Spijker V.1

V.1
Role	Single seat fighter aircraft
National origin	Netherlands
Manufacturer	Spijker (from March 1914 the Nederlands Automobile and Aeroplane Co.), Trompenburg.
Designer	Fransman Vannehard and Albert Gilles Von Baumgarter
First flight	31 March 1917
Introduction	1917
Retired	1920
Primary user	MLD
Number built	1

Last updated May 04, 2021

The Spijker, Spyker V.1 or Spyker-Trompenburg V.1, was a single seat biplane fighter built in the Netherlands during World War I. It was underpowered and did not go into production.

Design and development

After the outbreak of World War I it was difficult for the neutral Dutch armed forces to obtain aircraft from abroad and so the Ammunition Agency approached the Nederlands Automobile and Aeroplane Co. for an indigenous fighter. This request resulted in the Spijker V.1, a conventionally laid out tractor biplane powered by a 60 kW (80 hp) Swedish licence built Thulin Gnôme rotary engine. It was a single bay design with pairs of parallel interplane struts assisted by four parallel cabane struts between the central upper wing and the fuselage. There was neither stagger nor sweep to the fabric covered wings, which had constant chord and squared tips. A semi-circular cut-out in the upper wing trailing edge over the cockpit enhanced the pilot's upward view.^[1]

The V.1's fuselage was rectangular in cross-section, with the engine partially enclosed by a helmet shaped cowling open at the bottom. The open, single seat cockpit was over the wing trailing edge. The tailplane, carrying separate elevators, was mounted on the top of the fuselage and wire-braced to the fin; the rounded rudder extended to the keel. The V.1 had a fixed, conventional undercarriage with mainwheels on a single axle supported by two V-form pairs of struts, originally curved but straight by May 1917. There was a small tail skid mounted forward of the elevator.^[1]

Operational history

The prototype was complete by late 1916 but concerns over structural strength and some engine tuning delayed the first flight until 31 March 1917, flown by Floris Albert Van Heyst. Test flights led to aerobatics and Van Heyst became the first Dutchman to execute a loop in a military aircraft. Nonetheless, its low powered engine did not provide high enough performance for a fighter and no more powerful engines were immediately available in the Netherlands. No more V.1s were built; the prototype was bought by the Netherlands Naval Aviation Service in 1917 and retired in 1920.^[1]

Specifications

The Spijker V.1 in its early form with curved undercarriage front legs and no cut-out in the upper wing SpykerB.png — The Spijker V.1 in its early form with curved undercarriage front legs and no cut-out in the upper wing

Data from Wesselink^[1]

General characteristics

Crew: One
Length: 7.50 m (24 ft 7 in)
Wingspan: 9.50 m (31 ft 2 in)
Powerplant: 1 × Thulin rotary engine, 60 kW (80 hp)
Propellers: 2-bladed

Performance

Maximum speed: 138 km/h (86 mph, 75 kn)

Related Research Articles

The Siemens-Schuckert DDr.I was a World War I German twin engine, push-pull configuration triplane fighter aircraft. Only one was built, crashing on its first flight.

The FVM Ö 1 Tummelisa is a single seat, single engine Swedish biplane from the 1920s. It was operated by the Swedish Air Force as its advanced trainer until the mid-1930s.

The Gabardini biplane was an Italian single seat biplane, designed and built near the beginning of World War I. It was an advanced trainer and could be fitted with engines of output between about 40 to 80 kW.

The Spijker V.2, sometimes anglicized to Spyker V.2 or Spyker-Trompenburg V.2, was a low powered, tandem seat biplane designed and built for the Dutch government for pilot training towards the end of World War I. More than seventy were built.

The Spijker V.3, sometimes anglicized to Spyker V.3 or Spyker-Trompenburg V.3, was a Dutch single-engine, single-seat biplane fighter, designed and built just before the end of World War I.

The Pander E was the first indigenous Dutch training aircraft, used by clubs and also privately owned. A two-seat, single-engine biplane, 17 were built in the Netherlands from 1926 with engines of increasing power.

The Koolhoven F.K.47 was a 1930s one-off two seat biplane designed and built in the Netherlands for an individual customer as a sport and touring aircraft.

The NVI F.K.29 was a small Dutch biplane transport, carrying two passengers who boarded after the nose, with its single engine and fuselage, had been swung open. It was intended to link small local fields to main airports.

The NVI F.K.32 was a tandem two seat biplane training aircraft designed and built in the Netherlands in the mid-1920s. It did not go into service.

The Kondor E 3, sometimes erroneously known as E.III, was a German single seat, monoplane fighter aircraft designed and built close to the end of World War I. Though successful in the third D-type fighter competition at Aldershof in September 1918, only a few were produced, given the Idflieg designation of Kondor D.I.

The Kondor D 6 was a prototype German biplane fighter aircraft flown in 1918. In the interests of better upward vision for the pilot, its upper wing was in two halves, separated over the central fuselage. Its development was soon abandoned.

The Pfalz D.VII was a German biplane fighter aircraft from World War I. It was not put into production.

The Weymann W-1 was a French single seat biplane fighter aircraft, built during World War I. It had a most unusual layout, with an engine buried in the fuselage driving a pusher configuration propeller behind a cruciform tail. It was not successful and soon abandoned.

The Letov Š-3 was a single-seat, single-engine parasol wing fighter aircraft designed and built in Czechoslovakia in the early 1920s. Only one was completed and flown, its makers preferring to develop a biplane fighter.

The Hanriot HD.5 was a French two-seat fighter aircraft prototype, built towards the end of World War I. A single-engine biplane with an unusually narrow gap between the upper and lower wings, it did not enter production.

The LFG Roland D.IX was a World War I German single seat fighter aircraft, a biplane powered by one of a new generation of powerful rotary engines. Three slightly different prototypes were built but there was no series production.

The LFG Roland D.XVI, initially designated the LFG Roland E.I, was a single-seat, single-engine, parasol wing German fighter aircraft flown close to the end of World War I. Only two were built.

The Schütte-Lanz D.VI was a single engine, parasol wing fighter aircraft designed and built in Germany towards the end of World War I. It had a very short career, crashing on its first flight.

The Schütte-Lanz D.VII was a single engine, biplane fighter aircraft designed and built in Germany towards the end of World War I.

The Caudron 02 was a French high altitude single seat fighter that was flown in November 1917.

References

1 2 3 4 5 6 Wesselink, Theo; Postma, Thijs (1982). De Nederlandse vliegtuigen. Haarlem: Romem. pp. 13–4. ISBN 90 228 3792 0.

This page is based on this Wikipedia article
Text is available under the CC BY-SA 4.0 license; additional terms may apply.
Images, videos and audio are available under their respective licenses.

[DNV-1] 1 2 3 4 5 6 Wesselink, Theo; Postma, Thijs (1982). De Nederlandse vliegtuigen. Haarlem: Romem. pp. 13–4. ISBN 90 228 3792 0.

[1]