EEL ULF 1

Last updated

ULF 1
EEL ULF 1 D-NZJH at Aero Friedrichshafen 2016.jpg
Role Glider
National origin West Germany
Manufacturer Entwicklung und Erprobung von Leichtflugzeugen (EEL)
Designer Dieter Reich
First flightNovember 1977
IntroductionAugust 1978
StatusPlans no longer available
Produced1978-2019
Number builtMore than 40

The EEL ULF 1 is a West German high-wing, single-seat, foot-launched, microlift glider that was designed by Dieter Reich. When it was available it was provided in the form of plans by Entwicklung und Erprobung von Leichtflugzeugen (EEL) (English: Development and Testing of Light Aircraft) for amateur construction. By the end of 2019 the company website had been take down and it is likely that the company has gone out of business. [1] [2]

Contents

Design and development

The ULF 1 was first flown in November 1977 and first shown at the 3rd International Hang Glider Meet at the Wasserkuppe in August 1978. The prototype was built by Reich's partner at EEL, Heiner Neumann. The design was intended to be able to soar in weak ridge and thermal lift. [1] [2]

The aircraft is made from spruce, birch plywood and balsa, covered in doped aircraft fabric and features conventional full three axis controls. Its two-piece, single-spar 10.4 m (34.1 ft) span wing is a cantilever design and employs a Wortmann FX 63-137 airfoil. Glide path control is via spoilers on the wing top surface. The aircraft is normally flown without a windshield, but a Plexiglas canopy is optional. The aircraft's best glide ratio is 16:1 at 55 km/h (34 mph). With both the canopy and pilot doors fitted the best glide ratio is 18:1. The landing gear is a fixed skid and the aircraft is equipped with a ballistic parachute full aircraft rescue system. The aircraft is normally transported by trailer and can be assembled in 10 minutes. [1] [2] [3]

The ULF 1 was approved in West Germany in July 1980 and Australia in 1983. [2]

The ULF 1 can be foot-launched from slopes of at least 15°. The pilot foot launches the aircraft suspending it on the shoulder harness and, once airborne sits on a retractable slat seat and closes two partial lower doors. It can also be launched by bungee launch, winch-launch, auto-tow and aerotow. [2]

The cost of building the aircraft from plans is estimated by the designer as €2500. In 2011 the plans cost €150 and were available in German and English. The plans consist of 31 blueprint pages and a 37-page construction manual. The manufacturer claims a build time of about 1000 hours. [2] [4]

Operational history

The prototype has flown more than 200 flights totalling over 150 hours, most of which were foot-launched. The longest flight flown by a ULF 1 is six hours and 140 km (87 mi). [2]

More than 40 examples have been completed and flown. [2]

Specifications (ULF 1)

Data from Bertrand and company website [1] [3]

General characteristics

Performance

See also

Related lists

Related Research Articles

Schempp-Hirth Standard Cirrus German single-seat glider, 1969

The Standard Cirrus is a German Standard-class glider built by Schempp-Hirth. The Standard Cirrus was produced between 1969 and 1985, when it was replaced by the Discus. Over 800 examples were built, making it one of the most successful early fibreglass glider designs.

Schleicher ASK 23 German glider, 1983

The Schleicher ASK 23 is a single-seat Club Class sailplane that was built by the German manufacturer Alexander Schleicher GmbH & Co.

Schweizer SGS 1-34

The Schweizer SGS 1-34 is a United States Standard Class, single-seat, high-wing glider built by Schweizer Aircraft of Elmira, New York.

The SZD-35 Bekas (Snipe) is a two-seater glider aircraft that was designed and built in Poland.

The IKV-3 "Kotka" is an FAI Open Class glider that was designed by Tuomo Tervo and Jorma Jalkanen. The prototype first flew in 1966. It was produced initially by IK-Vasama and KK. Lehtovaara.

The Gehrlein GP-1 is an American mid-wing, single seat FAI Standard Class glider that was designed by Jay and Rod Gehrlein and first flown in July 1968.

The Whigham GW-2 is an American high-wing, single-seat, V-tailed, FAI Open Class glider that was designed and constructed by Gene Whigham, a retired flight test engineer for Convair.

Glasflügel 205 Club Libelle German single-seat glider, 1975

The Glasflügel 205 Club Libelle is a high wing, T-tailed, single seat glider that was designed and produced in West Germany by Glasflügel for club and rental use.

Lehtovaara PIK-16 Vasama

The Lehtovaara PIK-16 Vasama is a Finnish mid-wing, single-seat, FAI Standard Class glider that was designed by Tuomo Tervo, Jorma Jalkanen and Kurt Hedstrom, who were students at the Polyteknikkojen Ilmailukerho (PIK) and produced by Lehtovaara.

SZD-51 Junior

The PZL Bielsko SZD-51 Junior is a Polish single-seat training and club sailplane.

PZL Krosno KR-03 Puchatek Polish glider

The PZL Krosno KR-03 Puchatek is a Polish mid-wing, T-tailed, two-seats-in-tandem, glider that was designed by Jerzy Krawczyk and Eugeniusz Pelczar and produced by PZL Krosno, first flying in 1985.

Rensselaer RP-1 American glider

The Rensselaer RP-1 is an American low-wing, single-seat, foot-launchable glider that was designed and produced by the Rensselaer Polytechnic Institute of Troy, New York. It first flew in 1980.

The ProFe Banjo is a family of Czech high-wing, strut-braced, T-tailed gliders and motor gliders designed and produced by ProFe in kit form for amateur construction.

Aviastroitel AC-6 Russian glider

The Aviastroitel AC-6 is a Russian mid-wing, single-seat FAI 15 Metre Class glider that was designed and manufactured by Aviastroitel, now Glider Air Craft.

The Aviastroitel AC-7 is a Russian mid-wing, T-tailed, two seats in side-by-side configuration, glider that was designed by Vladimir Egorovich Fedorov and produced by Aviastroitel, now Glider Air Craft. It first flew in 2007.

EEL ULF 2 German single-seat motor glider, 1993

The EEL ULF-2 is a German low-wing, conventional landing gear, single-seat motor glider that was designed by Dieter Reich and is provided in the form of plans by Entwicklung und Erprobung von Leichtflugzeugen for amateur construction.

The Akaflieg Braunschweig SB-8 is an experimental, single-seat, high performance glider built in Germany in the 1960s, constructed largely from glass fibre skin over built up balsa wood structure. Two were built; the second of which was later fitted with a high aspect ratio (30:1) wing, becoming the Akaflieg Braunschweig SB-9 Stratus.

ISF Mistral-C German single-seat glider, 1976

The Mistral-C was one of the first gliders, designed in 1974 to the then new Club Class rules. It was based on the Strauber Mistral, a Standard Class glider flown a year earlier, but with a new wing and built from newer composite materials. Both types were designed and constructed in Germany. More than 75 Mistral-Cs were produced.

The Schleicher K 10 is a Standard class competition glider, designed by Rudolf Kaiser and built in Germany in 1963. Only a few were produced.

Entwicklung und Erprobung von Leichtflugzeugen (EEL) is a German aircraft design firm based in Putzbrunn. The company was founded in 1976 by Heiner Neumann and Dieter Reich. It specializes in the design of gliders and motor gliders, provided in the form of plans for amateur construction.

References

  1. 1 2 3 4 Bertrand, Noel; Rene Coulon; et al: World Directory of Leisure Aviation 2003-04, page 56. Pagefast Ltd, Lancaster OK, 2003. ISSN 1368-485X
  2. 1 2 3 4 5 6 7 8 Entwicklung und Erprobung von Leichtflugzeugen. "ULF 1 Description". Archived from the original on 9 September 2019. Retrieved 12 October 2011.
  3. 1 2 Entwicklung und Erprobung von Leichtflugzeugen (n.d.). "ULF 1 Technical Data" . Retrieved 12 October 2011.
  4. ↑ Entwicklung und Erprobung von Leichtflugzeugen. "Order Info" . Retrieved 12 October 2011.
This page is based on this Wikipedia article
Text is available under the CC BY-SA 4.0 license; additional terms may apply.
Images, videos and audio are available under their respective licenses.