Schneider ES-56 Nymph

Last updated
ES-56 Nymph
RoleSingle-seat glider
National origin Australia
Manufacturer Edmund Schneider Pty Australia
DesignerEdmund Schneider
First flightDecember 1955
Number built4

The Schneider ES-56 Nymph was a short span, Australian glider with a laminar flow wing, built in the 1950s. Only four were built.

Contents

Design and development

The Nymph, with its 11.9 m (39 ft 1 in) span laminar flow wing was designed by Edmund Schneider, who had emigrated from Germany in 1950 and built them in his Australian factory. [1]

It was wooden framed and mostly covered with plywood, though parts of the wing and all the rear control surfaces were fabric covered. Its one piece high wing was built around a single spar, well set back from the leading edge and with closely spaced (210 mm (8.3 in)) ribs to preserve the laminar flow profile of the ply covered forward part. This covering included the plain, upper surface hinged ailerons and a torsion resisting D-box around the leading edge from the spar. There was 2° of dihedral. In plan the wing was straight tapered with a taper ratio of 0.416 and 1° of sweep at the quarter chord line. Most Nymphs had very small endplates at their wing tips, though one was built with traditional blunt tips. Metal, Schempp-Hirth type spoilers, opening above and below the wing, were mounted just behind the spar at about one third span. [1] [2]

The fuselage of the Nymph was a plywood covered box formed with frames and stringers, with inward sloping sides, a central keel from nose to mid fuselage and an upper turtleback or semi-conical decking behind the wing trailing edge. The cockpit was ahead of the leading edge, with a single piece, blown perspex side opening canopy and an upper line that merged into the wing. On each side a secondary, D-shaped window gave some rearward vision. The Nymph's ply covered, straight tapered, horizontal tail was unusually far back on top of the fuselage, locating the tailplane, also ply skinned, aft of the fin with the elevators largely behind the rudder which ended above them. Its starboard elevator carried a trim tab. The vertical tail was straight edged, tapered and flat topped. There was an unsprung monowheel below the wing at about one third chord, semi-recessed into a rubber sprung skid which reached from the nose to the trailing edge. The Nymph without wing endplates also had its wheel mounted a little further forward and its skid removed. There was a miniature skid tail bumper rather than the usual cantilever tailskid. [1] [2]

Operational history

The first flight of the Nymph was in December 1955. In the next month Harry Schneider, Edmund Schneider's eldest son, flew it 310 km (193 mi). It also had some aerobatic capabilities, being certified for loops, stall turns, spinning and rolls off the top. Despite these demonstrations of its capability, the Nymph proved less popular than its near contemporary, the even shorter span, less aerodynamically advanced Schneider ES-57 Kingfisher and only four were built. [1]

Variants

Specifications

Data from The World's Sailplanes (1963) pp.24-5 [2]

General characteristics

Performance

Related Research Articles

<span class="mw-page-title-main">Göppingen Gö 4</span> German two-seat glider, 1937

The Göppingen Gö 4 or Goevier is a German sailplane of the late 1930s used for training pilots. Its most notable features include side-by-side seating and dual controls, making the plane ideal for use as a trainer. It boasted average performance, compared to other gliders of the day, and was advertised as making the process of learning to fly sailplanes easier.

<span class="mw-page-title-main">Slingsby Sky</span> British single-seat glider, 1950

The Slingsby Type 34 Sky is a high performance single seat competition sailplane built in the United Kingdom. It was successful in major events, particularly in the World Gliding Championships of 1952.

<span class="mw-page-title-main">Slingsby Skylark 4</span> British competition glider, 1961

The Slingsby T.50 Skylark 4 was a British single seat competition glider built by Slingsby Sailplanes in the early 1960s. It sold in numbers and had success at national, though not world level competition.

<span class="mw-page-title-main">Cijan-Obad Orao</span> Type of aircraft

The Cijan-Obad Orao is a competition single seat sailplane designed in Yugoslavia just after World War II, one of the most advanced of its type at the time. It flew in three World Gliding Championships, having greatest success at its first in 1950 when it reached third place.

<span class="mw-page-title-main">Ikarus Meteor</span> 1950s Yugoslavian sailplane

The Ikarus Meteor is a long-span, all-metal sailplane designed and built in Yugoslavia in the 1950s. It competed in World Gliding Championships (WGC) between 1956 and 1968 and was placed fourth in 1956; it also set new triangular-course world speed records.

<span class="mw-page-title-main">Lommatzsch FES-530 Lehrmeister</span> Type of aircraft

The Lommatzsch FES-530 Lehrmeister is a two-seat trainer glider that was built in the German Democratic Republic in the 1950s. Over 300 were built, with a mixture of 17 m and 15 m spans.

The Ciani EC.37/53 Spillo or SSVV EC.37/53 Spillo was a single seat competition glider designed and built in Italy in the 1950s. It had the highest aspect ratio wing of any wooden glider. Only one was built.

<span class="mw-page-title-main">Bruni 3V-1 Eolo</span> Type of aircraft

The Bruni 3V-1 Eolo was a single seat Italian competition glider, first flown in 1955. It took part World Gliding Championships of 1956 but retired early after sustaining damage.

The IIL IS-7 was a two-seat, sailplane designed by Iosif Șilimon and built in Romania in the late 1950s. Only one prototype was built.

The IIL IS-8 was a two-seat sailplane designed by Iosif Șilimon and built in Romania in 1960. They served with Romanian gliding clubs.

The IIL IS-10 was a high-performance, single-seat glider, designed and built in Romania in the early 1960s. It was the first Romanian aircraft to use laminar flow airfoils.

The IIL IS-11 was an aerobatic, single seat glider, designed and built in Romania in 1959. It was built in small numbers.

IFIL-Reghin RG-5 Pescarus Type of aircraft

The IFIL-Reghin RG-5 Pescăruș or CIL Reghin RG-5 Pescăruș was a Romanian single seat sailplane built in the 1950s. Twenty six were constructed for gliding clubs.

The Schneider Grunau 7 Moazagotl was a high-performance sailplane designed in Germany in 1933 specifically for fast, long distance flying using strong thermals. In 1937 it came second in the first World Gliding Championships, having previously made a flight of 300 km (186 mi).

<span class="mw-page-title-main">Schneider ES-57 Kingfisher</span> Type of aircraft

The Schneider ES-57 Kingfisher is a low-cost, short-span Australian glider capable of respectable cross country soaring flights. It was produced in small numbers in the late 1950s.

The Schneider ES49 is a two-seat glider trainer, designed, first flown in late August 1951 and commercially produced in Germany but later built from plans by gliding clubs in Australia. A major redesign there led to the ES49B Kangaroo.

The Merville SM.31 is a French high performance glider with a laminar flow wing, first flown in 1960. Only one was built.

<span class="mw-page-title-main">Zlin Z-25 Šohaj</span> Type of aircraft

The Zlín Šohaj series of club gliders began as a post World War II development of the DFS Olympia Meise. A large number were built in the 1940s and '50s.

<span class="mw-page-title-main">Oberlerchner Mg 19</span> Type of aircraft

The Oberlerchner Mg 19 Steinadler is an Erwin Musger designed two seat tandem trainer glider built in Austria and first flown in 1951. Several examples of this successful aircraft, which competed in the two seat class at two World Gliding Championships in the 1950s, were still flying in 2000.

The Ilić Ilindenka was a series of Yugoslavian standard class sailplanes capable of aerobatics.

References

Citations

  1. 1 2 3 4 5 Simons, 2006, pp.179-181
  2. 1 2 3 Shenstone, 1963, pp.24-25

Bibliography