| LFG Roland D.IX | |
|---|---|
 | |
| LFG Roland D.IX first prototype | |
| Role | Single-seat fighter |
| National origin | Germany |
| Manufacturer | LFG Roland (Luft-Fahrzeug-Gesellschaft) |
| First flight | Late 1917-early 1918 |
| Number built | 3 |
The LFG Roland D.IX was a World War I German single seat fighter aircraft, a biplane powered by one of a new generation of powerful rotary engines. Three slightly different prototypes were built but there was no series production.
Late in 1917 new, more powerful rotary engines were appearing and the Idflieg encouraged aircraft manufacturers to incorporate them into fighters. The D.IX was LFG Roland's response. Apart from its engine it had much in common with the earlier D.VI, D.VII and D.VIII designs. It was a two bay biplane, with straight wings of constant chord and blunt tips. The upper plane was a little larger in both span and chord, so the two interplane struts on each side diverged slightly upwards and leant gently outwards. Bracing was assisted by flying and landing wires. There were ailerons on the upper wing only, the first and third prototypes using the overhung, balanced type and the second with unbalanced ones ending at the wing tip. [1] [2]
The D.IX had a fuselage of the Klinkerrumpf (clinker-built fuselage) type, roughly circular in cross section and built from overlapping longitudinal strips of spruce over a light, wooden frame, pioneered by LFG on the D.IV and used on the D.VI, D.VII and D.VIII. Because of the shortness and large diameter of the 160 hp (119 kW) Siemens-Halske Sh.III geared rotary of the first prototype, the nose of the new fighter was short and blunt compared with those of the earlier aircraft, which had all used liquid cooled V engines. Nonetheless, the metal oil deflecting cowling was carefully blended into the wooden fuselage. The rotary engine drove a four blade propeller, an unusual feature at this time and only fitted to one other LFG fighter, the later D.XVI. The tailplane of the fighter was straight edged with blunt tips and slightly rounded, split elevators. Its vertical tail repeated the small ventral fin of the D.VI and later Rolands and the rudder was similarly deep and rounded, but the tail surfaces of the second prototype were much enlarged and the rudder of the third horn balanced. The D.IX's conventional undercarriage was of the single axle type, mounted on V-struts to the lower fuselage and with a tailskid attached to the ventral fin. [1] [2]
As well the ailerons and empennage revisions of the later prototypes, both were powered by the newer, 210 hp (157 kW) Siemens-Halske Sh.IIIa rotary. [2]
The first prototype flew in the first D type competition, held in January 1918, and performed well but was lost soon after in an accident in which the pilot's seat collapsed, followed by an inadvertent loop with g-forces that expelled him through the fuselage bottom. The armed second prototype continued development and took part in the second D type competition held in May. There it was judged not worthy of series production. [1]
Data fromGreen and Swanborough p.339. [1]
General characteristics
Performance
Armament
The Siemens-Schuckert D.IV was a late-World War I fighter aircraft from Siemens-Schuckert (SSW). It reached service too late and was produced in too few numbers to have any effect on the war effort.
Luft-Fahrzeug-Gesellschaft, also referred to as LFG, was a German aircraft manufacturer during World War I. They are best known for their various "Roland" designs, notably the Roland C.II Walfisch (whale), Roland D.II haifisch (Shark) and Roland D.VI, although they also produced a number of airships and many experimental designs.
The Albatros D.XI was a German single-seat fighter sesquiplane first flown in February 1918. It was the first Albatros fighter to use a rotary engine, in the form of the 120 kW (160 hp) Siemens-Halske Sh.III, and also featured a new wing construction with diagonal struts from the fuselage replacing traditional wire bracing.
VL Viima, constructed by the State Aircraft Factory is a Finnish two-seat, biplane trainer used by the Finnish Air Force from the late 1930s to the early 1960s. After military service, several were released into civil use.
The Siemens-Schuckert D.III was a German single-seat fighter built by Siemens-Schuckert Werke. The D.III was a development of the earlier Siemens-Schuckert D.IIc prototype. The D.III was an (nearly) equal-span biplane powered by a 160 hp (119 kW) Siemens-Halske Sh.III bi-rotary engine. Idflieg placed an order for 20 aircraft in December 1917, followed by a second order of 30 aircraft in February 1918.
The Hanriot HD.6 was a French two-seat fighter aircraft prototype, built towards the end of World War I though not flown until after the armistice with Germany. A biplane with an unusually narrow gap between upper and lower wings, powered by a single water-cooled radial engine, it did not enter production.
The Siemens-Schuckert D.VI was a single engine, single seat, parasol wing German fighter aircraft flown in 1919.
The Siemens-Schuckert DDr.I was a World War I German twin engine, push-pull configuration triplane fighter aircraft. Only one was built, crashing on its first flight.
The Kondor E 3, sometimes erroneously known as E.III, was a German single seat, monoplane fighter aircraft designed and built close to the end of World War I. Though successful in the third D-type fighter competition at Aldershof in September 1918, only a few were produced, given the Idflieg designation of Kondor D.I.
The Kondor D 6 was a prototype German biplane fighter aircraft flown in 1918. In the interests of better upward vision for the pilot, its upper wing was in two halves, separated over the central fuselage. Its development was soon abandoned.
The Pfalz D.XV was a German single seat fighter aircraft which was approved for production right at the end of World War I, too late to enter service.
The Pfalz D.VII was a German biplane fighter aircraft from World War I. It was not put into production.
The Pfalz D.VI was a German sesquiplane fighter aircraft from World War I. It was not put into production.
The LFG Roland D.IV, later redesignated LFG Roland Dr.I was a German single engine, single seat triplane fighter flown in mid-1917. It produced no performance or operational advantages over existing types and only one was built.
The Luft-Fahrzeug-Gesellschaft (LFG) Roland D.VII was a German single seat, single engine biplane fighter aircraft built during World War I. Problems with its underdeveloped V-8 engine prevented its production.
The LFG Roland D.XV was a World War I German single seat fighter aircraft, ordered as a test-bed for engine comparisons. It was distinguished from earlier Roland biplane designs by the elimination of flying wires. Two later aircraft, also called LFG Roland D.XV, were completely different designs with slab sided fuselages.
The LFG Roland D.XVI, initially designated the LFG Roland E.I, was a single-seat, single-engine, parasol wing German fighter aircraft flown close to the end of World War I. Only two were built.
The LFG Roland D.XVII was a single-seat, single-engine, parasol wing German fighter aircraft flown close to the end of World War I. Only one was built.
The Siemens-Schuckert Dr.I was a German single seat triplane fighter aircraft first flown in 1917. Its development and that of a more powerful, uncompleted variant, was abandoned after a flight test programme.
The Udet U 1 was the first of a line of small, low-powered, low wing, cantilever monoplanes built in Germany in the early 1920s.
