Fire pit

Last updated

A fire pit Kindling for starting a campfire IMG 2454.JPG
A fire pit

A fire pit or a fire hole can vary from a pit dug in the ground to an elaborate gas burning structure of stone, brick, and metal. The defining feature of fire pits is that they are designed to contain fire and prevent it from spreading.

Contents

Certain contemporary fire pit styles include a fire bowl that can either be set in the ground or elevated on legs.[ citation needed ]

Contemporary types

A metal backyard fire pit Backyard Fire Pit (35110804524).jpg
A metal backyard fire pit

Pre-made fire pits are the most common form of fire pits and can be purchased from a store. These are commonly made of pre-cast concrete or metal or a combination of metal table and stone. They burn usually natural gas, propane (LP) or bio ethanol. Wood-burning fire pits made of metal are also quite common but are under increasing scrutiny due to fire bans and air particulate emissions.

Natural gas and propane burners in these sorts of pre-fabricated vessels are certified under ANSI (American), CSA (Canadian), and CE (European) standards. Unregulated and uncertified fire pit burners are increasingly being scrutinized by regulatory authorities and being denied permits. Fire pits have recommended clearance to combustibles and require at least 6 feet (1.8 m) above the flame and 16 inch (40 cm) circumference from the exterior perimeter of the vessel.[ citation needed ]

Essentially, a fire pit needs only a hole that can safely contain a fire. This can be as simple as a hole dug in the ground, or as complex as a holed-out brick or rock pillar. A wood-burning fire pit should be located at least ten feet (three meters) away from structures for safety. Use of a fire pit in adverse conditions should be avoided, and basic fire safety precautions apply.[ citation needed ]

Dakota fire pit

Dakota fire pit Campfire5 mgx.svg
Dakota fire pit

The Dakota fire pit is an efficient, simple fire design that produces little to no smoke. [1] Two small holes are dug in the ground: one for the firewood and the other to provide a draft of air. Small twigs are packed into the fire hole and readily combustible material is set on top and lit. The fire burns from the top downward, drawing a steady, laminar stream of fresh air from the air hole as it burns. Because the air passes freely around the fuel, near complete combustion is achieved, the result being a fire that burns strongly and brightly and with little or no seen smoke. The Dakota fire pit is a tactical fire used by the United States military as the flame produces a low light signature, reduced smoke, and is easier to ignite under strong wind conditions. [2]

This style of fire pit is said to get its name from the Dakota people, who used it while hunting bison herds on the Great Plains. As well as resisting the strong winds of that area, the design also reduced the risk of causing a prairie fire. [3]

Fire pits in history

Many cultures, particularly nomadic ones, would cut the turf above the fire-pit in a turf cutting ceremony, replacing the turf afterwards to hide any evidence of the fire.[ citation needed ] The youth organization Woodcraft Folk also does this.[ citation needed ]

Archaeological significance

The remains of fire pits preserve information about past cultures. Radiocarbon dating from charcoal found in old fire pits can estimate when regions were first populated or when civilizations died out. Bones and seeds found in fire pits indicate the diet of that area.[ citation needed ]

In archaeological terms fire pits are referred to as features because they can be seen and recorded as part of the site but cannot be moved without being destroyed. [4]

Fire ring

Campfire in a metal fire ring Campfire with metal ring.jpg
Campfire in a metal fire ring

A fire ring is a construction or device used to contain campfires and prevent them from spreading and turning into wildfires.[ citation needed ]

A fire ring is designed to contain a fire that is built directly upon the ground, such as a campfire. Fire rings have no bottom, and are simply circles made of forged metal, stones, concrete, etc. which surround and contain a fire. Manufactured steel fire rings are available in various sizes to suit every need.[ citation needed ]

When a fire is to be built somewhere such as on a patio or in a backyard, a fire pit or outdoor fireplace may be better used instead. These are designed to contain the entire fire instead of just keeping it in one place.[ citation needed ]

A tipi fire in a stone fire ring Fire Ring.jpg
A tipi fire in a stone fire ring

A fire ring may be nothing more than a short, wide section of metal tube, partially buried in the ground. Slightly more advanced fire rings may be partially covered with metal bars so that the fire may be used for cooking. These types are seen at many campgrounds. Fire rings in urban areas, such as on beaches, may be made of poured concrete. Makeshift fire rings can be constructed out of a ring of stones where pre-constructed rings are not available, but care should be taken as some stones can explode when heated due to trapped gas pockets, thermal expansion, or water contained flashing into steam.[ citation needed ]

See also

Related Research Articles

<span class="mw-page-title-main">Forge</span> Workshops of a blacksmith, who is an ironsmith who makes iron into tools or other objects

A forge is a type of hearth used for heating metals, or the workplace (smithy) where such a hearth is located. The forge is used by the smith to heat a piece of metal to a temperature at which it becomes easier to shape by forging, or to the point at which work hardening no longer occurs. The metal is transported to and from the forge using tongs, which are also used to hold the workpiece on the smithy's anvil while the smith works it with a hammer. Sometimes, such as when hardening steel or cooling the work so that it may be handled with bare hands, the workpiece is transported to the slack tub, which rapidly cools the workpiece in a large body of water. However, depending on the metal type, it may require an oil quench or a salt brine instead; many metals require more than plain water hardening. The slack tub also provides water to control the fire in the forge.

<span class="mw-page-title-main">Smoking (cooking)</span> Exposing food to smoke to flavor or preserve it

Smoking is the process of flavoring, browning, cooking, or preserving food by exposing it to smoke from burning or smoldering material, most often wood. Meat, fish, and lapsang souchong tea are often smoked.

<span class="mw-page-title-main">Campfire</span> Fire lit at a campsite

A campfire is a fire at a campsite that provides light and warmth, and heat for cooking. It can also serve as a beacon, and an insect and predator deterrent. Established campgrounds often provide a stone or steel fire ring for safety. Campfires are a popular feature of camping. At summer camps, the word campfire often refers to an event at which there is a fire. Some camps refer to the fire itself as a campfire.

<span class="mw-page-title-main">Incineration</span> Waste treatment process

Incineration is a waste treatment process that involves the combustion of substances contained in waste materials. Industrial plants for waste incineration are commonly referred to as waste-to-energy facilities. Incineration and other high-temperature waste treatment systems are described as "thermal treatment". Incineration of waste materials converts the waste into ash, flue gas and heat. The ash is mostly formed by the inorganic constituents of the waste and may take the form of solid lumps or particulates carried by the flue gas. The flue gases must be cleaned of gaseous and particulate pollutants before they are dispersed into the atmosphere. In some cases, the heat that is generated by incineration can be used to generate electric power.

<span class="mw-page-title-main">Portable stove</span> Cooking stove specially designed to be portable and lightweight

A portable stove is a cooking stove specially designed to be portable and lightweight, used in camping, picnicking, backpacking, or other use in remote locations where an easily transportable means of cooking or heating is needed. Portable stoves can be used in diverse situations, such as for outdoor food service and catering and in field hospitals.

<span class="mw-page-title-main">Outdoor cooking</span>

Outdoor cooking is the preparation of food in the outdoors. A significant body of techniques and specialized equipment exists for it, traditionally associated with nomad in cultures such as the Berbers of North Africa, the Arab Bedouins, the Plains Indians, pioneers in North America, and indigenous tribes in South America. These methods have been refined in modern times for use during recreational outdoor pursuits, by campers and backpackers.

<span class="mw-page-title-main">Barbecue grill</span> Device for barbecueing or grilling

A barbecue grill or barbeque grill is a device that cooks food by applying heat from below. There are several varieties of grills, with most falling into one of three categories: gas-fueled, charcoal, or electric. There is debate over which method yields superior results.

A flashover is the near-simultaneous ignition of most of the directly exposed combustible material in an enclosed area. When certain organic materials are heated, they undergo thermal decomposition and release flammable gases. Flashover occurs when the majority of the exposed surfaces in a space are heated to their autoignition temperature and emit flammable gases. Flashover normally occurs at 500 °C (932 °F) or 590 °C (1,100 °F) for ordinary combustibles and an incident heat flux at floor level of 20 kilowatts per square metre (2.5 hp/sq ft).

<span class="mw-page-title-main">Stove</span> Device used to generate heat or to cook

A stove or range is a device that generates heat inside or on top of the device, for local heating or cooking. Stoves can be powered with many fuels, such as electricity, natural gas, gasoline, wood, and coal.

<span class="mw-page-title-main">Wood fuel</span> Wood used as fuel for combustion

Wood fuel is a fuel such as firewood, charcoal, chips, sheets, pellets, and sawdust. The particular form used depends upon factors such as source, quantity, quality and application. In many areas, wood is the most easily available form of fuel, requiring no tools in the case of picking up dead wood, or few tools, although as in any industry, specialized tools, such as skidders and hydraulic wood splitters, have been developed to mechanize production. Sawmill waste and construction industry by-products also include various forms of lumber tailings.

<span class="mw-page-title-main">Fire triangle</span> Model for understanding the ingredients for fires

The fire triangle or combustion triangle is a simple model for understanding the necessary ingredients for most fires.

<span class="mw-page-title-main">Fireplace</span> Device for firing solid fuels in buildings

A fireplace or hearth is a structure made of brick, stone or metal designed to contain a fire. Fireplaces are used for the relaxing ambiance they create and for heating a room. Modern fireplaces vary in heat efficiency, depending on the design.

<span class="mw-page-title-main">Firebox (steam engine)</span> Part of a steam engine

In a steam engine, the firebox is the area where the fuel is burned, producing heat to boil the water in the boiler. Most are somewhat box-shaped, hence the name. The hot gases generated in the firebox are pulled through a rack of tubes running through the boiler.

<span class="mw-page-title-main">Earth oven</span> Simple pit for cooking

An earth oven, ground oven or cooking pit is one of the simplest and most ancient cooking structures. The earliest known earth oven was discovered in Central Europe and dated to 29,000 BC. At its most basic, an earth oven is a pit in the ground used to trap heat and bake, smoke, or steam food. Earth ovens have been used in many places and cultures in the past, and the presence of such cooking pits is a key sign of human settlement often sought by archaeologists. Earth ovens remain a common tool for cooking large quantities of food where no equipment is available. They have been used in various civilizations around the world and are still commonly found in the Pacific region to date.

<span class="mw-page-title-main">Masonry heater</span> Heating device

A masonry heater is a device for warming an interior space through radiant heating, by capturing the heat from periodic burning of fuel, and then radiating the heat at a fairly constant temperature for a long period. Masonry heaters covered in tile are called cocklestoves. The technology has existed in different forms, from back into the Neoglacial and Neolithic periods. Archaeological digs have revealed excavations of ancient inhabitants utilizing hot smoke from fires in their subterranean dwellings, to radiate into the living spaces. These early forms have evolved into modern systems.

<span class="mw-page-title-main">Fire pan</span> Pan for holding or conveying fire

A fire pan is a pan for holding or conveying fire. The use of a fire pan reduces the impact to the ground, vegetation and rocks, and its compact size results in the burning of less wood. Fire pans also allow users to easily burn their accumulated garbage although the best practice is to only burn paper. Combustible items will be reduced to ash. A fire pan user can leave no trace of the fire, as the ashes can be collected and buried.

<span class="mw-page-title-main">Oxy-fuel welding and cutting</span> Metalworking technique using a fuel and oxygen

Oxy-fuel welding and oxy-fuel cutting are processes that use fuel gases and oxygen to weld or cut metals. French engineers Edmond Fouché and Charles Picard became the first to develop oxygen-acetylene welding in 1903. Pure oxygen, instead of air, is used to increase the flame temperature to allow localized melting of the workpiece material in a room environment.

Home safety is the awareness of risks and potential dangers in and around a home that may cause bodily harm, injury, or even death to those living there.

<span class="mw-page-title-main">Charcoal pile</span> Covered fire for producing charcoal

A charcoal pile or charcoal clamp is a carefully arranged pile of wood, covered by turf or other layer, inside which a fire is lit in order to produce charcoal. The pile is tended by a charcoal burner. It is similar to a charcoal kiln, but the latter is usually a permanent structure made of materials such as stone.

<span class="mw-page-title-main">Class B fire</span> Class of fire

In fire classes, a Class B fire is a fire in flammable liquids or flammable gases, petroleum greases, tars, oils, oil-based paints, solvents, lacquers, or alcohols. For example, propane, natural gas, gasoline and kerosene fires are types of Class B fires. The use of lighter fluid on a charcoal grill, for example, creates a Class B fire. Some plastics are also Class B fire materials.

References

  1. "Dakota Fire Hole Construction". wildernessoutfitters. May 4, 2014. Archived from the original on December 12, 2021. Retrieved February 2, 2015.
  2. "Survival Manual Winter 2002". US Marine Corps Mountain Warfare Training Center. 2002. Retrieved January 8, 2024.
  3. "The Origins of the Dakota Fire Pit". Stealth Fyre. April 30, 2020. Retrieved January 8, 2024.
  4. "Binghamton University Archeology of the Divide Project" (PDF). paf.binghamton.edu. 2006. Archived from the original (PDF) on September 2, 2009.