Teichfuss Supergrifo

Last updated
Supergrifo
RolePerformance single-seat glider
National origin Italy
ManufacturerF.A.L. Teichfuss (Fabrica Alianti Teichfuss), la Aie, Pavulla
DesignerLuigi Teichfluss
First flight1935
Number built1

The Teichfuss Supergrifo or Super Grifo was an Italian competition glider designed by Luigi Teichfuss and flown in 1935. Only one was built.

Contents

Design and development

The Supergrifo design began as an attempt to improve upon the Grifo but evolved into a much higher performance aircraft. The two models shared the same fuselage apart from the introduction of an enclosed cockpit but its wing was entirely new and of much greater span.

It was a braced high-wing monoplane, its single spar wing having a centre section, covering about one third of the span, which was rectangular in plan and had slight dihedral. The rest of the wing was strongly tapered to rounded wing tips; there was no sweep on the leading edges but the trailing edges were forward swept. There was no dihedral on these outer panels, making the Supergrifo slightly gull winged. Ailerons almost filled their trailing edges. [1] The increase of span to 18 m (59 ft 1 in) increased the aspect ratio by 60% to just over 20:1. [2] The wing was centrally mounted over the fuselage on a pedestal, which dropped rapidly away to the upper fuselage behind the trailing edge, and braced on each side by a pair of parallel faired struts from the lower fuselage to the ends of the wing central panel. [1]

The Supergrifo's fuselage was a ply covered wooden hexagonal structure with deep sides. The cockpit, placed immediately ahead of the pedestal, was covered with a multi-transparency canopy attached to the cockpit rim and lifting off in one piece. All the tail surfaces were straight tapered and straight tipped, with the tailplane mounted on top of the fuselage and carrying unbalanced elevators. The fin was small but mounted a large, balanced rudder which extended down to the keel, working in an elevator cut-out and provided with a protecting tail bumper. The Supergrifo's landing skid, equipped with rubber shock absorbers, reached aft to the rear wing strut. [1]

The Supergrifo first flew in 1935. Only one was built. It competed in the Second Italian National Gliding Competition, held at Asiago in August 1938. There, Adriano Mantelli won the City of Vicenza prize for a flight to that city lasting 219 minutes [1] and gaining 2,000 m (6,600 ft) en route. [3]

Specifications

Data from The Sailplane May 1950 [2]

General characteristics

Performance

See also

Related lists

Related Research Articles

The Bonomi BS.10 Ardea was an Italian single seat high performance glider, designed and built in the mid-1930s. Only one was built.

The Bonomi BS.24 Biposto Rome was an Italian dual control trainer designed for club use. Six were built in the mid-1930s.

The Bazzocchi EB.2 was a one off, Italian single seat glider designed and built by a university student in 1936, his second design of the year.

The Pagliani Vittoria was a single-seat glider built in Italy during Second World War. Only one was constructed.

The Caproni Vizzola MF and 2 were single-seat gliders built in Italy just before World War II. Intended as training aircraft capable of aerobatics, the two variants differed only in their fuselages. Only one of each was built, but they were both successful in Italian competitions.

The Sala N1 or N1 Sala was a single-seat,18 m span competition glider built in Italy in 1937. Only one was constructed.

The GVV Dal Molin MD.1 Anfibio Varese,, was a single-seat, amphibious flying boat glider built in Italy in 1933. Eight were constructed.

The Teichfuss Tenax was an Italian, one-off, single seat glider, designed and built by Luigi Treichfuss in 1926 and influenced by German developments.

The Teichfuss Gabbiano was an Italian, one-off, single seat, high performance glider, designed by Luigi Teichfuss and flown in 1928.

The Teichfuss Nibio was an Italian single seat glider, designed by Luigi Teichfuss and flown in two versions around 1930.

The Teichfuss Falco was an Italian single-seat, intermediate-performance glider, designed by Luigi Teichfuss and flown in 1931.

The Teichfuss LT.12 Biposto was an Italian tandem seat primary glider designed by Luigi Teichfuss and flown in 1933.

The Teichfuss Grifo was an Italian training glider designed by Luigi Teichfuss and flown in 1934. It was built in small numbers.

The Teichfuss Astore was an Italian Intermediate single-seat trainer glider designed by Luigi Teichfuss and flown in 1936. Two were built.

The Teichfuss Sparviero was an Italian single seat aerobatic glider, designed by Luigi Teichfuss and flown in 1938.

The Teichfuss Turbine was an Italian single seat high performance glider, designed by Luigi Teichfuss and flown in 1939.

The Teichfuss Balilla was an Italian single seat primary glider, designed by Luigi Teichfuss and flown in 1939.

The Teichfuss Allievo Pavullo was an Italian single seat open frame primary glider, designed by Luigi Teichfuss of Pavullo and first flown in 1940. It was sold in two versions, strut and cable braced. A single two seat variant was also built.

The Teichfuss Borea or LT.35 Borea was an Italian high performance glider designed by Luigi Teichfuss. It was completed by 1943 but never flew and the sole example was destroyed during the German occupation of Italy.

Rubik R-03 Szittya I

The Rubik R-03 Szittya I was a Hungarian single-seat sailplane flown in the late 1930s. The design was developed through three improving variants. though only one of each was built.

References

  1. 1 2 3 4 Pedrielli, Vincenzo; Camastra, Francesco (2011). Italian Vintage Sailplanes. Königswinter: EQIP Werbung & Verlag GmbH. pp. 44–5. ISBN   9783980883894.
  2. 1 2 "Notes on the Situation of Gliding in Italy". The Sailplane. 18 (5): 107. May 1950.
  3. "Teichfuss Super Grifo" . Retrieved 24 November 2013.