| CA-28 Ceres | |
|---|---|
 | |
| CA-28 Ceres at Wangaratta, Victoria, in March 1988 | |
| Role | Agricultural aircraft |
| Manufacturer | Commonwealth Aircraft Corporation |
| First flight | 1958 (see Development) |
| Introduction | 1959 |
| Produced | 1959-1963 |
| Number built | 21 |
| Developed from | CAC Wirraway |
The Commonwealth Aircraft CA-28 Ceres was a crop-duster aircraft manufactured in Australia by the Commonwealth Aircraft Corporation (CAC) between 1959 and 1963. The aircraft was a development of the Wirraway trainer of World War II.
In the 1950s, most crop-dusting aircraft in Australia were conversions of military types that met with varying success. Two CAC types so converted were the Wackett and the Wirraway. Neither type was successful as a crop duster, the Wackett because it was underpowered and the Wirraway because it was not designed for low-level slow-speed flight. Following a market survey conducted together with ICI[ clarification needed ], CAC determined there was a need for a purpose-built aircraft optimized for agricultural work. Once the board approved the project, a number of surplus Wirraways were purchased from the RAAF for use in the production of this new aircraft. [1]
The design that emerged, although superficially similar to the Wirraway, was really a new type that used some Wirraway components, rather than a conversion. The only major components used in both types without alteration were the tail group and the landing gear. The fuselage was completely new, with a 41-cubic-foot (1.16 m3) hopper installed between the engine and the high-mounted single-seat cockpit. The Wirraway wing was substantially altered for use in the Ceres. The outer wing panels had slotted trailing-edge flaps and fixed leading edge slats, while the centre-section was substantially altered to accommodate the hopper, the greater weight of the Ceres, the different flaps (the Wirraway had split flaps,) and the new type's fixed landing gear with CAC Mustang main wheels, [2] as opposed to the Wirraway's retractable gear, although the same landing gear legs were used however. The increase in wingspan and wing area of the Ceres compared to the Wirraway was also incorporated in the centre section, and the result was an aircraft with much more docile stalling characteristics than those of the Wirraway. [2] The engine was the same, a Pratt & Whitney R-1340, but altered so that it was direct drive rather than geared as on the Wirraway. [2] The three-bladed variable-pitch propeller was also different, having a wider chord and smaller diameter compared to the Wirraway, to suit the Ceres different operating regime and the direct-drive engine. [2]
The Ceres prototype first flew in February 1958, in the hands of CAC test pilot Bill Scott, and the first production aircraft was delivered in April 1959. After five aircraft had been built, provision was made for a rear-facing seat behind the cockpit, housed under an extended canopy, which was the only major design change during production. The CAC hoped to sell at least fifty aircraft, but production of the Ceres ended in July 1963 after 21 aircraft had been built, although one could be more accurately described as a rebuild, because it was manufactured using parts salvaged from the first aircraft, which had crashed in 1961. The Ceres succumbed to the popularity of more modern and economical designs such as the Piper Pawnee and PAC Fletcher.
Ceres aircraft survive in small numbers, with two still registered to fly in Australia, and examples in museums in Australia and New Zealand, the latter being a survivor of the six Ceres exported to that country. Recently, with the popularity of the Wirraway as a warbird, and the scarcity of Wirraway components, Ceres wings have been "de-converted" for use in Wirraway restorations. However, because of the substantial differences between the two types, that has proved to be troublesome.
Data from Sword into Ploughshare, [3] Jane's all the World's Aircraft 1959-60 [4]
General characteristics
Performance
Related development
Aircraft of comparable role, configuration, and era
The CAC Boomerang is a fighter aircraft designed and manufactured in Australia by the Commonwealth Aircraft Corporation between 1942 and 1945. Approved for production shortly following the Empire of Japan's entry into the Second World War, the Boomerang was rapidly designed as to meet the urgent demands for fighter aircraft to equip the Royal Australian Air Force (RAAF). It was the first combat aircraft designed and constructed in Australia.
The Piper PA-24 Comanche is an American four-seat or six-seat, low-wing, all-metal, light aircraft of semimonocoque construction with tricycle retractable landing gear. Piper Aircraft designed and developed the Comanche, which first flew on May 24, 1956. Together with the PA-30 and PA-39 Twin Comanches, it made up the core of the Piper Aircraft lineup until the production lines for both aircraft were destroyed in the 1972 Lock Haven flood.
The Antonov An-14 Pchelka or Pchyolka, Bdzhilka is a Soviet utility aircraft which was first flown on 15 March 1958. It was a twin-engined light STOL utility transport, with two 300 hp Ivchenko AI-14RF radial piston engines. Serial production started in 1966, and about 300 examples were built by the time production ended in 1972. The An-14 failed to replace the more successful An-2 biplane, which was manufactured until 1990,. The An-14's successor, the An-28 with turboprop engines, is still manufactured at PZL Mielec factories in Poland, under the names PZL M28 Skytruck and PZL M28B Bryza.
The CAC CA-15, also known unofficially as the CAC Kangaroo, was an Australian propeller-driven fighter aircraft designed by the Commonwealth Aircraft Corporation (CAC) during World War II. Due to protracted development, the project was not completed until after the war, and was cancelled after flight testing, when the advent of jet aircraft was imminent.
The Auster B8 Agricola was a commercially unsuccessful British agricultural aircraft designed for the aerial topdressing market which opened up in New Zealand in the early 1950s.
The CAC Wirraway was a training and general purpose military aircraft manufactured in Australia by the Commonwealth Aircraft Corporation (CAC) between 1939 and 1946. It was an Australian development of the North American NA-16 training aircraft. The Wirraway has been credited as being the foundation of Australian aircraft manufacturing.
The Commonwealth Aircraft Corporation (CAC) was an Australian aircraft manufacturer. The CAC was established in 1936, to provide Australia with the capability to produce military aircraft and engines.
The CAC Wackett Trainer was the first aircraft type designed in-house by the Commonwealth Aircraft Corporation of Australia. The name was derived from its designer Lawrence Wackett. "In acknowledgement of the CAC Manager's enormous contribution, the RAAF were to call the aircraft the Wackett Trainer"
The Gippsland GA-200 Fatman is a low-wing single-engine agricultural aircraft built by GippsAero.
The Zlin Z-37 Čmelák, also known as LET Z-37 Čmelák is an agricultural aircraft which was manufactured in Czechoslovakia. It is powered by a Soviet-built Ivchenko reciprocating engine. The aircraft is used mainly as a cropduster.
The PZL-105 Flaming (flamingo) is a Polish short-takeoff-and-landing (STOL) utility aircraft designed by PZL "Warszawa-Okęcie". It remained a prototype.
The Yeoman Cropmaster was an Australian agricultural aircraft developed from the CAC Wackett trainer of World War II.
The Evektor EV-55 Outback is a twin-engine turboprop aircraft designed and built in the Czech Republic by Evektor-Aerotechnik. The prototype first flew on 24 June 2011. The project's development was suspended in March 2017.
The Historical P-51 Mustang is an American homebuilt aircraft that was designed and produced by the Historical Aircraft Corporation of Nucla, Colorado. The aircraft is a 62.5% scale replica of the original North American P-51 Mustang and when it was available was supplied as a kit for amateur construction.
The Historical F4U Corsair is an American homebuilt aircraft that was designed and produced by the Historical Aircraft Corporation of Nucla, Colorado. The aircraft is a 60% scale replica of the original Chance-Vought F4U Corsair and when it was available was supplied as a kit for amateur construction.
The Historical P-40C Tomahawk is an American homebuilt aircraft that was designed and produced by the Historical Aircraft Corporation of Nucla, Colorado. The aircraft is a 62.5% scale replica of the original Curtiss P-40C Tomahawk and when it was available was supplied as a kit for amateur construction.
The Storm 320E, sometimes written Storm 320 E, is an Italian microlight aircraft that was designed and produced by Storm Aircraft of Sabaudia. Storm Aircraft was originally called SG Aviation srl. When it was available the aircraft was supplied as a kit for amateur construction.
The Stewart S-51D Mustang is an American aerobatic homebuilt aircraft that was designed by Jim Stewart and produced by Stewart 51 of Vero Beach, Florida, introduced in 1994. When it was available the aircraft was supplied as a kit for amateur construction.
The V-STOL Super Solution 2000 is an American STOL homebuilt aircraft that was designed by Dick Turner and produced by V-STOL Aircraft Corporation of Fort Myers, Florida. When it was available the aircraft was supplied as a kit for amateur construction.
The Brown 1926 parasol monoplane was a 1920s US, three seat, parasol wing civil aircraft developed from a biplane wartime scout. It was intended for either the private or commercial passenger markets, though one was used as a crop-duster.
 | Wikimedia Commons has media related to CAC Ceres . |
