L&YR railmotors

Last updated

Type and origin
Builder Kerr, Stuart and Company
Build date1905
Total produced4 (Two Taff Vale Railway, two L&YR)
Specifications
Configuration:
   Whyte 0-2-2T, with semi-trailer
Driver dia.2 ft 10 in (0.864 m)
Trailing dia. 2 ft 10 in (0.864 m)
Length58 ft 8 in (17,882 mm)
45 ft (13,716 mm) (trailer)
Loco weight37 tons 10 cwt 2 qr (with trailer coach)
Fuel capacity10 cwt
Water cap.550 gallons
Firebox:
  Grate area8 sq ft
Boiler3 ft 4.5 in (1,029 mm) diameter
2 ft 1.2 in (640 mm) transverse length (each side)
Boiler pressure160 psi (1.10 MPa)
Heating surface338.5 sq ft
Cylinders Two, outside
Cylinder size 9 in × 14 in (229 mm × 356 mm) [lower-roman 1]
Career
Operators L&YR
Number in class2
NumbersL&Y 1-2
First runJuly 1905
Withdrawn1909
DispositionAll scrapped

The Lancashire and Yorkshire Railway (L&YR) operated two classes of twenty steam railmotors in total.

Contents

Kerr Stuart railmotors

The first L&YR railmotors were two by Kerr Stuart, copies of a design that had already been supplied to the Taff Vale Railway. They were ordered by Hughes in 1904. [1]

The locomotive units had transverse boilers of a type similar to the Yorkshire steam wagon, where a single central firebox fed extremely short fire-tubes to a smokebox at each side. Like the Yorkshire, these then returned to a central smokebox and chimney. The outside cylinders were rear-mounted and drove only the leading axle, without coupling rods. The locomotive units were dispatched separately to Newton Heath, where their semi-trailers were attached. [1]

Their coaches were semi-trailers, with reversible seats for 48 passengers and electric lighting. [lower-roman 2] There were also a luggage compartment and a driving compartment for use in reverse. Folding steps were provided at each of the two doors on each side. [3] They were built by Bristol Wagon & Carriage Works [1]

Stock list [1]
L&YR No.Works No.Delivery DateWithdrawn
Lot 54
19047 June 19051909
290528 June 19051909

Service

Both railmotors worked the Bury-Holcombe Brook line at first. In 1906 they briefly worked at Southport, then between Burnley and Colne for their remaining years. They were both withdrawn in 1909. [1]

Hughes railmotors

Type and origin
Build date1906-1911
Total produced18
Specifications
Configuration:
   Whyte 0-4-0T, with semi-trailer
Driver dia.3 ft 7.675 in (1.109 m) [4]
Length69 ft 5 in (21,158 mm)
47 ft 6 in (14,478 mm) (trailer)
Loco weight32 tons 14 cwt (engine)
47 tons 10 cwt (with trailer coach)
Water cap.550 gallons
Firebox:
  Grate area9.4 sq ft
Boiler4 ft 3 in (1,295 mm) diameter 5 ft (1,524 mm) length
Boiler pressure180 psi (1.24 MPa)
Heating surface509 sq ft
Cylinders Two, outside
Cylinder size 12 in × 16 in (305 mm × 406 mm)
Career
Operators L&YR
LMS
Number in class18
NumbersL&Y 1-18
Withdrawn1927-1948
DispositionAll scrapped

Hughes designed a further class of railmotors that were then built at Horwich and Newton Heath, in four batches over five years. They were of the "0-4-0T locomotive + semi-trailer type", with conventional locomotive boilers. [1] [3]

No 15, works number 983, was the 1,000th locomotive to be built at Horwich. [1]

Service

All were inherited by the London, Midland and Scottish Railway (LMS) in 1923, who numbered the locomotives 10600-17 and gave the trailers separate numbers in the coaching stock series. These were the only self-propelled vehicles numbered in the LMS locomotive series rather than the coaching stock series. The first was withdrawn in 1927, and only one survived by nationalisation in 1948. That railmotor, LMS No. 10617, was withdrawn in 1948 and given the British Railways internal number 50617, but got withdrawn in March of the same year. None were preserved.

The best-remembered of these railmotors was the 'Altcar Bob' service from Southport to Barton railway station (also known as 'Downholland') (before 1926, it ran to Altcar and Hillhouse) and the 'Horwich Jerk' service from Horwich to Blackrod. The latter became the last part of the L&Y System which made use of Hughes Railmotors. [5]

Stock list [6]
L&YR No.Works No.Service DateLMS No.Withdrawn
Lot 54
39513 May 19061060028 June 1947
495217 May 19061060120 February 1934
595325 May 190610602August 1927
69541 June 190610603May 1927
79557 June 1906106045 October 1929
895622 May 190610605June 1929
Lot 57
997712 January 190710606November 1943
1097819 January 19071060727 November 1934
119796 February 190710608November 1935
1298016 February 190710609June 1937
139812 March 190710610August 1937
149829 March 190710611October 1931
1598323 March 19071061221 December 1934
Lot 63
1106910 December 19091061316 December 1931
2107017 December 190910614June 1937
16107124 December 190910615September 1928
Lot 69
171172December 1911106168 November 1933
181173December 1911106176 March 1948

See also

Notes and references

Notes

  1. These were also listed at 10+12 inches in some sources.
  2. The L&YR had experimented with electric lighting with steam locomotive dynamos from 1885 and, under the electrically-minded Henry Hoy, with wheel-driven dynamos on coaches from 1901 to 1905. However Aspinall had rejected these as too expensive and electric lighting would not become standard until 1914. Like many railways, this had only been in reaction to the 1913 Ais Gill rail accident. [2]

Related Research Articles

<span class="mw-page-title-main">Lancashire and Yorkshire Railway</span> Pre-1923 grouping British Railway company

The Lancashire and Yorkshire Railway (L&YR) was a major British railway company before the 1923 Grouping. It was incorporated in 1847 from an amalgamation of several existing railways. It was the third-largest railway system based in northern England.

George Hughes was an English locomotive engineer, and chief mechanical engineer (CME) of the Lancashire and Yorkshire Railway (L&YR) and the London, Midland and Scottish Railway (LMS).

The Lancashire and Yorkshire Railway (LYR) built suburban electric stock for lines in Liverpool and Manchester. The line between Liverpool to Southport began using electric multiple units (EMUs) on 22 March 1904, using a third rail 625 V DC. Additional trains were later built for this route, and in 1913 incompatible stock for the route to Ormskirk. Lightweight units were built to run on the Liverpool Overhead Railway.

Henry Albert Hoy (1855–1910) was a locomotive engineer with the Lancashire and Yorkshire Railway (L&YR). Hoy was born on 13 January 1855 in London, and educated at King Edward VI's Grammar School in St Albans, and at St John's College, Liverpool University.

<span class="mw-page-title-main">LMS Hughes Crab</span> British steam locomotive, built 1926–1932

The London, Midland and Scottish Railway (LMS) Hughes Crab or Horwich Mogul is a class of mixed-traffic 2-6-0 steam locomotive built between 1926 and 1932. They are noted for their appearance with large steeply-angled cylinders to accommodate a restricted loading gauge.

This is a list of the locomotives of the Lancashire and Yorkshire Railway. The Lancashire and Yorkshire Railway locomotive works were originally at Miles Platting, Manchester. From 1889 they were at Horwich.

<span class="mw-page-title-main">Horwich Works</span>

Horwich Works was a railway works built in 1886 by the Lancashire and Yorkshire Railway (LYR) in Horwich, near Bolton, in North West England when the company moved from its original works at Miles Platting, Manchester.

<span class="mw-page-title-main">L&YR Class 5</span> Lancashire & Yorkshire Railway 2-4-2T passenger tank locomotive introduced in 1889

The Lancashire and Yorkshire Railway Class 5 were 2-4-2T steam locomotives designed by Chief Mechanical Engineer (CME) John Aspinall and introduced from 1889 for local passenger work. Later batches included progressive modifications such as extended coal bunkers and Belpaire fireboxes. The final batch built from 1911 to 1914 under George Hughes incorporating superheated boilers gave increased tractive effort, others were also rebuilt to this standard. When Hughes introduced his classification system in 1919, the more powerful superheated locomotives were designated Class 6. The final examples were withdrawn in 1961.

<span class="mw-page-title-main">L&YR Class 21</span>

The L&YR Class 21 is a class of small 0-4-0ST steam locomotive built by the Lancashire and Yorkshire Railway for shunting duties. They were nicknamed Pugs.

<span class="mw-page-title-main">L&YR Class 23</span>

The Lancashire and Yorkshire Railway (L&YR) Class 23 is a class of 0-6-0ST steam locomotive. Their main use was for shunting and for short-trip freight working.

The Altcar Bob was a train service introduced in July 1906 by the Lancashire and Yorkshire Railway on the Barton Branch of the Liverpool, Southport and Preston Junction Railway. The service was so named because it terminated at Altcar and Hillhouse, though from 1926 it only went as far as Barton. The Bob was a diminutive steam railmotor: a locomotive attached to a single coach. The coach was supported by only a single bogie at one end, and the locomotive at the other. Remote controls located at the rear of the coach meant that the vehicle did not require turning.

<span class="mw-page-title-main">L&YR Class 8</span>

The Lancashire and Yorkshire Railway (L&YR) Class 8 was a four-cylinder 4-6-0 express passenger locomotive designed by George Hughes introduced in 1908.

The Lancashire and Yorkshire Railway (L&YR) Class 7 was a class of Atlantic passenger steam locomotives to the design of John Aspinall. Forty were built between 1899 and 1902. They were known as "High-Flyers" as a result of having a high-pitched boiler that was supposed to increase stability at speed. All passed into London, Midland and Scottish Railway (LMS) ownership on the grouping of 1923, becoming the LMS's only Atlantic tender engine class. The LMS gave them the power classification 2P. Withdrawals started in 1926, and the last was withdrawn in 1934. None were preserved.

<span class="mw-page-title-main">L&YR Class 32</span> Class of 5 British 0-8-2T locomotives

The Lancashire and Yorkshire Railway Class 32 was a small class of 0-8-2T steam locomotives, intended for heavy shunting and banking duties.

<span class="mw-page-title-main">L&YR Class 24</span>

The L&YR Class 24 was a class of short-wheelbase 0-6-0T steam locomotives of the Lancashire and Yorkshire Railway (L&YR). It was designed by Aspinall and introduced in 1897 for shunting duties. Twenty locomotives were built, but six were withdrawn between 1917 and 1922.

The L&YR Class 2 (Aspinall) was a class of 4-4-0 steam locomotives of the Lancashire and Yorkshire Railway.

<span class="mw-page-title-main">L&YR Class 3</span>

The L&YR Class 3 was a class of 4-4-0 steam locomotives of the Lancashire and Yorkshire Railway introduced in 1891 with forty being built. George Hughes rebuilt six locomotives with superheaters between 1908 and 1909, they were later designated L&YR Class 4. All passed to the London, Midland and Scottish Railway at the grouping in 1923 but were withdrawn by 1930.

<span class="mw-page-title-main">British steam railcars</span> A self-propelled railcar powered by a steam engine

A steam railcar is a rail vehicle that does not require a locomotive as it contains its own steam engine. The first steam railcar was an experimental unit designed and built in 1847 by James Samuel and William Bridges Adams. In 1848, they made the Fairfield steam carriage that they sold to the Bristol and Exeter Railway, who used it for two years on a branch line.

The L&YR 2-10-0 was a prospective design for a class of 2-10-0 steam locomotives on the Lancashire and Yorkshire Railway. Initial designs were made by George Hughes between 1913 and 1914, but none of the class were built. If they had been, these would have been the UK's first 10-coupled locomotives in regular service.

<span class="mw-page-title-main">LNWR Newton Class</span>

The LNWR Newton Class was a class of ninety-six 2-4-0 steam locomotives built by the London and North Western Railway at their Crewe Works between 1866 and 1873.

References

  1. 1 2 3 4 5 6 7 Marshall, John (1972). The Lancashire & Yorkshire Railway. Vol. 3: Locomotives and Rolling Stock. Newton Abbott: David & Charles. pp. 170–171. ISBN   0-7153-5320-9.
  2. Marshall 1972, p. 120
  3. 1 2 Marshall 1972 , p. 155
  4. Marshall 1972, p. 150
  5. Lost Railways of Lancashire, G Suggitt Countryside Books 2003
  6. Marshall 1972 , pp. 263–264

Further reading