BL 16.25-inch Mk I naval gun

Last updated

Ordnance BL 16.25 inch gun Mk I
BL 16.25 inch 110 ton gun Photo.jpg
Type Naval gun
Place of originUnited Kingdom
Service history
In service1888 – 1909?
Used by Royal Navy
Production history
Manufacturer Elswick Ordnance Company
No. built12
Variantsno two guns were identical
Specifications
Mass111 tons
Length43 ft 7 in; 13.3 m
Barrel  length40 ft 8 in; 12.4 m bore (30 calibres)

Shell 1,800 lb (820 kg) Armour-piercing, Common, or Shrapnel
Calibre 16.25 in (413 mm)
Elevation -5° – 13°
Rate of fire about one round every three minutes
Muzzle velocity 2,087 feet per second (636 m/s) [1]
Maximum firing range12,000 yards (11,000 m) [2]

The Elswick BL 16.25 inch naval gun was an early British superheavy rifled breech-loading naval gun, commonly known as the 110-ton gun or 111-ton gun.

Contents

Service

Forward barbette on HMS Benbow HMS Benbow Forward 16.25 inch gun barbette.jpg
Forward barbette on HMS Benbow
Turret on HMS Sans Pareil HMS Sans Pareil 16.25 inch turret.jpg
Turret on HMS Sans Pareil
111-ton gun on proof mount The railroad and engineering journal (1887) (14571889167).jpg
111-ton gun on proof mount

Elswick had already supplied similar guns to Italy's Regia Marina and fitted in the Italian ironclad Andrea Doria of 1885 and the Royal Navy required parity for its Mediterranean Fleet. The adoption of this gun was influenced by the slow rate of production of the preferred new 13.5-inch (343 mm) guns: the Royal Navy had the option of delaying the completion of the new Admiral-class ironclads until sufficient 13.5-inch guns were available to equip them with four guns in two twin barbettes as planned; to use 12-inch (305 mm) guns, or to equip them with the new 16.25-inch (413 mm) guns.

The decision made was to install 16.25-inch guns in HMS Benbow in 1887 in single barbettes fore and aft, each gun substituting for two 13.5-inch guns. For the following HMS Victoria and HMS Sans Pareil the 16.25-inch guns were mounted in pairs in a single turret placed forward.

Weaknesses such as droop and cracking were discovered in the early design, and the many subsequent changes meant that none of the twelve guns built were identical, so the Mk I denomination was discontinued and the individual guns were referred to by their serial numbers. The great weight, low rate of fire and short life of less than 75 rounds meant that the guns were less than successful and were in fact never fired in action.

Ammunition

Diagrams of common, shrapnel and armour-piercing projectiles and their fuzes for the gun BL 16.25 inch gun ammunition diagrams.jpg
Diagrams of common, shrapnel and armour-piercing projectiles and their fuzes for the gun

See also

Notes

  1. 1800lb shell, with 960lb S.B.C. ("slow burning Brown cocoa" powder – a form of gunpowder) charge. Text Book of Gunnery, 1902. Table XII, Page 336
  2. Text Book of Gunnery, 1902. Table XII, Page 336

Related Research Articles

<i>Warrior</i>-class ironclad Class of ironclads of the Royal Navy

The Warrior-class ironclads were a class of two warships built for the Royal Navy between 1859 and 1862, the first ocean-going ironclads with iron hulls ever constructed. The ships were designed as armoured frigates in response to an invasion scare sparked by the launch of the French ironclad Gloire and her three sisters in 1858. They were initially armed with a mix of rifled breech-loading and muzzle-loading smoothbore guns, but the Armstrong breech-loading guns proved unreliable and were ultimately withdrawn from service.

<span class="mw-page-title-main">RBL 7-inch Armstrong gun</span> Naval gun

The Armstrong RBL 7-inch gun, also known as the 110-pounder, was a heavy caliber Armstrong gun, an early type of rifled breechloader.

HMS <i>Collingwood</i> (1882) Admiral-class battleship

HMS Collingwood was the lead ship of her class of ironclad battleships built for the Royal Navy during the 1880s. The ship's essential design became the standard for most of the following British battleships. Completed in 1887, she spent the next two years in reserve before she was assigned to the Mediterranean Fleet for the next eight years. After returning home in 1897, the ship spent the next six years as a guardship in Ireland. Collingwood was not significantly damaged during an accidental collision in 1899 and was paid off four years later. The ship was sold for scrap in 1909 and subsequently broken up.

HMS <i>Anson</i> (1886) Admiral-class battleship

HMS Anson was the last of six Admiral-class ironclad battleships built for the Royal Navy during the 1880s. The ship was completed, except for her armament, in 1887, but had to wait two years for her guns to be installed. She was assigned to the Channel Fleet in mid-1889 as a flagship for the fleet's second-in-command. Two years later, the passenger ship SS Utopia sank with the loss of 562 lives after colliding with Anson in the Bay of Gibraltar. In mid-1893, Anson was transferred to the Mediterranean Fleet, subsequently returning home in 1900 when she was assigned to the Reserve Fleet. She recommissioned for the Home Fleet in early 1901. Anson was paid off three years later and then sold for scrap in 1909.

<span class="mw-page-title-main">100-ton gun</span> Naval gun

The 100-ton gun was a 17.72-inch (450 mm) rifled muzzle-loading (RML) gun made by Elswick Ordnance Company, the armaments division of the British manufacturing company Armstrong Whitworth, owned by William Armstrong. The 15 guns Armstrong made were used to arm two Italian battleships and, to counter these, British fortifications at Malta and Gibraltar.

<span class="mw-page-title-main">QF 6-inch naval gun</span> Naval gun

The QF 6-inch 40 calibre naval gun (Quick-Firing) was used by many United Kingdom-built warships around the end of the 19th century and the start of the 20th century. In British service it was known as the QF 6-inch Mk I, II, III guns. As the 15 cm/40 (6") 41st Year Type naval gun it was used for pre-dreadnought battleships, armoured cruisers and protected cruisers of the early Imperial Japanese Navy built in UK and European shipyards. It was also the heaviest gun ever carried by a pre-Cold War destroyer.

<span class="mw-page-title-main">Armstrong Whitworth 12-inch 40-calibre naval gun</span> Naval gun

The Armstrong Whitworth 12-inch naval gun of 40 calibres length was designed by and manufactured mainly by Armstrong's ordnance branch, Elswick Ordnance Company. It was intended for the Royal Navy's Royal Sovereign-class battleships, but budgetary constraints delayed their introduction. The first units were instead supplied to Japan. As the Type 41 12-inch (305 mm) 40-calibre naval gun it was the standard main battery on several early United Kingdom-built pre-dreadnought battleships of the Imperial Japanese Navy.

<span class="mw-page-title-main">BL 12-inch Mk I – VII naval gun</span> Naval gun

The BL 12 inch naval gun Mk I was a British rifled breech-loading naval gun of the early 1880s intended for the largest warships such as battleships and also coastal defence. It was Britain's first attempt to match the large guns being installed in rival European navies, particularly France, after Britain transitioned from rifled muzzle-loading guns to the modern rifled breech-loaders somewhat later than the European powers. Mks I - VII all had a barrel of approximately 303 inches in length and similar performance.

<span class="mw-page-title-main">BL 13.5-inch Mk I – IV naval gun</span> Naval gun

The BL 13.5 inch naval gun Mk I was Britain's first successful large breechloading naval gun, initially designed in the early 1880s and eventually deployed in the late 1880s. Mks I - IV were all of 30 calibres length and of similar construction and performance.

<span class="mw-page-title-main">BL 12-inch Mk VIII naval gun</span> Naval Gun, Coastal Defence

The BL 12-inch Mark VIII naval gun was one of the first large British rifled breech-loading naval guns designed for the higher pressures generated by the new cordite propellant of the 1890s, and Britain's first large wire-wound gun. It represented a major advance compared to previous British guns.

<span class="mw-page-title-main">BL 9.2-inch Mk VIII naval gun</span> Naval gun

The BL 9.2-inch Mk VIII naval gun was designed for the new cordite propellants and was the first British wire-wound gun of this calibre.

<span class="mw-page-title-main">BL 9.2-inch Mk IX – X naval gun</span> Naval gun

The BL 9.2-inch Mk IX and Mk X guns were British breech loading 9.2-inch (234 mm) guns of 46.7 calibre, in service from 1899 to the 1950s as naval and coast defence guns. They had possibly the longest, most varied and successful service history of any British heavy ordnance.

<span class="mw-page-title-main">BL 9.2-inch Mk I – VII naval gun</span> Naval gun

The BL 9.2-inch Mk I–VII guns were a family of early British heavy breechloading naval and coast defence guns in service from 1881 to the end of World War I. They were originally designed to use the old gunpowder propellants.

<span class="mw-page-title-main">BL 6-inch Mk II – VI naval gun</span> Naval gun

The BL 6-inch gun Marks II, III, IV and VI were the second and subsequent generations of British 6-inch rifled breechloading naval guns, designed by the Royal Gun Factory in the 1880s following the first 6-inch breechloader, the relatively unsuccessful BL 6-inch 80-pounder gun designed by Elswick Ordnance. They were originally designed to use the old gunpowder propellants but from the mid-1890s onwards were adapted to use the new cordite propellant. They were superseded on new warships by the QF 6-inch gun from 1891.

<span class="mw-page-title-main">BL 10-inch Mk I – IV naval gun</span> Naval gun

The BL 10 inch guns Mks I, II, III, IV were British rifled breechloading 32-calibre naval and coast defence guns in service from 1885.

<span class="mw-page-title-main">BL 8-inch Mk I – VII naval gun</span> Naval gun

The BL 8 inch guns Mark I to Mark VII were the first generations of British rifled breechloaders of medium-heavy calibre. They were initially designed for gunpowder propellants and were of both 25.5 and 30 calibres lengths.

<span class="mw-page-title-main">BL 6-inch gun Mk V</span> Coast defence gun

The BL 6 inch gun Mk V was an early Elswick Ordnance Company breech-loading naval gun originally designed to use the old gunpowder propellants. They were used for coast defence around the British Empire.

<span class="mw-page-title-main">BL 5-inch gun Mk I – V</span> Naval gun

The BL 5-inch guns Mk I – Mk V were early British 5-inch rifled breechloading naval guns after it switched from rifled muzzle-loaders in the late 1870s. They were originally designed to use the old gunpowder propellants. The 5-inch calibre was soon discontinued in favour of QF 4.7-inch.

<span class="mw-page-title-main">BL 6-inch 80-pounder gun</span> Naval gun

The BL 6-inch 80-pounder gun Mk I was the first generation of British 6-inch breechloading naval gun after it switched from muzzle-loaders in 1880. They were originally designed to use the old gunpowder propellants.

<span class="mw-page-title-main">RML 7-inch gun</span> Naval gun

The RML 7-inch guns were various designs of medium-sized rifled muzzle-loading guns used to arm small to medium-sized British warships in the late 19th century, and some were used ashore for coast defence.

References