HP-25

Last updated

HP-25
HP-25-front.jpg
Calculator
Entry mode RPN

The HP-25 was a hand-held programmable scientific/engineering calculator made by Hewlett-Packard between early January 1975 and 1978. The HP-25 was introduced as a cheaper (US$195 MSRP) alternative to the ground-breaking HP-65.

Contents

To reduce cost, the HP-25 omitted the HP-65's magnetic card reader, so it could only be programmed using the keyboard. After switching off, the program was lost and had to be typed in again. The model HP-25C, introduced in 1976, addressed that shortcoming through the first use of battery-backed CMOS memory in a calculator, termed continuous memory by HP.

Like all early HP calculators, the 25 used the Reverse Polish Notation (RPN) for entering calculations, working on a four-level stack (x,y,z,t). Nearly all buttons had two alternative functions, accessed by a blue and yellow prefix key. A small sliding switch was used to change between "run" and "program" mode. The HP-25 used a 10-digit red LED display and was the first calculator to introduce the "engineering" display option, a denormalized mantissa/exponent format where the exponent is always a multiple of 3 to match the common SI prefixes, e.g. mega, kilo, milli, micro, nano.

The HP-25 had memory space for up to 49 program steps. It was the first HP calculator which used fully merged keycodes (storing prefix key and function key together in one program location) to save memory space. Additionally there were eight storage registers and specialized scientific and statistical functions. The owner's manual came with 161 pages in four colors and contained many mathematical, scientific, navigational and financial programming examples.

The HP-25 was about 25% smaller than the HP-65. It used the same trapezoid profiled keys introduced with the HP-65. The HP-25 was regarded as a competitor to the TI-58 and TI-58C calculators offered by Texas Instruments. Looking strictly at the functionality and capacity, the more equal competitor would be the TI-57. It lacked a few of the HP-25's functions, but had some other advantages.

One notable deficiency of the HP-25/25C was the lack of a subroutine capability, at a time when the TI-58 and even the earlier SR-56 had subroutines. Although 49 fully merged keycodes were roughly equivalent to the unmerged 100 steps of the SR-56; by the time the TI-58 arrived with 480 steps, subroutines, DSZ loops, etc., the HP-25/25C had serious competition. HP would go on to introduce the HP-29C/19C calculators with 99 merged steps, labels, and subroutines. And TI would introduce a TI-58C with continuous memory.

A version adapted to support an additional backward-facing display manufactured by Educational Calculator Devices named EduCALC 25 GD existed as well. [1]

See also

Notes

  1. ^ US$195 in 1975 ≈ US$770 in 2009 (see The Inflation Calculator)

Related Research Articles

<span class="mw-page-title-main">Sinclair Scientific</span> Scientific calculator introduced in 1974

The Sinclair Scientific calculator was a 12-function, pocket-sized scientific calculator introduced in 1974, dramatically undercutting in price other calculators available at the time. The Sinclair Scientific Programmable, released a year later, was advertised as the first budget programmable calculator.

<span class="mw-page-title-main">Scientific calculator</span> Calculator designed to calculate problems in science, engineering, and mathematics

A scientific calculator is an electronic calculator, either desktop or handheld, designed to perform calculations using basic and complex mathematical operations and functions. They have completely replaced slide rules as well as books of mathematical tables and are used in both educational and professional settings.

<span class="mw-page-title-main">HP-35</span> First pocket scientific calculator

The HP-35 was Hewlett-Packard's first pocket calculator and the world's first scientific pocket calculator: a calculator with trigonometric and exponential functions. It was introduced in 1972.

<span class="mw-page-title-main">HP-65</span> Programmable handheld calculator with magnetic card reader

The HP-65 is the first magnetic card-programmable handheld calculator. Introduced by Hewlett-Packard in 1974 at an MSRP of $795, it featured nine storage registers and room for 100 keystroke instructions. It also included a magnetic card reader/writer to save and load programs. Like all Hewlett-Packard calculators of the era and most since, the HP-65 used Reverse Polish Notation (RPN) and a four-level automatic operand stack.

<span class="mw-page-title-main">HP-41C</span> Hewlett-Packard handheld RPN calculator

The HP-41C series are programmable, expandable, continuous memory handheld RPN calculators made by Hewlett-Packard from 1979 to 1990. The original model, HP-41C, was the first of its kind to offer alphanumeric display capabilities. Later came the HP-41CV and HP-41CX, offering more memory and functionality.

<span class="mw-page-title-main">HP-20S</span> Programmable calculator

The HP-20S (F1890A) is an algebraic programmable scientific calculator produced by Hewlett-Packard from 1987 to 2000.

Engineering notation or engineering form (also technical notation) is a version of scientific notation in which the exponent of ten is always selected to be divisible by three to match the common metric prefixes, i.e. scientific notation that aligns with powers of a thousand, for example, 531×103 instead of 5.31×105 (but on calculator displays written without the ×10 to save space). As an alternative to writing powers of 10, SI prefixes can be used, which also usually provide steps of a factor of a thousand. On most calculators, engineering notation is called "ENG" mode as scientific notation is denoted SCI.

<span class="mw-page-title-main">TI SR-50</span> Early scientific pocket calculator

The SR-50 was Texas Instruments' first scientific pocket calculator with trigonometric and logarithm functions. It enhanced their earlier SR-10 and SR-11 calculators, introduced in 1973, which had featured scientific notation, squares, square root, and reciprocals, but had no trig or log functions, and lacked other features. The SR-50 was introduced in 1974 and sold for US$170. It competed with the Hewlett-Packard HP-35.

<span class="mw-page-title-main">TI-59 / TI-58</span> Programmable calculator produced by Texas Instruments

The TI-59 is an early programmable calculator, that was manufactured by Texas Instruments from 1977. It is the successor to the TI SR-52, quadrupling the number of "program steps" of storage, and adding "ROM Program Modules". Just like the SR-52, it has a magnetic card reader for external storage. One quarter of the memory is stored on each side of one card.

Programmable calculators are calculators that can automatically carry out a sequence of operations under control of a stored program. Most are Turing complete, and, as such, are theoretically general-purpose computers. However, their user interfaces and programming environments are specifically tailored to make performing small-scale numerical computations convenient, rather than general-purpose use.

<span class="mw-page-title-main">Hewlett-Packard Voyager series</span> Programmable calculator, 1982–1984

The Hewlett-Packard Voyager series of calculators were introduced by Hewlett-Packard in 1981. All members of this series are programmable, use Reverse Polish Notation, and feature continuous memory. Nearly identical in appearance, each model provided different capabilities and was aimed at different user markets.

<span class="mw-page-title-main">HP-16C</span> Programmable calculator produce by Hewlett-Packard

The HP-16C Computer Scientist is a programmable pocket calculator that was produced by Hewlett-Packard between 1982 and 1989. It was specifically designed for use by computer programmers, to assist in debugging. It is a member of the HP Voyager series of programmable calculators. It was the only programmer's calculator ever produced by HP, though many later HP calculators have incorporated most of the 16C's functions.

<span class="mw-page-title-main">HP-28 series</span> Series of graphing calculators produced by Hewlett-Packard

The HP-28C and HP-28S were two graphing calculators produced by Hewlett-Packard from 1986 to 1992. The HP-28C was the first handheld calculator capable of solving equations symbolically. They were replaced by the HP 48 series of calculators, which grew from the menu-driven RPL programming language interface first introduced in these HP-28 series.

<span class="mw-page-title-main">HP-27</span>

The HP-27 was a hand-held scientific and financial, but not programmable, calculator made by Hewlett-Packard between 1976 and 1978.

<span class="mw-page-title-main">Casio FX-502P series</span> Series of programmable calculators produced by Casio

The FX-501P and FX-502P were programmable calculators, manufactured by Casio from 1978/1979. They were the predecessors of the FX-601P and FX-602P.

<span class="mw-page-title-main">HP-55</span>

The HP-55 was a programmable handheld calculator, a lower-cost alternative to the HP-65. Introduced by Hewlett-Packard in 1975, it featured twenty storage registers and room for 49 keystroke instructions. Its outward appearance was similar to the HP-65, but its silver band went through between the display and the keyboard like HP-45, and the functions of some keys were different from HP-65, and it did not have a magnetic card reader/writer. Like all Hewlett-Packard calculators of the era and most since, the HP-55 used Reverse Polish Notation (RPN) and a four-level automatic operand stack.

<span class="mw-page-title-main">HP-67/97</span>

The HP-67 is a magnetic card-programmable handheld calculator, introduced by Hewlett-Packard in 1976 at an MSRP of $450. A desktop version with built-in thermal printer was sold as the HP-97 at a price of $750. Collectively, they are known as the HP-67/97.

<span class="mw-page-title-main">HP-21</span> Scientific calculator by Hewlett-Packard

The HP-21 was a scientific calculator produced by Hewlett-Packard between 1975 and 1978. It was designed as a replacement for the HP-35, and was one of a set of three calculators, the others being the HP-22 and HP-25, which were similarly built but aimed at different markets.

<span class="mw-page-title-main">HP-22</span> Finance calculator by Hewlett-Packard

The HP-22 was a finance-oriented pocket calculator produced by Hewlett-Packard between 1975 and 1978. It was designed as a replacement for the short-lived HP-70, and was one of a set of three calculators, the others being the HP-21 and HP-25, which were similarly built but aimed at different markets.

<span class="mw-page-title-main">HP 30 series</span>

The HP-30 or Spice series are RPN Scientific hand held calculators introduced by Hewlett-Packard in 1978. Some models are a programmable.

References

  1. ↑ "The EduCALC". 65 Notes . Vol. 3, no. 2. February–March 1976. p. 8. Archived from the original on 2017-07-04. Retrieved 2022-07-01– via HP Museum.
This page is based on this Wikipedia article
Text is available under the CC BY-SA 4.0 license; additional terms may apply.
Images, videos and audio are available under their respective licenses.