Unimolecular ion decomposition

Last updated

Unimolecular ion decomposition is the fragmentation of a gas phase ion in a reaction with a molecularity of one. [1] Ions with sufficient internal energy may fragment in a mass spectrometer, which in some cases may degrade the mass spectrometer performance, but in other cases, such as tandem mass spectrometry, the fragmentation can reveal information about the structure of the ion.

Contents

Wahrhaftig diagram

Wahrhaftig diagram showing the relationship between internal energy and unimolecular ion decomposition for a hypothetical ion ABCD . Wahrhaftig Diagram.gif
Wahrhaftig diagram showing the relationship between internal energy and unimolecular ion decomposition for a hypothetical ion ABCD .

A Wahrhaftig diagram (named after Austin L. Wahrhaftig) illustrates the relative contributions in unimolecular ion decomposition of direct fragmentation and fragmentation following rearrangement. The x-axis of the diagram represents the internal energy of the ion. The lower part of the diagram shows the logarithm of the rate constant k for unimolecular dissociation whereas the upper portion of the diagram indicates the probability of forming a particular product ion. The green trace in the lower part of the diagram indicates the rate of the rearrangement reaction given by

and the blue trace indicates the direct cleavage reaction

A rate constant of 106 s−1 is sufficiently fast for ion decomposition within the ion source of a typical mass spectrometer. Ions with rate constants less than 106 s−1 and greater than approximately 105 s−1 (lifetimes between 10−5 and 10−6 s) have a high probability of decomposing in the mass spectrometer between the ion source and the detector. These rate constants are indicated in the Wahrhaftig diagram by the log k = 5 and log k = 6 dashed lines.

Indicated on the rate constant plot are the reaction critical energy (also called the activation energy) for the formation of AD+, E0(AD+) and AB+, E0(AB+). These represent the minimum internal energy of ABCD+ required to form the respective product ions: the difference in the zero point energy of ABCD+ and that of the activated complex.

When the internal energy of ABCD+ is greater than Em(AD+), the ions are metastable (indicated by m*); this occurs near log k > 5. A metastable ion has sufficient internal energy to dissociate prior to detection. [2] [3] The energy Es(AD+) is defined as the internal energy of ABCD+ that results in an equal probability that ABCD+and AD+ leave the ion source, which occurs at near log k = 6. When the precursor ion has an internal energy equal to Es(AB+), the rates of formation of AD+ and AB+ are equal.

Thermodynamic and kinetic effects

Schematic of "tight" and "loose" transition state complexes for a hypothetical ion ABCD . ABCD transition states.png
Schematic of "tight" and "loose" transition state complexes for a hypothetical ion ABCD .

Like all chemical reactions, the unimolecular decomposition of ions is subject to thermodynamic versus kinetic reaction control: the kinetic product forms faster, whereas the thermodynamic product is more stable. [4] In the decomposition of ABCD+, the reaction to form AD+ is thermodynamically favored and the reaction to form AB+is kinetically favored. This is because the AD+ reaction has favorable enthalpy and the AB+ has favorable entropy.

In the reaction depicted schematically in the figure, the rearrangement reaction forms a double bond B=C and a new single bond A-D, which offsets the cleavage of the A-B and C-D bonds. The formation of AB+ requires bond cleavage without the offsetting bond formation. However, the steric effect makes it more difficult for the molecule to achieve the rearrangement transition state and form AD+. The activated complex with strict steric requirements is referred to as a "tight complex" whereas the transition state without such requirements is called a "loose complex."

See also

Related Research Articles

Metastability stable state of a dynamical system other than the systems state of least energy

In physics, metastability is a stable state of a dynamical system other than the system's state of least energy. A ball resting in a hollow on a slope is a simple example of metastability. If the ball is only slightly pushed, it will settle back into its hollow, but a stronger push may start the ball rolling down the slope. Bowling pins show similar metastability by either merely wobbling for a moment or tipping over completely. A common example of metastability in science is isomerisation. Higher energy isomers are long lived because they are prevented from rearranging to their preferred ground state by barriers in the potential energy.

Mass spectrometry (MS) is an analytical technique that measures the mass-to-charge ratio of ions. The results are typically presented as a mass spectrum, a plot of intensity as a function of the mass-to-charge ratio. Mass spectrometry is used in many different fields and is applied to pure samples as well as complex mixtures.

Electron ionization Ionization technique

Electron ionization is an ionization method in which energetic electrons interact with solid or gas phase atoms or molecules to produce ions. EI was one of the first ionization techniques developed for mass spectrometry. However, this method is still a popular ionization technique. This technique is considered a hard ionization method, since it uses highly energetic electrons to produce ions. This leads to extensive fragmentation, which can be helpful for structure determination of unknown compounds. EI is the most useful for organic compounds which have a molecular weight below 600. Also, several other thermally stable and volatile compounds in solid, liquid and gas states can be detected with the use of this technique when coupled with various separation methods.

Tandem mass spectrometry

Tandem mass spectrometry, also known as MS/MS or MS2, is a technique in instrumental analysis where two or more mass analyzers are coupled together using an additional reaction step to increase their abilities to analyse chemical samples. A common use of tandem-MS is the analysis of biomolecules, such as proteins and peptides.

In physical organic chemistry, a kinetic isotope effect (KIE) is the change in the reaction rate of a chemical reaction when one of the atoms in the reactants is replaced by one of its isotopes. Formally, it is the ratio of rate constants for the reactions involving the light (kL) and the heavy (kH) isotopically substituted reactants (isotopologues):

Electron-capture dissociation

Electron-capture dissociation (ECD) is a method of fragmenting gas-phase ions for structure elucidation of peptides and proteins in tandem mass spectrometry. It is one of the most widely used techniques for activation and dissociation of mass selected precursor ion in MS/MS. It involves the direct introduction of low-energy electrons to trapped gas-phase ions.

Gas phase ion chemistry is a field of science encompassed within both chemistry and physics. It is the science that studies ions and molecules in the gas phase, most often enabled by some form of mass spectrometry. By far the most important applications for this science is in studying the thermodynamics and kinetics of reactions. For example, one application is in studying the thermodynamics of the solvation of ions. Ions with small solvation spheres of 1, 2, 3... solvent molecules can be studied in the gas phase and then extrapolated to bulk solution.

Electron-transfer dissociation a method of breaking proteins and other complex macromolecules into fragments in order to analyze their structures and functions

Electron-transfer dissociation (ETD) is a method of fragmenting multiply-charged gaseous macromolecules in a mass spectrometer between the stages of tandem mass spectrometry (MS/MS). Similar to electron-capture dissociation, ETD induces fragmentation of large, multiply-charged cations by transferring electrons to them. ETD is used extensively with polymers and biological molecules such as proteins and peptides for sequence analysis. Transferring an electron causes peptide backbone cleavage into c- and z-ions while leaving labile post translational modifications (PTM) intact. The technique only works well for higher charge state peptide or polymer ions (z>2). However, relative to collision-induced dissociation (CID), ETD is advantageous for the fragmentation of longer peptides or even entire proteins. This makes the technique important for top-down proteomics. The method was developed by Hunt and coworkers at the University of Virginia.

Time-of-flight mass spectrometry method of mass spectrometry

Time-of-flight mass spectrometry (TOFMS) is a method of mass spectrometry in which an ion's mass-to-charge ratio is determined via a time of flight measurement. Ions are accelerated by an electric field of known strength. This acceleration results in an ion having the same kinetic energy as any other ion that has the same charge. The velocity of the ion depends on the mass-to-charge ratio. The time that it subsequently takes for the ion to reach a detector at a known distance is measured. This time will depend on the velocity of the ion, and therefore is a measure of its mass-to-charge ratio. From this ratio and known experimental parameters, one can identify the ion.

Robert Graham Cooks is the Henry Bohn Hass Distinguished Professor of Chemistry in the Aston Laboratory of Mass Spectrometry at Purdue University. He is an ISI Highly Cited Chemist, with over 1,000 publications and an H-index of 94.

Mass spectral interpretation

Mass spectral interpretation is the method employed to identify the chemical formula, characteristic fragment patterns and possible fragment ions from the mass spectra. Mass spectra is a plot of relative abundance against mass-to-charge ratio. It is commonly used for the identification of organic compounds from electron ionization mass spectrometry. Organic chemists obtain mass spectra of chemical compounds as part of structure elucidation and the analysis is part of many organic chemistry curricula.

Mass-analyzed ion-kinetic-energy spectrometry

Mass-analyzed ion kinetic-energy spectrometry (MIKES) is a mass spectrometry technique by which mass spectra are obtained from a sector instrument that incorporates at least one magnetic sector plus one electric sector in reverse geometry. The accelerating voltage V, and the magnetic field B, are set to select the precursor ions of a particular m/z. The precursor ions then dissociate or react in an electric field-free region between the two sectors. The ratio of the kinetic energy to charge of the product ions are analyzed by scanning the electric sector field E. The width of the product ion spectrum peaks is related to the kinetic energy release distribution for the dissociation process.

Electron capture ionization is the ionization of a gas phase atom or molecule by attachment of an electron to create an ion of the form . The reaction is

Selected reaction monitoring

Selected reaction monitoring (SRM) is a method used in tandem mass spectrometry in which an ion of a particular mass is selected in the first stage of a tandem mass spectrometer and an ion product of a fragmentation reaction of the precursor ion is selected in the second mass spectrometer stage for detection.

Fragmentation (mass spectrometry)

In mass spectrometry, fragmentation is the dissociation of energetically unstable molecular ions formed from passing the molecules in the ionization chamber of a mass spectrometer. The fragments of a molecule cause a unique pattern in the mass spectrum. These reactions are well documented over the decades and fragmentation pattern is useful to determine the molar weight and structural information of the unknown molecule.

An ion-neutral complex in chemistry is an aggregate of an ion with one or more neutral molecules in which at least one of the partners has a rotational degree of freedom about an axis perpendicular to the intermolecular direction In chemistry, the dissociation of a molecule into two or more fragments can take place in the gas phase, provided there is sufficient internal energy for the requisite barriers to be overcome.

Collision-induced dissociation A mass spectrometry technique to induce fragmentation of selected ions in the gas phase

Collision-induced dissociation (CID), also known as collisionally activated dissociation (CAD), is a mass spectrometry technique to induce fragmentation of selected ions in the gas phase. The selected ions are usually accelerated by applying an electrical potential to increase the ion kinetic energy and then allowed to collide with neutral molecules. In the collision some of the kinetic energy is converted into internal energy which results in bond breakage and the fragmentation of the molecular ion into smaller fragments. These fragment ions can then be analyzed by tandem mass spectrometry.

Photoelectron photoion coincidence spectroscopy (PEPICO) is a combination of photoionization mass spectrometry and photoelectron spectroscopy. It is largely based on the photoelectric effect. Free molecules from a gas-phase sample are ionized by incident vacuum ultraviolet (VUV) radiation. In the ensuing photoionization, a cation and a photoelectron are formed for each sample molecule. The mass of the photoion is determined by time-of-flight mass spectrometry, whereas, in current setups, photoelectrons are typically detected by velocity map imaging. Electron times-of-flight are three orders of magnitude smaller than ion ones, which means that the electron detection can be used as a time stamp for the ionization event, starting the clock for the ion time-of-flight analysis. In contrast with pulsed experiments, such as REMPI, in which the light pulse must act as the time stamp, this allows to use continuous light sources, e.g. a discharge lamp or a synchrotron light source. No more than several ion–electron pairs are present simultaneously in the instrument, and the electron–ion pairs belonging to a single photoionization event can be identified and detected in delayed coincidence.

John H. Beynon Welsh chemist and physicist

John H. Beynon FRS was a Welsh chemist and physicist known for his work in mass spectrometry.

References

  1. ↑ Brenton, A G; Morgan, R P; Beynon, J H (1979). "Unimolecular Ion Decomposition". Annual Review of Physical Chemistry. 30: 51–78. Bibcode:1979ARPC...30...51B. doi:10.1146/annurev.pc.30.100179.000411.
  2. ↑ IUPAC , Compendium of Chemical Terminology , 2nd ed. (the "Gold Book") (1997). Online corrected version:  (2006–) " metastable ion (in mass spectrometry) ". doi : 10.1351/goldbook.M03874
  3. ↑ Hipple, J.; Condon, E. (1945). "Detection of Metastable Ions with the Mass Spectrometer". Physical Review. 68 (1–2): 54–55. Bibcode:1945PhRv...68...54H. doi:10.1103/PhysRev.68.54.
  4. ↑ Tureček, František; McLafferty, Fred W. (1993). Interpretation of mass spectra. Sausalito, Calif: University Science Books. p. 115. ISBN   0-935702-25-3.
This page is based on this Wikipedia article
Text is available under the CC BY-SA 4.0 license; additional terms may apply.
Images, videos and audio are available under their respective licenses.