Couzinet 100

Last updated
Couzinet 100
RoleLarge touring aircraft
National origin France
Manufacturer Société Avions René Couzinet
Designer René Couzinet
First flight23 June 1933

The Couzinet 100 was a three-engined, three-seat touring aircraft designed and built in France in 1930. Two variants, the Couzinet 101 and Couzinet 103, were very similar apart from their engines; no variant reached production.

Contents

Design

The Couzinet 100 series of touring aircraft was broadly similar to its contemporary the Couzinet 20 but was smaller, with a span reduced to 84%, carried three rather than five and had a fixed undercarriage. It used similarly low-powered engines and had Couzinet's characteristic fin, formed from the fuselage. [1]

The Couzinet 101 had a one piece, low, cantilever wing, constructed entirely from wood, with a single spar which ran from tip to tip and a rear false spar interrupted by the cabin. It was plywood-skinned and thick at the root but thinned progressively outboard from below, providing a little dihedral. Chord was also large at the root, where the wing was generously faired into the fuselage. The plan became trapezoidal outboard with long, approximately elliptical tips. The straight part of the trailing edges were filled with long, narrow-chord ailerons carrying ground-adjustable trim tabs. [1]

Two of the 101's three 63 kW (85 hp), seven-cylinder Pobjoy R radial engines, enclosed in NACA cowlings, were mounted ahead of the leading edges on steel frames isolated on rubber blocks and toed outwards. The third was in the fuselage nose. All had their own oil tanks and fire extinguishers; fuel was stored in the wings. The fuselage was a wooden semi-monocoque formed with frames and stringers. The enclosed cabin seated three in tandem, with the pilot at the leading edge between the engines and the two passengers behind. Each occupant had both roof and side windows. Behind the cabin the fuselage curved upwards in Couzinet's distinctive way, the upper side narrowing to form a very broad-chord fin; its one-piece, almost triangular tailplane was built into the fuselage, carrying very narrow elevators. Like the ailerons, these had ground adjustable tabs. The rudder had a rather pointed tip but was curved and full; extending down to the keel, it operated in a slight elevator cut-out. [1]

All versions of the Couzinet 100 had fixed, tailwheel landing gear. When the Couzinet 100, powered by 34 kW (45 hp) Salmson 9 ADb radials made its first flight it had mainwheels in trouser fairings [2] and relied on low pressure tyres to absorb landing shocks. One flight was enough to see its return to the factory, where a more conventional three strut arrangement was installed. [3] The Couzinet 101 had similar gear, each wheel with a near-vertical oleo strut to the forward spar in the inner wing and a cranked axle and drag strut from the lower fuselage. The wheels, in spats, were below the outer engines with a track of 2.83 m (9 ft 3 in). The mainwheels had independent brakes and the tailwheel castored on its oleo strut. [1]

Development

The forward fuselage of the Couzinet 100 was on display at the 13th Paris Salon in November 1932. [4] [5] It first flew at Villacoublay on 23 June 1933. [3] The Pobjoy-engined 101 was there early in November, being prepared for flight and still referred to as the Couzinet 100. [6] It first flew between 11 and 18 November. [7] At the end of February 1934 it returned from tests with C.E.M.A. for modifications to the fuel system. [8]

The Couzinet 101 failed to attract buyers and the sole example, F-AMTJ, was the only Couzinet 100 series aircraft to be registered. It became one of the many unusual aircraft to be bought by the Spanish (Republican) government when the Spanish Civil War began in 1936. Its subsequent history is unknown. [9] [10]

Little is recorded about the Couzinet 103, which was powered by three 60 kW (80 hp) Salmson 9 ADr radials. [11]

Variants

Couzinet 100
3 × 34 kW (45 hp) Salmson 9 ADb. Flew 23 June 1930. [3] Trousered undercarriage initially. [2]
Couzinet 101
3 × 56 kW (75 hp) Pobjoy R. [1] Flew November 1933. [7]
Couzinet 103
3 × 60 kW (80 hp) Salmson 9 ADr. [11]

Specifications (Couzinet 101)

Data from Les Ailes January 1934 [1]

General characteristics

Performance

Related Research Articles

Potez 40

The Potez 40 was a French three-engine, braced high-wing monoplane designed and built in response to a French government programme for colonial transport and policing aircraft duties.

The Caudron C.220 was a two-seat French biplane trainer. Only two were built, using different engines.

The Dupuy D-40 was a French built, low powered monoplane designed for touring abroad. The only example was used for an uncompleted journey to Saigon.

Lorraine-Hanriot LH.70

The Lorraine-Hanriot LH.70 or S.A.B. LH.70 was a French trimotor designed to a 1930 government programme for a colonial policing aircraft. Only two were built.

Dewoitine D.430

The Dewoitine D.430 was a three-engine, high-wing monoplane designed for policing and other roles in France's colonies. It did not go into production.

The Potez 51 was a 1930s French intermediate trainer, intended to replace the ageing Potez 25 which had sold worldwide. It did not go into production.

The Weymann W-100, Weymann CTW-100 or Weymann W-100 RBL was a French three seat observation aircraft with a position for the observer within its partially glazed fuselage. Only one was built.

Potez 50 French biplane of the 1930s

The Potez 50 or Potez 50 A2 was a French two seat military multi-rôle aircraft, first flown in 1931. It did not go into service but seven variants using five different engines were produced, one of them setting several speed with useful load records and another, the Potez 506, setting three altitude world records.

Dewoitine D.480

The Dewoitine D.480 was a French single engine side-by-side sports and training aircraft built in the early 1930s. Two were completed and flew with several different radial engines. One remained active through the 1950s.

The Kellner-Béchereau 23 was a French two seat cabin touring aircraft, built in 1932. Its wing was constructed in a novel way. Only one was completed.

The Morane-Saulnier MS.300 and MS.301 were French parasol wing introductory trainer aircraft, first flown in 1930. They differed only in engine type. Neither reached production but were developed into two similar trainers, the MS.230 and MS.315, which were made in large numbers.

Guillemin JG.40

The Guillemin JG.40 was designed and built to meet a French government requirement for a small air ambulance capable of operating in the colonies. Two were completed and performed well but the JG.40 did not reach production.

Guillemin JG.10

The Guillemin JG.10 or Blériot-Guillemin JG.10 was a French two seat touring aircraft, designed to be as simple and safe to fly and maintain as a car, with similar facilities, as well as provision for parachutes.

Couzinet 20

The Couzinet 20 was a low power, three-engined aircraft designed in France in 1929 for postal duties, though it could have been configured to carry three passengers or as a medical transport. Variants flew with three different engines but only two airframes were completed.

The Hanriot H.34 was a basic trainer designed in France in 1924 which did not reach production. It was a parasol wing aircraft, seating two in tandem.

Aviméta 92

The Aviaméta 92 was a French, all-metal, five seat monoplane built in the late 1920s. Three different engines were fitted, and one example flew the first non-stop Paris-Algiers flight in preparation for an abandoned trans-Atlantic attempt.

Hanriot H.46 Styx

The Hanriot H.46 Styx was a French, single-engined, parasol wing aircraft which could equally be configured for training, liaison or ambulance roles; in the latter form it was able to accept a patient on a stretcher. Several different engines were fitted and flown but the type did not reach production.

Raab-Katzenstein RK.9 Grasmücke

The Raab-Katzenstein RK.9 Grasmücke (Hedge-sparrow) was a 1920s German two-seat touring, advertising and training biplane. It was one of many designs from several countries aiming to provide low cost flying and was quite successful, with about twenty built.

The Morane-Saulnier MS.152 was a French multi-purpose aircraft built in 1928. It did not go into production.

Albert A-10

The Albert A-10 was a four-seat French transport aircraft which could be rapidly converted into an air ambulance. Two or three examples were built between 1929 and 1932, using at least two different engines, but neither variant reached production.

References

  1. 1 2 3 4 5 6 Frachet, André (11 January 1934). "La limousine René Couzinet 101". Les Ailes (656): 3.
  2. 1 2 "Couzinet 100" . Retrieved 31 October 2016.
  3. 1 2 3 "Notules Techniques - Le petit trimoteur Couzinet". Les Ailes (629): 4. 6 July 1933.
  4. "Couzinet". Flight . XXIV (48): 1108. 24 November 1932.
  5. "Le Salon (image, left)". Les Ailes (597): 3. 24 November 1932.
  6. "Notules Techniques - en meme temps". Les Ailes (646): 3. 2 November 1933.
  7. 1 2 "Notules Techniques - chez Couzinet". Les Ailes (649): 18. 23 November 1933.
  8. "A Villacoublay". Les Ailes (664): 14. 8 March 1934.
  9. Bernard, Martin; Sparrow, Dave; Espérou, Bernard (March 2013). "F-1922 - The French Civil Register from 1922". Air Britain Archive: 2015/178.
  10. Howson, Gerald (1990). Aircraft of the Spanish Civil War. London: Putnam Aeronautical Books. p. 91. ISBN   0 85177 842 9.
  11. 1 2 Bruno Parmentier (23 April 2003). "Couzinet 103" . Retrieved 1 November 2016.
  12. Hirschauer, L.; Dollfus, Ch. (1934). L'Anné Aéronautique 1933–1934. Paris: Dunod. p. 29.

Further reading