Penrose Pegasus

Last updated

Pegasus
RoleSingle seat glider
National origin United Kingdom
DesignerH.J. Penrose
First flight21 July 1935
Number built1

The Penrose Pegasus was a 1930s high-wing, single-seat, wooden glider from the UK. Designed, built and flown by Harald Penrose until the start of World War II, only one was built at the time though a reproduction was constructed in the 1990s.

Contents

Design and development

In 1932 Penrose, Chief Test Pilot at Westland Aircraft from 1931–53, [1] began the design of a wooden single-seat glider. One unusual design constraint was that no component could be more the 12 ft 6 in (3.81 m) long in order for it to leave the workshop. [2]

The wing of the Pegasus had the same spar and planform as the unbuilt Cloudcraft Junior. It was constructed around a single box spar of spruce and plywood and had three sections, a parallel-chord centre section and two slightly longer, tapered outer panels with ailerons along the whole of their trailing edges. It was fabric covered and braced with lift struts to the lower fuselage longerons. Both rudder and elevator were all-moving surfaces, fabric covered and with rounded trailing edges. The rudder extended to the lower fuselage so the elevator, mounted on the upper fuselage, had a cut-out to allow its movement. [2] [3]

The Pegasus had a rectangular-section, ply-covered fuselage, which tapered towards the tail. The wing was braced above the fuselage by the struts and the open, unscreened cockpit was under the leading edge; fabric-covered, inverted V-shaped decking tapered from the lower wing surface rearwards. There was a short, curved landing skid fixed at the nose and joined to the lower longerons at the same point as the lift struts by a V-form pair of telescopic compression struts. Initially the Pegasus had a tailskid but flight trials showed that both skids were easily broken, so the main skid was replaced with a stiffer one and the tailskid by a rubber tailwheel. [2] [3]

Operational history

The Pegasus flew for the first time in 1935 and gained its British Gliding Association certificate of airworthiness no. BGA 232. Early test flights with the improved undercarriage were made in July and August at Maiden Newton, home of the Dorset Gliding Club. [4] It flew in the annual BGA competition held at Sutton Bank in late August 1935 as no.20. [5] Until the outbreak of war Penrose often flew the Pegasus from Kimmeridge, on the Dorset coast, at weekends. [6] The Pegasus survived World War II and afterwards underwent modifications, never completed, to enlarge the cockpit. This, the only example built, was later burnt. [2]

A reproduction of the Pegasus, called the Pegasus 2, flew in 1993 and is now on display at the Norfolk and Suffolk Aviation Museum. [7]

Specifications

Data from British Gliders and Sailplanes 1922-1970 [2]

General characteristics

Performance

Related Research Articles

The Slingsby Type 26 Kite 2 was a post World War II development of the Slingsby Kite, a single seat medium performance sailplane. It sold in small numbers.

Abbott-Baynes Scud 1

The Abbott-Baynes Scud 1 was a parasol-winged single seat glider intended to introduce pilots to soaring flight. It was built in the United Kingdom and first flew in 1931.

Abbott-Baynes Scud 2

The Abbott-Baynes Scud 2 was a 1930s high-performance sailplane, built in the UK. It was a development of the intermediate-level Scud 1 with a new, high aspect ratio wing.

The Czerwiński Sparrow, sometimes known as the de Havilland Canada glider, was a single seat glider, designed and built by a group of de Haviiland engineers in Canada in 1942. It was intended to popularise gliding and be suitable for both basic training and thermal soaring.

The Dart Totternhoe was a single seat secondary training glider produced in the United Kingdom in the 1930s. Three were built, one serving in the RAF.

Manuel Wren

The Manuel Crested and Willow Wrens formed a series of wooden, single-seat gliders designed in the UK by W. L. Manuel in the early 1930s, intended for slope soaring. Some were built by the designer, others from plans he supplied. The Dunstable Kestrel was a further development.

Scott Viking 1

The Scott Viking 1 was a single seat, high-performance glider designed and built in the UK just before the Second World War. Only four were constructed, one setting records in Argentina and another remaining active into the 1980s.

The Stedman TS-1 City of Leeds was a parasol wing wooden sailplane, seating two in tandem open cockpits. Only one was built, by its designer in 1934; it remained active until the outbreak of World War II.

Lippisch Wien

The Lippisch Wien was a high-performance glider designed by Alexander Lippisch in Germany in 1929. Owned and flown by Robert Kronfeld, it was one of the first sailplanes intended to exploit thermals. It set world records both for distance and altitude and demonstrated the practicality of long-distance cross-country flights.

The Teichfuss Astore was an Italian Intermediate single-seat trainer glider designed by Luigi Teichfuss and flown in 1936. Two were built.

The RRG Professor was a very early soaring glider and the first to use a variometer for finding thermals. It was designed by Alexander Lippisch in Germany, first flying in 1928. The Professor was widely built by both flying clubs and factories.

RRG Falke

The RRG Falke of 1930 was a secondary training glider designed by Alexander Lippisch in Germany and intended to provide better performance than his earlier RRG Prüfling whilst being easier to fly because of its inherent stability. It was sold as plans for both club and commercial production and was built in Germany and abroad.

RRG Prüfling

The 1926 German RRG Prüfling of 1926 was a secondary training glider designed for club use. Plans were sold and it was built in Germany and across the world.

Schleicher Poppenhausen

The Schleicher Poppenhausen named after the town of Poppenhausen was a two-seat glider, available as a dual control advanced trainer, produced in Germany from 1928.

The Schneider ESG 31 Schlesierland (Silesia) was a representative of a group of German, 16 m span, one-off gliders, built by Schneider in Grunau from 1929 to at least 1931.

The Schneider Grunau 8 was a simple, two-seat trainer glider designed and built in Germany in the early 1930s.

The Musger Mg 9 was a tandem two seat glider built in Austria in the mid-1930s. It broke both world and national records.

<i>Lore</i> (glider)

Lore and a copy, Musterle, were high performance sailplanes designed at Darmstadt by Paul Laubenthal. Lore was flown successfully by the well known glider pilot Wolf Hirth at the 1929 Rhön (Wasserkuppe) glider competition. Musterle was used by Hirth used to demonstrate the possibilities of "blue sky" thermalling for the first time.

Avia 41-P

The Avia 41-P was a high performance French glider. Eric Nessler set many new national gliding records in one between 1934 and 1938.

WS Czajka Polish secondary training glider

The Czajka or Kocjan Czajka after its designer was a Polish secondary training glider which was in continuous production from 1931 to the start of World War II. More than 160 were completed in Warsztaty Szybowcowe in Warsaw.

References

  1. ↑ "Obituary:Harald Penrose". Independent. 11 September 1996. Retrieved 28 October 2011.
  2. 1 2 3 4 5 Ellison, Norman (1971). British Gliders and Sailplanes. London: A & C Black Ltd. p. 154. ISBN   978-0-7136-1189-2.
  3. 1 2 "A Multum-in-Parvo Sailplane". Flight . Vol. XXVIII no. 1399. 17 October 1935.
  4. ↑ "Dorset Gliding Club" (PDF). The Sailplane & Glider. 6 (9): 158. September 1935.
  5. ↑ "The Sutton Bank Competitions" (PDF). The Sailplane & Glider. 6 (9): 147–155. September 1935.
  6. ↑ "Prototype Parade: Penrose Pegasus" (PDF). Radio Control Scale Aircraft: 45–8. Autumn 1989.
  7. ↑ Ellis, Ken (2010). Wrecks & Relics (22 ed.). Manchester: Crecy. p. 196. ISBN   978-0-85979-150-2.
This page is based on this Wikipedia article
Text is available under the CC BY-SA 4.0 license; additional terms may apply.
Images, videos and audio are available under their respective licenses.