Teichfuss Falco

Last updated
Falco
RoleSingle seat intermediate performance glider
National origin Italy
DesignerLuigi Teichfuss
First flight1931
Number built2

The Teichfuss Falco (English: Falcon ) was an Italian single-seat, intermediate-performance glider, designed by Luigi Teichfuss and flown in 1931.

Contents

Design and development

The Falco was designed as a glider with performance better than that of a trainer though not at a soaring competition level. It was a high-wing monoplane, with its single spar wing braced on each side by a pair of faired struts arranged in a V, joining the lower fuselage to the outer end of the central panel at about one-third span. This central panel was rectangular in plan and without dihedral. The outer panels were straight-tapered to blunt tips, the wing becoming thinner and thus acquiring dihedral though retaining a horizontal upper surface. Ailerons occupied the whole trailing edges of these outer panels; there were no inboard flaps or air brakes. [1]

Its wood-framed, plywood-skinned fuselage was deep-sided and hexagonal in cross section, tapering markedly towards the tail. The wing was mounted on a pedestal which continued only briefly behind the wing. The pilot's open cockpit was immediately ahead of the pedestal and below the wing leading edge. There was no fixed tailplane; instead the Falco had a single-piece, all-moving elevator with a straight leading edge and a semi-elliptical trailing edge. There was a small triangular fin which supported a much larger, tall balanced rudder, essentially triangular in shape but with rounded vertices. Hinged above the elevator trailing edge, which had a cut-out for its movement, the rudder extended down to the keel, where it was protected by a small, faired tail bumper. There was a long landing skid with rubber shock absorbers, running from near the nose to under the aft end of the wing pedestal. [1]

The Falco first flew in 1931. Two were built; one was lost in a crash.

Specifications

Data from Pedrielli (2011) pp.36-7 [1]

General characteristics

Performance

See also

Related lists

Related Research Articles

The Bonomi BS.2 Balestruccio was an Italian sailplane designed to set records. In 1932 it set a new national endurance record with a flight of over 25 minutes.

The Bonomi BS.10 Ardea was an Italian single seat high performance glider, designed and built in the mid-1930s. Only one was built.

The Bonomi BS.18 Airone was a single seat training glider, designed in Italy in 1936. Only one was built.

The Pagliani Vittoria was a single-seat glider built in Italy during Second World War. Only one was constructed.

The Caproni Vizzola MF and 2 were single-seat gliders built in Italy just before World War II. Intended as training aircraft capable of aerobatics, the two variants differed only in their fuselages. Only one of each was built, but they were both successful in Italian competitions.

The Sala N1 or N1 Sala was a single-seat,18 m span competition glider built in Italy in 1933. Only one was constructed.

The Mantelli-Fossa MF-1 was a single-seat primary glider built in Italy in 1934. Only one was constructed.

The GP1 was an Italian glider constructed by university students in Pavia in 1925. Only one was built.

The Teichfuss Tenax was an Italian, one-off, single seat glider, designed and built by Luigi Treichfuss in 1926 and influenced by German developments.

The Teichfuss Gabbiano was an Italian, one-off, single seat, high performance glider, designed by Luigi Teichfuss and flown in 1928.

The Teichfuss Nibio was an Italian single seat glider, designed by Luigi Teichfuss and flown in two versions around 1930.

The Teichfuss Orione was an Italian high performance single seat glider, designed by Luigi Teichfuss. It made a six-hour record flight and also flew as the Italian representative at the 1936 Olympics.

The Teichfuss LT.12 Biposto was an Italian tandem seat primary glider designed by Luigi Teichfuss and flown in 1933.

The Teichfuss Grifo was an Italian training glider designed by Luigi Teichfuss and flown in 1934. It was built in small numbers.

The Teichfuss Supergrifo or Super Grifo was an Italian competition glider designed by Luigi Teichfuss and flown in 1935. Only one was built.

The Teichfuss Sparviero was an Italian single seat aerobatic glider, designed by Luigi Teichfuss and flown in 1938.

The Teichfuss Turbine was an Italian single seat high performance glider, designed by Luigi Teichfuss and flown in 1939.

The Teichfuss Balilla was an Italian single seat primary glider, designed by Luigi Teichfuss and flown in 1939.

The Teichfuss Allievo Pavullo was an Italian single seat open frame primary glider, designed by Luigi Teichfuss of Pavullo and first flown in 1940. It was sold in two versions, strut and cable braced. A single two seat variant was also built.

The Teichfuss Borea or LT.35 Borea was an Italian high performance glider designed by Luigi Teichfuss. It was completed by 1943 but never flew and the sole example was destroyed during the German occupation of Italy.

References

  1. 1 2 3 Pedrielli, Vincenzo; Camastra, Francesco (2011). Italian Vintage Sailplanes. Königswinter: EQIP Werbung & Verlag GmbH. pp. 36–7. ISBN   9783980883894.
  2. 1 2 "Teichfuss Falco" . Retrieved 19 November 2013.
This page is based on this Wikipedia article
Text is available under the CC BY-SA 4.0 license; additional terms may apply.
Images, videos and audio are available under their respective licenses.