Politechnika Warszawska PW-3 Bakcyl

Last updated
PW-3 Bakcyl
Role primary glider
National originPoland
ManufacturerPolitechnika Warszawska
Designerdr. Eng. Roman Świtkiewicz
First flight14 August 1988
Number built1
Developed from Politechnika Warszawska PW-2 Gapa

The Politechnika Warszawska PW-3 Bakcyl (Microbe) is a Polish primary glider developed from the PW-2 Gapa.

Contents

Design and development

The Bakcyl is a two seat development of the single seat PW-2 Gapa primary trainer from 1985. The main improvements were the addition of Frise ailerons and an enclosed cabin for pupil and instructor. The wingspan was increased by 33% and, overall, the changes doubled the empty weight. Despite this and the two occupants, bungee launches remained possible and, with the increased weight, the best glide angle improved by 25%. [1]

Over most of the span the two-part wings of the Bakcyl have constant chord and forward sweep but their long tips are trapezoidal, with sweep on their leading edges. Forward sweep has often been employed on two seat gliders to position the rear seat over the centre of gravity, so the aircraft can be flown solo from the front seat without re-trimming; an early example is the Schleicher Ka 2 Rhönschwalbe. [2] Largely constructed of glassfibre, it is built around a single spar with a glassfibre-covered D-box ahead of it and is fabric covered behind the spar. The wings are braced to the fuselage with a single, broad-chord strut on each side. Originally these struts could pivot through 90° to act as airbrakes, as on the PW-2, but they were later replaced with upper surface spoilers, inboard of the ailerons and positioned immediately behind the spars. [1] [3] [4]

The glass-epoxy composite fuselage is in two parts, a forward cabin which ends with a fairing under the wing trailing edge and a slender, square section tailboom just below the wing. Occupants sit in tandem, the student forward and their instructor under the leading edge. A long, one-piece canopy reaches back to the rear seat which has a short, fixed glazed extension under the wing. The Bakcyl lands on a fixed, fully exposed monowheel under the forward fuselage, aft of mid-chord, which has a shock absorber and a brake. A smaller nosewheel and plywood skid complete the landing gear. [1] [3] [4]

The Bakcyl's tail is conventional and similar to that of the PW-2, with a rectangular plan, canvas-covered tailplane mounted on top of the end of the tailboom and carrying a one-piece, narrow-chord elevator. Its fin and rudder, well forward of the elevator, are trapezoidal. [3] [4]

Operational history

The only Bakcyl first flew on 14 August 1988, followed by a period of flight testing. When this concluded the Bakcyl was used by the Bieszczadzki Aeroclub in Łódź and may still be active. [1] [3]

Specifications

Data from Jane's All the World's aircraft 1990-91 [1]

General characteristics

Performance

Related Research Articles

Schleicher ASK 13

The ASK 13 is a two-seater glider that was built by Alexander Schleicher. It was and still is widely used for basic training of glider pilots.

Politechnika Warszawska PW-2

The Politechnika Warszawska PW-2, also called the PW-2 Gapa, is a Polish lightweight high-wing, strut-braced single-seat, glider that was designed and built at the Warsaw University of Technology and also produced by DWLKK in the early 1990s. Total number of 19 gliders were built, including variant PW-2D bis.

The Scheibe SF-30 Club-Spatz is a 15 m class single seat sailplane built in Germany in the 1970s and intended for club use.

The LAK-16 is a single-seat, open-girder primary glider in the 1930s tradition but constructed with modern materials. It was produced in the 1980s in Lithuania.

The Civil Aviation Department Kartik was an Indian single seat competition glider first flown in 1963. It was built in small numbers and remained under development until 1975.

The Civil Aviation Department Ashvini was the first two-seat glider designed and built in India. It was produced in small numbers in the early 1960s.

Czerwiński CW 8

The Czerwiński CW 8 was a mid-1930s Polish open-frame basic training glider. Its design was advanced and its price low, but its stalling characteristics were too dangerous for beginners, so the thirty-plus examples completed were rapidly withdrawn from use. Two were subsequently modified, one with greater span and the other with a small engine.

WS Czajka Polish secondary training glider

The Czajka or Kocjan Czajka after its designer was a Polish secondary training glider which was in continuous production from 1931 to the start of World War II. More than 160 were completed in Warsztaty Szybowcowe in Warsaw.

Rubik R-03 Szittya I

The Rubik R-03 Szittya I was a Hungarian single-seat sailplane flown in the late 1930s. The design was developed through three improving variants. though only one of each was built.

Rubik R-07 Vöcsök

The Rubik R-07a Tücsök {Cicada) and R-07b Vöcsök (Grebe) were two versions of a Hungarian primary trainer, differing most obviously in the pilot's seating. First flown in the late 1930s, about 530 were built, some remaining in service into the 1960s.

Rubik R-12 Kevély

The Rubik R-12 Kevély (Proud) was a Hungarian advanced training glider. It was designed to provide safe cloud-flying experience and also raised the Hungarian height gained record several times. About fifty were built and operated between 1941 and 1951.

Rubik R-16 Lepke

The Rubik R-16 Lepke (Butterfly) was a single seat Hungarian training glider designed to follow the very similar but two seat Rubik R-15 Koma in a winch-launch training programme. The Lepke provided solo experience of the techniques learned with an instructor in an aircraft with similar handling characteristics. That done, the Lepke could be used as a standard trainer to take its pilot to C-certificate level. The pair were widely used by Hungarian glider clubs post-war, with sixty-five of each produced.

The MSRz Bene was a Hungarian two seat primary glider, first flown in 1952. By this time its competitor had been awarded a serial production order, so only one Bene was completed.

MRSz Z-04 Béke

The MRSz Z-04 Béke (Peace) was a Hungarian aerobatic glider. First flown in 1955, it became a familiar display aircraft, though only one was built.

Rubik R-23 Gébics

The Rubik R-23 Gébics (Shrike) was a Hungarian advanced training glider, the first of a series of metal-framed gliders designed by Ernő Rubik, though only one Gébics was built.

Rubik R-31 Dupla

The Rubik R-31 Dupla (Double) was a Hungarian side-by-side seat training glider first flown in 1983. Disappointing performance and vibration problems prevented it going into production.

The PZL M-3 Pliszka (Wagtail) was the first all-metal Polish glider. Three were built but its performance, particularly its glide ratio, was not good enough for it to be produced for Polish clubs.

The Oškinis BRO-23KR Garnys (Stork) is a glassfibre primary glider, built in the USSR in the early 1980s. Only two were completed.

The LAK-14 Strazdas (Thrush) was a 1980s primary glider designed and built by the Lithuanian Aircraft Construction factory. Like other LAK designs it developed the aeronautical use of glass fibre, foams and other novel materials. It was in production from 1981 to 1985.

Politechnika Warszawska PW-4 Pelikan

The Politechnika Warszawska PW-4 Pelikan was a motor-glider variant of the two seat Polish PW-3 Bakcyl glider. Only one flew.

References

  1. 1 2 3 4 5 Lambert, M. (1990). Jane's All the World's Aircraft 1990-1991. London: Jane's Information Group. p. 644. ISBN   07106 0908 6.
  2. ↑ Simons, Martin (2006). Sailplanes 1945-1965 (2nd revised ed.). Königswinter: EQIP Werbung & Verlag GmbH. pp. 80–1. ISBN   3 9807977 4 0.
  3. 1 2 3 4 "PW-3 Bakcyl, 1988 (1989)" . Retrieved 2 December 2019.
  4. 1 2 3 "Szybowiec PW-3 BAKCYL" . Retrieved 4 December 2019.
This page is based on this Wikipedia article
Text is available under the CC BY-SA 4.0 license; additional terms may apply.
Images, videos and audio are available under their respective licenses.