F9A & F10A | |
---|---|
Role | Amateur-built aircraft |
National origin | Canada |
Manufacturer | Falconar Avia Manna Aviation |
Designer | Chris Falconar |
Introduction | 1965 |
Status | Plans available (2019) |
Number built | 30 (1998) |
Developed from | Jodel D9 |
The Falconar F9A and F10A are a family of Canadian amateur-built aircraft, that were designed by Chris Falconar and produced by Falconar Avia. The F9A design was introduced in 1965 and both the F9A and F10A were supplied as kits or as plans for amateur construction by Falconar. The F9A and F10A are now available in the form of plans from Manna Aviation. [1] [2] [3] [4]
The F9 is a variant of the Jodel D9. Falconar indicated that it incorporates a larger cockpit, simplified fittings, shoulder harnesses and aerodynamic improvements to improve stall characteristics. [5]
Hans Teijgeler of Jodel.com says that the F9A varies from the D9 by using a new wing design, with new simplified spar and rib design and the dihedral point moved inboard, allowing the outer portion to fold for ground transport or storage, but at the cost of added weight. He describes the wing as "less efficient". Teijgeler says of the Falconar F9A, "the Falconar 'Jodel' should not be looked upon as a Jodel, but as a Falconar. This is [n]either good or bad. Just a fact to take into account" [6]
The F9A features a cantilever low-wing, a single seat enclosed cockpit that is 21 in (53 cm) wide, fixed conventional landing gear and a single engine in tractor configuration. [1]
The F9A and F10A are made from wood, with the flying surfaces covered in doped aircraft fabric. Its 23 ft (7.0 m) span wing has an area of 99 sq ft (9.2 m2). Construction time from the supplied kit is estimated as 700 hours. [1]
By November 2012, one F9A had been registered with Transport Canada, one F10A in the United States with the Federal Aviation Administration and none with the CAA in the United Kingdom. [7] [8] [9]
Data from Purdy [1]
General characteristics
Performance
The Jodel D.11 is a French two-seat monoplane designed and developed by Société Avions Jodel in response to a French government request for a low-wing aircraft for use by the nation's many emerging flying clubs.
The Luton L.A.5 Major was a 1930s British two-seat high-wing cabin monoplane. Following World War II, plans were made available to suit construction as a homebuilt aircraft.
The Jodel D.9 Bébé is a French single-seat ultralight monoplane designed by Jean Délémontez for amateur construction.
The Bradley BA 100 Aerobat is an American aerobatic homebuilt aircraft that was designed and produced by Bradley Aerospace of Chico, California. When it was available the aircraft was supplied as a kit for amateur construction.
The Zlin Z-526 Akrobat is a Czech sports plane used in aerobatics.
The Druine D.5 Turbi was a light aircraft designed in France in the 1950s for home building. It was a low-wing cantilever monoplane with fixed tailskid undercarriage. The pilot and a single passenger sat in tandem, open cockpits. Essentially a scaled-up version of the Druine Turbulent design, the Turbi shared that aircraft's wooden construction. Again, like its predecessor, it was intended to be able to be powered by a variety of air-cooled engines.
The Falconar AMF-S14 Maranda is a two-seat, light aircraft first flown in Canada in 1961 and originally marketed for amateur construction by Falconar Avia.
The Jurca MJ-5 Sirocco is a two-seat sport aircraft designed in France in the early 1960s and marketed for homebuilding. It is one of many wooden homebuilt designs from Romanian born designer Marcel Jurca. Jurca, a Henschel Hs 129 pilot in World War II marketed the plans in Canada and America through Falconar Aviation. It is a low-wing cantilever monoplane of conventional configuration and wooden construction throughout. The tandem seats are enclosed by a bubble canopy, and the tailwheel undercarriage can be built as either fixed or with retractable main units. Marcel Jurca died on 19 October 2001, at which time plans were still available from the designer's web site.
The Hummel H5 is an American amateur-built aircraft, designed by Morry Hummel and produced by Hummel Aviation. The aircraft is supplied as a kit or plans for amateur construction.
The Ganagobie is a single place, parasol wing homebuilt aircraft that was built by Willam and James Lobet, first flying in 1953.
The Aero Synergie Jodel D20 is a French ultralight aircraft that was designed by Jean Délémontez and produced by Aero Synergie of Villefranche-de-Rouergue. The aircraft was supplied as a kit for amateur construction or as a completed aircraft.
The Jodel D18 is a French ultralight aircraft, designed and produced by Jodel.
The Jodel DR1050 Excellence and Ambassadeur are part of a family of French built aircraft, designed by Jean Délémontez in collaboration with Pierre Robin, as a development of the Jodel D.10 project. The aircraft was built from 1958 to 1967 both by Centre-Est Aeronautique (CEA) and by Société Aéronautique Normande (SAN) but since the demise of the latter in 1968 has only been supplied as plans.
The Falconar AMF-14H Maranda is a Canadian amateur-built aircraft, designed and originally produced by Falconar Avia for the Canadian basic ultralight class and US light-sport aircraft category. The aircraft is supplied as a kit or as plans for amateur construction.
The Falconar F11 Sporty is a Canadian amateur-built aircraft, that was designed by Chris Falconar and produced by Falconar Avia. Falconar supplied it as a kit or as plans for amateur construction. Today both the F11A and E models are available as plans from Manna Aviation.
The Falconar F12A Cruiser is a Canadian amateur-built aircraft, designed by Chris Falconar and originally produced as a kit by Falconar Avia. The aircraft is now supplied as plans for amateur construction by Manna Aviation.
The Falconar SAL Mustang, also called the 2/3 Mustang and the SAL P-51D Mustang is a Canadian amateur-built aircraft, originally produced by Falconar Avia and introduced in 1969. The aircraft is a 2⁄3 scale replica of the North American P-51 Mustang and is supplied as a kit or as plans for amateur construction.
The Falconar Minihawk is a Canadian amateur-built aircraft, originally produced by Falconar Avia. The aircraft is supplied as a kit or plans for amateur construction.
The Hummel Ultracruiser is an American amateur-built aircraft, designed by Morry Hummel and produced by Hummel Aviation. The aircraft is supplied as a kit or plans for amateur construction or as a complete ready-to-fly aircraft.
The Bounsall Super Prospector is an American STOL homebuilt aircraft that was designed and produced by Bounsall Aircraft of Mesquite, Nevada, introduced in 1990s. When it was available the aircraft was supplied as a kit or in the form of plans for amateur construction.
{{cite journal}}
: Missing or empty |title=
(help)