Aero-Works Aerolite 103 | |
---|---|
![]() | |
Role | Ultralight aircraft |
National origin | United States |
Manufacturer | Aero-Works Inc. U-Fly-It Light Sport Aircraft, LLC |
Designer | Terry Raber |
First flight | October 1996 [1] |
Introduction | 1997 |
Status | 1997-2005 [2] 2013-present |
Number built | 150 (December 2004) [3] |
Variants | Wings Of Freedom Phoenix 103 |
The Aero-Works Aerolite 103 is an American single seat, high-wing, pusher configuration ultralight aircraft, designed by Terry Raber and introduced by Aero-Works, Inc, of Millersburg, Ohio, in 1997. The aircraft's model number indicates that it was designed to comply with the Federal Aviation Administration FAR 103 ultralight rules. [1] [4] [5] [6] [7]
Production of the aircraft ended in 2005 when the manufacturer went out of business. [2] The rights to the design were purchased by its original designer, the aircraft updated with an updated aluminum fuel tank and put back into production in 2013 by U-Fly-It Light Sport Aircraft, LLC of DeLand, Florida. [8] [9]
The aircraft was designed to meet the requirements of FAR 103 Ultralight Vehicles, including maximum 254 lb (115 kg) empty weight. [4] [6] [9]
The builder-achieved empty weights vary from 252 lb (114 kg) to 300 lb (136 kg), with 275 lb (125 kg) being typical. [10] To remain under the FAR 103 empty weight requires the use of a light-weight engine, such as the 35 hp (26 kW) 2si 460-F35 or the 28 hp (21 kW) Hirth F-33. [3] [7] [9]
The Aerolite 103 features a high wing with half-span flaps that are extended by use of an overhead bellcrank to a maximum of 40 degrees. The flight controls are three-axis and are actuated by a wheel mounted on a control column via flexible push-pull cables and conventional rudder pedals connected to the rudder by cables. The engine throttle is a twist-grip type and incorporates a brake lever to operate the non-differential mechanical drum brakes installed on the main wheels of the tricycle landing gear. [4] [6] [9]
The aircraft has conventional nose wheel steering connected to the rudder pedals. The main landing gear utilizes sprung-tubes for suspension and absorbing landing loads. There is a fourth small caster-wheel under the tail, because when the pilot's seat is unoccupied the aircraft rests on its tail, due to the aircraft's empty center of gravity. [4]
The Aerolite 103 is sold as an assembly kit aircraft. The kit includes an illustrated assembly manual and pre-built fuselage, wings, control surfaces, jury struts and struts. The wings are covered by the builder with pre-sewn Dacron envelopes. The company estimates the time to complete the airframe at 60–80 hours. The kit does not include powerplant, propeller or instruments. [11]
When the aircraft was first introduced the standard engine was the 35 hp (26 kW) 2si 460-F35, with the 40 hp (30 kW) Rotax 447 optional. [4] In 2009 the standard recommended engine was the Rotax 447, with the 46 hp (34 kW) Rotax 503 single carburettor engine optional. [6] [12] In 2021 an electric aircraft option was added as the manufacturer offered a complete electric drivetrain and up to four batteries as an alternative to gasoline powerplants. [13]
Aerobatics and spins are prohibited. [10]
Since its introduction the Aerolite 103 has won many awards, including: [5]
In December 2004 the company reported that 150 aircraft were flying, the majority as unregistered US ultralights. In July 2009 there were 12 Aerolite 103s registered as experimental amateur-builts in the USA. [3] [14]
On 15 September 2019, former NASCAR driver Mike Stefanik was killed in the crash of an Aerolite 103 at Riconn Airport near Greene, Rhode Island. [15]
Data from Aerolite 103 website [10] & KitPlanes [1]
General characteristics
Performance
Aircraft of comparable role, configuration, and era
The Aero Adventure Aventura is a family of ultralight amphibians marketed as a kit aircraft by Aero Adventure of DeLand, Florida. The aircraft was designed by Bob Bailey in 1995.
The ISON Airbike and Tandem Airbike are a family of American high-wing, tractor configuration ultralight aircraft, that were available in kit form. The single-seat Airbike was introduced in 1994 and the two-seat Tandem Airbike was unveiled in 1996.
The Avenger is a single-seat, Canadian low-wing, tractor configuration ultralight aircraft. The Avenger was introduced in 1994 and is available as a kit or as plans from Fisher Flying Products.
The Adams CA-2 is a single seat, low-wing, American ultralight aircraft that was designed by Frank Griffith of Corning Aircraft around 1992 and was available as plans for amateur construction until 1999. In 1999, Hummel Aviation of Bryan, Ohio began offering the design. Although the design was well received, plans were no longer listed as being available from Hummel Aviation as of 2007.
The Avid Champion is an American single-seat, high-wing ultralight aircraft that was produced starting in 1998 as a kit by Avid Aircraft of Caldwell, Idaho, later Ennis, Montana.
The Airdrome Dream Classic is a minimalist, high wing, single seat, single engine ultralight aircraft inspired by the 1908 Santos-Dumont Demoiselle and produced in kit form by Airdrome Aeroplanes of Holden, Missouri.
The Lockwood Drifter is a family of high wing, single engine, pusher configuration, open cockpit, one and two-seat kit aircraft that was first introduced in the 1980s by Maxair and remains in production today by Lockwood Aircraft of Sebring, Florida.
The Chotia Gypsy is an American single engine, high-wing, conventional landing gear-equipped ultralight aircraft that was designed by John Chotia in 1980.
The Flightstar is a large family of single and two-seat, high wing, single engined kit aircraft that was produced by Flightstar Sportplanes of South Woodstock, Connecticut. In 2009 the rights, tooling and parts inventory were sold to Yuneec International of China when Flightstar Sportplanes' business was wound up.
The Wings of Freedom Flitplane is an American single-seat, high-wing, single-engine ultralight aircraft that is available as a kit aircraft or as plans for amateur construction from Wings of Freedom of Hubbard, Ohio.
The Fisher FP-202 Koala is a Canadian single-seat high wing, conventional landing gear, single engined light kit aircraft designed for construction by amateur builders. The aircraft was inspired by the design of the Piper J-3 Cub and outwardly resembles that design.
The Fisher FP-404 is a Canadian single-seat, conventional landing gear, single-engined biplane kit aircraft designed for construction by amateur builders. Fisher Flying Products was originally based in Edgeley, North Dakota, USA but the company is now located in Woodbridge, Ontario, Canada.
The Fisher FP-606 Sky Baby is a Canadian single-seat, conventional landing gear or tricycle landing gear-equipped, single-engined, high-wing monoplane kit aircraft designed for construction by amateur builders. Fisher Flying Products was originally based in Edgeley, North Dakota, United States, but the company is now located in Woodbridge, Ontario, Canada.
The CGS Hawk is a family of high wing, strut-braced, pusher configuration, single and two-seats-in-tandem ultralight aircraft, designed by Chuck Slusarczyk and manufactured by CGS Aviation.
The Rans S-12 Airaile is a family of related American single-engined, pusher configuration, high-wing monoplanes designed by Randy Schlitter and manufactured by Rans Inc. The aircraft are available in kit form for amateur construction.
The RagWing RW4 Midwing Sport is a single seat, strut-braced mid wing, single engine ultralight aircraft designed by Roger Mann and sold as plans by RagWing Aircraft Designs for amateur construction.
The Loehle SPAD XIII is an American single-seat ultralight aircraft scale replica of the First World War SPAD XIII fighter produced in kit form by Loehle Aircraft for amateur construction.
The Carlson Sparrow is a family of American, high wing, strut-braced, single engine, ultralight aircraft that was designed by Ernst W. Carlson and produced by Carlson Aircraft of East Palestine, Ohio and later Skyline Technologies of Salem, Ohio for amateur construction.
The Howland H-3 Pegasus is an American ultralight aircraft that was designed by Bert Howland and made available by Howland Aero Design in the form of plans for amateur construction, with kits provided by Aircraft Spruce & Specialty Co. The H-3 first flew in 1988.
The Fletcher Hercules is an American two-seat ultralight trike that was designed by AW Harrison and produced by Fletcher's Ultralights of Turlock, California, in the late 1990s and early 2000s. The aircraft was supplied as a kit for amateur construction and was also available as a completed aircraft.