A Silver streak 8 in a 1949 Pontiac Streamliner - note the large intake silencer leading to an oil-bath air cleaner on the left side of the engine
The Pontiac straight-8 engine is an inline eight-cylinder automobile engine produced by Pontiac from 1933 to 1954. Introduced in the fall of 1932 for the 1933 models, it was Pontiac's most powerful engine at the time and the least expensive eight-cylinder engine built by an American automotive manufacturer. During its 21-year run displacement of the "eight" increased twice as platforms grew. It was superseded by Pontiac's new V8, the 287, in 1955. Engine block and cylinder heads were cast at Saginaw Metal Casting Operations then assembled at Tonawanda Engine before delivery to Pontiac Assembly for installation.[1]
The straight-8 was dubbed the Silver-Streak[2] at Pontiac Division. Powered by the "eight", optional in lower-end models, a Pontiac was promoted as a likable automobile, with enough power under the hood to get the job done in affordable luxury.
However, by the early 1950s, powerful overhead valve V8s from sister GM Divisions Cadillac, Buick and Oldsmobile, as well as new overhead valve V8s from Ford Motor Company and Chrysler Corporation, made the flathead "Silver Streak" all but obsolete. It was a quiet, smooth running, cheap to produce engine that served the needs of the 1930s and '40s Pontiac buyers adequately for power. By 1953 the 287-cubic-inch (4.7L)Strato Streak V8 was ready to go, with Pontiac chassis and steering already adapted for it, but it was held back by the protesting Buick and Olds divisions.[citation needed] It was a truly modern, durable but affordable design perfectly matched to Pontiac's target market. A few years later (fall of 1956), under the guidance of Bunkie Knudsen Pontiac was determined to change its image into a performance car to boost sales, this led Knudsen to look for further talent, including Pete Estes as chief engineer (taken from Olds division) and John DeLorean as director of advanced engineering, a former Packard and Chrysler engineer. Pontiac became known as a performance division based upon the durable, well performing V8s that came later, all of them based upon the original 287 of 1955.
Market
Designed and priced for conservative lower middle class buyers, the Pontiacs filled a slot between the popular Chevrolet and the higher priced Oldsmobiles and Buicks.
Design
The "eight" was a typical American built engine for its time, a side-valve L-head, or "flathead", with a chain driven cam. It was naturally aspirated through a Carter "W" series single or dual-venturi (one- or two-barrel) downdraft carburetor.
Advantages
Of all cylinder layouts without balance shaft, a straight eight design has very low inherent vibration, while the side-valve layout contains the moving parts of the valve train within the cast-iron block, enabling it to be very quiet compared to an overhead valve configuration (as in the contemporary Buick engines). Combined with a substantial exhaust manifold and effective intake and exhaust muffling this can lead to a very quiet vehicle, both internally and externally. At the time of its use, a quiet and vibration free engine was thought to be a mark of quality in an automobile. Bores need be of small diameter to keep the engine length down, and so strokes must be long to obtain larger displacements — such configurations (called "undersquare") exhibit good low-rpm torque and are capable of slow idle speeds, enhancing both drivability and quietness. While Chrysler vehicles had similar engines they were not targeted for the lower middle price range enabled by General Motors' manufacturing expertise and volumes of the time.
Disadvantages
As with other iron block straight configurations, the engine is considerably heavier than an equivalent V configuration, requiring more materials for the crank and crankcase and so increasing overall vehicle weight in even greater proportion. The long crankshaft tends to exhibit torsional vibration modes under high power, while side-valve flathead engines inhibit smooth intake and exhaust gas flow, limiting power. None of these disadvantages were disabling until the "horsepower race" initiated in the early 1950s ensured the dominance of the overhead valve V8.
Applications
During its run, the eight came in all Pontiacs, which included the Special and Deluxe (1936–40), Torpedo (1940–48) and Streamliner (1942–52), as well as the first six years of the Chieftain (1949–58) and the debut year for the Star Chief (1954–66).
Specifications
Compression on the "eight" started at 5.7:1 initially,[3] and was increased to 6.2:1 in 1934.[1] In 1940 it was increased again to 6.5:1. From 1952 to 1954 two compression ratios were specified, 6.8:1 with synchromesh (manual) transmission, and 7.7:1 with Hydramaticautomatic transmission.[4] The engine had a remarkably low idle speed of 450 rpm with standard transmission and 375 rpm (while in drive) for the automatic;[5] a modern engine is usually tuned to a minimum 600-700 rpm. The electrical system was a 6-volt primary with a negative ground, and a conventional mechanical ignition, with the firing order 1-6-2-5-8-3-7-4. The Pontiac engines employed a full pressure oiling system and full bearing inserts, unlike its Chevrolet cousin.
Below are specifications as per the model year and displacement, with output shown as horsepower (kilowatts).
At the General Motors Motorama for 1954, Pontiac debuted its all new Bonneville Special, a concept car envisioned by head designer Harley J. Earl. The concept was equipped with the "Special"-8, a high output 268-cubic-inch (4.4L) engine that was painted bright red and detailed in chrome. This was a unique configuration for the "eight", installed in the only two Specials ever made. Similar in appearance only, this was a high compression variant, modified with a high-lift cam and fitted with four Carter YH side-draft one-barrel carburetors, the same used in the 1953 Corvette, under open-mesh breathers. Total output was the highest ever for the "eight", rated at 230bhp (172kW), though some estimated it at over 300bhp (224kW).[14] Like the Special, only two were ever made.
Note: Pontiac’s new V8 was being considered for use in the Special but was instead held back by GM marketing. They directed that the straight-eight be used to keep the V8 a secret from consumers for one more year until its debut the following year.[15]
1 2 3 4 Pontiac Shop Manual 1934 Models General Motors of Canada
↑ Silver-Streak: The name taken from a body detail peculiar to Pontiacs manufactured from 1935 to 1956, called a "silver-streak", which is a five-banded, chromed metal band that ran down the middle of the hood and trunk. Born in the Art Deco style of the mid thirties, it was meant as a visual cue to help distinguish Pontiacs from their competitors, and create the illusion of speed.
1 2 Pontiac sales brochure, Pontiac Motor Division, 1933.
The straight-eight engine or inline-eight engine is an eight-cylinder internal combustion engine with all eight cylinders mounted in a straight line along the crankcase. The type has been produced in side-valve, IOE, overhead-valve, sleeve-valve, and overhead-cam configurations.
The straight-six engine is a piston engine with six cylinders arranged in a straight line along the crankshaft. A straight-six engine has perfect primary and secondary engine balance, resulting in fewer vibrations than other designs of six or less cylinders.
The Pontiac Sunbird is a model line that was manufactured and marketed by Pontiac from the 1976 to the 1994 model years. Loosely deriving its name from the Pontiac Firebird, the Sunbird was introduced as the eventual replacement for the Pontiac Astre, replacing it entirely in 1978 as the smallest Pontiac.
The Pontiac Tempest is an automobile that was produced by Pontiac from 1960 to 1970, and again from 1987 to 1991.
The Y-block engine is a family of overhead valve V8 automobile engines produced by Ford Motor Company. The engine is well known and named for its deep skirting, which causes the engine block to resemble a Y. It was introduced in 1954 as a more modern replacement for the outdated side-valved Ford Flathead V8 and was used in a variety of Ford vehicles through 1964.
The Iron Duke engine is a 151 cu in (2.5 L) straight-4 piston engine built by the Pontiac Motor Division of General Motors from 1977 until 1993. Originally developed as Pontiac's new economy car engine, it was used in a wide variety of vehicles across GM's lineup in the 1980s as well as supplied to American Motors Corporation (AMC). The engine was engineered for fuel efficiency, smooth operation, and long life, not for performance. Total Duke engine production is estimated to be between 3.8 and 4.2 million units.
The General Motors 60° V6 engine family is a series of 60° V6 engines produced for both longitudinal and transverse applications. All of these engines are 12-valve cam-in-block or overhead valve engines, except for the LQ1; which uses 24 valves driven by dual overhead cams. These engines vary in displacement between 2.5 and 3.4 litres and have a cast-iron block and either cast-iron or aluminum heads. Production of these engines began in 1980 and ended in 2005 in the U.S., with production continued in China until 2010. This engine family was the basis for the GM High Value engine family. These engines have also been referred to as the X engines due to their first usage in the X-body cars.
The Pontiac V8 engine is a family of overhead valve 90° V8 engines manufactured by the Pontiac Division of General Motors Corporation between 1955 and 1981. The engines feature a cast-iron block and head and two valves per cylinder. Engine block and cylinder heads were cast at Saginaw Metal Casting Operations then assembled at Tonawanda Engine before delivery to Pontiac Assembly for installation.
The Buick V6 was an OHV V6 engine developed by the Buick division of General Motors and introduced in 1962. Originally 198 cu in (3.2 L) and initially marketed as Fireball, it later became popularly referred to as the 3800 for its various 3.8 L (230 cu in) incarnations.
The Oldsmobile V8, also referred to as the Rocket, is series of engines that was produced by Oldsmobile from 1949 until 1990. The Rocket, along with the 1949 Cadillac V8, were the first post-war OHV crossflow cylinder head V8 engines produced by General Motors. Like all other GM divisions, Olds continued building its own V8 engine family for decades, adopting the corporate Chevrolet 350 small-block and Cadillac Northstar engine only in the 1990s. All Oldsmobile V8s were manufactured at plants in Lansing, Michigan while the engine block and cylinder heads were cast at Saginaw Metal Casting Operations.
An overhead valve (OHV) engine, sometimes called a pushrod engine, is a piston engine whose valves are located in the cylinder head above the combustion chamber. This contrasts with earlier flathead engines, where the valves were located below the combustion chamber in the engine block.
The Buick V8 is a family of V8 engines produced by the Buick division of General Motors between 1953 and 1981. The first version replaced the Buick straight-eight. Displacements vary from 215 cu in (3.5 L) to 455 cu in (7.5 L) for its last big block in 1976. All are naturally aspirated OHV pushrod engines, except for an optional turbocharged version of the short-lived 215 used in the 1962-63 Oldsmobile Jetfire.
The 122 engine was designed by Chevrolet and was used in a wide array of General Motors vehicles. The 122 was similar to the first two generations of the General Motors 60° V6 engine; sharing cylinder bore diameters and some parts. The 122 was available in the US beginning in 1982 for the GM J platform compact cars and S-series trucks.
The Pontiac straight-6 engine is a family of inline-six cylinder automobile engines produced by the Pontiac Division of General Motors Corporation in numerous versions beginning in 1926.
The Chevrolet Inline-4 engine was one of Chevrolet's first automobile engines, designed by Arthur Mason and introduced in 1913. Chevrolet founder Billy Durant, who previously had owned Buick which had pioneered the overhead valve engine, used the same basic engine design for Chevrolet: exposed pushrods and rocker arms which actuated valves in the detachable crossflow cylinder head. This was referred to this as a "valve-in-head" design, and it drew considerable publicity in a time when most rivals were flatheads. It was produced through 1928 when it was replaced by the Chevrolet Stovebolt engine.
The Oakland Motor Car Company of Pontiac, Michigan, was an American automobile manufacturer and division of General Motors. Purchased by General Motors in 1909, the company continued to produce modestly priced automobiles until 1931 when the brand was dropped in favor of the division's Pontiac make.
The Pontiac Bonneville Special is a Pontiac concept car unveiled at the General Motors Motorama in 1954, the first 2-seat sports car prototype the division had ever produced. Conceived by renowned designer Harley J. Earl and hand built by Homer C. LaGassey Jr. and Paul Gilland, the "Special" is a grand touring sport coupé that incorporated innovative styling like a Plexiglas canopy with gull-wing windows on a sleek fiberglass body.
The Chevrolet Series D is an American automobile produced by Chevrolet between 1917 and 1918. Over 4,000 Series D cars were manufactured in the 1918 model year, and was initially the only Chevrolet car manufactured with a V8 engine. It was not until 1955 that Chevrolet introduced another V8.
The Chevrolet Series AC International is an American vehicle manufactured by Chevrolet in 1929 to replace the 1928 Series AB National. In all, 1,328,605 Series ACs were manufactured in a range of ten body styles, with 73,918 from Oshawa. The Series AC was distinguished from the AB by the introduction of a new six-cylinder engine, the first Chevrolet with a six-cylinder since the 1915 Chevrolet Series C Classic Six. Advertised as "A Six for the price of a Four", it was only $10 more than the outgoing four-cylinder Series AB. To simplify production operations, each factory was designated one body style for national consumption and shipped by railroad to major American cities. The serial number of origin was relocated to the right body sill underneath the rubber floormat except for the roadster and phaeton, which were inscribed on the right side of seat frame. Prices listed started at US$525 for the roadster or phaeton to US$725 for the Landau Convertible.
This page is based on this Wikipedia article Text is available under the CC BY-SA 4.0 license; additional terms may apply. Images, videos and audio are available under their respective licenses.
