Carbon nanotube computer

Last updated

Carbon nanotube computers are a class of experimental computing processors constructed from carbon nanotube field-effect transistors, instead of from conventional silicon-based field-effect transistors.

Contents

In a carbon nanotube field-effect transistor (CNTFET), the conduction channel is made from carbon nanotubes, rather than from doped silicon. In theory, CNTFETs are more efficient than silicon FETs: CNFETs require less energy to turn them on and off, and the slope between on/off states is steeper. These factors contribute to an energy–delay product (an energy efficiency metric) that is an order of magnitude better than with silicon-based transistors. [1] Moreover, carbon is an excellent conductor of heat, and carbon-based transistors can therefore dissipate heat much faster than silicon-based ones. This factor, combined with better heat tolerance, could theoretically allow carbon nanotube transistors to be packed more densely together, [2] which in turn could reduce material and electrical losses.

These characteristics suggest that carbon nanotubes are a potential substitute for silicon with regards to CNTFETs and logic circuits. But CNTFETs cannot (yet) be mass manufactured, and therefore carbon nanotube processors cannot either, and both are currently limited to research facilities where they are manually assembled. The first carbon nanotube computer was built in 2013 by Max Shulaker and coworkers at Stanford University. [3] This one-bit processor, named Cedric, ran at 1 KHz and contained just 178 transistors. Since then, many research teams have built increasingly complex processors with CNTFETs. In 2019, a team of engineers from the Massachusetts Institute of Technology and Analog Devices created a programmable 16-bit, ~15,000-transistor processor called the RV16X-NANO. [4]

Major milestones

Cedric

Carbon nanotubes are difficult to position accurately on a substrate, but in 2012 IBM researchers discovered that carbon nanotubes could be made to chemically self-assemble themselves into patterned arrays in which the nanotubes stick in some areas of the surface while leaving other areas untouched.

In 2013, a team of researchers at Stanford University refined the technique discovered at IBM such that misaligned nanotubes could be destroyed on the wafer, leaving only the aligned ones intact. To destroy the misaligned nanotubes, the researchers subjected them to high voltage, which vaporized them. [5] The researchers used the same method to eliminate transistors in which the carbon nanotubes were unswitchable conductors (thus nicknamed "metallic" nanotubes).

The researchers applied these refinements to a wafer with 197 8-micrometer (8,000 nanometer) carbon nanotube based transistors on a silicon oxide substrate, leaving 178 usable transistors. With these, the researchers created a one-bit, single-instruction, Turing-complete processor. [1] Named 'Cedric', the only operation the computer could perform was SUBNEG, short for "subtract and branch if negative". With SUBNEG, Cedric could count and sort integers, [3] [6] [7] and could switch between sorting and counting modes. [1]

RV16XNano

In 2019, a team at the Massachusetts Institute of Technology in cooperation with engineers from Analog Devices created a 16-bit programmable processor with nearly 15,000 carbon nanotube transistors. [8] Called RV16XNano, the processor implemented a significant portion of the 32-bit RISC-V instruction set [9] and was able to execute a "Hello, World!" program that said "Hello, world! I am RV16XNano, made from CNTs". [4]

Related Research Articles

<span class="mw-page-title-main">Integrated circuit</span> Electronic circuit formed on a small, flat piece of semiconductor material

An 'integrated circuit, also known as a microchip or IC, is a small electronic device made up of multiple interconnected electronic components such as transistors, resistors, and capacitors. These components are etched onto a tiny piece of semiconductor material, usually silicon. Integrated circuits are used in a wide range of electronic devices, including computers, smartphones, and televisions, to perform various functions such as processing and storing information. They have greatly impacted the field of electronics by enabling device miniaturization and enhanced functionality.

<span class="mw-page-title-main">Semiconductor device fabrication</span> Manufacturing process used to create integrated circuits

Semiconductor device fabrication is the process used to manufacture semiconductor devices, typically integrated circuits (ICs) such as computer processors, microcontrollers, and memory chips that are present in everyday electronic devices. It is a multiple-step photolithographic and physio-chemical process during which electronic circuits are gradually created on a wafer, typically made of pure single-crystal semiconducting material. Silicon is almost always used, but various compound semiconductors are used for specialized applications.

<span class="mw-page-title-main">Transistor</span> Solid-state electrically operated switch also used as an amplifier

A transistor is a semiconductor device used to amplify or switch electrical signals and power. It is one of the basic building blocks of modern electronics. It is composed of semiconductor material, usually with at least three terminals for connection to an electronic circuit. A voltage or current applied to one pair of the transistor's terminals controls the current through another pair of terminals. Because the controlled (output) power can be higher than the controlling (input) power, a transistor can amplify a signal. Some transistors are packaged individually, but many more in miniature form are found embedded in integrated circuits. Because transistors are the key active components in practically all modern electronics, many people consider them one of the 20th century's greatest inventions.

<span class="mw-page-title-main">Very Large Scale Integration</span> Creating an integrated circuit by combining many transistors into a single chip

Very-large-scale integration (VLSI) is the process of creating an integrated circuit (IC) by combining millions or billions of MOS transistors onto a single chip. VLSI began in the 1970s when MOS integrated circuit chips were developed and then widely adopted, enabling complex semiconductor and telecommunication technologies. The microprocessor and memory chips are VLSI devices.

<span class="mw-page-title-main">Moore's law</span> Observation on the growth of integrated circuit capacity

Moore's law is the observation that the number of transistors in an integrated circuit (IC) doubles about every two years. Moore's law is an observation and projection of a historical trend. Rather than a law of physics, it is an empirical relationship linked to gains from experience in production.

A thin-film transistor (TFT) is a special type of field-effect transistor (FET) where the transistor is made by thin film deposition. TFTs are grown on a supporting substrate. A common substrate is glass, because the traditional application of TFTs is in liquid-crystal displays (LCDs). This differs from the conventional bulk metal oxide field effect transistor (MOSFET), where the semiconductor material typically is the substrate, such as a silicon wafer.

<span class="mw-page-title-main">Nanoelectromechanical systems</span> Class of devices for nanoscale functionality

Nanoelectromechanical systems (NEMS) are a class of devices integrating electrical and mechanical functionality on the nanoscale. NEMS form the next logical miniaturization step from so-called microelectromechanical systems, or MEMS devices. NEMS typically integrate transistor-like nanoelectronics with mechanical actuators, pumps, or motors, and may thereby form physical, biological, and chemical sensors. The name derives from typical device dimensions in the nanometer range, leading to low mass, high mechanical resonance frequencies, potentially large quantum mechanical effects such as zero point motion, and a high surface-to-volume ratio useful for surface-based sensing mechanisms. Applications include accelerometers and sensors to detect chemical substances in the air.

The transistor count is the number of transistors in an electronic device. It is the most common measure of integrated circuit complexity. The rate at which MOS transistor counts have increased generally follows Moore's law, which observes that transistor count doubles approximately every two years. However, being directly proportional to the area of a chip, transistor count does not represent how advanced the corresponding manufacturing technology is: a better indication of this is transistor density.

<span class="mw-page-title-main">Potential applications of carbon nanotubes</span>

Carbon nanotubes (CNTs) are cylinders of one or more layers of graphene (lattice). Diameters of single-walled carbon nanotubes (SWNTs) and multi-walled carbon nanotubes (MWNTs) are typically 0.8 to 2 nm and 5 to 20 nm, respectively, although MWNT diameters can exceed 100 nm. CNT lengths range from less than 100 nm to 0.5 m.

In semiconductor electronics fabrication technology, a self-aligned gate is a transistor manufacturing approach whereby the gate electrode of a MOSFET is used as a mask for the doping of the source and drain regions. This technique ensures that the gate is naturally and precisely aligned to the edges of the source and drain.

Nanoelectronics refers to the use of nanotechnology in electronic components. The term covers a diverse set of devices and materials, with the common characteristic that they are so small that inter-atomic interactions and quantum mechanical properties need to be studied extensively. Some of these candidates include: hybrid molecular/semiconductor electronics, one-dimensional nanotubes/nanowires or advanced molecular electronics.

Nanocircuits are electrical circuits operating on the nanometer scale. This is well into the quantum realm, where quantum mechanical effects become very important. One nanometer is equal to 10−9 meters or a row of 10 hydrogen atoms. With such progressively smaller circuits, more can be fitted on a computer chip. This allows faster and more complex functions using less power. Nanocircuits are composed of three different fundamental components. These are transistors, interconnections, and architecture, all fabricated on the nanometer scale.

A transistor is a semiconductor device with at least three terminals for connection to an electric circuit. In the common case, the third terminal controls the flow of current between the other two terminals. This can be used for amplification, as in the case of a radio receiver, or for rapid switching, as in the case of digital circuits. The transistor replaced the vacuum-tube triode, also called a (thermionic) valve, which was much larger in size and used significantly more power to operate. The first transistor was successfully demonstrated on December 23, 1947, at Bell Laboratories in Murray Hill, New Jersey. Bell Labs was the research arm of American Telephone and Telegraph (AT&T). The three individuals credited with the invention of the transistor were William Shockley, John Bardeen and Walter Brattain. The introduction of the transistor is often considered one of the most important inventions in history.

A carbon nanotube field-effect transistor (CNTFET) is a field-effect transistor that utilizes a single carbon nanotube (CNT) or an array of carbon nanotubes as the channel material, instead of bulk silicon, as in the traditional MOSFET structure. There have been major developments since CNTFETs were first demonstrated in 1998.

This article details the history of electronics engineering. Chambers Twentieth Century Dictionary (1972) defines electronics as "The science and technology of the conduction of electricity in a vacuum, a gas, or a semiconductor, and devices based thereon".

In computing and computer science, a processor or processing unit is an electrical component that performs operations on an external data source, usually memory or some other data stream. It typically takes the form of a microprocessor, which can be implemented on a single or a few tightly integrated metal–oxide–semiconductor integrated circuit chips. In the past, processors were constructed using multiple individual vacuum tubes, multiple individual transistors, or multiple integrated circuits.

<span class="mw-page-title-main">Deji Akinwande</span> Nigerian-American professor of Electrical and Computer Engineering

Deji Akinwande is a Nigerian-American professor of Electrical and Computer Engineering with courtesy affiliation with Materials Science at the University of Texas at Austin. He was awarded the Presidential Early Career Award for Scientists and Engineers in 2016 from Barack Obama. He is a Fellow of the American Physical Society, the African Academy of Sciences, the Materials Research Society (MRS), and the IEEE.

Max M. Shulaker is a Stanford-educated American electrical engineer and a professor at MIT credited with the development of the first carbon nanotube computer and the first modern microprocessor built from carbon nanotube transistors. His research was widely reported in US and British media.

References

  1. 1 2 3 Shulaker, Max M.; Hills, Gage; Patil, Nishant; Wei, Hai; Chen, Hong-Yu; Wong, H.-S. Philip; Mitra, Subhasish (2013). "Carbon nanotube computer". Nature . 501 (7468): 526–530. Bibcode:2013Natur.501..526S. doi:10.1038/nature12502. PMID   24067711. S2CID   205235321.
  2. ↑ Moore, Samuel K. (14 December 2020). "Scaled-Down Carbon Nanotube Transistors Inch Closer to Silicon Abilities Solution to gate dielectric problem makes devices easier to turn off". IEEE Spectrum . Retrieved 7 July 2022.
  3. 1 2 Markoff, John (26 September 2013). "Researchers Build a Working Carbon Nanotube Computer". New York Times. Retrieved 26 September 2013.
  4. 1 2 Gibney, Elizabeth (28 August 2019). "Biggest carbon-nanotube chip yet says 'Hello, World!'". Nature News. doi:10.1038/d41586-019-02576-7. PMID   32848234. S2CID   203021651.
  5. ↑ Morgan, James (26 September 2013). "First computer made of carbon nanotubes is unveiled". BBC. Retrieved 26 September 2013.
  6. ↑ Kim, Meeri (26 September 2013). "Scientists create first carbon nanotube computer". Washington Post. Retrieved 26 September 2013.
  7. ↑ Courtland, Rachel (25 September 2013). "First Computer Made From Carbon Nanotubes Debuts". IEEE Spectrum . Retrieved 19 September 2019.
  8. ↑ Moore, Samuel K. (28 August 2019). "A Carbon Nanotube Microprocessor Mature Enough to Say Hello". IEEE Spectrum . Retrieved 19 September 2019.
  9. ↑ Shulaker, Max M.; Chandrakasan, Anantha; Murphy, Denis; Stein, Yosi; Amer, Aya; Kanhaiya, Pritpal; Srimani, Tathagata; Bishop, Mindy D.; Fuller, Samuel; Wright, Andrew; Lau, Christian; Hills, Gage (2019). "Modern microprocessor built from complementary carbon nanotube transistors". Nature . 572 (7771): 595–602. Bibcode:2019Natur.572..595H. doi:10.1038/s41586-019-1493-8. ISSN   1476-4687. PMID   31462796. S2CID   201658375.
This page is based on this Wikipedia article
Text is available under the CC BY-SA 4.0 license; additional terms may apply.
Images, videos and audio are available under their respective licenses.