Diversity scheme

Last updated April 04, 2020

In telecommunications, a diversity scheme refers to a method for improving the reliability of a message signal by using two or more communication channels with different characteristics. Diversity is mainly used in radio communication and is a common technique for combatting fading and co-channel interference and avoiding error bursts. It is based on the fact that individual channels experience different levels of fading and interference. Multiple versions of the same signal may be transmitted and/or received and combined in the receiver. Alternatively, a redundant forward error correction code may be added and different parts of the message transmitted over different channels. Diversity techniques may exploit the multipath propagation, resulting in a diversity gain, often measured in decibels.

Diversity techniques

The following classes of diversity schemes can be identified:

Time diversity : Multiple versions of the same signal are transmitted at different time instants. Alternatively, a redundant forward error correction code is added and the message is spread in time by means of bit-interleaving before it is transmitted. Thus, error bursts are avoided, which simplifies the error correction.
Frequency diversity : The signal is transmitted using several frequency channels or spread over a wide spectrum that is affected by frequency-selective fading. Later examples include:
- OFDM modulation in combination with subcarrier interleaving and forward error correction
- Spread spectrum, for example frequency hopping or DS-CDMA.
Space diversity : The signal is transmitted over several different propagation paths. In the case of wired transmission, this can be achieved by transmitting via multiple wires. In the case of wireless transmission, it can be achieved by antenna diversity using multiple transmitter antennas (transmit diversity) and/or multiple receiving antennas (reception diversity). In the latter case, a diversity combining technique is applied before further signal processing takes place. If the antennas are far apart, for example at different cellular base station sites or WLAN access points, this is called macrodiversity or site diversity. If the antennas are at a distance in the order of one wavelength, this is called microdiversity. A special case is phased antenna arrays, which also can be used for beamforming, MIMO channels and space–time coding (STC).
Polarization diversity: Multiple versions of a signal are transmitted and received via antennas with different polarization. A diversity combining technique is applied on the receiver side.
Multiuser diversity : Multiuser diversity is obtained by opportunistic user scheduling at either the transmitter or the receiver ^[1]. Opportunistic user scheduling is as follows: at any given time, the transmitter selects the best user among candidate receivers according to the qualities of each channel between the transmitter and each receiver. A receiver must feed back the channel quality information to the transmitter using limited levels of resolution, in order for the transmitter to implement Multiuser diversity.
Cooperative diversity : Achieves antenna diversity gain by using the cooperation of distributed antennas belonging to each node.

Combiner techniques

An important element in communication systems applying diversity schemes is the "Combiner", which processes the redundantly received signals. Combiner technologies are traditionally classified according to Brennan:^[2]

Maximal-Ratio Combiner
Equal-Gain Combiner
Scanning/Switching Combiner
Selection Combiner

To combine parallel redundant transmitted longer signal sequences, for example network packets, the principle of a Timing Combiner was defined in 2012 ^[3]. Similarly working like a Selection Combiner, the first fully received and valid data packet will be immediately further processed, whereas the later arriving redundant packets will be immediately discarded after reception. With this approach, always the faster of the redundant channels "wins", yielding significant performance improvements especially in wireless applications.^[3]

Related Research Articles

Code-division multiple access (CDMA) is a channel access method used by various radio communication technologies. CDMA is an example of multiple access, where several transmitters can send information simultaneously over a single communication channel. This allows several users to share a band of frequencies. To permit this without undue interference between the users, CDMA employs spread spectrum technology and a special coding scheme.

In telecommunications, orthogonal frequency-division multiplexing (OFDM) is a type of digital transmission, and a method of encoding digital data on multiple carrier frequencies. OFDM has developed into a popular scheme for wideband digital communication, used in applications such as digital television and audio broadcasting, DSL internet access, wireless networks, power line networks, and 4G mobile communications.

Digital Audio Broadcasting (DAB) is a digital radio standard for broadcasting digital audio radio services in many countries around the world but not in North America where HD Radio is the standard for digital radio.

In wireless communications, fading is variation of the attenuation of a signal with various variables. These variables include time, geographical position, and radio frequency. Fading is often modeled as a random process. A fading channel is a communication channel that experiences fading. In wireless systems, fading may either be due to multipath propagation, referred to as multipath-induced fading, weather, or shadowing from obstacles affecting the wave propagation, sometimes referred to as shadow fading.

A communication channel refers either to a physical transmission medium such as a wire, or to a logical connection over a multiplexed medium such as a radio channel in telecommunications and computer networking. A channel is used to convey an information signal, for example a digital bit stream, from one or several senders to one or several receivers. A channel has a certain capacity for transmitting information, often measured by its bandwidth in Hz or its data rate in bits per second.

Ultra-wideband is a radio technology that can use a very low energy level for short-range, high-bandwidth communications over a large portion of the radio spectrum. UWB has traditional applications in non-cooperative radar imaging. Most recent applications target sensor data collection, precision locating and tracking applications.

A single-frequency network or SFN is a broadcast network where several transmitters simultaneously send the same signal over the same frequency channel.

A space–time code (STC) is a method employed to improve the reliability of data transmission in wireless communication systems using multiple transmit antennas. STCs rely on transmitting multiple, redundant copies of a data stream to the receiver in the hope that at least some of them may survive the physical path between transmission and reception in a good enough state to allow reliable decoding.

Antenna diversity, also known as space diversity or spatial diversity, is any one of several wireless diversity schemes that uses two or more antennas to improve the quality and reliability of a wireless link. Often, especially in urban and indoor environments, there is no clear line-of-sight (LOS) between transmitter and receiver. Instead the signal is reflected along multiple paths before finally being received. Each of these bounces can introduce phase shifts, time delays, attenuations, and distortions that can destructively interfere with one another at the aperture of the receiving antenna.

Diversity combining is the technique applied to combine the multiple received signals of a diversity reception device into a single improved signal.

An ATSCtuner, often called an ATSC receiver or HDTV tuner, is a type of television tuner that allows reception of digital television (DTV) television channels that use ATSC standards, as transmitted by television stations in North America, parts of Central America, and South Korea. Such tuners are usually integrated into a television set, VCR, digital video recorder (DVR), or set-top box which provides audio/video output connectors of various types.

In computing, telecommunication, information theory, and coding theory, an error correction code, sometimes error correcting code, (ECC) is used for controlling errors in data over unreliable or noisy communication channels. The central idea is the sender encodes the message with redundant information in the form of an ECC. The redundancy allows the receiver to detect a limited number of errors that may occur anywhere in the message, and often to correct these errors without retransmission. The American mathematician Richard Hamming pioneered this field in the 1940s and invented the first error-correcting code in 1950: the Hamming (7,4) code.

In the field of wireless communication, macrodiversity is a kind of space diversity scheme using several receiver antennas and/or transmitter antennas for transferring the same signal. The distance between the transmitters is much longer than the wavelength, as opposed to microdiversity where the distance is in the order of or shorter than the wavelength.

Dynamic Single Frequency Networks (DSFN) is a transmitter macrodiversity technique for OFDM based cellular networks.

Precoding is a generalization of beamforming to support multi-stream transmission in multi-antenna wireless communications. In conventional single-stream beamforming, the same signal is emitted from each of the transmit antennas with appropriate weighting such that the signal power is maximized at the receiver output. When the receiver has multiple antennas, single-stream beamforming cannot simultaneously maximize the signal level at all of the receive antennas. In order to maximize the throughput in multiple receive antenna systems, multi-stream transmission is generally required.

Multi-user MIMO (MU-MIMO) is a set of multiple-input and multiple-output (MIMO) technologies for wireless communication, in which a set of users or wireless terminals, each with one or more antennas, communicate with each other. In contrast, single-user MIMO considers a single multi-antenna transmitter communicating with a single multi-antenna receiver. In a similar way that OFDMA adds multiple access (multi-user) capabilities to OFDM, MU-MIMO adds multiple access (multi-user) capabilities to MIMO. MU-MIMO has been investigated since the beginning of research into multi-antenna communication.

WiMAX MIMO refers to the use of Multiple-input multiple-output communications (MIMO) technology on WiMAX, which is the technology brand name for the implementation of the standard IEEE 802.16.

In radio, multiple-input and multiple-output, or MIMO, is a method for multiplying the capacity of a radio link using multiple transmission and receiving antennas to exploit multipath propagation. MIMO has become an essential element of wireless communication standards including IEEE 802.11n (Wi-Fi), IEEE 802.11ac (Wi-Fi), HSPA+ (3G), WiMAX (4G), and Long Term Evolution. More recently, MIMO has been applied to power-line communication for 3-wire installations as part of ITU G.hn standard and HomePlug AV2 specification.

Radio is the technology of signaling and communicating using radio waves. Radio waves are electromagnetic waves of frequency between 30 hertz (Hz) and 300 gigahertz (GHz). They are generated by an electronic device called a transmitter connected to an antenna which radiates the waves, and received by a radio receiver connected to another antenna. Radio is very widely used in modern technology, in radio communication, radar, radio navigation, remote control, remote sensing and other applications.

CDMA spectral efficiency refers to the system spectral efficiency in bit/s/Hz/site or Erlang/MHz/site that can be achieved in a certain CDMA based wireless communication system. CDMA techniques are characterized by a very low link spectral efficiency in (bit/s)/Hz as compared to non-spread spectrum systems, but a comparable system spectral efficiency.

References

↑ F. Foukalas and T. Khattab, "Multi-User Diversity with Optimal Power Allocation in Spectrum Sharing under Average Interference Power Constraint." 2014 IEEE 79th Vehicular Technology Conference (VTC Spring), May 2014
↑ Brennan, D. G. (June 1959). "Linear Diversity Combining Techniques". Proceedings of the IRE. 47 (6): 1075–1102. doi:10.1109/JRPROC.1959.287136. ISSN 0096-8390.
1 2 Rentschler, M.; Laukemann, P. (September 2012). "Performance analysis of parallel redundant WLAN". Proceedings of 2012 IEEE 17th International Conference on Emerging Technologies Factory Automation (ETFA 2012): 1–8. doi:10.1109/ETFA.2012.6489647. ISBN 978-1-4673-4737-2.

External links

Diversity reception - Background information of the development of Diversity reception devices.

This page is based on this Wikipedia article
Text is available under the CC BY-SA 4.0 license; additional terms may apply.
Images, videos and audio are available under their respective licenses.

[1] F. Foukalas and T. Khattab, "Multi-User Diversity with Optimal Power Allocation in Spectrum Sharing under Average Interference Power Constraint." 2014 IEEE 79th Vehicular Technology Conference (VTC Spring), May 2014

[Brennan-2] Brennan, D. G. (June 1959). "Linear Diversity Combining Techniques". Proceedings of the IRE. 47 (6): 1075–1102. doi:10.1109/JRPROC.1959.287136. ISSN 0096-8390.

[Rentschler-3] 1 2 Rentschler, M.; Laukemann, P. (September 2012). "Performance analysis of parallel redundant WLAN". Proceedings of 2012 IEEE 17th International Conference on Emerging Technologies Factory Automation (ETFA 2012): 1–8. doi:10.1109/ETFA.2012.6489647. ISBN 978-1-4673-4737-2.