paul's development of steel-framed aircraft early in the 1920s. It was the RAF's first metal-framed aircraft.
The Parnall Puffin was an experimental amphibious fighter-reconnaissance biplane produced in the United Kingdom just after World War I. It had several unusual features, principally a single central float and an inverted vertical stabilizer and rudder, and showed promise, but at that time no new aircraft were being ordered in numbers for the RAF and only the three Puffins of the initial order were built.
The Parnall Perch was a single-engined, side-by-side-seat aircraft designed in the UK to meet an Air Ministry specification for a general-purpose trainer. Only one Perch was constructed, and no contract was ever awarded with this specification.
The Parnall Pike was a 2/3-seat biplane reconnaissance aircraft, capable of operating off carrier decks or from water, built to an Air Ministry specification in 1927. Only one was constructed.
The Parnall Pipit was a single-engined, single-seat naval fighter designed to an Air Ministry specification in 1927. Two prototypes were built but both were destroyed by tail flutter.
The Parnall Parasol was an experimental parasol winged aircraft design to measure the aerodynamic forces on wings in flight. Two were built and flown in the early 1930s in the UK.
The Parnall Prawn was an experimental flying boat built in the United Kingdom in 1930. Its single engine was fitted on a tilting mounting in the nose, so that the propeller could be kept clear of the water on takeoff and landing. Only one was built and it is not known whether it was ever flown.
The Westland PV.7 was a private venture submission to a 1930s British specification for a general-purpose military aircraft with two crew. It was a single-engined, high-wing monoplane of promise, but was destroyed early in official tests.
The Lioré et Olivier LeO 8, Lioré et Olivier LeO 8-Cau 2 or Lioré et Olivier LeO 8 CAN 2 was a French two seat, parasol wing monoplane night fighter and reconnaissance aircraft, built in 1923.
The Salmson-Béchereau SB-5 was a two-seat fighter aircraft built for a French government programme in 1925. Despite a powerful engine it did not perform well and only one was built.
The Caproni Ca.66 was an Italian night bomber designed to reequip the post-World War I Italian Air Force. Only two examples of the four-engined biplane were built.