| Specht | |
|---|---|
 | |
| Role | Two seat training glider |
| National origin | German Federal Republic |
| Manufacturer | Scheibe Flugzeugbau |
| Designer | Rudolf Kaiser |
| First flight | March 1953 |
| Number built | 55 |
The Scheibe Specht (English: Woodpecker) is a tandem seat training glider produced in Germany in the early 1950s. More than fifty were built.
The Specht was designed by Rudolph Kaiser, who around 1952 was dividing his time between Scheibe in Dachau and Schleicher in Poppenhausen. Hence the Specht and its contemporary Schleicher Ka-4 Rhönlerche, also designed by Kaiser, have much in common. [1]
The Specht has a wooden, two spar, high wing, braced on each side by V-struts from the spars to the lower fuselage, jury struts and mounted with 2° of dihedral. There is plywood skinning from the leading edge to the rear spar on the upper surface and to the forward spar below. The leading edge of the wing is straight and unswept and the trailing edge is parallel to it over its inner section, becoming tapered outboard. Ailerons, with inset hinges, fill these sections. Spoilers are mounted in the mid-inner wing panels at 11% chord. [2]
Scheibe used their usual fabric covered, steel tube and wooden stringer construction for the fuselage. Pupil and instructor sit in tandem in an enclosed cockpit, with the rear seat accessed by an under wing door. The fuselage, flat sided and hexagonal in section, narrows to the conventional tail. The horizontal tail, mounted on top of the fuselage, is roughly rectangular in plan and of low aspect ratio and the fin and rudder together are straight tapered and flat topped. The rudder is hinged behind the elevators and extends down to the keel. The Specht lands on a fixed monowheel under the rear seat, assisted by a central skid.
The Specht prototype first flew in March 1953. Just three years (7 March 1956) later Scheibe flew the Sperber (English: Sparrowhawk), a side by side seat version. [3] Necessarily wider in the cockpit area, the two types differed little, though the Sperber's span was 700 mm (28 in) greater and it was slightly (12 kg (26 lb)) heavier. Their performances were also very similar; the Sperber's minimum sink rate was 7% greater. [2]
Fifty-five Spechts were produced. [2] These were used by gliding clubs for pilot training in place of the earlier, open, single-seat primary gliders like the Zögling and its descendants. A few remained on the European civil aircraft registers in 2010. [4] In 2009 at least two of these were flight worthy, each with historic aircraft groups in Denmark and Norway; [5] in Sweden a third Specht, with a certificate of airworthiness valid into 2015, is owned by a similar group. [6]
Only five Sperbers were built, [2] one of which remained on the German civil aircraft register in 2010. [4]
Data fromThe World's Sailplanes (1958) pp.77-80 [2]
General characteristics
Performance
Aircraft of comparable role, configuration, and era
Related lists
The ASK 13 is a two-seater glider that was built by German sailplane manufacturer Alexander Schleicher Gmbh & Co. It was and still is widely used for basic training of glider pilots.
The Schleicher K 8 is a single-seat glider designed by Rudolf Kaiser and built by the Alexander Schleicher company in Germany.
The Scheibe Bergfalke is a German glider designed by Egon Scheibe as a post-World War II development of the Akaflieg München Mü13 produced before and during the war.
The Scheibe SF 28 Tandem-Falke is a German motorglider that was designed by Egon Scheibe in 1970 and which flew for the first time in May the following year. It was a development of the Scheibe Falke with seating in tandem rather than side-by-side as in the original Falke design.
The ESG Grunau 9, later known as the ESG 29 and post-1933 as the DFS 108-10, was one of the first primary gliders, built in Germany from the late 1920s. It was widely sold.
The Schleicher Ka-4 Rhönlerche II, sometimes called the KA-4 or even K 4, is a West German high-wing, strut-braced, two-seat glider that was designed by Rudolf Kaiser and produced by Alexander Schleicher GmbH & Co.
The Czerwiński-Shenstone Harbinger, aka the Shenstone-Czerwiński Harbinger or the Shenstone Harbinger was a Canadian high performance tandem seat sailplane designed in Canada. Only two were built, one in the UK and one in Canada. The latter did not fly until 1975, being under construction for 26 years; the former remained active until at least 1994.
The Horikawa H-23B-2 is a two-seat training glider designed and built in Japan in the 1950s. It was produced in small numbers.
The Horikawa H-22B-3 is a simple, open frame, two seat primary trainer glider designed and built in Japan in the 1950s.
The LCF II is a single seat Club Class glider, designed and built in the 1970s by German glider club members and intended to be suitable for training, competition and in particular aerobatics. Only one was completed.
The Schleicher Rhönbussard, otherwise known as the DFS Rhönbussard was intended as an intermediate glider trainer which could also fly competitively. It was designed by Hans Jacobs in Germany in the early 1930s. More than 200 were built.
The Schleicher Rhönadler, DFS Rhönadler or Jacobs Rhönadler is a high performance, single seat competition sailplane built in Germany in the 1930s. More than 65 were built.
The Scheibe SF-30 Club-Spatz is a 15 m class single seat sailplane built in Germany in the 1970s and intended for club use.
The IIL IS-8 was a two-seat sailplane designed by Iosif Șilimon and built in Romania in 1960. They served with Romanian gliding clubs.
The Schleicher Ka-2 Rhönschwalbe is a tandem two-seat training glider designed and built in Germany, in 1952.
The Schleicher Ka 3 or Kaiser Ka 3, is a 1950s single seat training glider, mostly sold in kit form.
The Schneider ES49 is a two-seat glider trainer, designed, first flown in late August 1951 and commercially produced in Germany but later built from plans by gliding clubs in Australia. A major redesign there led to the ES49B Kangaroo.
The Oberlerchner Mg 19 Steinadler is an Erwin Musger designed two seat tandem trainer glider built in Austria and first flown in 1951. Several examples of this successful aircraft, which competed in the two seat class at two World Gliding Championships in the 1950s, were still flying in 2000.
The Warsztaty Szybowcowe Mewa was a Polish, high performance, two seat sailplane flown in 1936 and built in small numbers.
The Politechnika Warszawska PW-3 Bakcyl (Microbe) is a Polish primary glider developed from the PW-2 Gapa.
