| Sperber Junior | |
|---|---|
 | |
| Role | Competition sailplane |
| National origin | Germany |
| Manufacturer | Deutsche Forschungsanstalt für Segelflug (DFS) |
| Designer | Hans Jacobs |
| First flight | 1936 |
| Number built | 1 |
The DFS Sperber Junior (English: Hawk Junior) was a competition sailplane designed for Hanna Reitsch and built in Germany in 1936.
The Sperber Junior, was designed as a development of the Rhönsperber for Hanna Reitsch by Hans Jacobs. It had much in common with his other Rhönsperber development, the Sperber Senior, though the latter was intended for large pilots. Reitsch's small and light frame allowed a narrower cockpit than in the Senior in a revised, more slender forward fuselage, a tight fit for her and too small for her contemporaries. This increased the fuselage length, though the span was 400 mm (16 in) less. A different airfoil section, the same as on the Rhönsperber, was used and the gull wing was more pronounced with airbrakes on the inner wing. [1]
It was a shoulder wing aircraft with a double straight tapered gull wing, built around two spars and fabric covered apart from the leading edge from the front spar forward and the wing roots, which were plywood skinned. The wing roots were carefully faired into the fuselage. The inner panels, filling about one third of the span had only slight taper, the sweep entirely on the trailing edge; the inner parts of them carried about 10° of dihedral but they flattened outboard. Spoilers were mounted on the bend, behind the front spar and opening above the wing. The outer panels had no dihedral but were strongly tapered, swept mostly on the trailing edge with a taper ratio of 0.42. Ailerons occupied the whole of the outer panels' trailing edges. [1]
The Junior had a completely ply covered fuselage with a narrow ovoid cross section which tapered progressively to the tail. The cockpit was just ahead of the wing, under a largely ply fairing smoothly integrated into the nose and fuselage; its only transparencies were portholes in its slightly concave sides. The cockpit fairing was removable for access; aft, it blended immediately into the fuselage line without the long fairing of the Sperber Senior. A tapered, round tipped and largely fabric covered horizontal tail was mounted on top of the fuselage, far enough forward to place the trailing edges of its elevators at the rudder hinge line. The latter was mounted on a narrow ply covered fin, carefully faired into the fuselage and extending below it to form a tail bumper. The mostly fabric covered rudder was full, curved and slightly pointed, likewise extending below the fuselage. A short skid from just behind the nose to beyond mid-chord completed the undercarriage. [1]
As a woman Reitsch had serious problems with her admission into the 1936 German National Competitions on the Wasserkuppe but managed fifth place. In May 1937 she was one of a group of five pilots who soared from Salzburg across the Alps for 100 miles into Italy. [2] : 116 After that she became more absorbed in military testing and the Junior was lost in World War II.
Data from Sailplanes 1920-1945 (2006) pp.116-7 [1]
General characteristics
Performance
The Akaflieg Darmstadt D-34 sailplanes were a series of experimental single seat sailplanes, designed at the University of Darmstadt in the 1950s and early 1960s to explore the structural and aerodynamic advantages of the then emerging plastics and composite materials.
The Cijan-Obad Orao is a competition single seat sailplane designed in Yugoslavia just after World War II, one of the most advanced of its type at the time. It flew in three World Gliding Championships, having greatest success at its first in 1950 when it reached third place.
The Maeda 703 was one of the first indigenous Japanese gliders, a high performance single seat aircraft which first flew in 1940. Three were built, two with gull wing wings; one of these set a national endurance record in 1941.
The CVV1 Pinguino was a single seat, high performance glider designed and built in Italy in the mid-1930s, the first of a series of gliders from the Milan Polytechnic. It did not go into production.
The DFS Rhönsperber, otherwise known as the Schweyer Rhönsperber or Jacobs Rhönsperber was a single seat competition glider designed in Germany by Hans Jacobs and first flown in 1935. For several years it was regarded as the best German sailplane and about one hundred were built.
The DFS Reiher was a single seat competition glider designed in Germany by Hans Jacobs and first flown in 1937. The type won the last two German Rhön gliding championships before the start of World War II. Six were factory produced.
The Schleicher Rhönadler, DFS Rhönadler or Jacobs Rhönadler is a high performance, single seat competition sailplane built in Germany in the 1930s. More than 65 were built.
The CVT1 Zigilo was a single-seat, 12-metre-span (39 ft) Italian training glider designed and built in Italy in the 1950s. Only one was completed.
The RRG Fafnir, named after the legendary dragon, was a single seat German high performance glider designed by Alexander Lippisch. It won the Rhön competition in 1931 and made several outstanding flights as well as setting a fashion for gull wings.
The RRG Fafnir 2 São Paulo, named after the legendary dragon and the Brazilian city which partially financed it, was a single seat German high performance glider designed by Alexander Lippisch. It set a new world distance record in 1934 and won the 1937 International Gliding Championships.
The Scheibe Specht is a tandem seat training glider produced in Germany in the early 1950s. More than fifty were built.
The IIL IS-5 was a single seat, high performance sailplane designed by Iosif Șilimon and built in Romania in 1960.
The IIL IS-10 was a high-performance, single-seat glider, designed and built in Romania in the early 1960s. It was the first Romanian aircraft to use laminar flow airfoils.
The DFS Sperber Senior was a competition sailplane designed and built in Germany in 1936. During 1937 the sole example visited the United States and scored highest in the US National Soaring Competition.
The Schneider Grunau 7 Moazagotl was a high-performance sailplane designed in Germany in 1933 specifically for fast, long distance flying using strong thermals. In 1937 it came second in the first World Gliding Championships, having previously made a flight of 300 km (186 mi).
The Schneider ES-57 Kingfisher is a low-cost, short-span Australian glider capable of respectable cross country soaring flights. It was produced in small numbers in the late 1950s.
The Merville SM.31 is a French high performance glider with a laminar flow wing, first flown in 1960. Only one was built.
The Musger Mg 9 was a tandem two seat glider built in Austria in the mid-1930s. It broke both world and national records.
The Civil Aviation Department Ashvini was the first two-seat glider designed and built in India. It was produced in small numbers in the early 1960s.
The Rubik R-03 Szittya I was a Hungarian single-seat sailplane flown in the late 1930s. The design was developed through three improving variants. though only one of each was built.