Godiva device

Last updated

Experimenters produced bursts of gamma rays and neutrons by assembling Godiva I's three parts and dropping a burst rod through the center. This image shows it in the safe, scrammed, state. Godiva-before-scrammed.jpg
Experimenters produced bursts of gamma rays and neutrons by assembling Godiva I's three parts and dropping a burst rod through the center. This image shows it in the safe, scrammed, state.

The Lady Godiva device [1] was an unshielded pulsed nuclear reactor [2] originally situated at the Los Alamos National Laboratory (LANL), near Santa Fe, New Mexico. It was one of a number of criticality devices within Technical Area 18 (TA-18). Specifically, it was used to produce bursts of neutrons and gamma rays for irradiating test samples, and inspired development of Godiva-like reactors. [lower-alpha 1]

Contents

The radiation source within the Godiva device was a fissile metallic mass (usually highly enriched 235U), [3] about 11.8 inches (30 cm) in diameter. This was located at the top of a 6.5-foot (2 m) high metal tower. The burst of radiation was produced when a piston of fissile material was quickly inserted into and extracted from a cavity within the larger fissile mass. During the time these two masses were combined, they formed a critical mass and a nuclear chain reaction was briefly sustained. [2]

Godiva's design was inspired by a self terminating property [ further explanation needed ] discovered when incorrectly experimenting with the Jemima device in 1952. Jemima operated by remotely lifting one stack of enriched uranium-235 disks up towards another, fixed, stack. On 18 April 1952, due to a miscalculation, Jemima was assembled with too many disks; this caused an excursion of 1.5 x 1016 fissions—an automatic scram—but no damage. [1]

On 3 February 1954 and 12 February 1957, accidental criticality excursions occurred, causing damage to the device but only insignificant exposures to personnel. This original Godiva device, known as Lady Godiva, was irreparable after the second accident and was replaced by the Godiva II. [1]

Godiva II

A cylindrical wire cage encloses the spherical uranium mass at the top of this image of Godiva II. Godiva critical mass assembly machine.jpg
A cylindrical wire cage encloses the spherical uranium mass at the top of this image of Godiva II.

Godiva II was constructed inside a concrete building with 20-inch-thick (51 cm) walls and 8-inch-thick (20 cm) roof in a canyon a quarter-mile (400 m) away from the control room. [4] [5]

In 1959, Los Alamos agreed to make Godiva II available to DOD contractors free of charge for two days each month, acknowledging its unique facility for radiation tests. [6]

Godiva's success in creating intense bursts spurred development of similar pulsed reactors, which also suffered accidental excursions, for example: 28 May 1965 at the White Sands Missile Range (parts were thrown 15 feet (4.6 m)); [7] and 6 September 1968 at the Aberdeen Proving Ground (middle melted, disks warped and bolts stretched). [8]

In December 2002, the U.S. Department of Energy announced it was to move its TA-18 testing equipment including the Godiva burst machine from the LANL to the Device Assembly Facility (DAF) at the Nevada Test Site (NTS). [2] [9]

See also

Notes

Explanatory notes

  1. according to the physicist Otto Frisch, "We were building an unusual assembly, with no reflecting material around it; just the reacting compound of uranium-235 ... For obvious reasons we called it the Lady Godiva assembly." (Frisch 1980, p. 161)

Citations

  1. 1 2 3 McLaughlin et al. pages 78, 80-83. "Jemima ... apparent self terminating property of this excursion stimulated study with Lady Godiva,46,47,48"
  2. 1 2 3 Garcia page 1
  3. McLaughlin et al. page 109, "93%"
  4. Engelke pages 3-4
  5. Wimett, T. F.; White, R. H.; Stratton, W. R.; Wood, D. P. (1 December 1960). "Godiva II—An Unmoderated Pulse-Irradiation Reactor". Nuclear Science and Engineering. 8 (6): 691–708. Bibcode:1960NSE.....8..691W. doi:10.13182/NSE60-2. ISSN   0029-5639.
  6. Zipprich, L.J.
  7. McLaughlin et al. page 86, "Unreflected uranium–molybdenum metal fast burst reactor"
  8. Kazi et al., "center third of the safety block was melted"
  9. U.S. Department of Energy page 1

General references

Related Research Articles

<span class="mw-page-title-main">Little Boy</span> Atomic bomb dropped on Hiroshima

Little Boy is the name of the type of atomic bomb used in the bombing of the Japanese city of Hiroshima on 6 August 1945 during World War II, making it the first nuclear weapon used in warfare. The bomb was dropped from the Boeing B-29 Superfortress Enola Gay piloted by Colonel Paul W. Tibbets Jr., commander of the 509th Composite Group, and Captain Robert A. Lewis. It exploded with an energy of approximately 15 kilotons of TNT (63 TJ) and had an explosion radius of approximately 1.3 kilometers which caused widespread death across the city. The Hiroshima bombing was the second nuclear explosion in history, after the Trinity nuclear test.

<span class="mw-page-title-main">Nuclear fission</span> Nuclear reaction splitting an atom into multiple parts

Nuclear fission is a reaction in which the nucleus of an atom splits into two or more smaller nuclei. The fission process often produces gamma photons, and releases a very large amount of energy even by the energetic standards of radioactive decay.

<span class="mw-page-title-main">Nuclear chain reaction</span> When one nuclear reaction causes more

In nuclear physics, a nuclear chain reaction occurs when one single nuclear reaction causes an average of one or more subsequent nuclear reactions, thus leading to the possibility of a self-propagating series or "positive feedback loop" of these reactions. The specific nuclear reaction may be the fission of heavy isotopes. A nuclear chain reaction releases several million times more energy per reaction than any chemical reaction.

<span class="mw-page-title-main">Nuclear reactor</span> Device for controlled nuclear reactions

A nuclear reactor is a device used to initiate and control a fission nuclear chain reaction. Nuclear reactors are used at nuclear power plants for electricity generation and in nuclear marine propulsion. When a fissile nucleus like uranium-235 or plutonium-239 absorbs a neutron, it splits into lighter nuclei, releasing energy, gamma radiation, and free neutrons, which can induce further fission in a self-sustaining chain reaction. The process is carefully controlled using control rods and neutron moderators to regulate the number of neutrons that continue the reaction, ensuring the reactor operates safely. The efficiency of energy conversion in nuclear reactors is significantly higher compared to conventional fossil fuel plants; a kilo of uranium-235 can release millions of times more energy than a kilo of coal.

<span class="mw-page-title-main">Nuclear weapon design</span> Process by which nuclear WMDs are designed and produced

Nuclear weapon designs are physical, chemical, and engineering arrangements that cause the physics package of a nuclear weapon to detonate. There are three existing basic design types:

<span class="mw-page-title-main">Louis Slotin</span> Canadian physicist and chemist

Louis Alexander Slotin was a Canadian physicist and chemist who took part in the Manhattan Project. Born and raised in the North End of Winnipeg, Manitoba, Slotin earned both his Bachelor of Science and Master of Science degrees from the University of Manitoba, before obtaining his doctorate in physical chemistry at King's College London in 1936. Afterwards, he joined the University of Chicago as a research associate to help design a cyclotron.

<span class="mw-page-title-main">Otto Robert Frisch</span> Austrian-born British nuclear physicist

Otto Robert Frisch was an Austrian-born British physicist who worked on nuclear physics. With Otto Stern and Immanuel Estermann he first measured the magnetic moment of the proton. With Lise Meitner he advanced the first theoretical explanation of nuclear fission and first experimentally detected the fission by-products. Later, with his collaborator Rudolf Peierls he designed the first theoretical mechanism for the detonation of an atomic bomb in 1940.

In nuclear physics, an energy amplifier is a novel type of nuclear power reactor, a subcritical reactor, in which an energetic particle beam is used to stimulate a reaction, which in turn releases enough energy to power the particle accelerator and leave an energy profit for power generation. The concept has more recently been referred to as an accelerator-driven system (ADS) or accelerator-driven sub-critical reactor.

A criticality accident is an accidental uncontrolled nuclear fission chain reaction. It is sometimes referred to as a critical excursion, critical power excursion, divergent chain reaction, or simply critical. Any such event involves the unintended accumulation or arrangement of a critical mass of fissile material, for example enriched uranium or plutonium. Criticality accidents can release potentially fatal radiation doses if they occur in an unprotected environment.

<span class="mw-page-title-main">Harry Daghlian</span> American physicist (1921–1945)

Haroutune Krikor Daghlian Jr. was an American physicist with the Manhattan Project, which designed and produced the atomic bombs that were used in World War II. He accidentally irradiated himself on August 21, 1945, during a critical mass experiment at the remote Omega Site of the Los Alamos Laboratory in New Mexico and died 25 days later from the resultant radiation poisoning.

In nuclear engineering, prompt criticality describes a nuclear fission event in which criticality is achieved with prompt neutrons alone and does not rely on delayed neutrons. As a result, prompt supercriticality causes a much more rapid growth in the rate of energy release than other forms of criticality. Nuclear weapons are based on prompt criticality, while nuclear reactors rely on delayed neutrons or external neutrons to achieve criticality.

<span class="mw-page-title-main">Nuclear fuel</span> Material fuelling nuclear reactors

Nuclear fuel is material used in nuclear power stations to produce heat to power turbines. Heat is created when nuclear fuel undergoes nuclear fission. Nuclear fuel has the highest energy density of all practical fuel sources. The processes involved in mining, refining, purifying, using, and disposing of nuclear fuel are collectively known as the nuclear fuel cycle.

<span class="mw-page-title-main">Bhabha Atomic Research Centre</span> Nuclear research facility in Mumbai, India

The Bhabha Atomic Research Centre (BARC) is India's premier nuclear research facility, headquartered in Trombay, Mumbai, Maharashtra, India. It was founded by Homi Jehangir Bhabha as the Atomic Energy Establishment, Trombay (AEET) in January 1954 as a multidisciplinary research program essential for India's nuclear program. It operates under the Department of Atomic Energy (DAE), which is directly overseen by the Prime Minister of India.

Uranium-233 is a fissile isotope of uranium that is bred from thorium-232 as part of the thorium fuel cycle. Uranium-233 was investigated for use in nuclear weapons and as a reactor fuel. It has been used successfully in experimental nuclear reactors and has been proposed for much wider use as a nuclear fuel. It has a half-life of 160,000 years.

<span class="mw-page-title-main">Plutonium</span> Chemical element with atomic number 94 (Pu)

Plutonium is a chemical element; it has symbol Pu and atomic number 94. It is a silvery-gray actinide metal that tarnishes when exposed to air, and forms a dull coating when oxidized. The element normally exhibits six allotropes and four oxidation states. It reacts with carbon, halogens, nitrogen, silicon, and hydrogen. When exposed to moist air, it forms oxides and hydrides that can expand the sample up to 70% in volume, which in turn flake off as a powder that is pyrophoric. It is radioactive and can accumulate in bones, which makes the handling of plutonium dangerous.

<span class="mw-page-title-main">Comparison of Chernobyl and other radioactivity releases</span>

This article compares the radioactivity release and decay from the Chernobyl disaster with various other events which involved a release of uncontrolled radioactivity.

<span class="mw-page-title-main">Oregon State University Radiation Center</span> Building on the Oregon State University campus in Corvallis, Oregon, U.S.

The Oregon State University Radiation Center (OSURC) is a research facility that houses a nuclear reactor at Oregon State University (OSU) in Corvallis, Oregon, United States. The Oregon State TRIGA Reactor (OSTR) serves the research needs of the OSU nuclear engineering department along with other departments.

<span class="mw-page-title-main">Uranium hydride bomb</span> Type of atomic bomb

The uranium hydride bomb was a variant design of the atomic bomb first suggested by Robert Oppenheimer in 1939 and advocated and tested by Edward Teller. It used deuterium, an isotope of hydrogen, as a neutron moderator in a uranium-deuterium ceramic compact. Unlike all other fission-bomb types, the concept relies on a chain reaction of slow nuclear fission. Bomb efficiency was harmed by the slowing of neutrons since the latter delays the reaction, as delineated by Rob Serber in his 1992 extension of the original Los Alamos Primer.

<span class="mw-page-title-main">Hydrogen-moderated self-regulating nuclear power module</span>

The hydrogen-moderated self-regulating nuclear power module (HPM), also referred to as the compact self-regulating transportable reactor (ComStar), is a type of nuclear power reactor using hydride as a neutron moderator. The design is inherently safe, as the fuel and the neutron moderator is uranium hydride UH3, which is reduced at high temperatures (500–800 °C) to uranium and hydrogen. The gaseous hydrogen exits the core, being absorbed by hydrogen absorbing material such as depleted uranium, thus making it less critical. This means that with rising temperature the neutron moderation drops and the nuclear fission reaction in the core is dampened, leading to a lower core temperature. This means as more energy is taken out of the core the moderation rises and the fission process is stoked to produce more heat.

<span class="mw-page-title-main">Flattop (critical assembly)</span> Device for testing fissionable materials

Flattop is a benchmark critical assembly that is used to study the nuclear characteristics of uranium-233, uranium-235, and plutonium-239 in spherical geometries surrounded by a relatively thick natural uranium neutron reflector.