ABIT BP6

Last updated
ABIT BP6 with unpopulated processor sockets Abit-BP6.JPG
ABIT BP6 with unpopulated processor sockets
ABIT BP6 PC-99 colored peripheral connectors Abit-bp6 rear-IO.jpeg
ABIT BP6 PC-99 colored peripheral connectors
ABIT BP6 with CPUs and heat sinks Abit dual celeron pc motherboard.jpg
ABIT BP6 with CPUs and heat sinks

The ABIT BP6 was an ATX motherboard released by ABIT in 1999. It was the first motherboard to allow the use of two unmodified Intel Celeron processors in dual Symmetric multiprocessing (SMP) configuration. This combined with its overclocking capabilities made it a popular option among computer enthusiasts. [1] The BP6 has been credited as the product that made multi-processor systems affordable for mainstream users, [2] because prior to its release the expense of any multi-processor configuration made it a feature only to be considered for workstation-class systems.

The BP6 was based on the Intel Seattle 440BX chipset, consisting of the 82443BX Northbridge and the 82371AB Southbridge.

Processors that were supported by the BP6 in SMP configuration were the PPGA Socket 370 Celeron processors (300–533 MHz). Later Pentium III and Celeron Coppermine models could also operate on the BP6, albeit only in single processor configuration with the use of aftermarket socket adaptors. Intel never intended the Celeron to be able to operate in SMP, and later-generation Celeron processors had their SMP interface disabled, restricting the feature to the higher-end Pentium III and Xeon product lines.

The motherboard also featured two extra HDD ports, one with the HPT366 Ultra DMA/66 adapter fitted on the mainboard itself. This allowed up to eight IDE compatible drives to operate at the interface's maximum speed.

The motherboard featured ABIT SoftMenu [3] BIOS extension which allowed for jumper-less adjustment of system parameters such as system bus speed, CPU & AGP bridge multipliers, voltages from inside the BIOS and PC-99 coloring.

The BP6, and many other of ABIT's motherboards produced between 1999 and 2005, were victims of the capacitor plague. [4]

Specification [1]
CPU socketSocket 370
Chipseti440 BX
Expansion cards AGP 2x, 5× PCI and 2× ISA (1 PCI-ISA shared)
RAM DIMM slots, maximum 768 MB SDRAM
IDE support4× Ultra ATA/66, 4× Ultra ATA/33 devices
Peripheral2× USB 1.1, 2× RS-232, 1× Parallel port

Related Research Articles

<span class="mw-page-title-main">Motherboard</span> Main printed circuit board (PCB) for a computing device

A motherboard is the main printed circuit board (PCB) in general-purpose computers and other expandable systems. It holds and allows communication between many of the crucial electronic components of a system, such as the central processing unit (CPU) and memory, and provides connectors for other peripherals. Unlike a backplane, a motherboard usually contains significant sub-systems, such as the central processor, the chipset's input/output and memory controllers, interface connectors, and other components integrated for general use.

<span class="mw-page-title-main">Celeron</span> Line of semi-discontinued microprocessors made by Intel

Celeron is a semi-discontinued series of low-end IA-32 and x86-64 computer microprocessor models targeted at low-cost personal computers, manufactured by Intel. The first Celeron-branded CPU was introduced on April 15, 1998, and was based on the Pentium II.

<span class="mw-page-title-main">Pentium III</span> Line of desktop and mobile microprocessors produced by Intel

The Pentium III brand refers to Intel's 32-bit x86 desktop and mobile CPUs based on the sixth-generation P6 microarchitecture introduced on February 28, 1999. The brand's initial processors were very similar to the earlier Pentium II-branded processors. The most notable differences were the addition of the Streaming SIMD Extensions (SSE) instruction set, and the introduction of a controversial serial number embedded in the chip during manufacturing. The Pentium III is also a single-core processor.

<span class="mw-page-title-main">Pentium Pro</span> Sixth-generation x86 microprocessor by Intel

The Pentium Pro is a sixth-generation x86 microprocessor developed and manufactured by Intel and introduced on November 1, 1995. It introduced the P6 microarchitecture and was originally intended to replace the original Pentium in a full range of applications. While the Pentium and Pentium MMX had 3.1 and 4.5 million transistors, respectively, the Pentium Pro contained 5.5 million transistors. Later, it was reduced to a more narrow role as a server and high-end desktop processor and was used in supercomputers like ASCI Red, the first computer to reach the trillion floating point operations per second (teraFLOPS) performance mark in 1996. The Pentium Pro was capable of both dual- and quad-processor configurations. It only came in one form factor, the relatively large rectangular Socket 8. The Pentium Pro was succeeded by the Pentium II Xeon in 1998.

<span class="mw-page-title-main">Pin grid array</span> Type of integrated circuit packaging with the pins mounted on the underside of the package

A pin grid array (PGA) is a type of integrated circuit packaging. In a PGA, the package is square or rectangular, and the pins are arranged in a regular array on the underside of the package. The pins are commonly spaced 2.54 mm (0.1") apart, and may or may not cover the entire underside of the package.

<span class="mw-page-title-main">Xeon</span> Line of Intel server and workstation processors

Xeon is a brand of x86 microprocessors designed, manufactured, and marketed by Intel, targeted at the non-consumer workstation, server, and embedded markets. It was introduced in June 1998. Xeon processors are based on the same architecture as regular desktop-grade CPUs, but have advanced features such as support for error correction code (ECC) memory, higher core counts, more PCI Express lanes, support for larger amounts of RAM, larger cache memory and extra provision for enterprise-grade reliability, availability and serviceability (RAS) features responsible for handling hardware exceptions through the Machine Check Architecture (MCA). They are often capable of safely continuing execution where a normal processor cannot due to these extra RAS features, depending on the type and severity of the machine-check exception (MCE). Some also support multi-socket systems with two, four, or eight sockets through use of the Ultra Path Interconnect (UPI) bus.

<span class="mw-page-title-main">AMD K6-2</span> CPU by AMD

The K6-2 is an x86 microprocessor introduced by AMD on May 28, 1998, and available in speeds ranging from 266 to 550 MHz. An enhancement of the original K6, the K6-2 introduced AMD's 3DNow! SIMD instruction set and an upgraded system-bus interface called Super Socket 7, which was backward compatible with older Socket 7 motherboards. It was manufactured using a 250 nanometer process, ran at 2.2 volts, and had 9.3 million transistors.

<span class="mw-page-title-main">Socket 370</span> CPU socket

Socket 370, also known as PGA370, is a CPU socket first used by Intel for Pentium III and Celeron processors to first complement and later replace the older Slot 1 CPU interface on personal computers. The "370" refers to the number of pin holes in the socket for CPU pins.

<span class="mw-page-title-main">Slot 1</span> Physical and electrical specification for the connector used by some Intel microprocessors

Slot 1 refers to the physical and electrical specification for the connector used by some of Intel's microprocessors, including the Pentium Pro, Celeron, Pentium II and the Pentium III. Both single and dual processor configurations were implemented.

<span class="mw-page-title-main">Northbridge (computing)</span> PC chip handling onboard control tasks

In computing, a northbridge is one of two chips comprising the core logic chipset architecture on motherboards for older personal computers. A northbridge is connected directly to a CPU via the front-side bus (FSB) to handle high-performance tasks, and is usually used in conjunction with a slower southbridge to manage communication between the CPU and other parts of the motherboard.

<span class="mw-page-title-main">LGA 775</span> Intel desktop CPU socket

LGA 775, also known as Socket T, is an Intel desktop CPU socket. Unlike PGA CPU sockets, such as its predecessor Socket 478, LGA 775 has no socket holes; instead, it has 775 protruding pins which touch contact points on the underside of the processor (CPU).

<span class="mw-page-title-main">Universal Abit</span> Taiwanese computer components manufacturer

Universal ABIT Co., Ltd was a computer components manufacturer, based in Taiwan, active since the 1980s. Its core product line were motherboards aimed at the overclocker market. Abit experienced serious financial problems in 2005. The brand name "ABIT" and other intangible properties, including patents and trademarks, were acquired by Universal Scientific Industrial Co., Ltd. (USI) in May 2006.

<span class="mw-page-title-main">Slotket</span>

In computer hardware terminology, slotkets, also known as slockets, are adapters that allow socket-based microprocessors to be used on slot-based motherboards.

<span class="mw-page-title-main">SGI Visual Workstation</span> Series of workstation computers

SGI Visual Workstation is a series of workstation computers that are designed and manufactured by SGI. Unlike its other product lines, which used the 64-bit MIPS RISC architecture, the line used Intel Pentium II and III processors and shipped with Windows NT 4.0 or Windows 2000 as its operating system in lieu of IRIX. However, the Visual Workstation 320 and 540 models deviated from the architecture of IBM-compatible PCs by using SGI's ARCS firmware instead of a traditional BIOS, internal components adapted from its MIPS-based products, and other proprietary components that made them incompatible with internal hardware designed for standard PCs and hence unable to run other versions of Microsoft Windows, especially Windows 9x. By contrast, the remaining models in the line are standard PCs, using VIA Technologies chipsets, Nvidia video cards, and standard components.

The Intel Core microarchitecture is a multi-core processor microarchitecture launched by Intel in mid-2006. It is a major evolution over the Yonah, the previous iteration of the P6 microarchitecture series which started in 1995 with Pentium Pro. It also replaced the NetBurst microarchitecture, which suffered from high power consumption and heat intensity due to an inefficient pipeline designed for high clock rate. In early 2004 the new version of NetBurst (Prescott) needed very high power to reach the clocks it needed for competitive performance, making it unsuitable for the shift to dual/multi-core CPUs. On May 7, 2004 Intel confirmed the cancellation of the next NetBurst, Tejas and Jayhawk. Intel had been developing Merom, the 64-bit evolution of the Pentium M, since 2001, and decided to expand it to all market segments, replacing NetBurst in desktop computers and servers. It inherited from Pentium M the choice of a short and efficient pipeline, delivering superior performance despite not reaching the high clocks of NetBurst.

<span class="mw-page-title-main">Yonah (microprocessor)</span> Code name of Intels first generation 65 nm process CPU cores

Yonah is the code name of Intel's first generation 65 nm process CPU cores, based on cores of the earlier Banias / Dothan Pentium M microarchitecture. Yonah CPU cores were used within Intel's Core Solo and Core Duo mobile microprocessor products. SIMD performance on Yonah improved through the addition of SSE3 instructions and improvements to SSE and SSE2 implementations; integer performance decreased slightly due to higher latency cache. Additionally, Yonah included support for the NX bit.

<span class="mw-page-title-main">Intel 440BX</span> Chipset from Intel

The Intel 440BX is a chipset from Intel, supporting Pentium II, Pentium III, and Celeron processors. It is also known as the i440BX and was released in April 1998. The official part number is 82443BX.

<span class="mw-page-title-main">Haswell (microarchitecture)</span> Intel processor microarchitecture

Haswell is the codename for a processor microarchitecture developed by Intel as the "fourth-generation core" successor to the Ivy Bridge. Intel officially announced CPUs based on this microarchitecture on June 4, 2013, at Computex Taipei 2013, while a working Haswell chip was demonstrated at the 2011 Intel Developer Forum. With Haswell, which uses a 22 nm process, Intel also introduced low-power processors designed for convertible or "hybrid" ultrabooks, designated by the "U" suffix.

<span class="mw-page-title-main">LGA 1156</span> Intel desktop CPU socket

LGA 1156, also known as Socket H or H1, is an Intel desktop CPU socket. Its incompatible successor is LGA 1155.

References

  1. 1 2 Gonzo; Fisher, Ken "Cæsar". "Abit BP6 Dual Socket-370 Motherboard". Ars Technica . Archived from the original on 2016-02-13. Retrieved 2017-07-19.
  2. Ung, Gordon Mah (2010-10-14). "Mobos that Mattered the Most". Maximum PC . Future US, Inc. Archived from the original on 2015-03-19. Retrieved 2017-07-19.
  3. Gavrichenkov, Ilya (1999-08-24). "ABIT BP6 Review". X-bit labs. Archived from the original on 2016-11-22. Retrieved 2017-07-19.
  4. "Busting Caps". Maximum PC. Future Publishing: 24. February 2005 via Google Books.