| La-17 | |
|---|---|
 | |
| La-17 on display in Kubinka | |
| Role | UAV |
| National origin | Soviet Union |
| Manufacturer | Lavochkin |
| First flight | 1953 |
| Primary user | Soviet Air Force |
The Lavochkin La-17 was the first Soviet unmanned aerial vehicle (UAV) to reach operational service. The first versions were developed in the early 1950s, and remained in service into the 1980s.
The La-17 was designed by the Lavochkin design bureau, with work beginning in 1950. Flight tests began in 1953, with prototype drones carried on a Tupolev Tu-4 four-engine bomber. La-17 production began in 1956.
The La-17 was a jet drone of all-metal construction, with straight flight surfaces, and a jet engine carried in a nacelle under the fuselage. The initial variant, which was just known as the "La-17", was air-launched. and powered by a Bondaryuk RD-900 ramjet with 800 kgf (1,760 lbf) thrust. There was a "windmill" type electric generator in the nose, somewhat along the lines of the WW II-era Luftwaffe's Me 163 manned rocket interceptor to provide electric power. The La-17 was directed by radio control and simply "bellied in" to land, with the engine taking the abuse of the touchdown. The ramjet was strictly expendable and easily replaced. The drone could carry Luneburg lenses to give an enhanced radar signature.
The original La-17 was only marginally effective, and air launch was expensive and logistically clumsy, making simulations of "mass attacks" with drones difficult at best. The ramjet engine was thirsty, resulting in such short endurance that if a fighter pilot missed the drone on his first pass, it would have run out of fuel before he could come around again. To address these problems, Lavochkin engineers came up with a ground-launched variant, the La-17M, which performed its initial flights in 1959 and went into service in 1960. The La-17M was launched using a RATO booster under each wing root, from a four-wheel towed launcher derived from the carriage of a standard 100 millimeter antiaircraft gun.
The La-17M was powered by a Mikulin RD-9BK turbojet with 1,950 kgf (4,300 lbf) thrust; the RD-9BK was a derated, non-afterburning, and simplified version of the RD-9B engine used on the MiG-19 fighter. There were teardrop fairings on the wingtips used for compressed air that would be fed to the engine to improve the flight ceiling. Flight endurance improved from the 40 minutes of the La-17 to 60 minutes. As with the La-17, the La-17M bellied in to land.
Early production La-17Ms did not have an autopilot, so were quickly replaced by the La-17MA, which did. Later production featured the RD-9BKR engine, with the same performance as the RD-9BK but with some minor changes to permit low-level operation, and a service life improved from 15 to 30 hours. They also featured an improved landing control system that caused the UAV to "nose up" before touchdown, as well as a landing skid under the engine nacelle. These two refinements permitted landings with much less risk of engine damage. These machines were designated La-17MM and went into service in 1964.
A number of old ramjet-powered La-17s were updated for ground launch, with the twin RATO boosters and some airframe reinforcements. These drones were redesignated La-17n.
Early on, development work was initiated to use the ramjet-powered La-17 as the basis for an air-launched reconnaissance drone, but because of the model's deficiencies, it did not happen. However, a ground-launched battlefield reconnaissance drone based on the La-17MM, the La-17R, was introduced in 1962. It featured a nose stretched by 54 cm (22 in) to accommodate a reconnaissance payload. Ultimately a number of different payloads were developed, including high resolution or wide area film cameras, a real-time TV camera, and a radiation monitoring instrument. The La-17R did not have the wingtip compressed air pods for high altitude operation. An improved version of the La-17R, the La-17RM, was introduced in 1965, featuring some of the refinements of the La-17MM target drone.
The evolution of the target and reconnaissance variants of the La-17 progressed along two paths, with the result that commonality between the two branches of the family diverged. In order to rationalize production and logistics, a target drone designated the La-17UM and a reconnaissance drone designated the La-17RU were manufactured that were designed for the maximum parts commonality.
These were the last La-17s built by the Lavochkin OKB, but not the last La-17s built in the USSR. The Lavochkin OKB became more and more involved in the development of space systems and the production of La-17s proceeded on "autopilot" into the late 1970s, until availability of RD-9BK engines was exhausted, so that it was no longer possible to build the La-17 as it was.
A group of Soviet aerospace organizations then came up with the R11K, an expendable non-afterburning version of the Tumanskiy R11F-300 turbojet, used on first-generation Mikoyan MiG-21 fighters, and the La-17 was redesigned to be fitted with this engine. The Sokol design bureau (OKB) began production of this reengined La-17 in the late 1970s. To the armed services it was still an La-17MM, but had an internal OKB designation of La-17K. The R11K engines were rebuilds of retired R11F-300 engines.
The La-17K remained in production into the early 1990s. It apparently remains in lingering use in Russian service.
It does not appear that the La-17 family was widely exported, though La-17RM reconnaissance drones were exported to Syria in the 1980s.
The Chinese also obtained the La-17, and in fact built it themselves, though not under a license agreement. In the late 1950s, a number of La-17s had been handed over to the People's Republic of China. When stocks began running low in the later half of the 1960s, when relations with the USSR were generally poor, an effort was begun to reverse engineer the La-17 and build it in China. The resulting product, the Chang Kong (Blue Sky) CK-1, was introduced to service in 1966. It was powered by the WP-6 engine, which was a Chinese copy of the RD-9B and featured some system changes from the original La-17s used as a pattern. It also featured a parachute recovery system.
The CK-1 was quickly followed by the CK-1A, which had underwing pods for additional kit. A CK-1B was introduced into service in 1983 that was optimized for low-level flight and had non-jettisonable underwing fuel tanks. It was followed by the CK-1C, with a much improved control system to provide much more maneuverability, as well as reinforcement to withstand maneuvering stresses.
A vintage example of the La-17 drone apparently is under restoration late in 2012, at the National Museum of the U.S. Air Force. [1]
General characteristics
Performance
A ramjet, or athodyd, is a form of airbreathing jet engine that uses the forward motion of the engine to produce thrust. Since it produces no thrust when stationary ramjet-powered vehicles require an assisted take-off like a rocket assist to accelerate it to a speed where it begins to produce thrust. Ramjets work most efficiently at supersonic speeds around Mach 3 and can operate up to speeds of Mach 6.
The Mikoyan-Gurevich MiG-19 is a Soviet second generation, single-seat, twinjet fighter aircraft, the world's first mass-produced supersonic aircraft. It was the first Soviet production aircraft capable of supersonic speeds in level flight. A comparable U.S. "Century Series" fighter was the North American F-100 Super Sabre, although the MiG-19 primarily fought against the more modern McDonnell Douglas F-4 Phantom II and Republic F-105 Thunderchief over North Vietnam.
The Lavochkin La-7 was a piston-engined single-seat Soviet fighter aircraft developed during World War II by the Lavochkin Design Bureau. It was a development and refinement of the Lavochkin La-5, and the last in a family of aircraft that had begun with the LaGG-1 in 1938. Its first flight was in early 1944 and it entered service with the Soviet Air Forces later in the year. A small batch of La-7s was given to the Czechoslovak Air Force the following year, but it was otherwise not exported. Armed with two or three 20 mm (0.8 in) cannon, it had a top speed of 661 kilometers per hour (411 mph). The La-7 was felt by its pilots to be at least the equal of any German piston-engined fighter. It was phased out in 1947 by the Soviet Air Force, but served until 1950 with the Czechoslovak Air Force.
The Lockheed D-21 is an American supersonic reconnaissance drone. The D-21 was initially designed to be launched from the back of an M-21 carrier aircraft, a variant of the Lockheed A-12 aircraft. The drone had maximum speed in excess of Mach 3.3 at an operational altitude of 90,000 feet. Development began in October 1962. Originally known by the Lockheed designation Q-12, the drone was intended for reconnaissance deep into enemy airspace.
The Yakovlev Yak-25 was a swept wing, turbojet-powered interceptor and reconnaissance aircraft built by Yakovlev and used by the Soviet Union.
The Yakovlev Yak-15 was a first-generation Soviet turbojet fighter developed by the Yakovlev design bureau (OKB) immediately after World War II. The main fuselage was that of Yakovlev Yak-3 piston-engine fighter modified to mount a reverse-engineered German Junkers Jumo 004 engine. The Yak-15 and the Swedish Saab 21R were the only two jets to be successfully converted from piston-power to enter production. 280 aircraft were built in 1947. Although nominally a fighter, it was mainly used to qualify piston-engine-experienced pilots to fly jets.
The Kuznetsov Design Bureau was a Russian design bureau for aircraft engines, administrated in Soviet times by Nikolai Dmitriyevich Kuznetsov. It was also known as (G)NPO Trud and Kuybyshev Engine Design Bureau (KKBM).
The Lockheed DC-130 was a variant of the C-130 Hercules, designed for drone control. It could carry four Ryan Firebee drones underneath its wings.
The AQM-35 was a supersonic target drone produced by the Northrop Corporation.
The Lavochkin La-250 "Anakonda" was a high-altitude interceptor aircraft prototype developed in the Soviet Union by the Lavochkin design bureau in the 1950s. Its nickname "Anaconda" was invented during the flight test and referred to both the elongated body shape as well as the relatively critical flight characteristics of the machine.
The Tumansky R-15 is an axial flow, single shaft turbojet with an afterburner. Its best known use is on the Mikoyan-Gurevich MiG-25.
The Klimov RD-33 is a turbofan jet engine for a lightweight fighter jet that is the primary engine for the Mikoyan MiG-29 and CAC/PAC JF-17 Thunder. It was developed in OKB-117 led by S. P. Izotov from 1968 with production starting in 1981. Previous generations of Russian supersonic fighters such as the MiG-21 and MiG-23 used turbojets, but western fighters such as the F-111 and F-4K introduced the use of afterburning turbofans in the 1960s which were more efficient.
The Ryan Firebee is a series of target drones developed by the Ryan Aeronautical Company beginning in 1951. It was one of the first jet-propelled drones, and remains one of the most widely used target drones ever built.
The Tupolev Tu-123 Yastreb was one of the earliest Soviet reconnaissance drones that began development in 1960. Sometimes referred to as the "DBR-1", it was introduced into active service in 1964.
The Lavochkin La-150, was designed by the Lavochkin design bureau (OKB) in response to a 1945 order to build a single-seat jet fighter using a single German turbojet. By this time both the Americans and British, as well as the Germans, had already flown jet fighters and the single Soviet jet engine under development was not yet ready for production. The design was completed quickly, but the construction of the five flying prototypes was protracted by the factory's inexperience in building metal aircraft. The aircraft made its first flight in September 1946, but proved to require extensive modifications to meet the Soviet Air Forces' requirements. These took so long to make and test that the aircraft was essentially obsolete by the time that they were completed. Even one variant with a much more powerful engine was inferior to other aircraft that the OKB had under development and all work was terminated in 1947.
The Lavochkin La-152,, and its variants, was a jet fighter prototype designed and manufactured by the Lavochkin Design Bureau (OKB) shortly after the end of World War II. Derived from the Lavochkin La-150, the 152 used several different engines, but the program was canceled as other fighters with more powerful engines and swept wings showed more promise.
The Lavochkin La-160, known as Strelka (Arrow), was the first Soviet swept-winged jet fighter research prototype. It was designed and manufactured by the Lavochkin Design Bureau from 1946. USAF reporting name - Type 6
The Lavochkin La-200 was a two-seater, swept winged, night/all-weather jet interceptor designed and manufactured by the Soviet Union's Lavochkin Design Bureau from 1948.
The Mikoyan-Gurevich I-320 was a prototype Soviet long-range all-weather interceptor aircraft of the late 1940s-early 1950s. Only two were made, with no production following.
The Nanjing CK-1 is a radio-controlled target drone developed by the Nanjing Institute of Aeronautics in the People's Republic of China. It is based on the reverse engineering of Lavochkin La-17C drones supplied to the PRC by the Soviet Union in the early 1960s before all such Soviet technical aid to the nation was withdrawn. Its chief designer was General Zhao Xu and the first example flew on December 6, 1966.
 | Wikimedia Commons has media related to Lavochkin La-17 . |
This article contains material that originally came from the web article Unmanned Aerial Vehicles by Greg Goebel, which exists in the Public Domain.
