AB Flygindustri Fi-1

Last updated
Flygindustri Fi-1
RoleSingle-seat intermediate training glider
National origin Sweden
Manufacturer AB Flygindustri, Halmstad
DesignerTord Lindman and Rudolf Abelin
First flight1942
Number built7

The AB Flygindustri Fi-1 was a Swedish intermediate training glider built in small numbers in the 1940s.

Contents

Design and development

What became AB Flygindustri was initially a canoe building factory founded by Rudolf Abelin, who had earlier worked in de Havilland's aircraft factory in England. His canoes had hulls formed with moulded veneers and he saw that these techniques could be used to produce glider fuselages. AB Flygindustri became the first Swedish glider company and began by building German aircraft under licence. [1]

The Fi-1 was originally intended to be an improved Grunau Baby but developed into a much more capable design. Its shoulder mounted wing was largely based on that of the DFS Olympia though reduced in span by 1.00 m (3 ft 3 in) to 14.00 m (45 ft 11 in) by clipping the Olympia's tips to produce a tetragonal, equal-tapered plan. It is built around a single spar and an inboard, internal, diagonal drag strut rearwards to the fuselage on each side. The leading edge is plywood-covered back to the spar and struts. Apart from some ply reinforcement around the Schempp-Hirth type spoiler mounted on the rear of the spar at around mid-span, the rest of the wing surface is fabric-covered. Its ailerons, also fabric-covered, fill less than half the trailing edge. [1] [2]

The glider has a pod-and-boom fuselage, constructed with techniques learned in canoe building. Both pod shell and boom, made separately, were shaped by glueing crisscrossed layers of veneer strips round a former and held down within a vacuum bag. The resulting shell was then stabilised by oven-baking for up to a day. The nose cone, made from glue-soaked rayon fabric, was also preformed. The pod shell was then attached to a steel tube skeleton which contains the cockpit under a multi-part canopy, placing the pilot above the wing leading edge. The rear of the cockpit is smoothly faired into the boom. Below, the pod carries the monowheel landing gear, placed under the forward wing, with a landing skid ahead of it. Behind the wheel the pod curves upwards on its underside to meet the slender boom just aft of the wing rather abruptly. [1]

The tail surfaces are fabric-covered apart from ply-reinforced leading edges of the tailplane and very narrow fin and the bottom of the rudder. The latter has a blunted triangular profile. In plan, the tailplane and elevators, mounted on top of the boom, are straight-tapered to rounded tips with a small cut-out for rudder movement. On its underside the boom has a ply-covered tail bumper. [1]

The Fi-1 first flew in 1942. Flight tests revealed a problem with the original canopy, which produced turbulence over the tail, but this was rapidly fixed. [1]

Operational history

The Fi-1 had been intended as a Grunau Baby replacement but emerged as too advanced for first-solo pilots and only seven were built. One went to Denmark; modified by students of the Polyteknisk Flyvergruppe in Copenhagen, it was flown by K.A. Rasmussen in the 1950 World Championships, held at Örebro. He finished in 18th place out of 29, a remarkable result for a trainer. The same aircraft was used to make the first Danish Gold C flight. [1]

Another Fi-1 was exported to Iceland in 1945 and registered as TF-SDR. [1]

Aircraft on display

Specifications

Data from j2mcl planeurs [4]

General characteristics

Performance

Related Research Articles

<span class="mw-page-title-main">Schneider Grunau 9</span> German single-seat glider, 1928

The ESG Grunau 9, later known as the ESG 29 and post-1933 as the DFS 108-10, was one of the first primary gliders, built in Germany from the late 1920s. It was widely sold.

The Akaflieg Darmstadt D-6 Geheimrat, often shortened to Darmstadt D-6 Geheimrat, was an early competition glider with a single seat and high cantilever wing, designed and built by German University students in 1922.

<span class="mw-page-title-main">Akaflieg Darmstadt D-7 Margarete</span> German two-seat glider, 1923

The Akaflieg Darmstadt D-7 Margarete, often shortened to Darmstadt D-7 Margarete, was one of the earliest two seat monoplane gliders, designed and built by German university students in 1923.

<span class="mw-page-title-main">Cijan-Obad Orao</span> Type of aircraft

The Cijan-Obad Orao is a competition single seat sailplane designed in Yugoslavia just after World War II, one of the most advanced of its type at the time. It flew in three World Gliding Championships, having greatest success at its first in 1950 when it reached third place.

The CVV1 Pinguino was a single seat, high performance glider designed and built in Italy in the mid-1930s, the first of a series of gliders from the Milan Polytechnic. It did not go into production.

The Aeronautica Lombarda AL-3 was an Italian sailplane, designed and built in 1939 to take part in the Olympic sailplane competition. It did so but was not successful.

The Bonomi BS.28 Alcione, sometimes known as the Lombarda BS.28 Alcione, was a single seat competition sailplane designed and built in Italy in 1937-8. About four were completed, with two more or less refined fuselages.

The GP1 was an Italian glider constructed by university students in Pavia in 1925. Only one was built.

<span class="mw-page-title-main">CVT2 Veltro</span> Type of aircraft

The CVT2 Veltro was an Italian competition glider built in the mid-1950s. Its advanced design incorporated a laminar flow wing, T-tail, retracting undercarriage and a reclining seat to reduce parasitic drag.

The Teichfuss Gabbiano was an Italian, one-off, single seat, high performance glider, designed by Luigi Teichfuss and flown in 1928.

The Teichfuss Grifo was an Italian training glider designed by Luigi Teichfuss and flown in 1934. It was built in small numbers.

The Teichfuss Astore was an Italian Intermediate single-seat trainer glider designed by Luigi Teichfuss and flown in 1936. Two were built.

The RRG Professor was a very early soaring glider and the first to use a variometer for finding thermals. It was designed by Alexander Lippisch in Germany, first flying in 1928. The Professor was widely built by both flying clubs and factories.

<span class="mw-page-title-main">RRG Falke</span> German single-seat glider, 1930

The RRG Falke of 1930 was a secondary training glider designed by Alexander Lippisch in Germany and intended to provide better performance than his earlier RRG Prüfling whilst being easier to fly because of its inherent stability. It was sold as plans for both club and commercial production and was built in Germany and abroad.

The Schneider Grunau 7 Moazagotl was a high-performance sailplane designed in Germany in 1933 specifically for fast, long distance flying using strong thermals. In 1937 it came second in the first World Gliding Championships, having previously made a flight of 300 km (186 mi).

The Schneider ESG 31 Schlesierland (Silesia) was a representative of a group of German, 16 m span, one-off gliders, built by Schneider in Grunau from 1929 to at least 1931.

The Emelyanov KIM-3 Stakanovets was a record breaking two seat glider, one of the first high performance sailplanes to use forward swept wings. It repeatedly set new international distance records in the late 1930s and early 1940s.

The Schneider ES-54 Gnome was an experimental low cost glider with a laminar flow but low aspect ratio wing, built in Australia in the mid-1950s. Its performance was predictably poor and only one was completed.

The Musger Mg 9 was a tandem two seat glider built in Austria in the mid-1930s. It broke both world and national records.

<span class="mw-page-title-main">Janka-Rotter Vándor</span> Type of aircraft

The Vándor (Wanderer) was a 1930s Hungarian single seat glider intended to ready students who had qualified on primary gliders for contemporary soaring and aerobatic aircraft. Only one was built.

References

  1. 1 2 3 4 5 6 7 Simons, Martin (2006). Sailplanes 1945-1965 (2nd revised ed.). Königswinter: EQIP Werbung & Verlag GmbH. pp.  112-13. ISBN   3 9807977 4 0.
  2. ↑ Simons, Martin (2006). Sailplanes 1920-1945 (2nd revised ed.). Königswinter: EQIP Werbung & Verlag GmbH. pp. 129–31. ISBN   3 9806773 4 6.
  3. ↑ "AB Flygindustri Fi-1 TF-SDR" . Retrieved 31 July 2019.
  4. ↑ "AB Flygindustri Fi-1" . Retrieved 27 July 2019.
This page is based on this Wikipedia article
Text is available under the CC BY-SA 4.0 license; additional terms may apply.
Images, videos and audio are available under their respective licenses.