F11 Sporty | |
---|---|
Role | Amateur-built aircraft |
National origin | Canada |
Manufacturer | Falconar Avia |
Designer | Chris Falconar |
Status | Plans available (2019) |
Number built | 101 (2011) |
Developed from | Jodel D11 |
Variants | Falconar F12A Cruiser |
The Falconar F11 Sporty is a Canadian amateur-built aircraft, that was designed by Chris Falconar and produced by Falconar Avia. Falconar supplied it as a kit or as plans for amateur construction. Today both the F11A and E models are available as plans from Manna Aviation. [1] [2] [3] [4] [5]
The F11 is a variant of the Jodel D11. Falconar indicated that it incorporates a larger cockpit, simplified fittings, shoulder harnesses and aerodynamic improvements to improve stall characteristics. [6]
Hans Teijgeler of Jodel.com says that the F11 varies from the D11 by using a new wing design, with new simplified spar and rib design and the dihedral point moved inboard, allowing the outer portion to fold for ground transport or storage, but at the cost of added weight. Teijgeler describes the wing as "less efficient". Teijgeler also notes that the F11 uses larger and heavier engines with higher fuel consumption. Teijgeler says of the Falconar F11, "the Falconar 'Jodel' should not be looked upon as a Jodel, but as a Falconar. This is [n]either good or bad. Just a fact to take into account" [7]
The F11 features a cantilever low-wing, a two-seats-in-side-by-side configuration enclosed cockpit that is 40 in (102 cm) wide, fixed conventional landing gear, or optionally tricycle landing gear, and a single engine in tractor configuration. [1]
The aircraft is made from wood, with its flying surfaces covered in doped aircraft fabric. Its 27.3 ft (8.3 m) span wing has an area of 138 sq ft (12.8 m2) and optionally can mount flaps. The aircraft's recommended engine power range is 65 to 140 hp (48 to 104 kW) and engines that have been used include the 100 hp (75 kW) Continental O-200, the 65 hp (48 kW) Continental A-65, the 100 to 116 hp (75 to 87 kW) Lycoming O-235, the 125 to 140 hp (93 to 104 kW) Lycoming O-290, the 65 to 113 hp (48 to 84 kW) Franklin 4AC, 65 to 85 hp (48 to 63 kW) Volkswagen air-cooled engine four-strokes and the 110 hp (82 kW) Hirth F-30 two-stroke powerplant. Construction time from the supplied kit varies depending on the model built. [1] [2]
The F11 was later developed into the larger Falconar F12A Cruiser, a two-seater with an option of a third seat. [1] [2]
By November 2012, 20 examples had been registered with Transport Canada, 13 in the United States with the Federal Aviation Administration and two with the CAA in the United Kingdom. [8] [9] [10]
Data from Kitplanes and Purdy [1] [2]
General characteristics
Performance
The Jodel D.11 is a French two-seat monoplane designed and developed by Société Avions Jodel in response to a French government request for a low-wing aircraft for use by the nation's many emerging flying clubs.
The Jodel D.9 Bébé is a French single-seat ultralight monoplane designed by Jean Délémontez for amateur construction.
The Druine D.5 Turbi was a light aircraft designed in France in the 1950s for home building. It was a low-wing cantilever monoplane with fixed tailskid undercarriage. The pilot and a single passenger sat in tandem, open cockpits. Essentially a scaled-up version of the Druine Turbulent design, the Turbi shared that aircraft's wooden construction. Again, like its predecessor, it was intended to be able to be powered by a variety of air-cooled engines.
The Falconar AMF-S14 Maranda is a two-seat, light aircraft first flown in Canada in 1961 and originally marketed for amateur construction by Falconar Avia.
The Jurca Gnatsum is a French homebuilt near scale replica aircraft based on the North American P-51 Mustang.
The Jurca MJ-5 Sirocco is a two-seat sport aircraft designed in France in the early 1960s and marketed for homebuilding. It is one of many wooden homebuilt designs from Romanian born designer Marcel Jurca. Jurca, a Henschel Hs 129 pilot in World War II marketed the plans in Canada and America through Falconar Aviation. It is a low-wing cantilever monoplane of conventional configuration and wooden construction throughout. The tandem seats are enclosed by a bubble canopy, and the tailwheel undercarriage can be built as either fixed or with retractable main units. Marcel Jurca died on 19 October 2001, at which time plans were still available from the designer's web site.
The CGS Hawk is a family of high wing, strut-braced, pusher configuration, single and two-seats-in-tandem ultralight aircraft, designed by Chuck Slusarczyk and manufactured by CGS Aviation.
The Falconar Golden Hawk is a Canadian tandem seat, pusher configuration, tricycle gear, canard-equipped ultralight aircraft that is offered in kit form by Falconar Avia of Edmonton, Alberta.
The Aero Synergie Jodel D20 is a French ultralight aircraft that was designed by Jean Délémontez and produced by Aero Synergie of Villefranche-de-Rouergue. The aircraft was supplied as a kit for amateur construction or as a completed aircraft.
The Jodel D18 is a French ultralight aircraft, designed and produced by Jodel.
The Jodel DR1050 Excellence and Ambassadeur are part of a family of French built aircraft, designed by Jean Délémontez in collaboration with Pierre Robin, as a development of the Jodel D.10 project. The aircraft was built from 1958 to 1967 both by Centre-Est Aeronautique (CEA) and by Société Aéronautique Normande (SAN) but since the demise of the latter in 1968 has only been supplied as plans.
The Falconar AMF-14H Maranda is a Canadian amateur-built aircraft, designed and originally produced by Falconar Avia for the Canadian basic ultralight class and US light-sport aircraft category. The aircraft is supplied as a kit or as plans for amateur construction.
The Falconar F12A Cruiser is a Canadian amateur-built aircraft, designed by Chris Falconar and originally produced as a kit by Falconar Avia. The aircraft is now supplied as plans for amateur construction by Manna Aviation.
The Falconar F9A and F10A are a family of Canadian amateur-built aircraft, that were designed by Chris Falconar and produced by Falconar Avia. The F9A design was introduced in 1965 and both the F9A and F10A were supplied as kits or as plans for amateur construction by Falconar. The F9A and F10A are now available in the form of plans from Manna Aviation.
The Falconar SAL Mustang, also called the 2/3 Mustang and the SAL P-51D Mustang is a Canadian amateur-built aircraft, originally produced by Falconar Avia and introduced in 1969. The aircraft is a 2⁄3 scale replica of the North American P-51 Mustang and is supplied as a kit or as plans for amateur construction.
The Falconar Minihawk is a Canadian amateur-built aircraft, originally produced by Falconar Avia. The aircraft is supplied as a kit or plans for amateur construction.
The Team Mini-Max AeroMax is an American amateur-built aircraft and light-sport aircraft, produced by Team Mini-Max of Niles, Michigan. The aircraft is supplied as a kit for amateur construction.
The Frontier MD-II was an American homebuilt aircraft that was designed and supplied as a kit by Frontier Aircraft Inc of Vail, Colorado, introduced in the 1990s.
The BDC Aero Puma is a Canadian ultralight and light-sport aircraft, originally designed by the Italian aircraft designer Antonio Bortolanza and built by Aeroplast of Sale, Piedmont, Italy. It is currently produced by BDC Aero Industrie of Lachute, Quebec. At one time available as a kit for amateur construction, now the aircraft is supplied only as a complete ready-to-fly-aircraft.
Manna Aviation is an Australian aircraft manufacturer based in Toronto, New South Wales, founded by Phil Hale. The company specializes in provision of parts and plans for amateur construction.
Wikimedia Commons has media related to Falconar F11 . |