Reflex Lightning Bug

Last updated

Lightning Bug
1995 Reflex Lightning Bug 2 N44MX.jpg
Reflex Lightning Bug 2 at Sun-N-Fun 2007
Role Homebuilt aircraft
National origin United States
Manufacturer Reflex Fiberglass Works
DesignerNick Jones
Introduction1990s
StatusProduction completed
Number builtAt least nine

The Reflex Lightning Bug, also called the Jones Lightning Bug, is an American homebuilt aircraft that was designed by Nick Jones and produced by Reflex Fiberglass Works of Walterboro, South Carolina, introduced in the mid-1990s. When it was available the aircraft was supplied as a kit for amateur construction. [1]

Contents

Design and development

The Lightning Bug features a cantilever low-wing, a single-seat enclosed cockpit under a bubble canopy, fixed tricycle landing gear with wheel pants, a retractable nose wheel and a single engine in tractor configuration. [1]

The aircraft is made from a combination of stainless steel and fiberglass. Its 17.83 ft (5.4 m) span wing has a wing area of 40.00 sq ft (3.716 m2). The cabin width is 25 in (64 cm). The standard engine used is the 100 hp (75 kW) AMW 808 in-line three cylinder, liquid-cooled, two-stroke, dual ignition, aircraft engine. With that engine the aircraft can cruise at 225 mph (362 km/h). [1]

The Lightning Bug has a typical empty weight of 475 lb (215 kg) and a gross weight of 800 lb (360 kg), giving a useful load of 325 lb (147 kg). With full fuel of 23 U.S. gallons (87 L; 19 imp gal) the payload for the pilot and baggage is 187 lb (85 kg). The aircraft meets American FAR 23 aerobatic category requirements at a gross weight of 750 lb (340 kg). [1]

The standard day, sea level, no wind, take off with a 100 hp (75 kW) engine is 800 ft (244 m) and the landing roll is 1,000 ft (305 m), due to its 62 mph (100 km/h) stall speed. [1]

The manufacturer estimated the construction time from the supplied kit as 300 hours. [1]

Operational history

In February 2014 two examples were registered in the United States with the Federal Aviation Administration, although a total of nine had been registered at one time. [2]

Specifications (Lightning Bug)

Data from AeroCrafter [1]

General characteristics

Performance

See also

Related Research Articles

Bradley Aerobat American homebuilt aircraft

The Bradley BA 100 Aerobat is an American aerobatic homebuilt aircraft that was designed and produced by Bradley Aerospace of Chico, California. When it was available the aircraft was supplied as a kit for amateur construction.

The White Lightning WLAC-1 is an American four-seat single-engined monoplane designed for amateur construction by Nick Jones and sold as kits by the White Lighting Aircraft Corporation of South Carolina.

The Dempsey TD-3 Beta Lightning is the second original homebuilt aeroplane design by Thomas Dempsey.

Aircraft Technologies Acro 1 American homebuilt airplane

The Aircraft Technologies Acro 1 is an American aerobatic homebuilt aircraft that was designed by Fred Meyer and produced by Aircraft Technologies of Lilburn, Georgia. When it was available the aircraft was supplied as a kit or in the form of plans for amateur construction. Neither plans nor kits are available anymore and the aircraft is out of production.

The Giles G-200 is an American aerobatic homebuilt aircraft that was produced by AkroTech Aviation of Scappoose, Oregon. When it was available the aircraft was supplied as a complete ready-to-fly-aircraft or a kit for amateur construction. AkroTech Aviation went out of business and the design is no longer in production.

Culp Special

The Culp Special is an American aerobatic homebuilt aircraft designed and produced by Culp's Specialties of Shreveport, Louisiana. The aircraft is supplied as a kit or in the form of plans for amateur construction.

The Historical P-51 Mustang is an American homebuilt aircraft that was designed and produced by the Historical Aircraft Corporation of Nucla, Colorado. The aircraft is a 62.5% scale replica of the original North American P-51 Mustang and when it was available was supplied as a kit for amateur construction.

The Historical P-40C Tomahawk is an American homebuilt aircraft that was designed and produced by the Historical Aircraft Corporation of Nucla, Colorado. The aircraft is a 62.5% scale replica of the original Curtiss P-40C Tomahawk and when it was available was supplied as a kit for amateur construction.

The Junkers Profly Ultima is a German aerobatic homebuilt aircraft that was designed by Andre Konig and produced by Junkers Profly of Kodnitz, introduced in 1993. When it was available the aircraft was supplied as a kit for amateur construction.

The Laron Wizard is an American homebuilt aircraft produced by Laron Aviation Tech of Borger, Texas. When it was available the aircraft was supplied as a kit for amateur construction.

The Progressive Aerodyne Stingray is an American homebuilt flying boat that was designed by and produced by Progressive Aerodyne of Orlando, Florida, introduced in the 1990s. When it was available the aircraft was supplied as a kit for amateur construction.

Rowley P-40F American homebuilt aircraft

The Rowley P-40F was an American homebuilt aircraft that was designed by Richard J Rowley and marketed by his company 76th Fighter Squadron Inc, of Meadow Lake Airport, Colorado, first flown in 1986. When it was available the aircraft was supplied in the form of plans for amateur construction.

SkyDancer SD-260 American homebuilt aircraft

The SkyDancer SD-260 was an American aerobatic homebuilt biplane that was designed and produced by SkyDancer Aviation of Louisville, Kentucky, introduced in the mid-1990s. When it was available the aircraft was supplied as a kit.

The Sport Racer is an American homebuilt racing aircraft that was designed and produced by Sport Racer Inc of Valley Center, Kansas. When it was available the aircraft was supplied in the form of plans for amateur construction.

The Starfire Firebolt, sometimes called the Starfire Firebolt Convertible, due to its removable canopy, is an American homebuilt aerobatic biplane that was designed by G. H. "Mac" McKenzie and produced by Starfire Aviation of Tempe, Arizona. When it was available the aircraft was supplied in the form of plans for amateur construction, with some pre-fabricated parts available.

The Stewart S-51D Mustang is an American aerobatic homebuilt aircraft that was designed by Jim Stewart and produced by Stewart 51 of Vero Beach, Florida, introduced in 1994. When it was available the aircraft was supplied as a kit for amateur construction.

The Tech Aero TR 200 is a French homebuilt aerobatic aircraft that was designed and produced by Tech Aero of Glisolles, first flown in August 1988. When it was available the aircraft was supplied as a kit for amateur construction.

The Bradley BA-200 ATAC was an American homebuilt aircraft that was designed by Bradley Aerospace of Chico, California, introduced in the mid-1990s. The aircraft was intended to be supplied as a kit for amateur construction, but is likely that only one was constructed.

The Vancil Spitz S1 is an American homebuilt aircraft that was designed and produced by A. Vancil of Belton, South Carolina, introduced in the late 1990s. When it was available the aircraft was supplied as a kit and also in the form of plans for amateur construction.

The Viper Aircraft Viperfan was an American homebuilt aircraft that was designed and produced by Viper Aircraft of Kennewick, Washington, introduced in the late 1990s. The aircraft was intended to be supplied as a kit for amateur construction, but only one was ever built.

References

  1. 1 2 3 4 5 6 7 Purdy, Don: AeroCrafter - Homebuilt Aircraft Sourcebook, Fifth Edition, page 242. BAI Communications, 15 July 1998. ISBN   0-9636409-4-1
  2. ↑ Federal Aviation Administration (February 6, 2014). "Make / Model Inquiry Results" . Retrieved February 6, 2014.
This page is based on this Wikipedia article
Text is available under the CC BY-SA 4.0 license; additional terms may apply.
Images, videos and audio are available under their respective licenses.