| Triplane | |
|---|---|
 | |
| Role | Anti-airship fighter |
| National origin | United Kingdom |
| Manufacturer | Blackburn |
| Designer | Harris Booth |
| First flight | 1917 |
| Number built | 1 |
The Blackburn Triplane was a single-engine pusher single-seater, designed specifically to attack Zeppelins. It flew in 1917, but was not successful.
The Triplane was the third unsuccessful attempt at an anti-Zeppelin fighter that involved Blackburn. The first was Blackburn's own Twin Blackburn and the second the AD Scout, Blackburn building two of the four machines of this type to an Air Department of the Admiralty design. In 1916, the Scout's designer, Harris Booth moved to Blackburn where he created a heavily revised aircraft, the Triplane. [1]
The layout of both Scout and Triplane was determined largely by the Admiralty requirement to carry a quick-firing, recoilless Davis gun that used 2 lb (1 kg) shells. At the time, there was no way of synchronising such a weapon with the propeller, or of mounting it elsewhere than the fuselage, so a pusher configuration was necessary, the pilot sitting in a nacelle with the gun in its nose. [1]
In order to make the aircraft more manoeuvrable and in particular to increase its roll rate, a triplane configuration was chosen. This provided about the same total wing area as that of the biplane Scout with a lower moment of inertia about the roll axis. The Triplane had single-bay wings with heavy stagger, carrying six ailerons. The lower wing was close to the ground so two underwing skids were added below the interplane struts. The mid-line of the nacelle, with the engine at its rear, was on the centre plane, giving the pilot a slightly inferior view than from the Scout. [1]
Four parallel tail booms ran aft, two from the mid-span of the upper wing and the others from the lower wing. These four members carried the tail. The tailplane, mounted on the upper booms and bearing a full-width elevator, had a span of 18 ft 10 in (5.74 m), no less than 78% of the wingspan. A pair of fin and rudders joined the upper and lower booms, a height of about 7 ft 6 in (2.3 m). The "reversed" undercarriage of the Scout was abandoned and the mainwheels were mounted on a single axle supported by two pairs of struts to the nacelle. Though photographs show the gunport, the gun itself was probably never fitted. [1]
The Triplane first flew with a 110 hp (80 kW) Clerget rotary engine driving a four-blade, 8 ft (2.46 m) diameter propeller, then later with a 100 hp (75 kW) Gnome with a two-blade propeller. [1]
Only one was built. It was accepted by the Admiralty on 20 February 1917, but was rapidly found wanting like the Scout before it. It was struck off charge just a month later, the only Blackburn triplane and the last of their attempts to build an anti-Zeppelin fighter. [1]
Data from Jackson 1968, p. 101
General characteristics
Performance
The AD Scout was designed by Harris Booth of the British Admiralty's Air Department as a fighter aircraft to defend Britain from Zeppelin bombers during World War I.
The Caproni Ca.4 was an Italian heavy bomber of the World War I era.
The Caproni Ca.1 was an Italian heavy bomber of the World War I era.
The Royal Aircraft Factory F.E.8 was a British single-seat fighter of the First World War designed at the Royal Aircraft Factory. Although a clean and well designed little aeroplane for a pusher, it could not escape the drag penalty imposed by its tail structure and was no match for the Albatros fighters of late 1916.
The Pemberton-Billing P.B.25 was a First World War British single-seat scout aircraft built by Pemberton-Billing Limited, later Supermarine Aviation Works Limited.
The Vickers F.B.12 was a biplane pusher fighter aircraft developed during World War I by Vickers Limited. The failure of the engine for which it was designed, and the obsolescence of the pusher configuration, resulted in its remaining an experimental type only.
The Port Victoria P.V.2 was a British prototype floatplane fighter of the First World War, designed and built at the Royal Naval Air Service's Port Victoria Marine Experimental Aircraft Depot on the Isle of Grain. Only a single aircraft was built, with the type not being chosen for production.
The Zeppelin-Staaken Riesenflugzeuge were a series of very large bomber aircraft - Riesenflugzeuge, usually powered by four or more engines, designed and built in Germany from 1915 to 1919.
The Short S.27 and its derivative, the Short Improved S.27, were a series of early British aircraft built by Short Brothers. They were used by the Admiralty and Naval Wing of the Royal Flying Corps for training the Royal Navy's first pilots as well as for early naval aviation experiments. An Improved S.27 was used by C.R. Samson to make the first successful take-off from a moving ship on 9 May 1912.
The Zeppelin-Lindau Rs.II was a biplane flying boat, designed by Claudius Dornier and built during 1914-15 on the German side of Lake Constance. Initially this aircraft was powered by three engines mounted inside the hull driving three pusher propellers via gearboxes and shafts. The later version was powered by four engines in two push-pull nacelles mounted between the wings.
The Grahame-White Type VI was an early British military aircraft manufactured by the Grahame-White Aviation Company. Only one was built but after an abortive flight development was abandoned.
The Short S.80 was an early British floatplane built by Short Brothers for Frank McClean to undertake an aerial expedition up the Nile to investigate the cataracts between Aswan and Khartoum. After a successful flight to Khartoum it was returned to England, where it was used for training by the RNAS. When built it was the largest successful aircraft that had been constructed in Britain. It was also known as the Short Nile Pusher Biplane Seaplane.
The Siemens-Schuckert DDr.I was a World War I German twin engine, push-pull configuration triplane fighter aircraft. Only one was built, crashing on its first flight.
The Siemens-Schuckert L.I was a large, three-engined biplane bomber aircraft, built in Germany towards the end of World War I. It was a twin boom design, strongly influenced by the successful Caproni Ca.3. Three were built but not used operationally.
The Voisin Type Bordeaux was an aircraft built by Voisin Frères in 1910, so-called because it was used by Juan Bielovucic to make a record-breaking flight from Paris to Bordeaux. The design differed significantly from previous Voisin designs in eliminating the forward-mounted elevator.
The Lloyd 40.08 Luftkreuzer was a three engine triplane bomber type built during World War I. The design was proven to be ineffective and development did not proceed past the prototype stage.
The Caudron Type L was a two-seat French pusher configuration amphibious biplane, flown around 1913 and intended for naval use.
The Caudron Type C was a single seat French biplane, intended for military evaluation. Two were built in 1911.
The Caudron Type D was a French pre-World War I single seat, twin-boom tractor biplane, a close but slightly smaller relative of the two seat Caudron Type C. More than a dozen were completed, one exported to the United Kingdom, where they may also have been licence built, and three to China.
The Euler Hydro-triplane was an unusual pusher configuration amphibious triplane flying boat, built in Germany in 1913.
 | Wikimedia Commons has media related to Blackburn Triplane . |