Menai Bridge | |
---|---|
Coordinates | 53°13′12″N4°9′47″W / 53.22000°N 4.16306°W |
Carries | A5 (London to Holyhead) |
Crosses | Menai Strait |
Locale | Anglesey, North West Wales |
Heritage status | Grade 1 |
Characteristics | |
Design | Suspension bridge |
Material | Wrought iron (original chains) Steel (replacement chains) Stone Cast iron |
Total length | 417 metres (1,368 ft) |
Width | 12 metres (39 ft) |
Longest span | 176 metres (577 ft) |
No. of spans | Main: One Arches: Seven |
Piers in water | Five |
Clearance below | 31 metres (102 ft) |
Design life | 1893: wooden deck replaced in steel 1938/40: iron chains replaced in steel |
History | |
Designer | Thomas Telford |
Construction start | 1819 |
Opened | 30 January 1826 |
Location | |
The Menai Suspension Bridge (Welsh : Pont y Borth or Pont Grog y Borth) is a suspension bridge spanning the Menai Strait between the island of Anglesey and the mainland of Wales. Designed by Thomas Telford and completed in 1826, it was the world's first major suspension bridge. [1] The bridge still carries road traffic and is a Grade I listed structure. [2]
The Menai Strait was created by glacial erosion along a line of weakness associated with the Menai Strait fault system. During a series of Pleistocene glaciations (that lasted from about 2,580,000 to 11,700 years ago), a succession of ice-sheets moved from northeast to southwest across Anglesey and neighbouring Gwynedd, scouring the underlying rock and creating a series of linear bedrock hollows. The deepest of these channels eventually became flooded by the sea as the ice sheets receded, forming the Menai Strait. [3]
As Anglesey has been an island throughout recorded human history, the only way to reach it was by crossing the strait. However, this has always been a dangerous endeavour because there are four strong tidal flows each day generated by the twice daily tides. These flow in both directions through the strait, creating strong currents and whirlpools. Despite the dangers, ferries operated all along the Menai Strait, carrying passengers and goods between the island and the mainland. In 1785, a boat carrying 55 people ran aground at the southern end of the Menai Strait in a strong gale and began to sink. The stricken vessel sank before a rescue boat from Caernarfon could reach it, and only one person survived. [4]
Additionally, the main source of income on Anglesey was from the sale of cattle, and to move them to the markets of the mainland, including London, they had to be driven into the water and encouraged to swim across the Strait. This often resulted in the loss of valuable animals. [5]
In 1800, Ireland joined Great Britain in the Act of Union. This led rapidly to an increase in people travelling between London and Holyhead en route to Dublin. In 1815, the British Parliament passed an act of Parliament, the Holyhead Roads Act 1815 (55 Geo. 3. c. 152), to build the Holyhead Road with responsibility for the project given to civil engineer Thomas Telford. Despite some difficult geographical obstacles to overcome (e.g. Snowdonia and the Menai Strait), the route was chosen because Holyhead was the principal port for ferries to Dublin as it was the closest point to Ireland. After Telford had completed a survey of the route from London to Holyhead, he proposed that the best option was to build a bridge over the Menai Strait from a point near Bangor on the mainland to the village of Porthaethwy (now commonly known as Menai Bridge) on Anglesey. [5]
The site for the bridge was chosen because it had tall banks that would be high enough to allow sailing ships to pass underneath. Telford proposed that a suspension bridge would be the best option because it would have a span wide enough to cross the fast flowing waters of the Strait at this point. His recommendation was accepted by Parliament, which authorised the bridge in the Roads Between London and Holyhead Act 1819 (59 Geo. 3. c. 48). [5]
Construction of the bridge, to Telford's design, began in 1819 with the towers on either side of the strait. These were constructed from Penmon limestone and were hollow with internal cross-walls. Then came the sixteen huge chain cables to support the 176-metre (577 ft) span, each consisting of five parallel bars of wrought iron links, for a total of 80 iron bars and 935 links per cable. [6] [7]
The chains were carried over the piers on cast iron saddles with rollers, allowing for movement caused by temperature changes. [6] Each chain measured 522.3 metres (1,714 ft) and weighed 121 long tons (123 t; 136 short tons). Their suspending power was calculated at 2,016 long tons (2,048 t; 2,258 short tons). [5] To avoid rusting between manufacture and use, the iron was soaked in linseed oil and later painted. [8] On both sides of the strait the chains were conveyed through three tunnels into a chamber cut into the rock, where they were held in place by 9 feet (2.7 m) bolts resting in cast iron sockets. [6] William Hazledine was contracted to supply the necessary wrought and cast iron, and each chain had four adjusting links to compensate for differences in length caused by imperfections during the production of the large number of separate links. [6] [9]
Workmen assembled the majority of the chains link by link on-site. This was carried out on platforms near the tunnel mouths until the chains, supported by scaffolding, reached the tops of the piers. A cradle capable of carrying two workers was then suspended from each tower and links were lifted up and attached by the men in the cradles until the chains reached water level. The final central portion of each chain was floated across on a 400 feet (120 m) raft and lifted via a system of pulleys by 150 men. [6]
The bridge was opened to much fanfare on 30 January 1826. It reduced the 36-hour journey time from London to Holyhead by 9 hours. [5] [9]
The roadway was only 24 feet (7.3 m) wide and, without stiffening trusses, soon proved highly unstable in the wind. The deck of the Menai Bridge was strengthened in 1840 by W. A. Provis and, in 1893, the entire wooden surface was replaced with a steel deck designed by Sir Benjamin Baker. [10] Over the years, the 41⁄2-ton weight limit proved problematic for the increasing freight industry and in 1938 the original wrought iron chains were replaced by a new arrangement of steel ones, without the need to close the bridge. In 1999, the bridge was closed for around a month to resurface the road and strengthen the structure, requiring all traffic to cross via the nearby Britannia Bridge.
On 28 February 2005, one carriageway of the bridge was closed for six months, restricting traffic to a single carriageway. The bridge was reopened to traffic in both directions on 11 December 2005 after its first major repainting in 65 years. [11] It has been proposed by the British government as a candidate World Heritage Site. [12]
On 21 October 2022, the bridge was shut without prior notice. A statement from the Welsh Government said it was closed for essential maintenance work following safety recommendations from structural engineers. [13] Initially, the bridge was shut completely in both directions, but it was soon reopened to foot passengers and dismounted cyclists. The Welsh Government stated the bridge will remain closed for 14 to 16 weeks, reopening in early 2023. [14]
On 1 February 2023, the bridge was reopened in both directions, but subject to a seven and a half ton weight restriction. A date for full remedial work has yet to be set. [15]
The Anglesey Coastal Path passes below the bridge and the Wales coast path passes over the bridge and joins the mainland path at the bridge end. The bridge has a memorial to the Aberfan disaster victims on the Anglesey side.[ citation needed ]
The nearest settlement is the town of Menai Bridge. A representation of the Menai Bridge inside a border of railings and stanchions is featured on the reverse of British one-pound coins minted in 2005. [16]
White Knight to Alice:
"I heard him then, for I had just
completed my design,
To keep the Menai bridge from rust
By boiling it in wine."
Uchelgaer uwch y weilgi – gyr y byd
Ei gerbydau drosti,
Chwithau, holl longau y lli,
Ewch o dan ei chadwyni.— Dewi Wyn o Eifion [17]
High fortress above the sea – the world drives
Its carriages across it;
And you, all you ships of the sea,
Pass beneath its chains.— David Owen (1784–1841)
The A5, the London-Holyhead trunk road, is a major road in England and Wales. It runs for about 243 miles (391 km) from London to the Irish Sea at the ferry port of Holyhead. In many parts the route follows that of the Roman Iter II route which later took the Anglo-Saxon name Watling Street.
The Menai Strait is a strait which separates the island of Anglesey from Gwynedd, on the mainland of Wales. It is situated between Caernarfon Bay in the south-west and Conwy Bay in the north-east, which are both inlets of the Irish Sea. The strait is about 25 km (16 mi) long and varies in width from 400 metres (1,300 ft) between Fort Belan and Abermenai Point to 7.5 kilometres (4.7 mi) between Puffin Island and Penmaenmawr. It contains several islands, including Church Island, on which is located St Tysilio's Church.
Menai Bridge is a town and community on the Isle of Anglesey in north-west Wales. It overlooks the Menai Strait and lies by the Menai Suspension Bridge, built in 1826 by Thomas Telford, just over the water from Bangor. It has a population of 3,376.
Britannia Bridge is a bridge in Wales that crosses the Menai Strait between the Isle of Anglesey and city of Bangor. It was originally designed and built by the noted railway engineer Robert Stephenson as a tubular bridge of wrought iron rectangular box-section spans for carrying rail traffic. Its importance was to form a critical link of the Chester and Holyhead Railway's route, enabling trains to directly travel between London and the port of Holyhead, thus facilitating a sea link to Dublin, Ireland.
The Conwy Railway Bridge carries the North Wales coast railway line across the River Conwy between Llandudno Junction and the town of Conwy. The wrought iron tubular bridge, which is now Grade I listed, was built in the 19th century. It is the last surviving example of this type of design by Stephenson after the original Britannia Bridge across the Menai Strait was partially destroyed in a fire in 1970 and rebuilt as a two-tier truss arch bridge design.
The Conwy Suspension Bridge is a Grade I-listed structure and is one of the first road suspension bridges in the world. Located in the medieval town of Conwy in Conwy county borough, North Wales, it is now only passable on foot. The bridge is now in the care of the National Trust. It originally carried the A55(T) road from Chester to Bangor.
A tubular bridge is a bridge built as a rigid box girder section within which the traffic is carried. Famous examples include the original Britannia Bridge over the Menai Strait, the Conwy railway bridge over the River Conwy, designed and tested by William Fairbairn and built by Robert Stephenson between 1846 and 1850, and the original Victoria Bridge in Montreal.
Abermenai Point is a headland in the southeast of the island of Anglesey in Wales. It is the southernmost point of the island and is the northern point of the western entrance of the Menai Strait.
Ynys Gored Goch, sometimes Ynys Gorad Goch, is a small island in the Menai Strait between Gwynedd and Anglesey in north Wales. It is situated in the stretch of the strait called the Swellies between Thomas Telford's Menai Suspension Bridge and Robert Stephenson's Britannia Bridge.
Salt Island is joined to Holy Island, Anglesey, in North Wales. It is a natural provider of shelter for the town's Old Harbour from the Irish Sea and is part of the Port of Holyhead.
The Chester and Holyhead Railway was an early railway company conceived to improve transmission of Government dispatches between London and Ireland, as well as ordinary railway objectives. Its construction was hugely expensive, chiefly due to the cost of building the Britannia Tubular Bridge over the Menai Strait. The company had relied on Government support in facilitating the ferry service, and this proved to be uncertain. The company opened its main line throughout in 1850. It relied on the co-operation of other railways to reach London, and in 1859 it was absorbed by the London and North Western Railway.
Ynys y Bîg is a small private island in the Menai Strait attached to the island of Anglesey, in North Wales, by a wooden bridge. The bridge runs from the grounds of a private house, itself also called Ynys y Bîg, preventing any public access. The bridge fell into disrepair but was reconstructed in 2019.
The Anglesey Coastal Path is a 200-kilometre (124 mi) long-distance footpath around the island of Anglesey in North Wales. The route is part of the Wales Coast Path.
William Hazledine was an English ironmaster. Establishing large foundries, he was a pioneer in casting structural ironwork, most notably for canal aqueducts and early suspension bridges. Many of these projects were collaborations with Thomas Telford, including the Pontcysyllte Aqueduct and the Menai Suspension Bridge.
The Bangor and Carnarvon Railway was a railway company promoted to build a branch railway connecting Caernarfon with the main line at Bangor, in north-west Wales. It opened in 1852 as far as Port Dinorwic and was extended to Caernarfon later in the same year.
Anglesey is an island off the north-west coast of Wales. It forms the bulk of the county known as the Isle of Anglesey, which also includes Holy Island and some islets and skerries. The county borders Gwynedd across the Menai Strait to the southeast, and is otherwise surrounded by the Irish Sea. Holyhead is the largest town, and the administrative centre is Llangefni. The county is part of the preserved county of Gwynedd. Anglesey is the northernmost county in Wales.
Holyhead Breakwater is situated at the north-western end of Holyhead in Anglesey in Wales. The Victorian structure, which is 1.71 miles (2.75 km) long, is the longest breakwater in the United Kingdom. The breakwater, which is accessible in good weather, has a promenade on top which leads out to the Holyhead Breakwater Lighthouse.
The Menai Heritage Bridges Exhibition is a museum based in the Canolfan Thomas Telford Centre in Menai Bridge, Anglesey, Wales. It is dedicated to the two bridges across the Menai Strait; the Menai Suspension Bridge and the Britannia Bridge, as well as the local history and natural history of the Menai Strait and the surrounding area
Robert Brian Daimond was a British civil engineer best known for his knowledge of and contributions to the history of civil engineering, particularly the works of Thomas Telford and the bridges over the Menai Strait in North Wales.
The Third Menai Crossing was a proposed bridge over the Menai Strait, connecting the Isle of Anglesey with mainland Wales. The bridge was proposed to carry the A55 as a dual carriageway, and would have superseded the current A55 Britannia Bridge.