| Yeoman Cropmaster YA-1 | |
|---|---|
 Cropmaster 250R Series 2 ZK-CTX | |
| General information | |
| Type | agricultural aircraft |
| Manufacturer | Yeoman Aviation |
| Designer | C. W. (Bill) Smith |
| Number built | 21 |
| History | |
| Manufactured | 1960–1966 |
| Introduction date | 1960 |
| First flight | 15 January 1960 |
| Developed from | Kingsford Smith Cropmaster |
The Yeoman Cropmaster was an Australian agricultural aircraft developed from the CAC Wackett trainer of World War II.
The type was developed by Yeoman Aviation, a company set up by Kingsford Smith Aviation Services Pty. Ltd. (KSA) at Bankstown Airport to engage in agricultural aircraft production. KSA had obtained a number of Wacketts following the type's retirement from Royal Australian Air Force service and had converted four for agricultural use as KS-3 Cropmasters in the second half of the 1950s. [1] The conversion involved little more than the installation of a hopper located in the rear cockpit of the Wackett, the cutting of a hole in the centre section of the Wackett's wooden wing to allow the dispersal of the chemical load, and re-routing controls to bypass the hopper. [1]
By contrast the YA-1 Cropmaster involved major modifications to the Wackett airframe. The Wackett fuselage structure of steel tube was retained but had a 23 cubic ft. (650 litre) capacity hopper in lieu of the Wackett's rear cockpit and different external panels of metal and fibreglass (the Wackett fuselage was fabric covered); the Wackett's wooden wing was replaced by a new metal wing. The first five aircraft retained the Wackett's wooden tail, but subsequent aircraft had a metal tail that featured a stabilator, a swept-back fin and larger rudder. The Wackett's fixed tailwheel undercarriage was retained. The Warner Scarab radial engine of the Wackett was replaced by a horizontally-opposed engine, the YA-1 250 being fitted with a Lycoming O-540 engine of 250hp driving a Hartzell Propeller, while the YA-1 250R was fitted with a Continental IO-470 also developing 250 hp (190 kW), driving a Hartzell or McCauley propeller.
The first Cropmaster, a YA-1 250, took to the air for the first time on 15 January 1960. [2] Twenty further aircraft were converted before production ceased in 1966, by which time the company was known as Cropmaster Aircraft. Like its contemporary the CAC Ceres the Cropmaster was unable to compete with more modern types of agricultural aircraft. Six of the twenty-one aircraft were the YA-1 250R model and the final three aircraft produced featured relocated main landing gear to counteract a tendency for the type to nose over on the ground. Six Cropmasters were exported to New Zealand with the last registered example being returned to Australia in April 2022. Two examples (one flying) are registered in Australia. [3] The second is under rebuild at Wagga Wagga. Several other Cropmasters reportedly still exist in Australia and New Zealand.
An intermediate flying test-bed, the single Yeoman 175 was converted from CA-6 Wackett airframe C/N 257 for trials of a new all-metal empennage, and had the swept fin of later Cropmasters but retained the Warner Scarab radial engine and fabric-covered aft fuselage of the Wackett.
A proposed variant with tricycle undercarriage was the YA-1B, none were built. A cut-away drawing of the YA-1B was included in a Yeoman Aviation brochure. The YA-1B design proposal also included an early version of the design for the all-metal empennage, with a more upright tail-fin than was actually produced. Another variant was the YA-1 285 with a 285 hp (213 kW) Continental engine, sources disagree as to whether any of this variant were produced.
At the time manufacture ceased, metal had been cut on the next evolution, this being the Cropmaster 300. The existing wing was to be retained with the span increased to 37 ft (11.28 m). The tail group was to remain unchanged. The tailwheel configuration was retained although new oleo legs to handle the heavier take-off weight were required. New plastic fuel tanks, still mounted between the front and rear wing spars, were of 21.5 imperial gallons capacity each, giving a total capacity of 43 gallons (195 lit.). Therefore, the practical working endurance remained at two hours or so. The fuselage was an all new design optimized for the topdressing role. The hopper remained in the same position but was of considerably increased capacity. Hopper load on topdressing would have varied between 12 and 17 cwt. (611/865 kg). The area from the hopper to the tail was to be of monocoque construction with an access hatch to permit loading of cargo/work equipment or (no doubt) the odd passenger. The cockpit section forward of the hopper was to be built on a steel tube frame and featured side by side seating for the pilot and a passenger (typically the landholder or the loader driver).
Four pilots were killed in Cropmasters. In 1961 at Deniliquin, Ralph Dennis ran a tank dry in Marshall's VH-MSS and spun in. In 1964 John Waddell pranged VH-BAQ near Boorowa while doing low level aerobatics. In 1965 Air-Culture's VH-CXQ, with Richard Adams flying, struck a tree whilst entering a spray run at Highbury near Narrogin. Also in 1965 Bill Pearson flying Bender's VH-RPB at Kempton went in from a hundred feet or so, just after lift-off. Non-fatal misadventures included wire strike, jammed elevators after fence strike, getting trapped in a blind gully, Hartzell propeller blade failures and nose-overs.
Data from Jane's All The World's Aircraft 1965–66 [4]
General characteristics
Performance
Aircraft of comparable role, configuration, and era
The Distributor Wing DW-1 was a prototype agricultural aircraft of unorthodox design, designed by Ken Razak in the United States and marketed by Aerial Distributors in the 1960s.
The PA-25 Pawnee is an agricultural aircraft produced by Piper Aircraft between 1959 and 1981. It remains a widely used aircraft in agricultural spraying and is also used as a tow plane, or tug, for launching gliders or for towing banners. In 1988, the design rights and support responsibility were sold to Latino Americana de Aviación of Argentina.
The Auster B8 Agricola was a commercially unsuccessful British agricultural aircraft designed for the aerial topdressing market which opened up in New Zealand in the early 1950s.
The American Champion 8KCAB Decathlon and Super Decathlon are two-seat fixed conventional gear light airplanes designed for flight training and personal use and capable of sustaining aerobatic stresses between +6g and −5g. The Decathlon entered production in the United States in 1970 as a more powerful and stronger complement to the American Champion Citabria line of aircraft.
The PL-11 Airtruck is a New Zealand agricultural aircraft.
The CAC Wackett Trainer, or simply Wackett, was the first aircraft type designed in-house by the Commonwealth Aircraft Corporation of Australia. The name was derived from its designer Lawrence Wackett.
The Transavia PL-12 Airtruk is a single-engine agricultural aircraft designed and built by the Transavia Corporation in Australia. The Airtruk is a shoulder-wing strut braced sesquiplane of all-metal construction, with the cockpit mounted above a tractor-location opposed-cylinder air-cooled engine and short pod fuselage with rear door. The engine cowling, rear fuselage and top decking are of fibreglass. It has a tricycle undercarriage, the main units of which are carried on the lower sesquiplane wings. It has twin tail booms with two unconnected tails. Its first flight was on 22 April 1965, and was certified on 10 February 1966.
The Harbin Y-11 is a high wing twin-engine piston utility and geological survey aircraft built by Harbin Aircraft Manufacturing Corporation (HAMC).
The PZL-101 Gawron (rook) is a Polish agricultural and utility aircraft designed and built by WSK-Okęcie.
The de Havilland Australia DHA-3 Drover is a small transport aircraft that was built by de Havilland Australia (DHA) in the 1940s and 1950s. The aircraft had some similarities with the two-engine British-built de Havilland Dove but used a trimotor configuration.
The Mooney M22 Mustang is the first attempt at a pressurized single engine aircraft by the Mooney Aircraft Company of the United States.
The Gippsland GA-200 Fatman is a low-wing single-engine agricultural aircraft built by GippsAero.
The PZL-106 Kruk is a Polish agricultural aircraft designed and built by WSK PZL Warszawa-Okęcie.
The Commonwealth Aircraft CA-28 Ceres was a crop-duster aircraft manufactured in Australia by the Commonwealth Aircraft Corporation (CAC) between 1959 and 1963. The aircraft was a development of the Wirraway trainer of World War II.
The KS-3 Cropmaster was an Australian agricultural aircraft developed from the CAC Wackett, an aircraft used for training purposes during World War II.
The SIAI-Marchetti S.205 is an Italian four-seat, single-engine, light airplane, manufactured by SIAI-Marchetti. The S.205 made its maiden flight in 1965. The Italian Air Force employs a version called S.208.
The Edgar Percival E.P.9 was a 1950s British light utility aircraft designed by Edgar Percival and initially built by his company, Edgar Percival Aircraft Limited and later as the Lancashire Aircraft Prospector by the Lancashire Aircraft Company.
The Sasin SA-29 Spraymaster was an agricultural aircraft designed and manufactured in Australia in the 1960s by Sasin Aircraft Service of Goulburn, New South Wales in conjunction with Aerostructures at Sydney's Bankstown Airport.
The Texas A&M College Ag-1 was a prototype single seat, single engine aircraft, one of the first specifically designed for agricultural spraying, dusting and fertilizer spreading. It was the first of a series of designs that led to the Piper PA-25 Pawnee.
The Kawasaki KAL-2 is a Japanese four/five seat, single engine aircraft, designed for both military and civil markets in the mid-1950s. Only two were completed.
