Industrial stormwater

Last updated

Industrial stormwater is runoff from precipitation (rain, snow, sleet, freezing rain, or hail) that lands on industrial sites (e.g. manufacturing facilities, mines, airports). This runoff is often polluted by materials that are handled or stored on the sites, and the facilities are subject to regulations to control the discharges. [1] [2]

Contents

To manage industrial stormwater effectively, facilities use best management practices (BMPs) that aim to both prevent pollutants from entering the runoff and treat water before it's released from the site. Common preventive steps include maintaining clean workspaces, conducting routine equipment checks, storing materials properly, preventing spills, and training staff on pollution prevention techniques. [3]

To treat stormwater, facilities may install structural controls such as detention and retention ponds, constructed wetlands, filter systems, or oil-water separators. These systems help reduce pollution by settling out solids, filtering water, or supporting natural treatment processes before the water is discharged. [4]

Regulation in the United States

Deicing of aircraft. All U.S. airports are required to obtain stormwater permits A U.S. Army C-37B aircraft transporting Army Chief of Staff Gen. Raymond T. Odierno, gets de-iced before it departs Joint Base Elmendorf-Richardson, Alaska.jpg
Deicing of aircraft. All U.S. airports are required to obtain stormwater permits

In the United States, facilities that discharge industrial stormwater to surface waters must obtain a permit under the National Pollutant Discharge Elimination System (NPDES), pursuant to the Clean Water Act. [5] Stormwater permit regulations issued by the United States Environmental Protection Agency (EPA) govern the permit process. [6] EPA published its "Phase I" stormwater rule, which covers industrial dischargers, in 1990. [7]

Most stormwater permits in the U.S. are issued by the agencies in 47 states that have been given authority by EPA. EPA regional offices issue the stormwater permits in the remaining parts of the country. [8]

Many industrial sites are legally required to have a Stormwater Pollution Prevention Plan (SWPPP), which outlines the steps they’ll take to control and monitor runoff. In the U.S., this falls under regulations like the National Pollutant Discharge Elimination System (NPDES).

Ongoing inspections and monitoring are essential to ensure these controls are working as intended, identify issues early, and maintain compliance while protecting nearby waterways.

Multi-sector general permit

EPA published its Multi-Sector General Permit (MSGP) initially in 1995 to govern how industrial stormwater should be managed, and periodically it has updated and reissued the permit. The 2021 MSGP covers 30 industrial and commercial sectors: [9]

  1. Timber Products Facilities (including wood preservation)
  2. Paper and Allied Products Manufacturing Facilities
  3. Chemical and Allied Products Manufacturing and Refining
  4. Asphalt Paving and Roofing Materials and Manufacturers and Lubricant Manufacturers
  5. Glass, Clay, Cement, Concrete, and Gypsum Product Manufacturing Facilities
  6. Primary Metals Facilities
  7. Metal Mining (Ore Mining and Dressing) Facilities
  8. Coal Mines and Coal Mining-Related Facilities
  9. Oil and GasExtraction Facilities
  10. Mineral Mining and Processing Facilities
  11. Hazardous Waste Treatment, Storage, or Disposal Facilities
    12. Scrap yards must obtain stormwater permits and control stormwater runoff Junk yard, Jacksonville, FL.jpg
    Scrap yards must obtain stormwater permits and control stormwater runoff
  12. Landfills and Land Application Sites
  13. Automobile Salvage Yards
  14. Scrap Recycling and Waste Recycling Facilities
  15. Steam Electric Power Generating Facilities, including Coal Handling Areas
  16. Motor Freight Transportation Facilities, Passenger Transportation Facilities, Petroleum Bulk Oil Stations and Terminals, Rail Transportation Facilities, and United States Postal Service Transportation Facilities
  17. Water Transportation Facilities with Vehicle Maintenance Shops and/or Equipment Cleaning Operations
  18. Ship and Boat Building or Repair Yards
  19. Vehicle Maintenance Areas, Equipment Cleaning Areas, or Deicing Areas Located at Air Transportation Facilities
  20. Sewage treatment plants
  21. Food and Kindred Products Facilities
  22. Textile Mills, Apparel, and Other Fabric Products Manufacturing Facilities
  23. Wood and Metal Furniture and Fixture Manufacturing Facilities
  24. Printing and Publishing Facilities
  25. Rubber, Miscellaneous Plastic Products, and Miscellaneous Manufacturing Industries
  26. Leather Tanning and Finishing Facilities
  27. Fabricated Metal Products Manufacturing Facilities
  28. Transportation Equipment, Industrial, or Commercial Machinery Manufacturing Facilities
  29. Electronic and Electrical Equipment and Components, Photographic, and Optical Goods Manufacturing Facilities
  30. Other industrial facilities not in the above categories that are designated by the permit authority as needing a permit

The permit is applicable to facilities in Massachusetts, New Hampshire, New Mexico, the District of Columbia and federal insular areas (territories). The other states have developed their own state-specific industrial stormwater permits (e.g. California's Industrial General Permit). [10] State-issued general permits often include the same requirements as EPA's permit, but some states have additional requirements. [8]

A silt fence is a type of sediment control used on construction sites. Silt fence illus EPA.jpg
A silt fence is a type of sediment control used on construction sites.

Construction site stormwater

Under EPA regulations, stormwater runoff from construction sites is also classified as industrial stormwater, however these discharges are covered by a separate set of permits. EPA periodically publishes its Construction General Permit and the approved state agencies publish similar permits, to regulate discharges from construction sites of 1 acre (4,000 m2) or more. (Also covered are sites that are less than one acre in size, that are part of a larger common plan of development that will disturb more than 1 acre.) [11] In addition to implementing the NPDES requirements, many states and local governments have enacted their own stormwater management laws and ordinances, and some have published stormwater treatment design manuals. [12] [13] Some of these state and local requirements have expanded coverage beyond the federal requirements. For example, the State of Maryland requires erosion and sediment controls on construction sites of 5,000 sq ft (460 m2) or more. [14]

See also

References

  1. ↑ Müller, Alexandra; Österlund, Heléne; Marsalek, Jiri; Viklander, Maria (2020-03-20). "The pollution conveyed by urban runoff: A review of sources". Science of the Total Environment. 709. Elsevier. Bibcode:2020ScTEn.709m6125M. doi: 10.1016/j.scitotenv.2019.136125 . PMID   31905584.
  2. ↑ "Stormwater Discharges from Industrial Activities". Washington, D.C.: United States Environmental Protection Agency (EPA). 2022-11-28.
  3. ↑ US EPA, OW (2015-10-30). "Industrial Stormwater Fact Sheet Series". www.epa.gov. Retrieved 2025-03-24.
  4. ↑ US EPA, OW (2015-10-28). "Stormwater Discharges from Industrial Activities". www.epa.gov. Retrieved 2025-03-24.
  5. ↑ United States. Federal Water Pollution Control Amendments of 1972. Pub.L. 92-500, October 18, 1972; as amended by the Water Quality Act of 1987, Pub.L. 100-4, February 4, 1987. Section 402(p), 33 U.S.C.   § 1342(p).
  6. ↑ EPA. "Storm water discharges." EPA Administered Permit Programs: The National Pollutant Discharge Elimination System.Code of Federal Regulations, 40 CFR 122.26 .
  7. ↑ EPA (1990-11-16). "National Pollutant Discharge Elimination System Permit Application Regulations for Storm Water Discharges". Federal Register, 44 FR 47990.
  8. 1 2 "NPDES State Program Authority". National Pollutant Discharge Elimination System (NPDES). EPA. 2023-01-03.
  9. ↑ "Stormwater Discharges from Industrial Activities-EPA's 2021 MSGP". NPDES. EPA. 2022-12-22.
  10. ↑ "Industrial Storm Water Program". State Water Resources Control Board. California Environmental Protection Agency. 2016-03-22.
  11. ↑ "Stormwater Discharges from Construction Activities". NPDES. EPA. 2023-02-27.
  12. ↑ Washington State Department of Ecology (August 2012). Olympia, WA. "Stormwater Management Manual for Western Washington." Publication No. 12-10-030.
  13. ↑ Maryland Stormwater Design Manual (Report). Baltimore, MD: Maryland Department of the Environment. 2009.
  14. ↑ State of Maryland. Code of Maryland Regulations (COMAR). Activities for Which Approved Erosion and Sediment Control Plans are Required. Archived 2020-02-27 at the Wayback Machine Sec. 26.17.01.05.
This page is based on this Wikipedia article
Text is available under the CC BY-SA 4.0 license; additional terms may apply.
Images, videos and audio are available under their respective licenses.