Sunbeam S7 and S8

Sunbeam S8
Manufacturer	Sunbeam Cycles Limited (Subsidiary of BSA)
Production	1949–1956
Engine	487 cc parallel twin OHC four stroke
Power	24 bhp (18 kW) @ 6,000 rpm
Wheelbase	57-inch (1,400 mm)

Last updated February 04, 2022

The Sunbeam S7 and S8 are British motorcycles designed by Erling Poppe with styling loosely based on the BMW R75 designs that were acquired as war reparations by BSA (full rights to the Sunbeam brand had been acquired from AMC in 1943).^[1] Built in Redditch, the unusual engine layout was similar to that of a car. The engine was a longitudinally mounted inline vertical OHC 500 cc twin based on an experimental 1932 BSA design (the Line-Ahead-Twin - LAT) with coil ignition and wet sump lubrication which, through a dry clutch, drove a shaft drive to the rear wheel. The inline engine made this technologically feasible—horizontally-opposed ("flat") twin engines on BMW motorcycles had already used shaft drives following the system employed by the four cylinder Nimbus since 1918. The early S7 was expensive and over engineered, which is why it is now the most sought-after and commands a premium over the S7 De Luxe and the S8, which were produced with fewer features to reduce costs, while retaining many of the innovative parts of the early Sunbeam and updating some ideas.

Models

Three models were produced, the S7, S7 "de luxe" and the S8. All three were very expensive with only modest performance resulting in low sales. The original model was the S7 (the "Tourer") (2,104 produced from 1946 to 1948), in 1949 the S7 was updated to become the S7 de luxe (5,554 produced) and the S8 (8,530 produced). Both had new cylinder linings, redesigned frames and increased oil capacity. The lighter S8 was sold as a "sportier" model with a top speed of 85 mph (137 km/h). It also had new (BSA) forks, a cast aluminium silencer and chromed wheels (with narrower tyres to replace the 'balloon' tyres which had led to uncertain handling at speed). S9 and S10 models were planned but never made as BSA decided to concentrate on the more traditional twins.^[2] Another "sports" model was also tested but never put into production. This had a much higher compression ratio with a different OHC design but was never sold, reputedly because of the undampened front fork system which affected handling. There were also trials with a rigid version for a cheaper model but this design was also abandoned.^[3]

The original S7 was produced in black. The S7 de luxe came in either "Mist Green" or black and the S8 in "Silver Grey" or black. For export abroad BSA would supply Sunbeams in any BSA colour.

Design problems

Erling Poppe’s design was originally based on a captured BMW R75 but so soon after the end of the war BSA did not want the S series to look too "German", so an in-line OHC parallel twin was designed instead of a flat twin "across the frame". Serious problems with vibration made the new Sunbeam bikes uncomfortable to ride and the initial production originally sent to South Africa was recalled. The excessive vibration was cured by mounting the engine on two bonded rubber engine mounts.^[2]

The in-line engine was inherently suitable for shaft drive, and BMW-style bevel gears would have been ideal. However, having inherited some worm-gear machinery from the Lanchester Motor Company, BSA opted to specify worm drive rather than bevel gears. Reputedly this created problems with the shaft drive, as the gears tended to strip under power.^[4] It is said that Sunbeam's "solution" to this was to reduce the power to 24 bhp (18 kW), which did nothing to help post-war sales.^[1]

Owners clubs

The Sunbeam Motor Cycle Club is one of the longest established in the UK and was founded in July 1924 at the London showrooms of John Marston Ltd in Holborn Viaduct who made the Sunbeam motorcycles in their factory at Wolverhampton.^[5] The Sunbeam Motor Cycle Club is, however, a sporting motorcycle club that organises trials and vintage bike rallies and runs and the "owners section" was just a small part of it. When Sunbeam production ended BSA sold the remaining stock of parts to Stewart Engineering. Bob and Chines Stewart were longtime fans of the Sunbeam and for a time members of the Sunbeam Motorcycle Club. In 1963 they, along with other enthusiasts, broke away from the Sunbeam Motorcycle Club and formed the Sunbeam Owners Fellowship (SOF) to support owners of an S7 or S8 with any problems. A good number of Sunbeams motorcycles survive in perfect working order and many owners have been fellows of the SOF since its inception, having owned their Sunbeam since bought new or second hand in the 1960s.

A web-based owners club has been created.^[6]

Related Research Articles

The Norton Motorcycle Company is a brand of motorcycles, originally based in Birmingham, England. For some years around 1990, the rights to use the name on motorcycles was owned by North American financiers.

Velocette is a line of motorcycles made by Veloce Ltd, in Hall Green, Birmingham, England. One of several motorcycle manufacturers in Birmingham, Velocette was a small, family-owned firm, selling almost as many hand-built motorcycles during its lifetime, as the mass-produced machines of the giant BSA and Norton concerns. Renowned for the quality of its products, the company was "always in the picture" in international motorcycle racing, from the mid-1920s through the 1950s, culminating in two World Championship titles and its legendary and still-unbeaten 24 hours at over 100 mph (161 km/h) record. Veloce, while small, was a great technical innovator and many of its patented designs are commonplace on motorcycles today, including the positive-stop foot shift and swinging arm rear suspension with hydraulic dampers. The business suffered a gradual commercial decline during the late 1960s, eventually closing in February 1971.

Overhead camshaft engine Valvetrain configuration

An overhead camshaft (OHC) engine is a piston engine where the camshaft is located in the cylinder head above the combustion chamber. This contrasts with earlier overhead valve engines (OHV), where the camshaft is located below the combustion chamber in the engine block.

The Honda CX series motorcycles, including the GL500 and GL650 Silver Wing variants, were developed and released by Honda in the late 1970s, with production ending in most markets by the mid 1980s. The design included innovative features and technologies that were uncommon or unused at the time such as liquid cooling, electric-only starting, low-maintenance shaft drive, modular wheels, and dual CV-type carburetors that were tuned for reduced emissions. The electronic ignition system was separate from the rest of the electrical system, but the motorcycle could only be started via the start button.

Sunbeam Cycles made by John Marston Limited of Wolverhampton was a British brand of bicycles and, from 1912 to 1956 motorcycles.

The BMW K100 is a family of four-cylinder 987 cc motorcycles that were manufactured by BMW from 1983 to 1992.

Matchless is one of the oldest marques of British motorcycles, manufactured in Plumstead, London, between 1899 and 1966. A wide range of models were produced under the Matchless name, ranging from small two-strokes to 750 cc four-stroke twins. Matchless had a long history of racing success; a Matchless ridden by Charlie Collier won the first single-cylinder race in the first Isle of Man TT in 1907.

A motorcycle engine is an engine that powers a motorcycle. Motorcycle engines are typically two-stroke or four-stroke internal combustion engines, but other engine types, such as Wankels and electric motors, have been used.

The BMW GS series of one purpose off-road/on-road BMW motorcycles have been produced from 1980, when the R80G/S was launched, to the present day. The GS refers to either Gelände/Straße or Gelände Sport. GS motorcycles can be distinguished from other BMW models by their longer travel suspension, an upright riding position, and larger front wheels – typically 19 to 21 inch. In May 2009, the 500,000th GS was produced, an R1200GS model.

The Triumph Tigress, also sold as the BSA Sunbeam, was a scooter designed to have good performance and handling for the motorcycle enthusiast. The entry of the BSA group into the scooter field was announced by Edward Turner in October 1958. The 250 cc model would have a cruising speed of 55 to 60 mph and petrol consumption of 120 miles per imperial gallon. A prototype 250 cc BSA Sunbeam was displayed at the 1958 Earl's Court Cycle and Motor Cycle Show. Manufacture started in late 1959, but delivery difficulties were acknowledged due to problems with recruiting labour, although it was claimed that the group had a manufacturing capacity of 50,000 machines a year.

Unit construction is the design of larger motorcycles where the engine and gearbox components share a single casing. This sometimes includes the design of automobile engines and was often loosely applied to motorcycles with rather different internal layouts such as the flat twin BMW models.

Associated Motor Cycles (AMC) was a British motorcycle manufacturer founded by the Collier brothers as a parent company for the Matchless and AJS motorcycle companies. It later absorbed Francis-Barnett, James, and Norton before incorporation into Norton-Villiers. Henry Herbert Collier founded Matchless as a cycle company in 1878. His sons Henry (Harry) and Charles (Charlie) joined him and the name was changed to H. Collier & Sons.

The BSA Gold Star is a motorcycle made by BSA from 1938 to 1963. They were 350 cc and 500 cc single-cylinder four-stroke production motorcycles known for being among the fastest bikes of the 1950s. Being hand built and with many optional performance modifications available, each motorcycle came from the factory with documented dynamometer test results, allowing the new owner to see the horsepower (bhp) produced.

Edward Turner was an English motorcycle designer. He was born in Camberwell in the London Borough of Southwark, on the day King Edward VII was proclaimed King. In 1915, Turner had his first ride on a motorcycle, a Light Tourist New Imperial.

Erling Poppe was an Austrian-born English-raised motor vehicle designer who studied engineering in Birmingham, England, and designed Packman & Poppe Motorcycles, Sunbeam motorcycles and Gordon three-wheeler cars.

The BMW R60/6, R75/6, R90/6 and the sport model BMW R90S form a range of boxer twin motorcycles that were manufactured in Berlin, Germany, by BMW from 1974 to 1976. The "slash six" models departed from the earlier "slash five" slightly. First, the smallest displacement changed from 500cc to 600cc. A sport model was offered, as were disc brakes for the first time. Additionally, the tank design was changed to remove the chrome trim panels, and the gauge pod was moved from the headlight housing to its own assembly over the housing.

The Ducati 125 Scrambler is an on/off road 124 cc (7.6 cu in) single cylinder bevel drive SOHC motorcycle produced by the Italian manufacturer Ducati in 1971 and 1972. Although Ducati had stopped production of the 'narrow case' singles in 1967, the Scrambler used a narrow case engine made by MotoTrans in Spain. The model was not a sales success with less than 200 sold worldwide and was soon taken out of production.

The Ducati 450 Scrambler, also known in the US as the Ducati Jupiter and in Europe as the Ducati 450 SCR is an on/off road 436 cc (26.6 cu in) single cylinder bevel drive SOHC motorcycle produced by the Italian manufacturer Ducati from 1969 to 1974. Total production was around 11,000 machines.

The Ducati Strada is a 249 cc (15.2 cu in) single cylinder bevel drive SOHC motorcycle produced by the Spanish manufacturer MotoTrans, who were licensed by Ducati to produce motorcycles under the Ducati brand name and was produced from 1978 to 1983. The model is based on the 250 'wide case' Ducati singles which the Italian Ducati factory had stopped manufacturing in 1974, but which MotoTrans continued to develop and produce.

References

1 2 Kemp, Andrew (2001). Classic British Bikes. Bookmart Ltd. pp. 124–125. ISBN 978-1-86147-058-4.
1 2 "Shaft Drive Sunbeam Motorcycle History". Archived from the original on 5 July 2001. Retrieved 3 June 2008.
↑ "A Brief History Of Sunbeams". Stewart Engineering. Retrieved 2 June 2008.
↑ Stewart Engineering's Guide to the Sunbeam S7 & S8
↑ "Sunbeam Motorcycle Club" . Retrieved 28 December 2011.
↑ "Sunbeam Owners Fellowship" . Retrieved 19 March 2011.

External links

The Sunbeam Owners Fellowship. The Club for owners and past owners

This page is based on this Wikipedia article
Text is available under the CC BY-SA 4.0 license; additional terms may apply.
Images, videos and audio are available under their respective licenses.

[Kemp-1] 1 2 Kemp, Andrew (2001). Classic British Bikes. Bookmart Ltd. pp. 124–125. ISBN 978-1-86147-058-4.

[Classic-2] 1 2 "Shaft Drive Sunbeam Motorcycle History". Archived from the original on 5 July 2001. Retrieved 3 June 2008.

[3] "A Brief History Of Sunbeams". Stewart Engineering. Retrieved 2 June 2008.

[4] Stewart Engineering's Guide to the Sunbeam S7 & S8

[5] "Sunbeam Motorcycle Club" . Retrieved 28 December 2011.

[6] "Sunbeam Owners Fellowship" . Retrieved 19 March 2011.

[1]

[2]

[3]

[4]

[5]

[6]