Avro Type D

Last updated

Type D
Avro Type D floatplane.jpg
An Avro Type D equipped as a floatplane. This particular aircraft made its first flight on 18 November 1911.
RoleExperimental aircraft
Manufacturer Avro
Designer Alliott Verdon Roe
First flight1 April 1911 [1]
Number built7

The Avro Type D was an aircraft built in 1911 by the pioneer British aircraft designer A.V. Roe. Roe had previously built and flown several aircraft at Brooklands, most being tractor layout triplanes. The Type D was his first biplane.

Contents

Design

The Type D was the first biplane design by A.V. Roe. Like his earlier aircraft, the Roe IV Triplane, it was of tractor (aircraft) configuration and had a triangular section ash fuselage, divided in two-halves bolted together behind the cockpit for ease of transportation. The high aspect ratio wings were braced in an irregular three-bay layout, the interval between the pairs of interplane struts increasing from the centre section outwards. Lateral control was by wing warping. The wing was mounted directly to the lower longeron of the fuselage, at the front of which was the 35 hp (26 kW) Green water-cooled engine, with the radiator mounted flat behind it in the direction of travel under the upper wing, between the fuselage and upper wing. Behind this a small coaming protected the passenger, with the pilot sitting behind. The empennage was similar to that of the Roe IV, with a low-mounted D-shaped rudder behind a small rectangular fixed fin and a large triangular tailplane bearing D-shaped elevators. The undercarriage had two forward-projecting skids, each mounted with a pair of wheels on a short axle.

Operational history

The Type D was first flown at Brooklands on 1 April 1911, piloted not by Roe but by C.H. Pixton, who reported that it was easy and pleasant to fly. [2] This assessment was confirmed a few days later when Lt. Wilfred Parke succeeded in flying it the length of Brooklands on his first attempt at flying an aircraft. [3] On 12 May Pixton flew the aircraft to Hendon to give a demonstration of the aircraft before the Parliamentary Aerial Defence Committee. During this occasion C.R. Samson was taken for a flight as a passenger, and A.V. Roe made his first solo flight in the aircraft. After Pixton had made a number of other flights, in June the aircraft was sold for £700 to Cdr Oliver Schwann of the Naval Airship Tender Hermione. It was sent by rail to Barrow-in-Furness, where Schwann converted it to a floatplane.

The second example built was a modified version, intended to compete in the £10,000 Daily Mail Circuit of Britain Race. As with all subsequent aircraft, the fuselage was lengthened by 2 ft (0.6 m). The central single radiator was replaced by a pair of panels mounted vertically along either side of the fuselage, and the lower wings were reduced in span, the overhang being braced by a pair of diagonal struts on either side. It was powered by a 60 hp 45 kW E.N.V. Type F. This was flown by R.C. Kemp, who was to fly it in the race. It proved to be fast, but the engine tended to overheat and the rate of climb was poor when loaded. Without Roe's approval, extensions were fitted to the lower wings, bringing them back to the original configuration. While making a short trial flight on the morning of the race, Kemp was making a fairly steep dive when the left-hand wing extension failed. The aircraft spun in from 150 ft (46 m): the aircraft was wrecked, but Kemp was unhurt.

Floatplane development

Cdr Schwann covered the rear section of the fuselage, modified the tailplane, moved the radiator to a position lying flat over the wing centre section and a series of experimental floats were lashed to the skids. Taxying trials were carried out in the Cavendish Dock using narrow flat-bottomed floats. On 18 November 1911, flown by Cdr Schwann it became the first seaplane to take off from British sea water. [4] It was reconstructed in 1912 as the Royal Aircraft Factory H.R.E.3 and was later flown as a landplane in 1913.

Specifications

Data from [1]

General characteristics

Performance

See also

Related Research Articles

Triplane aircraft wing configuration with three vertically stacked main wing surfaces

A triplane is a fixed-wing aircraft equipped with three vertical stacked wing planes. Tailplanes and canard foreplanes are not normally included in this count, although they may be occasionally.

Roe I Biplane

The Roe I Biplane was the first powered aircraft to be designed, built, and flown in England. Designed in an attempt to claim a prize offered by the Brooklands Automobile Racing Club, it was designed and built by Alliott Verdon Roe, who based it on a powered model with which he had won a Daily Mail prize of £75 at Alexandra Palace in April 1907. This prize was substantially larger: the club committee was offering £2,500 for the first person to fly a circuit of their three-mile (4.8 km) race track by the end of the year. In addition the Daily Graphic was offering a £1,000 prize for a flight of more than a mile (1.6 km).

Roe I Triplane 1909 aircraft by A.V. Roe

The Roe I Triplane was an early aircraft designed and built by A.V. Roe which was the first all-British aircraft to fly..

Roe IV Triplane

The Roe IV Triplane was an early British aircraft designed by Alliott Verdon Roe and built by A.V. Roe and Company. It was first flown in September 1910.

Avro 500 aircraft

The Avro Type E, Type 500, and Type 502 made up a family of early British military aircraft, regarded by Alliott Verdon Roe as his firm's first truly successful design. It was a forerunner of the Avro 504, one of the outstanding aircraft of the First World War.

British Army Aeroplane No 1 experimental aircraft, first to fly more than one mile in Europe

The British Army Aeroplane No 1 or sometimes Cody 1 was a biplane built by Samuel Franklin Cody in 1907 at the Army Balloon Factory at Farnborough. It made the first recognised powered and sustained flight in the United Kingdom on 16 October 1908.

The Lakes Water Bird, sometimes known as the Avro Curtiss-type is remembered as the first consistently successful British seaplane, developed by the Windermere-based Lakes Flying Co, during 1911.

The Avro Burga was built by Avro for R.F. Burga to test his unique system of lateral control. It was a single-engined two-seat monoplane, fitted with differentially operated surfaces above and below the central fuselage.

Handley Page H.P.31 Harrow

The Handley Page H.P.31 was a two-seat single-engined biplane built to a British specification for a carrier-based torpedo bomber and reconnaissance aircraft. After trials, the Blackburn Ripon was preferred, though the Harrow played a significant role in the development of automatic slots.

The Boulton & Paul P.12 Bodmin was an experimental British twin-engined biplane bomber with its engines mounted in a fuselage engine room and with tandem pairs of tractor and pusher airscrews mounted between the wings. The two Bodmins built flew in 1924, proving the concept but the layout was not developed to production.

Latécoère 4

The Latécoère 4 was a three-engined, 15-passenger biplane built in France in the early 1920s. It proved difficult to fly and was discontinued, though a second machine was completed as the Latécoère 5 bomber.

Parnall Possum

The Parnall Possum was an experimental triplane, with a single, central engine driving wing mounted propellers via shafts and gears. Two of these British aircraft were built in the mid-1920s.

Dunne D.8

The Dunne D.8 of 1912 was a tailless swept wing biplane, designed by J. W. Dunne to have inherent stability. One example was supplied to RAE Farnborough. License-built Burgess-Dunne models were used by the US Signal Corps and United States Navy and the short-lived Canadian Aviation Corps. It was the latter's first and only warplane.

The Perry Beadle T.1 was a single-seat, single engine biplane built and flown in the United Kingdom in 1913. In 1914 it flew with a more powerful engine and other modifications as the Perry Beadle T.2, which was acquired by the Royal Navy Air Service at the outbreak of World War I.

The Gaunt biplane no.2 'Baby' was a single-engine, single-seat biplane, designed by John Gaunt and flown by him with some success from Southport sands in Lancashire, England during the summer of 1911.

The Sopwith Admiralty Types 137 and 138 were a pair of single-engine, two-seat naval biplane floatplanes, built to a British Admiralty order in 1914. They were similar in design, but having a more powerful engine the Type 138 was the larger and heavier. They were used in early torpedo dropping experiments in 1914.

Curtiss Cox Racer

The Curtiss Model 22 Cox Racers were two specialised racing aircraft built by the American Curtiss Aeroplane and Motor Company. The type was flown as a monoplane, biplane and triplane.

The Kondor D 7 was a prototype German single seat biplane fighter built over the winter of 1917-18. It was not a success and its development was soon abandoned.

The Potez 26 was a single seat fighter aircraft designed and flown in France in the mid-1920s. It did not reach production.

The Aviatik 30.24 was a prototype Austro-Hungarian triplane fighter built by Aviatik in World War I.

References

  1. 1 2 Sharpe, Michael. Biplanes, Triplanes, and Seaplanes, pg.56. London, England: Friedman/Fairfax Books , 2000. ISBN   1-58663-300-7.
  2. Jackson 1965, p.26
  3. Brooklands Aerodrome Flight magazine 22 April 1911
  4. Jackson 1965 p.28