Albatros J.I

Last updated
Albatros J.I
Albatros J.I.jpg
RoleGround-attack aircraft
Manufacturer Albatros Flugzeugwerke
First flight 1917
Introduction 1917
Retired 1921
Primary users Luftstreitkräfte
Polish Air Force
Number built~240
Developed from Albatros C.XII

The Albatros J.I was an armored ground attack airplane designed and produced by the German aircraft manufacturer Albatros Flugzeugwerke. It saw active combat during the final months of the First World War.

Contents

The J.I was a "J-class" derivative of the Albatros C.XII reconnaissance aircraft; it shared both the wings and tail of the C.XII while adopting a new semi-armoured fuselage to protect its occupants from the anticipated ground fire from conducting low-altitude attack and reconnaissance missions over the battlefield. It was armed with three 7.92 mm (.312 in) machine guns, two of which were fixed in a downwards position for strafing ground targets. The heavy armouring around the crew compartment negatively impacted its performance capabilities.

During April 1918, units of the Luftstreitkräfte began receiving the J.I; it was commonly well-received by its crews due to its protection and good visibility. While the newer Albatros J.II began to replace it in frontline use only months later, the aircraft continued to be operated through to the Armistice of 11 November 1918 that ended the conflict. In addition to Germany, the J.I also was operated by Austria-Hungary, Poland, Norway, and Ukraine. Poland, which had captured ten aircraft during the Greater Poland Uprising, deployed them into combat during the Polish–Soviet War; the Ukrainian People's Army also used J.Is against the Soviet Union.

Design and development

A captured German Albatros J.I on display in the United States, circa 1919 German ground attack plane on display in the US c1919.jpg
A captured German Albatros J.I on display in the United States, circa 1919

The Albatros J.I was developed specifically as a "J-class" aircraft, which had the purpose of conducting low-altitude battlefield reconnaissance and ground-attack missions with the intended mission altitudes being around 50 meters (150 feet). Albatros' design team opted to develop the J.I as a derivative of the Albatros C.XII reconnaissance aircraft. In terms of its general configuration, the J.I shared both the wings and tail of the C.XII while adopting a new slab-sided fuselage, which was semi-armoured to protect its occupants from ground fire. [1] This steel plate armouring around the crew compartment, which weighed 490 kg (1,080 lb), came at a substantial cost in terms of performance. The poor climb performance was not deemed to be particularly impactful as the J.I was intended to continuously fly at a relatively low altitude throughout its entire mission profile. [2]

The overall design of the fuselage conformed to Albatros' established conventions, comprising multi-ply formers, six primary longerons, and skinned using plywood that was both pinned and glued to the structure. [1] While the bottom of the fuselage was flat, the top decking had an almost semi-circular curvature. Both the sides and bottom of the fuselage were covered by 5 mm thick chrome-nickel steel plate, which was bolted directly onto the wooden frame. [3] Aft of the cockpit, the exterior was covered by plywood instead. To avoid compromising the armour, there was no cutaway on either side of the forward cockpit to facilitate the pilot's entry and egress; instead, an outwards-folding panel was present. [4]

Unlike the C.XII, which was powered by the Mercedes D.IVa engine, capable of up to 190 kW (260 hp), the J.I was instead equipped with the Benz Bz.IV, which could produce up to 150 kW (200 hp); this choice in powerplant in combination with the considerably heavier fuselage was heavily responsible for the J.I's performance capabilities being marginal at best. [5] While partially covered by rounded sheet metal, the nose of the aircraft was unarmoured and thus the engine was left relatively unprotected. As a consequence of the nose's downwards sloping, pilots of the J.I enjoyed relatively favourable forward visibility. [2]

As a ground-attack aircraft, the J.I was armed with a pair of fixed 7.92 mm (.312 in) Spandau LMG 08/15 machine guns that faced downwards for the purpose of strafing ground targets; the observer was also provided with a separate freely-moving 7.92 mm Parabellum MG14 machine gun. [6]

Operational history

An Albatros J.I Albatros J.I - Ray Wagner Collection Image (21256885339).jpg
An Albatros J.I

During April 1918, units of the Luftstreitkräfte began receiving the J.I. Shortly thereafter, the type saw its combat debut during the Battle of the Lys. The J.I were typically issued to Flieger Abteilungen in support of the Army Corps or Army Headquarters; operationally, it was typically flown in flights comprising three to six aircraft at a time. [6] The type was relatively popular amongst its crews, often due to the armor protection provided and the good visibility facilitated by its low set engine. It was commonly deemed to be an operational success, although a frequent criticism of the J.I was that its armour was still inadequate.

By June 1918, the new Albatros J.II had started to replace J.I at the front. Nevertheless, the older aircraft nevertheless served until the end of the conflict. Two were bought by Austria-Hungary. After the conflict, J.Is remained in operation for a time with several nations, including Poland, Norway, and Ukraine. Poland was the largest post-war user of the type, operating 10 aircraft, which were captured during the Greater Poland Uprising. [7] These J.Is were used during the Polish–Soviet War. Additionally, between September 1920 and February 1921, four aircraft were lent by the Polish to an allied 1st Zaporizhska Aviation Escadrille of the Ukrainian People's Army. [7]

Operators

Flag of the German Empire.svg  German Empire
Flag of Poland.svg  Poland
Flag of Ukraine.svg  Ukraine

Specifications (J.I)

Albatros J.I drawing Albatros J.I dwg.jpg
Albatros J.I drawing

Data fromGerman Aircraft of the First World War [6]

General characteristics

Performance

Armament

See also

Related development

Aircraft of comparable role, configuration, and era

Related Research Articles

<span class="mw-page-title-main">AEG C.IV</span> Type of aircraft

The AEG C.IV was a two-seat biplane reconnaissance aircraft designed and produced by the German aircraft manufacturer Allgemeine Elektrizitäts-Gesellschaft.

<span class="mw-page-title-main">AEG J.I</span> Type of aircraft

The AEG J.I was a German biplane ground attack aircraft designed and produced by the German aircraft manufacturer Allgemeine Elektricitäts-Gesellschaft. It was a mission-specific derivative of the AEG C.IV reconnaissance aircraft.

<span class="mw-page-title-main">Albatros C.III</span> Type of aircraft

The Albatros C.III was a twin-seat general-purpose biplane designed and produced by the German aircraft manufacturer Albatros Flugzeugwerke. It was produced in greater numbers than any other C-type aircraft by Albatros as well as being the company's most-produced twin-seat aircraft.

<span class="mw-page-title-main">Albatros C.I</span> 1910s German aircraft

The Albatros C.I,, was a twin-seat general-purpose biplanes designed and produced by the German aircraft manufacturer Albatros Flugzeugwerke. It was the first of the successful C-series aircraft operated by the Luftstreitkräfte.

<span class="mw-page-title-main">Albatros B.II</span> Type of aircraft

The Albatros B.II, was an unarmed two-seat reconnaissance biplane designed and produced by the German aircraft manufacturer Albatros Flugzeugwerke. It was the aircraft that brought Albatros Flugzeugwerke to the world's attention.

<span class="mw-page-title-main">Albatros D.I</span> Type of aircraft

The Albatros D.I was an early fighter aircraft designed and produced by the German aircraft manufacturer Albatros Flugzeugwerke. It was the first of the Albatros D types which equipped the majority of the German and Austrian fighter squadrons (Jagdstaffeln) for the last two years of the First World War. Despite this, the D.I had a relatively brief operational career, having been rapidly eclipsed by rapid advances in fighter aircraft.

<span class="mw-page-title-main">Pfalz D.XII</span> Type of aircraft

The Pfalz D.XII was a German fighter aircraft built by Pfalz Flugzeugwerke. Designed by Rudolph Gehringer as a successor to the Pfalz D.III, the D.XII entered service in significant numbers near the end of the First World War. It was the last Pfalz aircraft to see widespread service. Though the D.XII was an effective fighter aircraft, it was overshadowed by the highly successful Fokker D.VII.

<span class="mw-page-title-main">Albatros W.4</span> 1916 fighter floatplane by Albatros

The Albatros W.4 was a military floatplane designed and produced by the German aircraft manufacturer Albatros Flugzeugwerke.

<span class="mw-page-title-main">Albatros C.V</span> Type of aircraft

The Albatros C.V was a military reconnaissance aircraft designed and produced by the German aircraft manufacturer Albatros Flugzeugwerke.

<span class="mw-page-title-main">Albatros C.VII</span> Type of aircraft

The Albatros C.VII was a military reconnaissance aircraft designed and produced by the German aircraft manufacturer Albatros Flugzeugwerke. It was a revised and re-engined development of the Albatros C.V, which had proved disappointing in service.

<span class="mw-page-title-main">Albatros C.X</span> Type of aircraft

The Albatros C.X was a military reconnaissance aircraft designed and produced by the German aircraft manufacturer Albatros Flugzeugwerke.

<span class="mw-page-title-main">Albatros C.XII</span> Type of aircraft

The Albatros C.XII was a military reconnaissance aircraft designed and produced by the German aircraft manufacturer Albatros Flugzeugwerke.

<span class="mw-page-title-main">Albatros C.XV</span> German military reconnaissance aircraft

The Albatros C.XV was a German military reconnaissance aircraft developed during World War I. It was essentially a refinement of the C.XII, which had been put into production in 1918. The war ended before any examples became operational. However, some found their way into civilian hands and flew as transport aircraft in peacetime under the factory designation L 47. Others saw service with the air forces of Russia, Turkey, and Latvia.

<span class="mw-page-title-main">Halberstadt C.V</span> Type of aircraft

The Halberstadt C.V was a German single-engined reconnaissance biplane of World War I, built by Halberstädter Flugzeugwerke. Derived from the Halberstadt C.III, with a more powerful supercharged 160 kW (220 hp) Benz Bz.IVü engine, it saw service only in the final months of the war. Cameras were mounted in the observer's cockpit floor.

<span class="mw-page-title-main">Halberstadt CL.IV</span> Type of aircraft

The Halberstadt CL.IV was a German ground attack aircraft of World War I.

<span class="mw-page-title-main">Gotha G.IV</span> German heavy bomber during World War I

The Gotha G.IV was a heavy bomber used by the Luftstreitkräfte during World War I. It was the first mass-produced relatively large airplane.

<span class="mw-page-title-main">Junkers J.I</span> Type of aircraft

The Junkers J.I was a German "J-class" armored sesquiplane of World War I, developed for low-level ground attack, observation and army cooperation. It is especially noteworthy as being the first all-metal aircraft to enter mass production; the aircraft's metal construction and heavy armour was an effective shield against small arms fire over the battlefield.

<span class="mw-page-title-main">Rumpler C.IV</span> Type of aircraft

The Rumpler C.IV was a German single-engine, two-seat reconnaissance biplane. It was a development of C.III with different tail surfaces and using a Mercedes D.IVa engine in place of the C.III's Benz Bz.IV. The Rumpler 6B 2 was a single-seat floatplane fighter variant with a 120 kW (160 hp) Mercedes D.III engine built for the Kaiserliche Marine.

<span class="mw-page-title-main">Halberstadt CL.II</span> German military aircraft in World War I

The Halberstadt CL.II was a German two-seat escort fighter/ground attack aircraft of World War I. It served in large numbers with the German Luftstreitkräfte in 1917-18.

<span class="mw-page-title-main">Rumpler D.I</span> Type of aircraft

The Rumpler D.I was a fighter-reconnaissance aircraft produced in Germany at the end of World War I. It was a conventional single-bay biplane with wings of unequal span braced by I-struts. It featured an open cockpit and a fixed, tailskid undercarriage. The upper wing was fitted with aerodynamically balanced ailerons and fuselage had an oval cross-section.

References

Citations

  1. 1 2 Grey and Thetford 1962, p. 53.
  2. 1 2 Grey and Thetford 1962, pp. 53-54.
  3. Grey and Thetford 1962, pp. 54-55.
  4. Grey and Thetford 1962, p. 54.
  5. Grey and Thetford 1962, pp. 36, 53.
  6. 1 2 3 Grey and Thetford 1962, p. 55.
  7. 1 2 Morgała 1997, p. 30.

Bibliography

Further reading