XB-36
In 1941, the fall of Britain to a German invasion seemed imminent. If the United States joined the war against the Axis Powers, the fall of Britain would leave no bases in Europe from which the United States Army Air Corps (AAC) could bomb Germany. This possibility led to AAC to seek a bomber of truly intercontinental range. On 1941 April 11, the AAC issued a design competition for an aircraft with a 275 mph (445 km/h) cruising speed, a service ceiling of 45,000 ft (14,000 m), capable of delivering 10,000 lb (4,500 kg) of bombs to targets 5,000 miles (8,000 km) away. At the time, these requirements far exceeded the best technology available.
In November 1941, the United States Army Air Forces signed a contract for two experimental aircraft under the designation XB-36, based on design studies previously submitted by Consolidated Aircraft Corporation. A few days later, the Engineering Division at Wright Field decided that Consolidated's six-engine design, with all engines on the trailing edge of the wing, was the best option for the aircraft. The original design used vertical stabilizers and rudders, similar to those used in the B-24 Liberator. By the time the first XB-36 was delivered, the design had been changed to a huge single tail, and the wingspan increased to 230 ft (70 m), an unprecedented size.
| Variant | Built |
|---|
| XB-36 | 1 |
| YB-36 | 1 |
| B-36A | 21 |
| B-36B | 62 |
| B-36D | 26 |
| RB-36D | 24 |
| B-36F | 36 |
| RB-36F | 24 |
| B-36H | 83 |
| RB-36H | 73 |
| B-36J | 33 |
|
| Total | 384 |
It was clear that the B-36 needed nose guns. Adding these required a substantial rearrangement of the cockpit. In late 1944, a mockup of the new nose was approved. Though too late for the first prototype, it would be fitted to the second XB-36. Unfortunately, the new nose with its radar and radio equipment added significant weight.
The first (and only) XB-36 was completed at the Consolidated Fort Worth factory in late 1945. The plane sat on huge wheels 9 ft (2.8 m) in diameter; only three airfields in the USA had concrete thick enough to support the pressure exerted by wheels of that size. In 1948 June, the single-wheel undercarriage was replaced by a new undercarriage consisting of two wheels with half the diameter on each strut. This design, which would become the production standard, enabled the B-36 to operate on runways of reasonable thickness.
The maiden flight revealed problems with the flap actuating system, engine cooling, and the reliability of the aluminum wiring. Propeller vibration adversely affected the wing structure. Worse yet, the XB-36 failed to meet the 1941 specifications. In particular, inadequate engine cooling kept its service ceiling under 30,000 ft (9,000 m), much less than that called for in the original contract.
Following a grounding for modifications, the XB-36 was flight tested for 160 hours by pilots of the Army Air Force Air Materiel Command, then returned to Convair for further testing.
References:
YB-36
The YB-36A, a conversion of the original XB-36, was turned over to the United States Air Force in June 1948, a week before the production B-36A was scheduled to be delivered. The YB-36A had inadequate operation value, and the Strategic Air Command used it primarily for training missions. Later it was idle for several years, then employed in the Carswell Air Force Base firefighting program.
The second prototype, designated YB-36, of which only a single instance was built, was chosen as the production version in mid-1945. Its new high-visibility cockpit and redesigned nose compartment became the standard. Thanks to various design improvements, the YB-36 outperformed the XB-36, eventually reaching altitudes of 40,000 ft (12,000 m). It was essentially built to B-36A specifications; in fact, it flew six months after the B-36A. In late 1950, the YB-36 was returned to Convair and converted into a reconnaissance aircraft under the designation RB-36E. In the spring of 1957, it was decommissioned and placed in the National Museum of the United States Air Force at Wright-Patterson Air Force Base.
References:
B-36A
The B-36A included several of the new elements developed on the YB-36, including the domed canopy and the four-wheel main landing gear (as opposed to the single-wheel landing gear used on the XB-36 and the YB-36). These new features were in a sense first seen on the B-36A rather than the YB-36, because it was the former that flew first — by six months.
The first B-36A ever built was destroyed by a series of brutal stress tests, consisting mainly of applying more and more load to various parts of the aircraft until they disintegrated.
On April 8, 1948, a B-36A made a 6,922 mile (11,140 km) flight of 33 hours, shuttling between Fort Worth and San Diego three times without landing, and carrying a 10,000 lb (4,500 kg) bomb load. In May, the same aircraft did a round trip of 8,062 miles (12,970 km) lasting 33 hours.
By virtue of its designation, the B-36A was technically a production aircraft. However, it lacked defensive armament because the system wasn't ready. It was an explicitly interim plane used by the 7th Bomb Group at Carswell Air Force Base in Texas for the sole purpose of flight testing and transitional crew training. When the newer B-36B became available, all B-36As were converted to reconnaissance aircraft and redesignated RB-36E.
A total of 22 were built.
References:
The Boeing B-47 Stratojet is a retired American long-range, six-engined, turbojet-powered strategic bomber designed to fly at high subsonic speed and at high altitude to avoid enemy interceptor aircraft. The primary mission of the B-47 was as a nuclear bomber capable of striking targets within the Soviet Union.
The Convair B-36 "Peacemaker" is a strategic bomber that was built by Convair and operated by the United States Air Force (USAF) from 1949 to 1959. The B-36 is the largest mass-produced piston-engined aircraft ever built. It has the longest wingspan of any combat aircraft ever built, at 230 ft (70 m). The B-36 was the first bomber capable of delivering any of the nuclear weapons in the U.S. arsenal from an internal bomb bay without aircraft modifications. With a range of 10,000 mi (16,000 km) and a maximum payload of 87,200 lb (39,600 kg), the B-36 is capable of intercontinental flight without refueling.
The Convair B-58 Hustler, designed and produced by American aircraft manufacturer Convair, was the first operational bomber capable of Mach 2 flight.
The North American B-45 Tornado was an early American jet bomber designed and manufactured by aircraft company North American Aviation. It has the distinction of being the first operational jet bomber to enter service with the United States Air Force (USAF), as well as the first multiengine jet bomber to be refueled in midair.
The Convair YB-60 was a prototype heavy bomber built by Convair for the United States Air Force in the early 1950s. It was a purely jet-powered development of Convair's earlier mixed-power B-36 Peacemaker.
The Pratt & Whitney R-4360 Wasp Major is an American 28-cylinder four-row radial piston aircraft engine designed and built during World War II. First run in 1944, at 4,362.5 cu in (71.5 L), it is the largest-displacement aviation piston engine to be mass-produced in the United States, and at 4,300 hp (3,200 kW) the most powerful. It was the last of the Pratt & Whitney Wasp family, and the culmination of its maker's piston engine technology.
The Northrop YB-35/XB-35, Northrop designation N-9 or NS-9, were experimental heavy bomber aircraft developed by the Northrop Corporation for the United States Army Air Forces during and shortly after World War II. The airplane used the radical and potentially very efficient flying wing design, in which the tail section and fuselage are eliminated and all payload is carried in a thick wing. Only prototypes and pre-production aircraft were built, although interest remained strong enough to warrant further development of the design as a jet bomber, under the designation YB-49.
The Northrop YB-49 was an American prototype jet-powered heavy bomber developed by Northrop Corporation shortly after World War II for service with the United States Air Force. The YB-49 featured a flying wing design and was a turbojet-powered development of the earlier, piston-engined Northrop XB-35 and YB-35. The two YB-49s built were both converted YB-35 test aircraft.
The Martin B-57 Canberra is an American-built, twin-engined tactical bomber and reconnaissance aircraft that entered service with the United States Air Force (USAF) in 1953. The B-57 is a license-built version of the British English Electric Canberra, manufactured by the Glenn L. Martin Company. Initial Martin-built models were virtually identical to their British-built twinjet counterparts; Martin later modified the design to incorporate larger quantities of US-sourced components and produced the aircraft in several variants.
The Boeing B-50 Superfortress is an American strategic bomber. A post–World War II revision of the Boeing B-29 Superfortress, it was fitted with more powerful Pratt & Whitney R-4360 radial engines, stronger structure, a taller tail fin, and other improvements. It was the last piston-engined bomber built by Boeing for the United States Air Force, and was further refined into Boeing's final such design, the prototype B-54. Although not as well known as its direct predecessor, the B-50 was in USAF service for nearly 20 years.
The Convair X-6 was a proposed experimental aircraft project to develop and evaluate a nuclear-powered jet aircraft. The project was to use a Convair B-36 bomber as a testbed aircraft, and though one NB-36H was modified during the early stages of the project, the program was canceled before the actual X-6 and its nuclear reactor engines were completed. The X-6 was part of a larger series of programs, costing US$7 billion in all, that ran from 1946 through 1961. Because such an aircraft's range would not have been limited by liquid jet fuel, it was theorized that nuclear-powered strategic bombers would be able to stay airborne for weeks at a time.
The Boeing B-29 Superfortress is a WWII era long range, strategic heavy bomber that was produced in many experimental and production models.
The General Electric J47 turbojet was developed by General Electric from its earlier J35. It first flew in May 1948. The J47 was the first axial-flow turbojet approved for commercial use in the United States. It was used in many types of aircraft, and more than 30,000 were manufactured before production ceased in 1956. It saw continued service in the US military until 1978. Packard built 3,025 of the engines under license.
The FICON program was conducted by the United States Air Force in the 1950s to test the feasibility of a Convair B-36 Peacemaker bomber carrying a Republic F-84 Thunderflash parasite fighter in its bomb bay. Earlier wingtip coupling experiments included Tip Tow, which were attempts at carrying fighters connected to the wingtips of bombers. Tom-Tom followed the FICON project afterwards.
The Boeing B-54 was an American strategic bomber designed by Boeing for use by the United States Air Force. Derived from the YB-50C Superfortress, construction of the prototype was canceled before completion, and the aircraft was never flown.
Curtiss Hawk was a name common to many aircraft designed and produced by the Curtiss Aeroplane and Motor Company, most of them fighters:
The 718th Bombardment Squadron is an inactive United States Air Force unit. It was last assigned to the 4128th Strategic Wing at Amarillo Air Force Base, Texas, where it was inactivated on 1 February 1963.
The Convair NB-36H was an experimental aircraft that carried a nuclear reactor to test its protective radiation shielding for the crew, but did not use it to power the aircraft. Nicknamed "The Crusader", it was created for the Aircraft Nuclear Propulsion program, to show the feasibility of a nuclear-powered bomber. Its development ended with the cancellation of the ANP program.
