| CANT 25 | |
|---|---|
 | |
| The CANT 25M, the initial version of the CANT 25. | |
| Role | Flying-boat fighter |
| Manufacturer | CANT |
| Designer | Raffaele Conflenti |
| First flight | 1927 |
| Introduction | 1931 |
| Primary user | Regia Aeronautica |
The CANT 25 was an Italian shipboard single-seat sesquiplane flying boat fighter that entered service with the Regia Aeronautica (Italian Royal Air Force) in 1931.
The CANT 25 was developed from the earlier CANT 18 flying boat to meet a requirement for a flying boat fighter for the Regia Aeronautica. The aircraft was of wooden construction and was armed with two fixed, forward-firing 7.7-millimeter (0.303-inch) Vickers machine guns. [1] It was built in two versions, the CANT 25M with removable wings and the CANT 25AR which was strengthened for catapult launching and had folding wings.
The CANT 25M appeared first, in 1931. It had Warren truss-type interplane bracing and a 306-kilowatt (410-horsepower) Fiat A.20 12-cylinder water-cooled engine mounted to drive a two-bladed pusher propeller, and was used for catapult trials aboard warships of the Regia Marina (Italian Royal Navy). It was replaced by the CANT 25AR—AR stood for Ali Ripiegabili, Italian for "Folding Wings"—which instead had vertical interplane bracing struts to allow the outer panels of the wings to fold to the rear. It also had strengthened tailplane bracing and a more powerful engine, a 328-kilowatt (440-horsepower) version of the Fiat A.20. [1]
Kingdom of Italy Data from Green, William, and Gordon Swanborough. The Complete Book of Fighters: An Illustrated Encyclopedia of Every Fighter Aircraft Built and Flown. New York: SMITHMARK Publishers, 1994. ISBN 0-8317-3939-8. p. 108.
General characteristics
Performance
•Maximum speed: 245 km/h (152 mph; 132 kn) at sea level
•Climb rate: 26 min 30 sec to 5,000 m (16,405 ft)
•Range: 900 km (560 mi) at 120 km/h (74 mph; 65 kn) Armament
Related lists
The Fiat CR.20 was an Italian biplane fighter used during the 1920s and 1930s. Designed by Celestino Rosatelli, it represented an intermediate step from the early biplane CR.1 and the later, successful series CR.30, CR.32 and CR.42.
The Caproni Vizzola F.5 was an Italian fighter aircraft that was built by Caproni. It was a single-seat, low-wing cantilever monoplane with retractable landing gear.
The IMAM Ro.51 was an Italian fighter aircraft that first flew in 1937. It was designed for the 1936 new fighter contest for the Regia Aeronautica, with practically all the Italian aircraft builders involved.
The IMAM Ro.57 was an Italian twin-engined, single-seat monoplane fighter of the Regia Aeronautica. Based on a 1939 design by Giovanni Galasso the aircraft did not enter production until 1943.
The Caproni Ca.114 was a fighter biplane produced in Italy in the early 1930s which was flown operationally in Peru in the 1930s and 1940s.
The SIAI S.52 was an Italian fighter prototype of 1924.
The Caproni Ca.70 was a two-seat night fighter and ground attack biplane produced in Italy in 1925. It was the only Italian aircraft designed from the outset as a night fighter.
The Caproni Ca.71, originally Ca.70L, was a two-seat biplane night fighter produced in Italy in 1927. It was derived from the Caproni Ca.70 of 1925.
The Caproni CH.1 was a single-seat biplane fighter, a single example of which was produced as a prototype in Italy in 1935.
The Caproni Ca.331 Raffica was an Italian aircraft built by Caproni in the early 1940s as a tactical reconnaissance aircraft/light bomber and also as a night fighter.
The Piaggio P.2 was an Italian fighter prototype of advanced design built by Piaggio in 1923.
The Gabardini G.8 was an Italian single-seat aircraft produced in both fighter and trainer versions by Gabardini in 1923.
The Gabardini G.9 was an Italian single-seat biplane fighter prototype produced by Gabardini in 1923.
The Marchetti MVT, later renamed SIAI S.50, was an Italian fighter of 1919 and the early 1920s.
The SIAI S.58 or Savoia-Marchetti S.M.58 was an Italian flying boat fighter prototype of the 1920s designed and manufactured by SIAI.
The SIAI S.67 or Savoia Marchetti SM.67 was an Italian flying boat fighter of the early 1930s designed and manufactured by SIAI.
The Macchi M.26 was an Italian flying boat fighter prototype of 1924 designed and manufactured by Macchi.
The Macchi M.71 was an Italian flying boat fighter of the 1930s designed and manufactured by Macchi.
The Macchi M.6 was an Italian flying boat fighter prototype of 1917.
The SIAI S.51, Savoia Marchetti S.51 or Savoia S.51 was an Italian racing flying boat built by SIAI for the 1922 Schneider Trophy race.
