| Chrysler VZ-6 | |
|---|---|
 | |
| Role | VTOL experimental platform |
| National origin | United States |
| Manufacturer | Chrysler |
| First flight | 1959 |
| Number built | 2 |
The Chrysler VZ-6 was an American VTOL ducted-fan test vehicle designed and built by Chrysler for the United States Army Flying Jeep competition. [1] [2]
Ordered in 1958, two VZ-6s were built. It was a rectangular-shaped vehicle with two three-bladed propellers inset at the front and back. [2] The 500 hp Lycoming engine was located in the center driving the ducted fan propellers. [2] It was also fitted with rubber skirts around the bottom edge of the vehicle similar to a hovercraft. [2]
The VZ-6 started tethered flight tests in 1959, but these showed that the vehicle was overweight and underpowered with stability problems. [2] An attempt at a non-tethered flight resulted in the VZ-6 flipping over, writing off the vehicle, but the pilot escaped without any serious injuries. [2] Both VZ-6s were scrapped in 1960. [2]
Data from [2]
General characteristics
Aircraft of comparable role, configuration, and era
Related lists
The Helio Courier is a cantilever high-wing light STOL utility aircraft designed in 1949.
The Piper PA-18 Super Cub is a two-seat, single-engine monoplane. Introduced in 1949 by Piper Aircraft, it was developed from the PA-11 Cub Special, and traces its lineage back through the J-3 Cub to the Taylor E-2 Cub of the 1930s. In close to 40 years of production, over 10,000 were built. Super Cubs are commonly found in roles such as bush flying, banner towing and glider towing.
The Vultee XP-54 Swoose Goose was a prototype fighter built by the Vultee Aircraft Company for the United States Army Air Forces (USAAF).
The Hiller VZ-1 Pawnee is a unique direct-lift rotor aircraft, using contra-rotating ducted fans for lift inside a flying platform upon which the single pilot shifted body weight for directional control. The platform was developed starting in 1953 under an Office of Naval Research (ONR) contract to Hiller Aircraft, and flew successfully beginning in 1955.
The Avro Canada VZ-9 Avrocar is a VTOL aircraft developed by Avro Canada as part of a secret U.S. military project carried out in the early years of the Cold War. The Avrocar intended to exploit the Coandă effect to provide lift and thrust from a single "turborotor" blowing exhaust out of the rim of the disk-shaped aircraft. In the air, it would have resembled a flying saucer.
The Ryan XV-5 Vertifan was a jet-powered V/STOL experimental aircraft in the 1960s. The United States Army commissioned the Ryan VZ-11-RY in 1961, along with the Lockheed VZ-10 Hummingbird. It successfully proved the concept of ducted lift fans, but the project was cancelled after multiple fatal crashes unrelated to the lift system.
The Interstate Cadet is an American two-seat tandem, high wing, single-engine monoplane light aircraft. Around 320 of these aircraft were produced between the years 1941 and 1942 by the Interstate Aircraft and Engineering Corporation based in El Segundo, California. The construction techniques employed were a welded steel tube fuselage, wood (spruce) wing structure with metal ribs, and fabric covering, all of which were fairly standard in the 1940s.
The Piasecki VZ-8 Airgeep was a prototype vertical takeoff and landing (VTOL) aircraft developed by Piasecki Aircraft. The Airgeep was developed to fulfill a U.S. Army Transportation Research Command contract for a flying jeep in 1957. The flying jeep was envisioned to be smaller and easier to fly than a helicopter.
The Doak VZ-4 was an American prototype Vertical Takeoff and Landing (VTOL) aircraft built in the 1950s for service in the United States Army. Only a single prototype was built, and the U.S. Army withdrew it from active trials in 1963.
The Vertol VZ-2 is a research aircraft built in the United States in 1957 to investigate the tiltwing approach to vertical take-off and landing.
The Fairchild VZ-5 was an experimental VTOL aircraft built in the 1950s. The VZ-5 was designed by Fairchild Aircraft for research use by the United States Army.
The Ryan VZ-3 Vertiplane, also known by the company designation Ryan Model 92 was an American experimental vertical/short take-off (VSTOL) aircraft built by the Ryan Aeronautical Company for the United States Army.
The Stipa-Caproni, also known as the Caproni Stipa, was an experimental Italian aircraft designed in 1932 by Luigi Stipa (1900–1992) and built by Caproni. It featured a hollow, barrel-shaped fuselage with the engine and propeller completely enclosed by the fuselage—in essence, the whole fuselage was a single ducted fan. Although the Regia Aeronautica was not interested in pursuing development of the Stipa-Caproni, its design influenced the development of jet propulsion.
The Mississippi State University XV-11A Marvel was an experimental American STOL research aircraft of the 1960s. The MARVEL (Mississippi Aerophysics Research Vehicle with Extended Latitude) was a single-engined pusher monoplane fitted with a boundary layer control system. The first all-composite aircraft, it carried out its initial program of research on behalf of the US Army in the late 1960s, and was rebuilt in the 1980s as a proof-of-concept for a utility aircraft.
The Curtiss-Wright VZ-7 was a VTOL quadrotor helicopter aircraft designed by the Curtiss-Wright company for the US Army. Like the Chrysler VZ-6 and the VZ-8 Airgeep it was to be a "flying jeep".
The Mississippi XAZ-1 Marvelette was an American research aircraft of the 1960s. A converted Anderson Greenwood AG-14 light single-engined pusher aircraft, it provided the test-bed, or test platform, on which to test the boundary layer control system and ducted propeller installation of the planned XV-11 Marvel STOL research aircraft. One aircraft was converted to XAZ-1 configuration; although underpowered, it provided valuable test data over a year-long flight program. Following the conclusion of test flying, the aircraft was used for ground testing before being scrapped.
The Dornier Do 29 was an experimental aircraft developed by Dornier Flugzeugwerke and the Deutsche Versuchsanstalt für Luftfahrt in the 1950s, used to test a tilting-propeller system for short takeoff and landing (STOL) aircraft. The concept was proved successful in flight testing; however, no further development of the system or aircraft was proceeded with, and at the conclusion of its test program the Do 29 was retired.
The Avian 2/180 Gyroplane was a two-seat, single-engine autogyro built in Canada in the 1960s. Several prototypes were built but series production was never achieved.
The Fleetwings PQ-12 , company designation Fleetwings Model 36, was a 1940s American manned aerial-target designed and built by Fleetwings for the United States Army Air Corps.
The Tactical Robotics Cormorant, formerly AirMule or Mule, Israel Defense Forces (IDF) codename Pereira, is a flying car unmanned aerial vehicle (UAV) built by Tactical Robotics Ltd., a subsidiary of designer Rafi Yoeli's Urban Aeronautics Ltd., in Yavne, Israel. It will be used in search and rescue operations where it is too dangerous or inaccessible for a helicopter, such as evacuating people from the upper stories of burning buildings, or delivering and extracting police and soldiers while very close to structures, narrow streets, or through holes into confined spaces.