Avro 529 | |
---|---|
Role | Long-range bomber |
National origin | United Kingdom |
Manufacturer | A.V. Roe & Co. |
First flight | April 1917 |
Number built | 2 |
Developed from | Avro Pike |
The Avro 529 was a twin-engined biplane long-range bomber of the First World War. Two prototypes were built but no production ensued.
The Avro 529 [1] was Avro's second twin-engined aircraft and their second attempt at a heavy bomber. Their first in both categories was the Pike, developed in early 1916 to Royal Flying Corps (RFC) guidelines for a short-range bomber. The Pike arrived too late to secure orders from the RFC who would order the Handley-Page O/100 and for the Royal Naval Air Service (RNAS) who had ordered the Short Bomber. Nonetheless, after trials of the Pike, the Admiralty ordered two prototypes of an enlarged Pike for a long-range bomber role. This was the Type 529.
Like the Pike, it was a large twin-engined biplane of the then-standard wood and canvas construction. It had three-bay wings without sweepback, dihedral or stagger, partly to facilitate wing folding. [1] The vertical tail was different from that of the Pike: it had a small, roughly triangular fin and a rudder with a round balance surface above the fin, a reminder of Avro's "comma" rudder form.
The fuselage was rectangular in cross-section and seated three in separate cockpits. The pilot sat just forward of the wing leading edge, there was a gunner's position (with emergency dual control) midway between the trailing edge and the tail and the front gunner/bomb-aimer's position was in the nose. [1] Both gunners' positions were provided with a .303 in (7.7 mm) Lewis Gun mounted on a Scarff ring. The landing gear used two main wheels on split axles, plus a tail-skid.
The two prototypes differed from each other chiefly in their powerplants. The first, [1] just known as the Avro 529, had a pair of uncowled Rolls-Royce Falcon water-cooled in-line engines mounted midway between the wings. Each produced 190 hp (140 kW) and drove four-bladed, opposite-handed wooden airscrews. It carried 140 gal (636 L) of fuel in a tank in the centre fuselage.
The second machine, [1] designated the Avro 529A, had a pair 230 hp (170 kW) BHP in-line water-cooled engines, cowled and mounted in nacelles on the lower wing. These drove wooden, two-bladed airscrews. In this aircraft fuel was held in a pair of 60 gal (273 L), one in each nacelle. Fuel was pumped from these to 10 gal (45 L) tanks above the engines by wind-driven pumps, and fed to the motors under gravity.
The type 529A had slightly different wings to the first prototype, 13 in (33 cm) greater in span, smaller in area and hence of higher aspect ratio. It was about 8% lighter. [1]
Another difference between the two prototypes were the arrangements for the bomb-aimer. [1] In the first machine, this was done from the seat of the front cockpit, but in the 529A there was provision for a prone bomb-aimer's position with a small window, noticeable in side view. From there, he communicated with the pilot by Gosport tube. The 529A could carry 20 50 lb (20 kg) bombs racked nose up inside the fuselage between the lower wing spars.
The Type 529 was, even with the B.H.P. engines rather low powered, but seems to have handled well apart from poor elevator control. There was no production order and the type was not developed further. [1]
Data from Jackson 1965, pp. 93–4
General characteristics
Performance
Armament
The Handley Page Type O was a biplane bomber used by Britain during the First World War. When built, the Type O was the largest aircraft that had been built in the UK and one of the largest in the world. There were two main variants, the Handley Page O/100 (H.P.11) and the Handley Page O/400 (H.P.12).
The Focke-Wulf Fw 191 was a prototype German bomber of World War II, as the Focke-Wulf firm's entry for the Bomber B advanced medium bomber design competition. Two versions were intended to be produced, a twin-engine version using the Junkers Jumo 222 engine and a four-engine variant which was to have used the smaller Daimler-Benz DB 605 engine. The project was eventually abandoned due to technical difficulties with the engines.
The Avro 549 Aldershot was a British single-engined heavy bomber aircraft built by Avro.
The Airco DH.11 Oxford was a British twin-engined biplane bomber which was designed to replace the earlier Airco DH.10 Amiens. It was designed to use the unsuccessful ABC Dragonfly engine and was abandoned after the first prototype was built.
The PZL.48 Lampart (leopard) was a Polish heavy fighter-bomber design, that remained only a project, owing to the outbreak of World War II.
The Avro 523 Pike was a British multi-role combat aircraft of the First World War that did not progress past the prototype stage. It was intended to provide the Royal Naval Air Service with an anti-Zeppelin fighter that was also capable of long-range reconnaissance and bombing.
The Blackburn T.4 Cubaroo was a British prototype biplane torpedo bomber of the 1920s. Built by Blackburn Aircraft and intended to carry a large 21 in (533 mm) torpedo, the Cubaroo was claimed to be the largest single-engined aircraft in the world at the time of its first flight.
The Savoia-Marchetti SM.91 was a two-seat, twin-engined, Italian heavy fighter prototype, designed to compete in a 1942 revision to a long-range fighter-bomber contract offered by the Regia Aeronautica to Italian aircraft companies in 1938. The original 1938 specification yielded the Savoia-Marchetti SM.88, which the SM.91 was largely based on.
The Avro Type 557 Ava was a British twin-engined biplane torpedo bomber of the 1920s. It was developed by Avro to meet a requirement for a heavy torpedo bomber for the Royal Air Force but was unsuccessful, only two prototypes being built.
The Avro 533 Manchester was a First World War-era twin-engine biplane photo-reconnaissance and bomber aircraft designed and manufactured by Avro.
The Grahame-White Ganymede was a prototype British heavy night bomber intended to serve with the Royal Air Force in the First World War. A large, three-engined, twin-boom biplane, the sole prototype Ganymede did not fly until after the war had ended, and although an attempt was made to convert the aircraft to an airliner, it was unsuccessful.
The Bristol Berkeley was built to a British government specification for a single-engine day or night bomber. Three of these two-seat biplanes were built, but no contract for further production was awarded.
The de Havilland DH.27 Derby was a large single-engined biplane designed to a heavy day bomber Air Ministry specification. It did not reach production.
The Handley Page Handcross was a single-engined biplane day bomber built to an Air Ministry specification. It was not put into production and only the three prototypes were built.
The Handley Page H.P.43 was a three-engined biplane bomber-transport built to an Air Ministry specification. It did not fly well and the biplane configuration was out-dated at completion; the only one constructed was later turned into a monoplane and led to the Handley Page H.P.54 Harrow.
The Handley Page H.P.31 was a two-seat single-engined biplane built to a British specification for a carrier-based torpedo bomber and reconnaissance aircraft. After trials, the Blackburn Ripon was preferred, though the Harrow played a significant role in the development of automatic slots.
The sole Boulton & Paul P.32 was a British three-engined biplane built to an Air Ministry specification for a long range night bomber. A lack of engine availability slowed construction and by the time it went for tests the thinking on bomber types had moved on.
The Sopwith Cobham was a British twin-engined triplane bomber aircraft designed and built by the Sopwith Aviation Company during the First World War. The only twin-engined aircraft built by Sopwith, the Cobham did not fly until after the end of the war, and was unsuccessful due to the failure of its engines, only three prototypes being built.
The Blackburn G.P seaplane,, was a British twin-engine reconnaissance torpedo floatplane of the First World War, built by the Blackburn Aeroplane and Motor Co Ltd.
The Sopwith 2B2 Rhino was a British two-seat triplane bomber designed and built by Sopwith Aviation Company as a private venture. The Rhino was powered by a 230 hp (172 kW) Beardmore Halford Pullinger inline piston engine. Only two aircraft were built and the type did not enter production.