Pilot-controlled lighting (PCL), also known as aircraft radio control of aerodrome lighting (ARCAL) or pilot-activated lighting (PAL), is a system that allows aircraft pilots to control the lighting of an airport or airfield's approach lights, runway edge lights, and taxiways via radio.
This section needs additional citations for verification . (February 2019) (Learn how and when to remove this template message) |
At some airfields, the airport/aerodrome beacon may also be ARCAL controlled. ARCAL is most common at non-towered airports or little-used airfields where it is neither economical to light the runways all night, nor to provide staff to turn the runway lighting on and off. It enables pilots to control the lighting only when required, saving electricity and reducing light pollution.
The ARCAL frequency for most aerodromes is usually the same as the UNICOM/CTAF frequency, although in some rare cases, a second ARCAL frequency may be designated to control the lighting for a second runway separately. An example of the latter is runway 18/36 at the airport in Sydney, Nova Scotia. To activate the lights, the pilot clicks the radio transmit switch on the ARCAL frequency a certain number of times within a specified number of seconds. [1] [2] There are two types of ARCAL systems — type J and type K.
Type J systems are activated by keying the microphone five times within five seconds, while type K is initially activated by clicking seven times within five seconds. Once activated, the intensity of type K systems may then be turned to low, medium, or high intensity settings by keying the microphone three, five, or seven times within five seconds, respectively. If runway identification lights are also controlled by type K ARCAL, they may be turned off by keying the microphone three times. [3]
When either type of system is activated, a 15-minute countdown starts, after which the lights turn off. While the lights are on, whenever a lighting command is issued, whether it changes the lighting intensity or not, the fifteen-minute countdown is reset. At some airfields, the lights may flash once to warn pilots that the lights are about to go off, before turning off two minutes later.
When using ARCAL, it is strongly recommended that aircraft on final approach to the airfield issue a fresh lighting command, even if the lights are already on, especially if the lights were activated by another aircraft. This is so that the lighting does not turn off at a critical moment, such as when crossing the runway threshold. When in operation, the receiver awaits a squelch break on the tuned VHF frequency and begins counting "clicks" in a five-second period to determine pilot intent. The pilot commanded output is held by the controller for a predetermined time interval (Federal Aviation Administration standard is 15 minutes) that is generally adjustable. The five-second click count period begins upon receipt of the first squelch break and the control sequence will respond to the click counts from three, five, seven and stop. As an example, cycling the microphone button rapidly 15 times in five seconds will command "three, five, seven". Similarly, slowly clicking seven times may result in the five-second timing period expiring prior to getting to the seventh input click.
In the United States, pilot-controlled lighting is governed by Federal Communications Commission Rule 87.187y. This section also lists the radio frequencies that are allowed to control runway lights via pilot-controlled lighting.
An airport is an aerodrome with extended facilities, mostly for commercial air transport. Airports often have facilities to park and maintain aircraft, and a control tower. An airport consists of a landing area, which comprises an aerially accessible open space including at least one operationally active surface such as a runway for a plane to take off and to land or a helipad, and often includes adjacent utility buildings such as control towers, hangars and terminals. Larger airports may have airport aprons, taxiway bridges, air traffic control centres, passenger facilities such as restaurants and lounges, and emergency services. In some countries, the US in particular, airports also typically have one or more fixed-base operators, serving general aviation.
According to the International Civil Aviation Organization (ICAO), a runway is a "defined rectangular area on a land aerodrome prepared for the landing and takeoff of aircraft". Runways may be a man-made surface or a natural surface. Runways, as well as taxiways and ramps, are sometimes referred to as "tarmac", though very few runways are built using tarmac. Runways made of water for seaplanes are generally referred to as waterways. Runway lengths are now commonly given in meters worldwide, except in North America where feet are commonly used.
In aviation, the instrument landing system (ILS) is a radio navigation system that provides short-range guidance to aircraft to allow them to approach a runway at night or in bad weather. In its original form, it allows an aircraft to approach until it is 200 feet (61 m) over the ground, within a 1⁄2 mile of the runway. At that point the runway should be visible to the pilot; if it is not, they perform a missed approach. Bringing the aircraft this close to the runway dramatically improves the weather conditions in which a safe landing can be made. Later versions of the system, or "categories", have further reduced the minimum altitudes.
A precision approach path indicator (PAPI) is a visual aid that provides guidance information to help a pilot acquire and maintain the correct approach to an airport or an aerodrome. It is generally located on the left-hand side of the runway approximately 300 meters beyond the landing threshold of the runway.
Common traffic advisory frequency (CTAF) is the name given to the VHF radio frequency used for air-to-air communication at United States, Canadian and Australian non-towered airports.
Essendon Fields Airport, colloquially known as Essendon Airport, is a 305 ha public airport serving scheduled commercial, corporate-jet, charter and general aviation flights. It is located next to the intersection of the Tullamarine and Calder Freeways, in the north western suburb of Essendon Fields of Melbourne, Victoria, Australia. The airport is the closest to Melbourne's City Centre, approximately a 13 km (8.1 mi) drive north-west from it and 8 km (5.0 mi) south-east from Melbourne Tullamarine Airport. In 1970, Tullamarine Airport replaced Essendon as Melbourne's main airport.
Whiteman Airport is a general aviation airport in the northeastern San Fernando Valley community of Pacoima, in the city of Los Angeles, California, United States.
Air France Flight 296 was a chartered flight of a new Airbus A320-111 operated by Air France for Air Charter. On 26 June 1988, the plane crashed while making a low pass over Mulhouse–Habsheim Airport as part of the Habsheim Air Show. Most of the crash sequence, which occurred in front of several thousand spectators, was caught on video. The cause of the crash has been the source of major controversy.
Ulukhaktok/Holman Airport, located at Ulukhaktok, Northwest Territories, Canada was fully opened in December 1978 with the start of the Community Aerodrome Radio Station (CARS). However, aircraft had been using the runway prior to that as construction was completed in the summer of 1978.
Runway edge lighting are used to outline the edges of runways during periods of darkness or restricted visibility conditions. These light systems are classified according to the intensity they are capable of producing:
Rimouski Aerodrome,, is a registered aerodome located 1.8 nautical miles northeast of Rimouski, Quebec, Canada. It only handles general aviation and cargo flights.
Athabasca Regional Airport,, is a registered aerodrome located 3.1 nautical miles east northeast of Athabasca, Alberta, Canada. It serves private and commercial aircraft.
An approach lighting system (ALS) is a lighting system installed on the approach end of an airport runway and consisting of a series of lightbars, strobe lights, or a combination of the two that extends outward from the runway end. ALS usually serves a runway that has an instrument approach procedure (IAP) associated with it and allows the pilot to visually identify the runway environment and align the aircraft with the runway upon arriving at a prescribed point on an approach.
Bathurst Airport is an airport serving Bathurst, New South Wales, Australia.
Shellharbour Airport, formerly Illawarra Regional Airport, also referred as Albion Park Aerodrome or Wollongong Airport, is an airport located in Albion Park Rail, Shellharbour City, New South Wales, Australia. The Historical Aircraft Restoration Society (HARS) is located at the airport. The airline Link Airways offers daily services from the airport to Melbourne–Essendon and Brisbane.
Redcliffe Airport is an aerodrome serving Redcliffe in Moreton Bay Region, Queensland, Australia. It is located 2.5 nautical miles northwest of Redcliffe, in the suburb of Rothwell, accessed via Nathan Road. The facility is owned and operated by Moreton Bay Regional Council, following the amalgamation of the Redcliffe City Council.
Muscatine Municipal Airport five miles (8 km) southwest of Muscatine, in Muscatine County, Iowa.
This is a list of the acronyms and abbreviations used in avionics.
Aeroflot Flight 36 was a scheduled domestic Aeroflot passenger flight from Chernivtsi International Airport to Kyiv International Airport (Zhuliany), Ukrainian Soviet Socialist Republic that crashed on 17 December 1976 near Kiev airport, resulting in 48 fatalities and 7 survivors.
Aztec Municipal Airport is a public-use airport located two nautical miles northwest of the central business district of Aztec, in San Juan County, New Mexico, United States. It is a general aviation airport with no tower, fixed base operator (FBO), or commercial services, but which is popular among smaller light sport and general aviation aircraft doing cross country flights, where the airport serves as a GA-friendly waypoint, refueling stop, and overnight layover stop.